SEARCH · Engineering Papers
Results for “Effectiveness”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Modeling thermal and irradiation-induced swelling effects on the integrity of Ti 3 SiC 2 /SiC joints
Previously, results for CVD-SiC joints created using solid state displacement reactions to form a dual-phase SiC/MAX phase irradiated at 800°C and 5 dpa indicated some extent of cracking in the joint and along the CVD-SiC/joint interface. This paper elucidates the origin of cracking by thermomechanical modeling combined with irradiation-induced swelling effects using a continuum damage approach with support of micromechanical modeling. Three irradiation temperatures (400°C, 500°C and 800°C) are considered assuming experimental irradiation doses in a range leading to saturation swelling in SiC. The analyses indicate that a SiC/MAX joint heated to 400°C fails during irradiation-induced swelling at this temperature while it experiences some damage after being heated to 500°C and irradiated at the same temperature. However, it fails during cooling from 500°C to room temperature. The joint experiences minor damage when heated to and irradiated at 800°C but does not fail after cooling. The prediction agrees with the experimental findings available for this case.
Effects of irradiation temperature on the response of CeO2, ThO2, and UO2 to highly ionizing radiation
Microcrystalline CeO 2 , ThO 2 , and UO 2 were irradiated with 198 MeV 132 Xe ions to the same fluence at temperatures ranging from 25°C to 700°C then characterized by synchrotron X-ray diffraction and X-ray absorption spectroscopy. All samples retain crystallinity and their nominal fluorite-type phase at a fluence of 1.5x10 13 ions/cm 2 . Both CeO 2 and ThO 2 display defect-induced unit cell expansion after irradiation at room temperature (~0.15% and ~0.10%, respectively), yet as irradiation temperature increases, the maximum swelling produced decreases to ~0.02%. Alternatively, UO 2 shows an initial contraction in unit cell parameter (approximately -0.05%), for room temperature irradiation most likely related to irradiation-enhanced annealing or irradiation-induced oxidation. At higher temperatures (above 200°C), UO 2 begins to swell, surpassing its unit cell parameter prior to irradiation (~0.05%), an effect which could be attributed to minor reduction in uranium oxidation state in vacuum. However, while CeO 2 irradiated at room temperature undergoes partial reduction, both UO 2 and ThO 2 exhibit no measurable change in cation oxidation state as evidenced by X-ray absorption spectroscopy. All samples display a decrease in irradiation-induced heterogeneous microstrain as a function of increasing irradiation temperature.
Effect of Composition on the Voltage Fade Phenomenon in Lithium-, Manganese-Rich xLiMnO 3 •(1-x)LiNi a Mn b Co c O 2 : A Combinatorial Synthesis Approach
The effect of composition on the voltage fade phenomenon was probed using combinatorial synthesis methods. In compositions that have the general formula, (Li 2 MnO 3 ) a (LiNiO 2 ) b (LiMnO 2 ) c (LiCoO 2 ) d , where 0 ≤ a≤0.83, 0.15 ≤ b ≤ 0.42, 0 ≤ c ≤ 0.85, and 0 ≤ d ≤ 0.30 (a + b + c + d = 1), the dependence of features in the x-ray diffraction pattern and of voltage fade on composition were identified and mapped. The observed values of voltage fade indicated that it displayed some sensitivity to composition, but that the sensitivity was not large. The values of voltage fade were found to be amenable to statistical modeling. The model indicated that it may be possible to lower the value of voltage fade below 0.01% by adjusting the composition of the system; however, the composition is not expected to have the layered–layered structure.
Effect of overcharge on Li(Ni 0.5 Mn 0.3 Co 0.2 )O 2 /Graphite cells–effect of binder
Cells based on NMC/graphite, containing styrene-butadiene rubber/carboxymethylcellulose binder in the anodes and pVdF latex/carboxymethykellulose in the cathodes, were systematically overcharged to 100, 120, 140, 160, 180, 250% and 270% state-of-charge. The impact of the binder was characterized by elemental analysis, SEM, and HPLC. These results were compared to similar cells just using the poly (vinylidene difluoride) binder. Not only did the binder impact the rate of transition metal transport from the cathode to the anode, it also had a marked effect on the microstructure and composition of the materials on the anode surface.
Electric double layer capacitance for ionic liquids in nanoporous electrodes: Effects of pore size and ion composition
The energy density of an electric double layer (EDL) capacitor, a type of supercapacitor, depends on the ion distribution within the micropores of electrodes that are typically made of amorphous carbon. By using coarse-grained models and the classical density functional theory, we investigate the distributions of ionic species among different idealized nanopores in contact with an asymmetric ionic liquid mixture and the effects of the bulk electrolyte composition on capacitive energy storage. We find that a charged pore is always small-ion selective, provided all ions have the same valence and similar non-electrostatic interactions. While small ions enhance both the EDL capacitance and the accessibility of micropores, an ionic mixture containing ions of different sizes may yield a capacitance higher than those corresponding to pure ionic liquids. Furthermore, the increased capacitance may be attributed to more efficient ion packing near the charged surface. At certain conditions, the improvement is on a par with the anomalous capacitance rise for pure ionic liquids in electrodes with ultranarrow pores.
The effect of low dose ionizing radiation on homeostasis and functional integrity in an organotypic human skin model
Not Available
Investigation of thermal aging effects on the tensile properties of Alloy 617 by in-situ synchrotron wide-angle X-ray scattering
The nickel-base Alloy 617 has been considered as the lead candidate structural material for the intermediate heat exchanger (IHX) of the Very-High-Temperature Reactor (VHTR). In order to assess the long-term performance of Alloy 617, thermal aging experiments up to 10,000 h in duration were performed at 1000 degrees C. Subsequently, in-situ synchrotron wide-angle X-ray scattering (WAXS) tensile tests were carried out at ambient temperature. M23C6 carbides were identified as the primary precipitates, while a smaller amount of M6C was also observed. The aging effects were quantified in several aspects: (1) macroscopic tensile properties, (2) volume fraction of the M23C6 Phase, (3) the lattice strain evolution of both the matrix and the M23C6 precipitates, and (4) the dislocation density evolution during plastic deformation. The property-microstructure relationship is described with a focus on the evolution of the M23C6 phase. For aging up to 3000 h, the yield strength (YS) and ultimate tensile strength (UTS) showed little variation, with average values being 454 MPa and 787 MPa, respectively. At 10,000 h, the YS and UTS reduced to 380 MPa and 720 MPa, respectively. The reduction in YS and UTS is mainly due to the coarsening of the M23C6 Precipitates. After long term aging, the volume fraction of the M23C6 phase reached a plateau and its maximum internal stress was reduced, implying that under large internal stresses the carbides were more susceptible to fracture or decohesion from the matrix. Finally, the calculated dislocation densities were in good agreement with transmission electron microscopy (TEM) measurements. The square roots of the dislocation densities and the true stresses displayed typical linear behavior and no significant change was observed in the alloys in different aging conditions.
Silicon-based anodes for lithium-ion batteries: Effectiveness of materials synthesis and electrode preparation
Lithium-ion batteries are widely used throughout the world for portable electronic devices and mobile phones and show great potential for more demanding applications like electric vehicles. Unfortunately, lithium-ion batteries still lack the required level of energy storage to completely meet the demands of such applications as electric vehicles. Among advanced materials being studied, silicon nanoparticles have demonstrated great potential as an anode material to replace the commonly used graphite. Silicon has been shown to have a high theoretical gravimetric capacity, approximately 4200 mA h/g, compared to only 372 mA h/g for graphite. Though silicon nanoparticles have remarkably high capacity, they suffer from rapid degradation with each cycle due to electrode volume expansion of approximately 400% during lithiation, placing a large strain on the material. With each cycle that strain creates cracks in the electrode particles and causes them to break down into smaller particles, which create void spaces between the particles and lead to poor contact as reflected in poor conductivity. In this review, we discuss exciting new research on silicon-based anodes conducted during the past couple of years. Besides stressing the importance of well-designed nanostructures of Si, we focus on optimization of the Si electrode and resulting performance enhancement by properly selecting binders and synergistically integrating them with various carbon materials during electrode design and fabrication. Importantly, although each improvement strategy has its own advantage, appropriate combination of them will yield much higher anode performance. We summarize the core issues in developing the silicon anode and effective strategies in yielding more promising results. (C) 2016 Elsevier Ltd. All rights reserved.
A system to test the effects of materials on the electron drift lifetime in liquid argon and observations on the effect of water
A materials test system (MTS) has been developed at FNAL to assess the suitability of materials for use in a large liquid argon time projection chamber. During development of the MTS, it was noted that controlling the cryostat pressure with a 'raining' condenser reduced the electron drift lifetime in the liquid argon. The effect of condensing has been investigated using a series of passive materials to filter the condensate. We report the results of these studies and of tests on different candidate materials for detector construction. The inferred reduction of electron drift lifetime by water concentrations in the parts per trillion is of particular interest.
Landau damping effects and evolutions of energy spread in small isochronous ring
This paper presents the Landau damping effects on the microwave instability of a coasting long bunch in an isochronous ring due to finite energy spread and emittance. Our two-dimensional (2D) dispersion relation gives more accurate predictions of the microwave instability growth rates of short-wavelength perturbations than the conventional 1D formula. The long-term evolution of energy spread is also studied by measurements and simulations.
Enabling cost-effective high-current burst-mode operation in superconducting accelerators
Explore the source record for details and available documents.
Measurement and simulation of cosmic rays effects on neutron multiplicity counting
Explore the source record for details and available documents.