Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “SLOPE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,153 records · Page 64

Analytic evaluation of display requirements for approach to landing

A computerized analysis procedure, based on a control theoretic model of the human pilot, is used to evaluate display requirements for longitudinal control in the landing approach. The display employed a digitally generated, perspective runway image with a superimposed artificial horizon for pitch indication. System performance measures are obtained for the approach phase of a light aircraft and a DC-8; predictions are made as to the effects of several display modifications. It is found that augmenting the basic display with glide slope reference bars and a velocity aim point yields adequate performance in calm air. Under moderate turbulence, the augmented display appears to be adequate for a DC-8 approach but not for a light aircraft.

Kleinman, D. L.↗

Delta Modulation

An optimum adaptive delta modulator-demodulator configuration is derived. This device utilizes two past samples to obtain a step size which minimizes the mean square error for a Markov Gaussian source. The optimum system is compared using computer simulations with the linear delta modulator and an enhanced Abate delta modulator. In addition the performance is compared to the rate distortion bound for a Markov source. It is shown that the optimum delta modulator is neither quantization nor slope-overload limited. The results show that the output signal-to-noise ratio is independent of the input signal power and is subject only to the limitations of the hardware employed. In addition, voice was recorded using these systems. The demodulated voice indicates negligible degradation is caused by the optimum system and by the enhanced Abate system while the linear delta modulator suffers significant degradation at a sampling frequency of 56 kilobits/sec.

Schilling, D. L.↗

The quasi-inertial and wide-deadband modes as backup attitude options for the Skylab mission

The quasi-inertial (QI) and wide deadband (WDB) modes were investigated as alternatives to the solar inertial (SI) mode in case two control moment gyros fail during the Skylab mission. Both modes provide a substantial reduction in propellant requirements from the solar interial hold requirement with either the orbital assembly/thruster attitude control system or service module reaction control system. Spacecraft motion in the QI mode is produced by a command rate and results in a small amplitude oscillation (17 deg, maximum) about the SI orientation. In the WDB mode a somewhat similar, but larger amplitude motion (35 deg maximum) about the SI orientation is developed by appropriate choice of controller deadbands and switch line slopes.

Elrod, B. D.↗

Electrochemical behavior of the boron anode in aqueous solutions

The electrochemical oxidation of p-type boron in 0.2 N NaNO3 solutions of pH 0.4 to 13.1 was studied by galvanostatic techniques. The capacitance of the electrode, Tafel slopes, and a limited analysis of reaction mechanisms are reported. The anodic dissolution in acid solution is a charge-transfer-limited one-electron reaction to form a monovalent species in the over-potential region of 0.25 to 0.70 V. The dissolution in basic solution is most probably a one-electron charge-transfer reaction from a monovalent to divalent species involving three hydroxyl ions. Open circuit potentials were mixed potentials, probably due to hydrogen formation at open circuit but not contributing to the electrochemical reaction at the applied overpotential. Exchange current, estimated by extrapolation of the Tafel line to the standard oxidation potential for the boron reaction, were of the order of 10 to the minus 6th power A/cm2 in acid solution and 10 to the minus 12th power A/cm2 in basic solution. The reaction order of the rate determining acidic and basic reactions was determined with regard to (H+) and (OH-). The level of illumination had no effect on the electrochemical behavior of the electrode.

Delduca, B. S.↗

Lunar surface engineering properties experiment definition

Research on the mechanics of lunar soils and on developing probes to determine the properties of lunar surface materials is summarized. The areas of investigation include the following: soil simulation, soil property determination using an impact penetrometer, soil stabilization using urethane foam or phenolic resin, effects of rolling boulders down lunar slopes, design of borehole jack and its use in determining failure mechanisms and properties of rocks, and development of a permeability probe for measuring fluid flow through porous lunar surface materials.

Mitchell, J. K.↗

Velocity dispersions in galaxies: 1: The SO galaxy NGC 7332

A Coude spectrum of the SO galaxy NGC 7332 with 0.9 A resolution from 4186 to 4364 A was obtained with the SEC vidicon television camera and the Hale telescope. Comparisons with spectra of G and K giant stars, numerically broadened for various Maxwellian velocity distributions, give a dispersion velocity in the line of sight of 160 + or - 20 km/sec with the best fit at G8III. The dispersion appears to be constant within + or - 35 km/sec out to 1.4 kpc (H = 100 km/sec/mpc). After correction for projection, the rotation curve has a slope of 0.16 km/sec/pc at the center and a velocity of 130 km/sec at 1.4 kpc where it is still increasing. For an estimated effective radius of 3.5 kpc enclosing half the light, the virial theorem gives a mass of 1.4 x 10 to the 11th power solar masses if the mass-to-light ratio is constant throughout the galaxy. The photographic luminosity is 8.3 x 10 to the 9th power solar luminosities so that the M/L ratio is 17.

Morton, D. C.↗

Sun compass error model

An error model is described for the Apollo 15 sun compass, a contingency navigational device. Field test data are presented along with significant results of the test. The errors reported include a random error resulting from tilt in leveling the sun compass, a random error because of observer sighting inaccuracies, a bias error because of mean tilt in compass leveling, a bias error in the sun compass itself, and a bias error because the device is leveled to the local terrain slope.

Blucker, T. J.↗

Thermal convection at infinite Prandtl number

Numerical solutions are developed for the full scaled three dimensional thermal convection problem, at infinite Prandtl number, and for rigid boundaries. The procedure is designed to give an approximate account of horizontally homogeneous and isotropic flow situations. Results, which included a maximum of 36 horizontal wave number vectors and 20 vertical wave numbers, appear to adequately describe the flow fill up to R = 100,000; beyond this R the results appear to show horizontal wave number truncation error. This error seems to affect the boundary slope of the mean temperature field more than other mean quantities. Despite some numerical uncertainities, certain of the qualitative features of the flow fill are predicted with reasonable confidence.

Herring, J. R.↗