Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “error rate”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,189 records · Page 66

Computation of the wind by forced adjustment to the height field.

Experimental study of the problem of the forced adjustment of the wind field to the height field with the Mintz-Arakawa two-level atmospheric general circulation model. In all but one of the experiments, the height field was assumed to be perfectly observed at 6-hr intervals, over a time period of one day or less, and from these height data the vector wind field was computed by forced dynamical adjustment. In one experiment, the temperature alone was prescribed. The winds computed in these experiments were compared with the 'control' winds of the general circulation simulation. The best agreement between the computed and the control winds was obtained when the time-differencing scheme in the governing finite-difference equations of motion had a large rate of damping of high-frequency motions. This damping rate also determined the optimum fraction and frequency of restoration of the height (or temperature) fields. With strong damping, total restoration at every time step gave the most rapid rate of wind error reduction and the smallest asymptotic limit of the wind error.

Mesinger, F.↗

Failure detection and isolation methods for redundant gimballed inertial measurement units.

Skewed alignment of two redundant conventional inertial measuring units permits nonambiguous detection and isolation of hard and soft failures in real time by an airborne computer. Accelerometer outputs and gimbal readouts are monitored periodically, and attitude rate and velocity error vectors are computed from these data. Magnitudes of these vectors provide failure detection, and projection of these error vectors onto the coordinate axes of the two clusters permits isolation. A detailed Monte Carlo simulation of one version of the mechanization as applied to Space Shuttle boost trajectories demonstrates effectiveness down to very low levels of inertial instrument performance failures. The results indicate that worst case overall navigation performance occurs when accelerometer failures are of the order of 20 sigma and gyro failures are about 100 sigma for conventional state-of-the-art IMU instruments.

Solov, E. G.↗

Numerical marching techniques for fluid flows with heat transfer

The finite difference formulation and method of solution is presented for a wide variety of fluid flow problems with associated heat transfer. Only a few direct results from these formulations are given as examples, since the book is intended primarily to serve a discussion of the techniques and as a starting point for further investigations; however, the formulations are sufficiently complete that a workable computer program may be written from them. In the appendixes a number of topics are discussed which are of interest with respect to the finite difference equations presented. These include a very rapid method for solving certain sets of linear algebraic equations, a discussion of numerical stability, the inherent error in flow rate for confined flow problems, and a method for obtaining high accuracy with a relatively small number of mesh points.

Hornbeck, R. W.↗

Simulation and flight studies of an approach profile indicator for VTOL aircraft

Simulation and flight investigations were conducted by using a method of providing supplementary information to the pilot in conjunction with a closed-circuit-television display during a VTOL instrument final approach including deceleration and hover. The supplementary information included range, cross range, ground speed, altitude, and rate-of-climb error and was displayed on an instrument called an approach profile indicator. The display was arranged to provide both quasi-command and situation information. Pilot comments indicated that the approach-profile-indicator display concept in conjunction with the closed-circuit television resulted in a decreased pilot workload and an increase in pilot confidence. Also, the results indicated that the approach profile repeatability was significantly improved because of the ground-speed and altitude information provided on the approach profile indicator.

Moen, G. C.↗

VLBI clock sync and the earth's rotational instability

Preparation is being made by the DSN to monitor the stability of its clocks and frequency standards in the 64 meter net by means of VLBI. Since variations in the earth's rotation rate represent an error source to VLBI clock synchronization, the Allan Variance of the earth rotation was calculated to find that, in a long-term sense at least, these variations do not noticeably increase the differential instability of two clocks as measured by Intercontinental VLBI.

Layland, A. W.↗

Prospects for TLRS baseline accuracies in the western USA

One of the main goals of the LAGEOS satellite mission is the detection of regional geotectonic movements. A parametric study with the intention to obtain the optimal baseline precision from dynamic solutions of laser ranging to LAGEOS is presented. The varied parameters are: length of reduced arc, number of tracking stations, data noise and rate, biases, refraction errors, system efficiency, gravity model errors in the value of GM. The baseline precisions are 1-10 cm depending upon the set of parameters adopted. General principles obtained are also presented.

Christodoulidis, D.↗

Modulation/demodulation techniques for satellite communications. Part 2: Advanced techniques. The linear channel

A theory is presented for deducing and predicting the performance of transmitter/receivers for bandwidth efficient modulations suitable for use on the linear satellite channel. The underlying principle used is the development of receiver structures based on the maximum-likelihood decision rule. The application of the performance prediction tools, e.g., channel cutoff rate and bit error probability transfer function bounds to these modulation/demodulation techniques.

Omura, J. K.↗

Simulation and analysis of differential global positioning system for civil helicopter operations

A Differential Global Positioning System (DGPS) computer simulation was developed, to provide a versatile tool for assessing DGPS referenced civil helicopter navigation. The civil helicopter community will probably be an early user of the GPS capability because of the unique mission requirements which include offshore exploration and low altitude transport into remote areas not currently served by ground based Navaids. The Monte Carlo simulation provided a sufficiently high fidelity dynamic motion and propagation environment to enable accurate comparisons of alternative differential GPS implementations and navigation filter tradeoffs. The analyst has provided the capability to adjust most aspects of the system, the helicopter flight profile, the receiver Kalman filter, and the signal propagation environment to assess differential GPS performance and parameter sensitivities. Preliminary analysis was conducted to evaluate alternative implementations of the differential navigation algorithm in both the position and measurement domain. Results are presented to show that significant performance gains are achieved when compared with conventional GPS but that differences due to DGPS implementation techniques were small. System performance was relatively insensitive to the update rates of the error correction information.

Denaro, R. P.↗

A new linear quadratic optimal controller for the 34-meter high efficiency antenna position loop

The design of a new position loop controller for the 34-meter High Efficiency Deep Space antennas using linear quadratic (LQ) optimal control techniques is discussed. The LQ optimal control theory is reviewed, and model development and verification are discussed. Families of optimal gain vectors are generated by varying weight parameters. Performance specifications were used to select a final gain vector. Estimator dynamics were selected and the corresponding gain vectors were computed. Final estimator selection was based on position, commanded rate, and estimator error responses.

Nickerson, J. A.↗

Study Of Candidate Architectures For Data Processor

Report discusses candidate architectures for digital computer system, part of communication system in spacecraft. Primary issues in analysis; performance, rates of bit errors attributable to single-event upsets (caused by ionizing radiation), reliability, size, and dissipation of power.

Mcroberts, Lou↗

Custom CMOS Reed Solomon coder for the Hubble Space Telescope

A VLSI coder is presented that can function either as an encoder or decoder for Reed-Solomon codes. VLSI is one approach to implementing high-performance Reed-Solomon decoders. There are three VLSI technologies that could be used: gate arrays, standard cells, and full custom. The first two approaches are relatively easy to implement, but are limited in both performance and density. Full-custom VLSI is used to achieve both circuit density and speed, and allows control of the amount of interconnect. Speed, which is a function of capacitance, which is a function of interconnect, is an important parameter in high-performance VLSI. A single 8.2 mm x 8.4 mm, 200,000 transistor CMOS chip implementation of the Reed-Solomon code required by the Hubble Space Telescope is reported. The chip features a 10-MHz sustained byte rate independent of error pattern. The 1.6-micron CMOS integrated circuit has complete decoder and encoder functions and uses a single data/system clock. Block lengths up to 255 bytes and shortened codes are supported with no external buffering. Erasure corrections and random error corrections are supported with programmable correction of up to 10 symbol errors. Correction time is independent of error pattern and the number of errors in the incoming message.

Whitaker, S.↗

Ames life science telescience testbed evaluation

Eight surrogate spaceflight mission specialists participated in a real-time evaluation of remote coaching using the Ames Life Science Telescience Testbed facility. This facility consisted of three remotely located nodes: (1) a prototype Space Station glovebox; (2) a ground control station; and (3) a principal investigator's (PI) work area. The major objective of this project was to evaluate the effectiveness of telescience techniques and hardware to support three realistic remote coaching science procedures: plant seed germinator charging, plant sample acquisition and preservation, and remote plant observation with ground coaching. Each scenario was performed by a subject acting as flight mission specialist, interacting with a payload operations manager and a principal investigator expert. All three groups were physically isolated from each other yet linked by duplex audio and color video communication channels and networked computer workstations. Workload ratings were made by the flight and ground crewpersons immediately after completing their assigned tasks. Time to complete each scientific procedural step was recorded automatically. Two expert observers also made performance ratings and various error assessments. The results are presented and discussed.

Haines, Richard F.↗

A reliable multicast for XTP

Multicast services needed for current distributed applications on LAN's fall generally into one of three categories: datagram, semi-reliable, and reliable. Transport layer multicast datagrams represent unreliable service in which the transmitting context 'fires and forgets'. XTP executes these semantics when the MULTI and NOERR mode bits are both set. Distributing sensor data and other applications in which application-level error recovery strategies are appropriate benefit from the efficiency in multidestination delivery offered by datagram service. Semi-reliable service refers to multicasting in which the control algorithms of the transport layer--error, flow, and rate control--are used in transferring the multicast distribution to the set of receiving contexts, the multicast group. The multicast defined in XTP provides semi-reliable service. Since, under a semi-reliable service, joining a multicast group means listening on the group address and entails no coordination with other members, a semi-reliable facility can be used for communication between a client and a server group as well as true peer-to-peer group communication. Resource location in a LAN is an important application domain. The term 'semi-reliable' refers to the fact that group membership changes go undetected. No attempt is made to assess the current membership of the group at any time--before, during, or after--the data transfer.

Dempsey, Bert J.↗

The snapshot survey - A search for gravitationally lensed quasars with the Hubble Space Telescope

The first results from the HST Non-Proprietary Snapshot Survey are presented in order to investigate new examples of multiply imaged quasars that are the result of gravitational lensing. None of the approximately 30 quasars observed at high spatial resolution show evidence of multiple imaging by gravitational lensing. These results are compared with lower resolution ground-based surveys and current theoretical predictions. Several engineering problems in the observatory's performance are addressed. It particular, the large telescope pointing errors and drift rates are found to be primarily the result of the lack of correction for stellar aberration when pointing and tracking are performed solely with gyroscopes. The implications for the possibly low intrinsic gyro drift rate on future observations are discussed.

Bahcall, J. N.↗

Modulation and coding for throughput-efficient optical free-space links

Optical direct-detection systems are currently being considered for some high-speed inter-satellite links, where data-rates of a few hundred megabits per second are evisioned under power and pulsewidth constraints. In this paper we investigate the capacity, cutoff-rate and error-probability performance of uncoded and trellis-coded systems for various modulation schemes and under various throughput and power constraints. Modulation schemes considered are on-off keying (OOK), pulse-position modulation (PPM), overlapping PPM (OPPM) and multi-pulse (combinatorial) PPM (MPPM).

Georghiades, Costas N.↗

Optical phase-locked loop (OPLL) for free-space laser communications with heterodyne detection

Several advantages of coherent free-space optical communications are outlined. Theoretical analysis is formulated for an OPLL disturbed by shot noise, modulation noise, and frequency noise consisting of a white component, a 1/f component, and a 1/f-squared component. Each of the noise components is characterized by its associated power spectral density. It is shown that the effect of modulation depends only on the ratio of loop bandwidth and data rate, and is negligible for an OPLL with loop bandwidth smaller than one fourth the data rate. Total phase error variance as a function of loop bandwidth is displayed for several values of carrier signal to noise ratio. Optimal loop bandwidth is also calculated as a function of carrier signal to noise ratio. An OPLL experiment is performed, where it is shown that the measured phase error variance closely matches the theoretical predictions.

Win, Moe Z.↗

Headphone localization of speech stimuli

Recently, three dimensional acoustic display systems have been developed that synthesize virtual sound sources over headphones based on filtering by Head-Related Transfer Functions (HRTFs), the direction-dependent spectral changes caused primarily by the outer ears. Here, 11 inexperienced subjects judged the apparent spatial location of headphone-presented speech stimuli filtered with non-individualized HRTFs. About half of the subjects 'pulled' their judgements toward either the median or the lateral-vertical planes, and estimates were almost always elevated. Individual differences were pronounced for the distance judgements; 15 to 46 percent of stimuli were heard inside the head with the shortest estimates near the median plane. The results infer that most listeners can obtain useful azimuth information from speech stimuli filtered by nonindividualized RTFs. Measurements of localization error and reversal rates are comparable with a previous study that used broadband noise stimuli.

Begault, Durand R.↗