SEARCH · Engineering Papers
Results for “Effectiveness”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
The effect of gravel size fraction on the distribution coefficients of selected radionuclides radionuclides
This manuscript addresses the consequences of the common practice of assuming that the gravel fraction of sediments does not participate in sorption reactions and thus sorption quantified by the distribution coefficient (Kd) construct can be estimated from laboratory tests on < 2mm fraction of sediments. As shown within the use of this common assumption can lead to inaccurate estimates of the mobility and sorption capacity of key radionuclides (Tc, U, and Np) at the Hanford Site where gravel dominates the lower Hanford formation and upper Ringold Formation. Batch sorption and column experiments showed that the distribution coefficient measured using only < 2mm fraction were not in agreement with those obtained from the bulk sediments depending on the radionuclide. The least reactive radionuclide, Tc showed the lowest effects from the presence of gravel. However, differences between measured Kds using < 2mm fractions of the sediment and the Kds measured on the bulk sediment were significant for strongly reactive radionuclides such as Np, especially on the sediment with gravel fractions that contained highly reactive sites. Highly reactive sites in the gravel fraction were attributed to the presence of Fe oxides coatings and/or reactive fracture faces on the gravel surfaces. Gravel correction factors that use the sum of the Kd,<2 mm and Kd,>2 mm values to estimate the Kd for the bulk sediment were found to best describe Kds for radionuclides on the bulk sediment. However, more detailed characterization of gravel surfaces should be also conducted to identify those gravels with higher reactive sorbents, if present. Gravel correction factors should be considered to predict precisely the sorption capacity of bulk sediments that contain more than 10% gravel and to estimate the mobility of contaminants in subsurface environments.
Extended defects in CdZnTe crystals: Effects on device performance
We explored some unique defects in a batch of cadmium zinc telluride (CdZnTe) crystals, along with dislocations and Te-rich decorated features, revealed by chemical etching. We extensively investigated these distinctive imperfections in the crystals to identify their origin, dimensions, and distribution in the bulk material. We estimated that these features ranged from 50 to 500 {micro}m in diameter, and their depth was about 300 {micro}m. The density of these features ranged between 2 x 10{sup 2} and 1 x 10{sup 3} per cm{sup 3}. We elaborated a model of them and projected their effect on charge collection and spectral response. In addition, we fabricated detectors with these defective crystals and acquired fine details of charge-transport phenomena over the detectors volume using a high-spatial resolution (25 {micro}m) X-ray response mapping technique. We related the results to better understand the defects and their influence on the charge-transport properties of the devices. The role of the defects was identified by correlating their signatures with the findings from our theoretical model and our experimental data.
Effect of temperature on the complexation of NpO 2 + with benzoic acid: Spectrophotometric and calorimetric studies
The equilibrium constants of the 1:1 NpO2+/benzoate complex were determined by spectrophotometric titrations at variable temperatures (T = 283 to 343 K) and the ionic strength of 1.05 mol · kg-1. The enthalpy of complexation at T = 298 K was determined by microcalorimetric titrations. Similar to other monocarboxylates, benzoate forms a weak complex with NpO2+ and the complexation is strengthened as the temperature is increased. The complexation is endothermic and is entropy-driven. The enhancement of the complexation at elevated temperatures is primarily attributed to the increasingly larger entropy gain when the water molecules are released from the highly-ordered solvation spheres of NpO2+ and benzoate to the bulk solvent where the degree of disorder is higher at higher temperatures. The spectroscopic features of the Np(V)/benzoate system, including the effect of temperature on the absorption bands, are discussed in terms of ligand field splitting and a thermal expansion mechanism.
The effect of bicarbonate on the microbial dissolution of autunite mineral in the presence of gram-positive bacteria
Not Available
Effect of ZrO 2 on the structure and properties of soda-lime silicate glasses from molecular dynamics simulations
Explore the source record for details and available documents.
Effect of Sulfate Sequestration by Ba-Sn Composite Material on Re Retention in Low-Activity Waste Glass
Difficulty incorporating radioactive Tc-99 into glass during vitrification of low-activity waste (LAW) at the Hanford Site is a technical challenge. Previous studies suggested that the presence of sulfate salts in the melt hinder the incorporation of Re, a non-radioactive surrogate for Tc-99, into nuclear waste glass. In this study, we assessed the capability of a Ba-Sn composite to sequester sulfate during vitrification of AN-102 LAW feed and the resulting effects on Re retention in the glass. We also investigated a feed where the initial soluble sulfate source in the simulated LAW (Na2SO4) was replaced with insoluble BaSO4. The Ba-Sn composite-treated feed and BaSO4-substitute feed were compared to a control, AN-102 baseline. The feeds were prepared and then heated to temperatures from 400-1000 °C at 5 °C/min and air-quenched to room temperature. The heated samples and dried feeds were leached in deionized water. The solutions from the leach test were analyzed by Inductively Coupled Plasma Optical Emission Spectroscopy (ICP-OES) to determine the amount of soluble sulfate as a function of temperature and the resulting solids were analyzed for Re retention. Although the Ba-Sn composite material successfully sequestered sulfate in the as-prepared LAW feed, heating to 400 °C resulted in most of the sulfate partitioning to a soluble salt phase. By 700°C, sulfate partitioning in the composite-treated feed was identical to the baseline feed. Throughout the entire temperature range the BaSO4-substitute feed behaved similarly to the composite-treated feed. The results of the study show that sequestering sulfate into a BaSO4 phase is ineffective for rhenium retention as the sulfate salt behavior was identical in the three feeds at =700 °C. The fraction of rhenium retained in the glass at 1000°C varied from 39.4-46.6% for the three feeds, which is shown to be an insignificant difference.
Effect of vanadium oxide addition on thermomechanical behaviors of borosilicate glasses: Toward development of high crack resistant glasses for nuclear waste disposal
The effect of of V2O5 additions (up to 8 mol%) on the physical properties (e.g., density, glass transition temperature and refractive indices) and mechanical behaviors (e.g., hardness, fracture toughness, elastic modulus) of a soda-lime borosilicate glass with a composition of 60.2SiO(2)-16.0B(2)O(3)-12.6Na(2)O-3.8Al(2)O(3)-5.7CaO-1.7ZrO(2) (mol%) have been investigated systematically. It was found that introducing V2O5 decreases the glass transition temperature and hardness while increases the refractive index and crack initiation load. Composition-property relationships, especially on mechanical properties, were examined in order to provide insights for the development of new glass materials with outstanding mechanical properties. The results show that V2O5 can be a glass component for engineering and insuring high crack resistant glasses and glasses with long-term stability. Additionally, elastic properties as a function of temperature were studied using Brillouin light scattering and temperature-independent elastic moduli behaviors were observed.
Effects of composition and canister centerline cooling on microstructure, phase distribution, and chemical durability of dehalogenated iron phosphate waste forms
This paper discusses the effects of composition and canister centerline cooling (CCC) on the microstructures, phase distribution, and chemical durability of dehalogenated iron phosphate waste forms starting from chloride-based salt simulants including KCl (Simple-1), NdCl3 (Simple-2), SrCl2 (Simple-3), LaCl3 (Simple-4), LiCl (Simple-5), CsCl (Simple-6), as well as a complex simulant containing LiCl, KCl, NaCl, CsI, SrCl2, CeCl3, and NdCl3 called ERV2. The simulants represent salt constituents present in salt wastes from electrorefiners used for electrochemical reprocessing. These salts are reacted with ammonium dihydrogen phosphate (ADP) resulting in a NH4Cl (dechlorination) byproduct that is captured and phosphate product containing oxides of the salt cations. This product is further stabilized using Fe2O3 through vitrification at higher temperatures. The results presented herein describe the properties of CCC-treated materials following dechlorination and vitrification including phase identification and quantification, elemental distributions, and chemical durabilities. The chemical durability in the CCC-cooled samples are lower durability than quenched materials for the ERV2 samples. The phases formed upon CCC cooling are very complex compositionally and microstructurally.
Effect of n=3 perturbation field amplitudes below the ELM triggering threshold on edge and SOL transport in NSTX
Explore the source record for details and available documents.
Effects of heat treatment on U–Mo fuel foils with a zirconium diffusion barrier
Not Available
Synergistic effects of iodine and silver ions co-implanted in 6H–SiC
Not Available
Characterization of high energy Xe ion irradiation effects in single crystal molybdenum with depth-resolved synchrotron microbeam diffraction
Microbeam X-ray diffraction experiments were conducted at beam line 34-ID of the Advanced Photon Source (APS) on fission fragment energy Xe heavy ion irradiated single crystal Molybdenum (Mo). Lattice strain measurements were obtained with a depth resolution of 0.7 mu m, which is critical in resolving the peculiar heterogeneity of irradiation damage associated with heavy ion irradiation. Q-space diffraction peak shift measurements were correlated with lattice strain induced by the ion irradiations. Transmission electron microscopy (TEM) characterizations were performed on the as-irradiated materials as well. Nanometer sized Xe bubble microstructures were observed via TEM. Molecular Dynamics (MD) simulations were performed to help interpret the lattice strain measurement results from the experiment. This study showed that the irradiation effects by fission fragment energy Xe ion irradiations can be collaboratively understood with the depth resolved X-ray diffraction and TEM measurements under the assistance of MD simulations. (c) 2015 Elsevier B.V. All rights reserved.
Irradiation effects and hydrogen behavior in H2+ and He+ implanted γ-LiAlO2 single crystals
Not Available
Component effects on crystallization of RE-containing aluminoborosilicate glass
Lanthanide-aluminoborosilicate (LABS) glass is one option for immobilizing rare earth (RE) oxide fission products generated during reprocessing of pyroprocessed fuel. This glass system can accommodate a high loading of RE oxides and has excellent chemical durability. The present study describes efforts to model equilibrium crystallinity as a function of glass composition and temperature as well as liquidus temperature (TL) as a function of glass composition. The experimental method for determining TL was ASTM C1720-11. Typically, three crystalline phases were formed in each glass: Ce-borosilicate (Ce 3 BSi 2 O 10 ), mullite (Al 10 Si 2 O 19 ), and corundum (Al 2 O 3 ). Cerianite (CeO 2 ) was a common minor crystalline phase and Nd-silicate (Nd 2 Si 2 O 7 ) occurred in some of the glasses. In the composition region studied, TL decreased as SiO 2 and B 2 O 3 fractions increased and strongly increased with increasing fractions of RE oxides; Al 2 O 3 had a moderate effect on the TL but, as expected, it strongly affected the precipitation of Alcontaining crystals.