Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “airfoil”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,171 records · Page 65
All sourcesNASA NTRSDOE OSTI
NASA NTRS1989

An interactive boundary-layer procedure for oscillating airfoils including transition effects

An interactive boundary-layer method previously developed and tested for steady flows is used here in a quasi-steady manner to examine the evolution of the flow behavior around oscillating airfoils operating inlight stall conditions. The calculations encompass the airfoil and wake flows at angles of attack which lead to flow separation. The location of the onset of transition is represented by a correlation based on steady flows. The results show the large effects of the viscous layer on the variation of lift coefficient with angle of attack and reduced frequency.

Cebeci, Tuncer↗
NASA NTRS1989

Flow visualization studies of the Mach number effects on the dynamic stall of an oscillating airfoil

Compressibility effects on the dynamic stall of a NACA 0012 airfoil undergoing sinusoidal oscillatory motion were studied using a stroboscopic schlieren system. Schlieren pictures and some quantitative data derived from them are presented and show the influence of free-stream Mach number and reduced frequency on the dynamic-stall vortex. This study shows that a dynamic stall vortex always forms near the leading edge and convects on the airfoil upper surface at approximately 0.3 times the free stream velocity for all cases studied. The results also demonstrate that initiation of the dynamic stall vortex is delayed to higher angles of attack with increased reduced frequency, but that dynamic stall occurs at lower angles of incidence with increasing Mach numbers.

Chandrasekhara, M. S.↗
NASA NTRS1989

Control of laminar separation over airfoils by acoustic excitation

The effect of acoustic excitation in reducing laminar separation over two-dimensional airfoils at low angles of attack is investigated experimentally. Airfoils of two different cross sections, each with two different chord lengths, are studied in the chord Reynolds number range of 25,000 is less than R sub c is less than 100,000. While keeping the amplitude of the excitation induced velocity perturbation a constant, it is found that the most effective frequency scales as U (sup 3/2) (sub infinity). The parameter St/R (sup 1/2)(sub c), corresponding to the most effective f sub p for all the cases studied, falls in the range of 0.02 to 0.03, St being the Strouhal number based on the chord.

Zaman, K. B. M. Q.↗
NASA NTRS1989

An experimental investigation of multi-element airfoil ice accretion and resulting performance degradation

An investigation of the ice accretion pattern and performance characteristics of a multi-element airfoil was undertaken in the NASA Lewis 6- by 9-Foot Icing Research Tunnel. Several configurations of main airfoil, slat, and flaps were employed to examine the effects of ice accretion and provide further experimental information for code validation purposes. The text matrix consisted of glaze, rime, and mixed icing conditions. Airflow and icing cloud conditions were set to correspond to those typical of the operating environment anticipated for a commercial transport vehicle. Results obtained included ice profile tracings, photographs of the ice accretions, and force balance measurements obtained both during the accretion process and in a past-accretion evaluation over a range of angles of attack. The tracings and photographs indicated significant accretions on the slat leading edge, in gaps between slat or flaps and the main wing, on the flap leading-edge surfaces, and on flap lower surfaces. Force measurements indicate the possibility of severe performance degradation, especially near C sub Lmax, for both light and heavy ice accretion and performance analysis codes presently in use. The LEWICE code was used to evaluate the ice accretion shape developed during one of the rime ice tests. The actual ice shape was then evaluated, using a Navier-Strokes code, for changes in performance characteristics. These predicted results were compared to the measured results and indicate very good agreement.

Potapczuk, Mark G.↗
NASA NTRS1989

Effect of 90 degree flap on the aerodynamics of a two-element airfoil

The aerodynamic performance of a two-element airfoil with a 90-deg trailing edge flap was experimentally investigated. The 5 percent-chord long flap, significantly increased the lift of the baseline airfoil, throughout a wide range of angles of attack. The maximum lift coefficient of the flapped wing increased too, whereas the lift/drag ratio decreased.

Katz, J.↗
NASA NTRS1989

Separation control on an airfoil by periodic forcing

The introduction of transverse velocity fluctuations into a separated shear layer on an airfoil at high angles of attack is presently demonstrated to be an effective separation-control technique. Airfoil aerodynamic characteristics, including poststall lift and drag as well as maximum lift coefficient and stall angle, all exhibited improvements controlled forcing at 20 deg angle of attack led to an increased spreading of the mean velocity profile, together with increased turbulence activity; separation moved from the leading edge to about 80 percent of chord.

Bar-Sever, A.↗
NASA NTRS1987

Wind tunnel results of the low-speed NLF(1)-0414F airfoil

The large performance gains predicted for the Natural Laminar Flow (NLF)(1)-0414F airfoil were demonstrated in two-dimensional airfoil tests and in wind tunnel tests conducted with a full scale modified Cessna 210. The performance gains result from maintaining extensive areas of natural laminar flow, and were verified by flight tests conducted with the modified Cessna. The lift, stability, and control characteristics of the Cessna were found to be essentially unchanged when boundary layer transition was fixed near the wing leading edge. These characteristics are very desirable from a safety and certification view where premature boundary layer transition (due to insect contamination, etc.) must be considered. The leading edge modifications were found to enhance the roll damping of the Cessna at the stall, and were therefore considered effective in improving the stall/departure resistance. Also, the modifications were found to be responsible for only minor performance penalties.

Murri, Daniel G.↗
NASA NTRS1990

A direct-inverse method for transonic and separated flows about airfoils

A direct-inverse technique and computer program called TAMSEP that can be used for the analysis of the flow about airfoils at subsonic and low transonic freestream velocities is presented. The method is based upon a direct-inverse nonconservative full potential inviscid method, a Thwaites laminar boundary layer technique, and the Barnwell turbulent momentum integral scheme; and it is formulated using Cartesian coordinates. Since the method utilizes inverse boundary conditions in regions of separated flow, it is suitable for predicting the flow field about airfoils having trailing edge separated flow under high lift conditions. Comparisons with experimental data indicate that the method should be a useful tool for applied aerodynamic analyses.

Carlson, Leland A.↗
NASA NTRS1989

CAST-10-2/DOA 2 Airfoil Studies Workshop Results

During the period of September 23 through 27, 1988, the Transonic Aerodynamics Division at the Langely Research Center hosted an International Workshop on CAST-10-2/DOA 2 Airfoil Studies. The CAST-10 studies were the outgrowth of several cooperative study agreements among the NASA, the NAE of Canada, the DLR of West Germany, and the ONERA of France. Both theoretical and experimental CAST-10 airfoil results that were obtained form an extensive series of tests and studies, were reviewed. These results provided an opportunity to make direct comparisons of adaptive wall test section (AWTS) results from the NASA 0.3-meter Transonic Cryogenic Tunnel and ONERA T-2 AWTS facilities with conventional ventilated wall wind tunnel results from the Canadian high Reynolds number two-dimensional test facility. Individual papers presented during the workshop are included.

Ray, Edward J.↗
NASA NTRS1989

Main results of CAST-10 airfoil tested in T2 cryogenic wind tunnel

The aim of this cooperative NASA/DFVLR/ONERA project was to examine the performance of the CAST-10 airfoil in the T2 cryogenic wind tunnel. Tests included general characteristics of the CAST-10 airfoil and fundamental studies on Reynold number effects. Good T2 cryogenic operation was observed. Improvements should be done for moisture elimination and for side wall boundary layer effects.

Blanchard, A.↗
NASA NTRS1989

Investigation of CAST-10-2/DOA 2 airfoil in NAE high Reynolds number two-dimensional test facility

A common airfoil model with the CAST 10-2/DOA-2 profile and 228 mm (9 inches) chord length was tested. The tests performed in NAE covered the Mach numbers from 0.3 to 0.8 and Reynolds numbers from 10 to 30 million. The model was tested with transition free and with transition fixed at 5 percent chord for both the upper and the lower surfaces. The data obtained were analyzed for the effects of Reynolds number, transition fixing and Mach number. The role of the boundary layer on the displacement effect, the interaction with the shock wave and the trailing edge separation are examined. The results are summarized as follows: (1) the airfoil performance depends strongly on Reynolds number and transition fixing; (2) with transition fixed, the aerodynamic quantities such as lift, pitching moment and drag show a monotonic variation with Reynolds number; (3) with transition free, the aerodynamic quantities vary less regularly with Reynolds number and a slight parametric dependency is shown. The weak dependency is due to the compensatory effect of the forward shift of the transition position and the thinning of the turbulent boundary layer as Reynolds number increases; (4) the shock Mach number and the shock position are weakly dependent on Reynolds number; and (5) the long extent of the laminar boundary layer at transonic speeds reduces the drag appreciably at low Reynolds numbers. The drag bucket around the design Mach number can be observed below Reynolds number 15 million.

Chan, Y. Y.↗
NASA NTRS1989

Comparison of NAE porous wall and NASA adaptive wall test results using the NAE CAST-10 airfoil model

Wind tunnels can now simulate flows over airfoils at high Reynolds numbers and high subsonic speeds. Methods to correct for (or reduce) test section wall interference at these test conditions must be validated. The National Aeronautics Establishment (NAE) of Canada and NASA have a cooperative agreement to study this area. The NAE designed, built, and tested a CAST-10 airfoil model in its conventional Two-Dimensional High Reynolds Number Facility. The results were corrected using classical correction techniques. NASA then tested the same model in its 0.3-meter Transonic Cryogenic Tunnel with the adaptive wall test section. The adaptive wall test section reduced the wall interference to what was expected to be an acceptable level. The corrected NAE results are compared with the uncorrected NASA results. The NAE results are also compared with NASA results after residual corrections for top and bottom wall interference. Finally, a comparison of both sets of results corrected for interference from all four walls is presented.

Mineck, Raymond E.↗
NASA NTRS1989

Three-dimensional aerodynamics of an annular airfoil cascade including loading effects

A series of experiments are described which investigate and quantify the effect of loading on the three-dimensional flow through a subsonic annular cascade of cambered airfoils. At two levels of loading, detailed data quantify the cascade inlet velocity, the intrapassage flow field, the airfoil surface pressure distributions, the exit flow field, and the total pressure loss distributions. Aerodynamic loading is shown to strengthen the radial pressure gradient, the passage vortex structure, the vortex-endwall boundary layer interactions, and the losses.

Fleeter, S.↗
NASA NTRS1990

Impact ice stresses in rotating airfoils

Finite element analysis is used to study the tensile and shear stresses at the interface between impact ice adhering to a rotating airfoil and the metal airfoil surface. A simple rotating beam-ice structure is used to obtain basic understanding of stress distribution in the ice. Calculations show that shear stresses increase linearly with ice thickness and tensile stresses tend to zero for a fully bonded surface. When shear stresses exceed the ultimate strength, adhesive failure occurs and tensile stresses are developed in the unbonded ice, resulting in tensile failure of the impact ice. A second model is used to study the OH-58 tail rotor with a measured ice profile. Ice shedding predictions are compared to the resulting data using a statistical structural analysis.

Scavuzzo, R. J.↗
NASA NTRS1990

Measurements in a separation bubble on an airfoil using laser velocimetry

An experimental investigation was conducted to measure the reverse flow within the transitional separation bubble that forms on an airfoil at low Reynolds numbers. Measurements were used to determine the effect of the reverse flow on integrated boundary-layer parameters often used to model the bubble. Velocity profile data were obtained on an NACA 663-018 airfoil at angle of attack of 12 deg and a chord Reynolds number of 140,000 using laser Doppler and single-sensor hot-wire anemometry. A new correlation is proposed based on zero velocity position, since the Schmidt (1986) correlations fail in the turbulent portion of the bubble.

Fitzgerald, Edward J.↗
NASA NTRS1990

Schlieren studies of compressibility effects on dynamic stall of airfoils in transient pitching motion

Compressibility effects on the flowfield of an airfoil executing rapid transient pitching motion from 0 - 60 degrees over a wide range of Mach numbers and pitching rates were studied using a stroboscopic schlieren flow visualization technique. The studies have led to the first direct experimental documentation of multiple shocks on the airfoil upper surface flow for certain conditions. Also, at low Mach numbers, additional coherent vortical structures were found to be present along with the dynamic stall vortex, whereas at higher Mach numbers, the flow was dominated by a single vortex. The delineating Mach number for significant compressibility effects was 0.3 and the dynamic stall process was accelerated by increasing the Mach number above that value. Increasing the pitch rate monotonically delayed stall to angles of attack as large as 27 degrees.

Chandrasekhara, M. S.↗
NASA NTRS1990

Angle-of-attack validation of a new zonal CFD method for airfoil simulations

The angle-of-attack validation of a new concept suggested by Summa (1990) for coupling potential and viscous flow methods has been investigated for two-dimensional airfoil simulations. The fully coupled potential/Navier-Stokes code, ZAP2D (Zonal Aerodynamics Program 2D), has been used to compute the flow field around an NACA 0012 airfoil for a range of angles of attack up to stall at a Mach number of 0.3 and a Reynolds number of 3 million. ZAP2D calculation for various domain sizes from 25 to 0.12 chord lengths are compared with the ARC2D large domain solution as well as with experimental data.

Yoo, Sungyul↗
NASA NTRS1989

Performance measurements of an airfoil at low Reynolds numbers

Performance characteristics of an Eppler 387 airfoil using both direct (force) and indirect (pressure) measurement techniques have been obtained at Reynolds numbers from 60,000 to 460,000 in the Langley Low-Turbulence Pressure Tunnel. Lift, drag, and pitching-moment data were obtained from two internally-mounted strain-gage balances specifically designed for small aerodynamic loads. Comparisons of these results with data from a pressure model of an Eppler 387 airfoil are included. Drag data for both models using the wake traverse method are compared with the balance data. Oil flow visualization and surface mounted hot-film sensors were used to determine laminar-separation and turbulent-reattachment locations. Problems associated with obtaining accurate wind-tunnel data at low Reynolds numbers are discussed.

Mcghee, Robert J.↗