Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “induction”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,171 records · Page 65
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Novel duplex vapor-electrochemical method for silicon solar cells

Silicon obtained by the SiF4-Na reaction was analyzed by spark source mass spectrometry (SSMS). Silicon samples prepared from induction melted powder were evaluated for electrical properties using four point probe conductivity and thermoelectric methods. SiF4-Na reaction under P sub SiF4 greater than 1 atmosphere. The amount of silicon produced was increased from 25 g per batch (in the glass reactor) to greater than 70 g per batch in the stainless steel reactor. The study of the effects of reaction variables such as P sub SiF4 and maximum temperature attained on the particle size of silicon powder showed that the silicon particle size tends to grow larger with increasing pressure of the SiF4 gas in the reaction system.

Kapur, V. K.↗
NASA NTRS1978

An investigation of the reduction of carbon dioxide in a silent electric discharge

The reduction of CO2 to O2 and CO in a silent electric discharge was studied. It was found that current alone (in the ionized plasma induced by the silent electric discharge) was reponsible for the CO2 reduction process. Voltage and frequency were important only in so far as they induced current in the plasma. Pressure and temperature were of minimum influence in the process. The large power consumption in the process was recognized as resulting from the low power factor of the reactor vessel which electrically behaved like a capacitor. The power factor was subsequently improved by adding an inductive element to make the reactor vessel capacitance part of a resonant circuit. It was found that the CO2 reduction process was most efficient in terms of power vs reduction rate when a voltage was employed that was only slightly higher than that needed to induce the plasma.

Luce, R. S.↗
NASA NTRS1976

Measurements of uranium mass confined in high density plasmas

An X-ray absorption method for measuring the amount of uranium confined in high density, rf-heated uranium plasmas is described. A comparison of measured absorption of 8 keV X-rays with absorption calculated using Beer Law indicated that the method could be used to measure uranium densities from 3 times 10 to the 16th power atoms/cu cm to 5 times 10 to the 18th power atoms/cu cm. Tests were conducted to measure the density of uranium in an rf-heated argon plasma with UF6 infection and with the power to maintain the discharge supplied by a 1.2 MW rf induction heater facility. The uranium density was measured as the flow rate through the test chamber was varied. A maximum uranium density of 3.85 times 10 to the 17th power atoms/cu cm was measured.

Stoeffler, R. C.↗
NASA NTRS1978

Preliminary power train design for a state-of-the-art electric vehicle

The state-of-the-art (SOTA) of electric vehicles built since 1965 was reviewed to establish a base for the preliminary design of a power train for a SOTA electric vehicle. The performance of existing electric vehicles were evaluated to establish preliminary specifications for a power train design using state-of-the-art technology and commercially available components. Power train components were evaluated and selected using a computer simulation of the SAE J227a Schedule D driving cycle. Predicted range was determined for a number of motor and controller combinations in conjunction with the mechanical elements of power trains and a battery pack of sixteen lead-acid batteries - 471.7 kg at 0.093 MJ/Kg (1040 lbs. at 11.7 Whr/lb). On the basis of maximum range and overall system efficiency using the Schedule D cycle, an induction motor and 3 phase inverter/controller was selected as the optimum combination when used with a two-speed transaxle and steel belted radial tires. The predicted Schedule D range is 90.4 km (56.2 mi). Four near term improvements to the SOTA were identified, evaluated, and predicted to increase range approximately 7%.

Ross, J. A.↗
NASA NTRS1978

Contact Whiskers for Millimeter Wave Diodes

Several techniques are investigated for making short conical tips on wires (whiskers) used for contacting millimeter-wave Schottky diodes. One procedure, using a phosphoric and chromic acid etching solution (PCE), is found to give good results on 12 microns phosphor-bronze wires. Full cone angles of 60 degrees-80 degrees are consistently obtained, compared with the 15 degrees-20 degrees angles obtained with the widely used sodium hydroxide etch. Methods are also described for cleaning, increasing the tip diameter (i.e. blunting), gold plating, and testing the contact resistance of the whiskers. The effects of the whisker tip shape on the electrical resistance, inductance, and capacitance of the whiskers are studied, and examples given for typical sets of parameters.

Kerr, A. R.↗
NASA NTRS1978

Gamma ray lines from novae

Activities identify the mechanisms responsible for the eruptions characterizing cataclysmic variables are concerned with close binary systems, the properties of which are dominated by the presence of mass transfer from a late-type star onto a white dwarf via an accretion disk. Theories for the outbursts vary in their identification of the eruption mechanism with either gravitational or nuclear energy sources. Existing models for the dwarf novae invoke a dynamical instability in the envelope of the red star which triggers episodic Roche lobe overflow and a concomitant increase in the rate of mass transfer and the outbursts are associated with an increase in the accretion luminosity liberated in the disk. The most successful theoretical models for common nova events involve thermonuclear runaways proceeding in accreted hydrogen envelopes on the white dwarf components of these systems. The characteristics of such runaway events, which can give rise to detectable gamma ray fluxes are discussed. Salient features of existing runaway models are reviewed. Gamma fluxes from Na-22 decay, positron annihilation, and shock induction are predicted.

Truran, J. W.↗
NASA NTRS1978

Silicon crystals: Process for manufacturing wafer-like silicon crystals with a columnar structure

Wafer-like crystals suitable for making solar cells are formed by pouring molten Si containing suitable dopants into a mold of the desired shape and allowing it to solidify in a temperature gradient, whereby the large surface of the melt in contact with the mold is kept at less than 200 D and the free surface is kept at a temperature of 200-1000 D higher, but below the melting point of Si. The mold can also be made in the form of a slit, whereby the 2 sides of the mold are kept at different temperatures. A mold was milled in the surface of a cylindrical graphite block 200 mm in diameter. The granite block was induction heated and the bottom of the mold was cooled by means of a water-cooled Cu plate, so that the surface of the mold in contact with one of the largest surfaces of the melt was held at approximately 800 D. The free surface of the melt was subjected to thermal radiation from a graphite plate located 2 mm from the surface and heated to 1500 D. The Si crystal formed after slow cooling to room temperature had a columnar structure and was cut with a diamond saw into wafers approximately 500 mm thick. Solar cells prepared from these wafers had efficiencies of 10 to 11%.

Authier, B.↗
NASA NTRS1977

Ignition of magnesium powders in shock wave induced flows

Ignition of magnesium powders, resulting from an interaction with incident shock wave-induced flows, has been studied. A numerical analysis of particle dynamics and heating is presented and compared with experimental measurements. The induction period is strongly dependent on convective heat transfer and not on chemical reaction rate. Experimentally observed ignition delays were on the order of 100 microns and were inversely dependent on shock strength and initial pressure, directly dependent on particle size and cloud concentration, and independent of oxygen concentration down to 2.3 percent oxygen. Good agreement between experiment and theory was realized.

Fox, T. W.↗
NASA NTRS1977

The reduction of SiO2 with carbon in a plasma

The feasibility of a process for the reduction of low impurity silica (SiO2) with carbon in a plasma heat source was investigated. An RF induction plasma reactor was fabricated and used to optimize process variables. Maximum silicon content of the product was 33% by weight. Emission spectrographic analysis of this product showed a reduction in some impurity levels of one to two orders of magnitude. While the plasma approach proved technically feasible, poor heat transfer from the plasma to the reactant and low yield make the process economically unattractive for large-scale use.

Coldwell, D. M.↗
NASA NTRS1977

Quantitative effect of initial current rise on pumping the double-pulsed copper chloride laser

The laser energy at optimum time delay of a double-pulsed CuCl laser was experimentally determined to be a logarithmic function of the initial current rise of the pumping pulse over the total circuit inductance range 1 to 12 microhenrys. The minimum delay was found to decrease with initial current rise, which implies that faster rising current pulses are more efficient at pumping copper atoms from the ground state to the upper laser level because lasing threshold occurs with a higher population in the lower laser level.

Vetter, A. A.↗
NASA NTRS1977

Ionosphere and atmosphere of the moon in the geomagnetic tail

The paper presents calculations of the densities and energies of the various constituents of the lunar ionosphere during the time that the moon is in the geomagnetic tail; the surface concentrations of neon and argon are calculated from a theoretical model to be 3,900 and 1,700, respectively. It is found that a hydrostatic model of the ionospheric plasma is inadequate because the gravitational potential energy of the plasma is considerably smaller than its thermal energy. A hydrodynamic model, comparable to that used to describe the solar wind, is developed to obtain plasma densities and flow velocities as functions of altitude. The electromagnetic properties of the quiescent ionosphere are then investigated, and it is concluded that plasma effects on lunar induction can be neglected for quiescent conditions in the geomagnetic tail lobes.

Daily, W. D.↗
NASA NTRS1977

Three-dimensional modelling in magnetotelluric and magnetic variational sounding

The Galerkin finite-element method is used to obtain approximate solutions for the three-dimensional induction problem. A rectangular conductive prism is considered as an example, and solutions are obtained for linear and circularly polarized incident plane-wave fields. Magnetotelluric tensor impedances and magnetic transfer functions are computed. Polar diagrams of the tensor impedances and magnetic transfer functions along with their amplitude contour maps are presented. The dimensionality parameter, skew, is contoured at the surface of the earth. It is shown that the relative amplitudes and shapes of the additional and principal impedance polar diagrams can be used to determine the dimensionality of geoelectrical structures. Stations with skew values greater than 0.2 are significantly influenced by the three-dimensionality of the geoelectric structure. The amplitudes of the magnetic transfer function and the orientations of its polar diagrams exhibit large anomalies in the vicinity of the intersection of the lateral contacts.

Reddy, I. K.↗
NASA NTRS1977

In situ oxidation studies on /001/ copper-nickel alloy thin films

High-resolution transmission electron microscopy studies are reported of (001)-oriented single crystalline thin films of Cu-3%Ni, Cu-4.6%Ni, and Cu-50%Ni alloy which were prepared by vapor deposition onto (001) NaCl substrates and subsequently annealed at around 1100 K and oxidized at 725 K at low oxygen partial pressure. At all alloy concentrations, Cu2O and NiO nucleated and grew independently without the formation of mixed oxides. The shape and growth rates of Cu2O nuclei were similar to rates found earlier. For low-nickel alloy concentrations, the NiO nuclei were larger and the number density of NiO was less than that of Cu-50%Ni films for which the shape and growth rates of NiO were identical to those for pure nickel films. Phenomena involving a reduced induction period, surface precipitation, and through-thickness growth are also described. The results are consistent with previously established oxidation mechanisms for pure copper and pure nickel films.

Heinemann, K.↗
NASA NTRS1977

Improved dynamic modeling of a Space-Shuttle Turbo-Pump

The dynamic response of turbo-pumps has traditionally been modeled mathematically using electrical networks. A recently developed computer program is used herein to adjust the model parameters (L - inductance, R - resistance, C - capacitance, etc.) of the electrical network in an attempt to bring the analytical response of the network into closer agreement with newly-available experimental results. Results are presented for a fully-wetted (noncavitating) test of a Space-Shuttle Turbo-Pump and a significant improvement in the dynamic model is achieved.

Evensen, D. A.↗
NASA NTRS1978

Scaling a double-pulsed copper chloride laser to 10 mJ

By use of low-inductance (0.5micro H) discharge circuits, pulses of 9.6 mJ were obtained from a double-pulsed CuCl laser. An oscillator-amplifier configuration produced a pulse energy of 11 mJ. Scaling studies indicate that additional increases in the laser energy could be obtained by increasing the discharge voltage above 20 kV and/or by increasing the laser-tube dimensions.

Nerheim, N. M.↗
NASA NTRS1978

Boundary-value problem for a counterrotating electrical discharge in an axial magnetic field

An electrical discharge between two ring electrodes embedded in the mantle of a cylindrical chamber is considered, in which the plasma in the anode and cathode regions rotates in opposite directions under the influence of an external axial magnetic field. The associated boundary-value problem for the coupled partial differential equations describing the azimuthal velocity and radial current-density fields is solved in closed form. The velocity, current density, induced magnetic induction, and electric fields are presented for typical Hartmann numbers, magnetic Reynolds numbers, and geometry parameters. The discharge is shown to produce anodic and cathodic plasma sections rotating at speeds of the order 1,000,000 cm/sec for conventional magnetic field intensities. Possible application of the magnetoactive discharge as a plasma centrifuge for isotope separation is discussed.

Hong, S. H.↗
NASA NTRS1977

Design of single-winding energy-storage reactors for dc-to-dc converters using air-gapped magnetic-core structures

A procedure is presented for designing air-gapped energy-storage reactors for nine different dc-to-dc converters resulting from combinations of three single-winding power stages for voltage stepup, current stepup and voltage stepup/current stepup and three controllers with control laws that impose constant-frequency, constant transistor on-time and constant transistor off-time operation. The analysis, based on the energy-transfer requirement of the reactor, leads to a simple relationship for the required minimum volume of the air gap. Determination of this minimum air gap volume then permits the selection of either an air gap or a cross-sectional core area. Having picked one parameter, the minimum value of the other immediately leads to selection of the physical magnetic structure. Other analytically derived equations are used to obtain values for the required turns, the inductance, and the maximum rms winding current. The design procedure is applicable to a wide range of magnetic material characteristics and physical configurations for the air-gapped magnetic structure.

Ohri, A. K.↗
NASA NTRS1978

Morphogenetic responses of cultured totipotent cells of carrot /Daucus carota var. carota/ at zero gravity

An experiment designed to test whether embryos capable of developing from isolated somatic carrot cells could do so under conditions of weightlessness in space was performed aboard the unmanned Soviet biosatellite Kosmos 782 under the auspices of the joint United States-Soviet Biological Satellite Mission. Space flight and weightlessness seem to have had no adverse effects on the induction of embryoids or on the development of their organs. A portion of the crop of carrot plantlets originated in space and grown to maturity were not morphologically different from controls.

Krikorian, A. D.↗