The interpretation of TIROS radiation data for practical use in synoptic weather analysis
Interpretation of TIROS III radiation data to demonstrate practical applications in synoptic weather analyses
RADIATION DISTRIBUTION↗
SEARCH · Engineering Papers
Results for “Practical Application”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Calculation of complex chemical equilibria.
Nonlinear equations governing complex chemical and phase equilibria derived from thermodynamic principles and supplemented by solving algorithms and practical applications
NONLINEAR EQUATION↗
Space plans and possibilities.
Space program in 1970s, discussing solar system exploration, investigation of universe, practical applications of space and development of technology
SPACE EXPLORATION↗
Effect of Engine Operating Variables on Combustor-inlet Parameters
Studies of the fundamental processes of combustion are usually concerned with wide ranges of investigation of individual processes. In general, each fundamental combustion process may be studied in an environment that is most suited to its evaluation and possibly unrelated basically to any practical application. The majority of the data presented in volume I of this series concern the fundamental aspects of combustion as functions of the individual occurrence of various contributing processes. In a jet engine, however, the various fundamental combustion processes may occur simultaneously and may interact. Furthermore, the engine environment usually does not permit independent variation of single combustion parameters, since specified operating conditions impose specific values on the parameters. In volume II, data are presented to show the effect of operating conditions on the over-all combustion process in different combustion components. To show the effect of operating conditions, it is necessary to specify the range of these conditions within which combustion components may operate. Therefore, this chapter presents only the operating conditions that might be required in the primary combustors and afterburners of typical current turbojet engines. (Corresponding information on ram-jet engines is presented in ch. xisi.) This chapter is not intended to serve as an explanation of engine operation. The operating conditions of the combustion components are presented in terms of total pressures and temperatures at the primary-combustor and afterburner inlets, reference velocities and outlet total temperatures of the primary combustors, and velocities at the plane of the flameholder in the afterburners. The data are presented to relate the operating regions of typical current turbojet combustion components to flight altitudes, Mach numbers, and modes of engine operation. Specifically, data are presented for the combustion parameters of the primary combustor and afterburner of three turbojet engines having rated compressor total-pressure ratios of 5, 8, and 12 under full-throttle conditions. Operational data for the primary combustor also include part-throttle operation at 70, 80, and 90 percent of rated engine speed and windmifling operation. The range of flight conditions includes altitudes from sea level to 65,000 feet and flight Mach numbers from zero to 1.6.
Jones, A. W.↗
Multifrequency laser beams for holographic contouring
Pulsed ruby laser emits two optical frequencies simultaneously so holographic recordings of test object give images showing desired range contours. Process enables generation of contour maps for practical applications such as gaging size and shape of mechanical parts and other structures.
Heflinger, L. O.↗
Investigation of single crystal ferrite thin films
Materials suitable for use in magnetic bubble domain memories were developed for aerospace applications. Practical techniques for the preparation of such materials in forms required for fabrication of computer memory devices were considered. The materials studied were epitaxial films of various compositions of the gallium-substituted yttrium gadolinium iron garnet system. The major emphasis was to determine their bubble properties and the conditions necessary for growing uncracked, high quality films.
Mee, J. E.↗
An evaluation of random analysis methods for the determination of panel damping
An analysis is made of steady-state and non-steady-state methods for the measurement of panel damping. Particular emphasis is placed on the use of random process techniques in conjunction with digital data reduction methods. The steady-state methods considered use the response power spectral density, response autocorrelation, excitation-response crosspower spectral density, or single-sided Fourier transform (SSFT) of the response autocorrelation function. Non-steady-state methods are associated mainly with the use of rapid frequency sweep excitation. Problems associated with the practical application of each method are evaluated with specific reference to the case of a panel exposed to a turbulent airflow, and two methods, the power spectral density and the single-sided Fourier transform methods, are selected as being the most suitable. These two methods are demonstrated experimentally, and it is shown that the power spectral density method is satisfactory under most conditions, provided that appropriate corrections are applied to account for filter bandwidth and background noise errors. Thus, the response power spectral density method is recommended for the measurement of the damping of panels exposed to a moving airflow.
Bhat, W. V.↗
Remote sensing project
The accomplishments and publications developed during the study are summarized. They illustrated a series of practical applications of remote sensing data to the urban-regional planning processes in the metropolitan Washington area.
Mallon, H. J.↗
Characterization of GTA weldments in 10Ni-8CO-2Cr-1MO steel
This study of 10Ni-8Co-2Cr-1Mo steel includes evaluations of tensile, impact, hardness, fracture toughness properties, and metallographic features. Base plate and three weldments in one-inch thicknesses were examined to compare as-welded properties with those obtained after reaging, and results of welding the 10%Ni alloy with 9-4-20 wire as opposed to a matching weld wire composition. Critical crack sizes are calculated for the material. The most desirable weld properties are obtained using the matching weld wire and a reaging cycle. However, the improvement gained through reaging is probably not sufficient to justify the additional cost for most practical applications.
Stonesifer, F. R.↗
Apollo experience report: Pressure vessels
The Apollo spacecraft pressure vessels, associated problems and resolutions, and related experience in evaluating potential problem areas are discussed. Information is provided that can be used as a guideline in the establishment of baseline criteria for the design and use of lightweight pressure vessels. One of the first practical applications of the use of fracture-mechanics technology to protect against service failures was made on Apollo pressure vessels. Recommendations are made, based on Apollo experience, that are designed to reduce the incidence of failure in pressure-vessel operation and service.
Ecord, G. M.↗
Inversion problem for ion-atom differential elastic scattering.
The paper describes a practical application of Remler's (1971) method by which one constructs a set of phase shifts from high resolution measurements of the differential elastic scattering of protons by rare-gas atoms. These JWKB phase shifts are then formally inverted to determine the corresponding intermolecular potentials. The validity of the method is demonstrated by comparing an intermolecular potential obtained by direct inversion of experimental data with a fairly accurate calculation by Wolniewicz (1965).
Rich, W. G.↗
Sky-wave backscatter - A means for observing our environment at great distances.
During the last five years, much progress has been made in the understanding of sky-wave backscatter. An explanation of the various interacting phenomena is presented, as is a review of the current state of knowledge reflecting recent advances in observational methods and analytic techniques. New narrow-beam antennas, coupled with signal modulations that permit fine resolution in time delay, are beginning to yield information concerning the character of the scatterers, which now can be separately discerned. These narrow beams also permit study of polarization fading from small regions, and this shows promise as a means for learning the distant sea state. Doppler shifts of a fraction of a hertz on signals of tens of megahertz are separable, permitting isolation of sea returns from ground returns by virtue of the Doppler effect resulting from sea-wave speed; this also suggests a potential sea-monitoring principle. Despite these advances, there is little practical application of sky-wave backscatter as a means of environmental monitoring. This lack is attributed to the large remaining gaps in our understanding of the echoes and our inability to interpret the forms of data that can be acquired with equipment of reasonable cost.
Croft, T. A.↗
Free in-plane vibration of circular arches.
Numerical data are presented for the natural frequencies and modes of vibration of hinged and fixed, uniform, circular arches vibrating in their own plane, and the effects of the various parameters affecting the response are analyzed. It is shown that the vibrational modes may be almost purely flexural, or almost purely extensional, or the extensional and flexural actions may be strongly coupled. The conditions of occurrence of each type of behavior are defined, and simple approximate formulas are derived; using these formulas, the free vibrational characteristics of arches may be estimated to a satisfactory degree of accuracy for most practical applications. The approach used to derive the approximate formulas may also be applied to arches having other boundary conditions, shapes, or distributions of stiffness and mass.
Veletsos, A. S.↗
NASA's plans for the 70's.
NASA's plan for the 70's is based on six objectives. These objectives include continued exploration of the moon, continued exploration of the planets and the universe, a substantial reduction in the cost of space operations, an expansion of man's capability to live and work in space, practical applications of space technology, and the encouragement of greater international cooperation in space. Applications of space technology considered are in the areas of meteorology, earth physics, earth resources, communications and navigation, astronomy, and space physics. Attention is given to the Skylab and the Space Shuttle.
Von Braun, W.↗
Marshes and turbid waters
There are no author-identified significant results in this report. The study of the alluvial zones of the French Atlantic littoral at a taxonomic scale which can bring out the general nature of the sediments and their geomorphic forms is being achieved with the aid of ERTS-1 imagery. It will be necessary to run as many lines as possible to study both the alluvial plains, indicating the seasonal phases of the lowest and highest humidity, as well as the turbidity of littoral waters which change in relation to the tides. A better understanding of these alluvial zones and the origin of the sedimentary forms will not be limited to theoretical interest alone, but will have practical application in numerous fields such as agriculture, shell fishing, and land reclamation.
Verger, F.↗
Ecological effects of strip mining in Ohio
The author has identified the following significant results. One result significant as a practical application and for cost benefit analysis is the relative ease with which ERTS-1 will monitor new and unclaimed stripping activities in Southeastern Ohio and in all of Appalachia. Band 5 resolution appears to be better than the often reported 80 meters. The strip mines stand out well enough to be easily identified without other graphic aids. Standing water within the strip mined area stands out in either bands 6 or 7. Areas of several acres are visible. Significant increases in surface extent of water of stripped areas should be detectable on a comparative basis. The degree of reclamation is observable in the imagery in rather gross percentage steps and for areas larger than the bare earth sizes in the table. The gradation in tones in the different bands indicates that probability density imagery using the four bands in CCT data (and statistical processing) is likely to separate degrees of vegetative reclamation.
Chase, P. E.↗
High loading, low speed fan study, 5
A low speed, low noise, single stage fan was designed and tested. Design pressure ratio was 1.5 at a rotor tip speed of 1000 ft/sec. No inlet guide vane was used, the rotor stator was spaced and the number of rotor and stator airfoils was selected for low noise. Tests were conducted with uniform and distorted inlet flows. Stall margin of the initial design was too low for practical application. Airfoil slots and boundary layer and endwall devices did not improve stall margin sufficiently. A redesigned stator with reduced loadings increased stall margin, giving a fan efficiency of 0.883, 15% stall margin, and a 1.474 pressure radio at a specific flow of 41.7 lb/sec sq ft. Casing treatment over rotor tips improved stall margin with distorted inlet flow; vortex generators did not. Blade passing frequency noise increased with rotor relative Mach number. No supersonic fan noise was measured below 105% of design speed. Slotting airfoils, casing treatments, and a reduction of the ratio (number-stators/number-rotors) from (2n + 16) to (2n + 2) had no significant effects on noise.
Keenan, M. J.↗
Seismicity and recent faulting in eastern California and western and central Nevada: A preliminary report
The author has identified the following significant results. ERTS-1 imagery covering the eastern California-Nevada seismic belt were utilized to study the fault pattern in relation to the distribution of earthquake epicenters and Quaternary volcanic rocks. Many suspected faults not previously mapped were identified. These include several suspected shear zones in Nevada, faults showing evidence of recent breakage, and major lineaments. Highly seismic areas are generally characterized by Holocene faulting and Quaternary volcanic activity. However, several major fault segments showing evidence of recent breakage are associated with little or no seismicity. The tectonic pattern strongly suggests that the eastern California-Nevada seismic belt coincides with a major crustal rift associated with zones of lateral shear. New data on potentially active fault zones have direct practical applications in national and local earthquake hazard reduction programs. Positive contacts have been made with Kern and Ventura Counties to make results of this investigation available for application to their earthquake hazards definition projects.
Abdel-Gawad, M.↗