Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Coefficient”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,135 records · Page 63

Theory versus experiment for the rotordynamic coefficients of annular gas seals. Part 1: Test facility and apparatus

A facility and apparatus are described for determining the rotordynamic coefficients and leakage characteristics of annular gas seals. The apparatus has a current top speed of 8000 cpm with a nominal seal diameter of 15.24 cmn (6 in). The air supply unit yields a seal pressure ratio of approximately 7. An external shaker is used to excite the test rotor. The capability to independently calculate all rotordynamic coefficients at a given operating condition with one excitation frequency are discussed.

Childs, D. W.↗

Transient technique for measuring heat transfer coefficients on stator airfoils in a jet engine environment

A transient technique was used to measure heat transfer coefficients on stator airfoils in a high-temperature annular cascade at real engine conditions. The transient response of thin film thermocouples on the airfoil surface to step changes in the gas stream temperature was used to determine these coefficients. In addition, gardon gages and paired thermocouples were also utilized to measure heat flux on the airfoil pressure surface at steady state conditions. The tests were conducted at exit gas stream Reynolds numbers of one-half to 1.9 million based on true chord. The results from the transient technique show good comparison with the steady-state results in both trend and magnitude. In addition, comparison is made with the STAN5 boundary layer code and shows good comparison with the trends. However, the magnitude of the experimental data is consistently higher than the analysis.

Gladden, H. J.↗

A comparison of experimental and theoretical results for rotordynamic coefficients of four annular gas seals

The test facility and initial test program developed to experimentally measure the fluid forces induced by annular gas seals is described. A comparison of theoretically predicted and experimentally obtained data for smooth and honeycomb seals is provided. And a comparison of experimental data from the tests of three smooth-rotor/smooth-stator seals is provided. The leakage of the working fluid through the seal, the pressure gradient along the seal length, entrance pressure-loss data, and rotordynamic coefficients provide a basis for comparison. A short discussion on seal theory is included, and various rotordynamic coefficient identification schemes are described.

Childs, D. W.↗

Spatial dependence of the local diffusion coefficient measured upstream of the November 12, 1978 interplanetary traveling shock

Characteristics of wuprathermal particles accelerated by quasi-parallel interplanetary traveling shocks have been generally explained in terms of a first order Fermi mechanism. Such models require diffusive scattering of particles upstream of the shock. This scattering is characterized by a local diffusion coefficient, kappa, which is determined by the local power density of waves in the upstream region. The dependence of the diffusion coefficient of suprathermal upstream protons on distance from the November 12, 1978 interplanetary traveling shock using a different approach is studied. Unlike previous studies this method, which is based on measurements of particle streaming and intensity gradients, does not rely on predictions. The local spatial variations of Kappa upstream of the November 12, 1978 shock have been chosen for study because the characteristics of this quasi-parallel shock have been extensively studied, and also because of its favorable geometry (i.e. B field nearly radial).

Gloeckler, G.↗

Relationship between phase difference and coefficient of restitution during low velocity foreign object transverse damage of composite plates

This work discusses a model to correlate the coefficient of restitution of low velocity transverse impacts of graphite-epoxy laminates with the residual deformation or central deflection at the end of the impact event. It is assumed that the energy absorbed by the target can be calibrated in terms of residual deflection, and thereby in terms of phase difference between the occurrence of impact force and central deflection to their maximas. Analysis was modeled on the basis of the experience from impact tests. Predictions are compared with the test results of impacted circular and flat plates. Experimentally measured values of coefficient of restitution and phase difference agreed well with the predicted relationship between them.

Lal, K. M.↗

Analysis of segregation trends observed in iron meteorites using measured distribution coefficients

Fe-Ni alloys of meteoritic composition were solidified by a plane front solidification technique. Distribution coefficients of Ni, P, Ir, Ge, and Cu were determined from the composition data of the plane front solidified alloys. Equations that describe the distribution coefficients (P, Ni, Ir, Ge, and Cu) as a function of S and P content as well as S to P ratio were used to calculate solute partitioning between solid and liquid during the solidification of IIAB, IIIAB, and IVA parent bodies. The calculated P versus Ni, Ir versus Ni, Ge versus Ni, and Cu versus Ni trends are in good agreement with the observed meteorite data for each chemical group. It is concluded that each chemical group formed as a single molten pool in a parent body and that solute partitioning that occurred during solidification is responsible for the observed compositional trends within a single meteorite group.

Sellamuthu, R.↗

Transient technique for measuring heat transfer coefficients on stator airfoils in a jet engine environment

A transient technique was used to measure heat transfer coefficients on stator airfoils in a high-temperature annular cascade at real engine conditions. The transient response of thin film thermocouples on the airfoil surface to step changes in the gas stream temperature was used to determine these coefficients. In addition, gardon gages and paired thermocouples were also utilized to measure heat flux on the airfoil pressure surface at steady state conditions. The tests were conducted at exit gas stream Reynolds numbers of one-half to 1.9 million based on true chord. The results from the transient technique show good comparison with the steady-state results in both trend and magnitude. In addition, comparison is made with the STAN5 boundary layer code and shows good comparison with the trends. However, the magnitude of the experimental data is consistently higher than the analysis.

Gladden, H. J.↗

Extinction coefficient of H2CC(3B2) at 137 nm

In spite of the conduction of numerous studies regarding the vinylidene free radical, its role and importance as a reactive intermediate is not well characterized. Laufer (1980, 1983) has reported the absorption spectrum of metastable H2CC(3B2), the lowest excited state, in the vacuum ultraviolet and has measured several aspects of its quenching properties. The present study provides a measurement of the extinction coefficient of H2CC(3B2). Knowledge of the vinylidene concentration is required to convert readily available absorption data into an extinction coefficient or cross section. In the current work, the H2CC(3B2) concentration was determined in an investigation of the photodissociation of vinyl chloride.

Fahr, A.↗

Rotordynamic coefficients for compressible flow in tapered annular seals

Derivation of the governing equations for compressible flow in a tapered annular seal is based on Hirs' turbulent bulk-flow model. Zeroth and first-order perturbation equations are developed by an expansion in the eccentricity ratio. These equations are numerically integrated to obtain the leakage, and the direct and cross-coupled stiffness and damping coefficients. Seal parameters similar to the Space Shuttle Main Engine High Pressure Oxidizer Turbopump are used to demonstrate output from the analysis procedure. The effects of preswirl and seal taper are shown for three different length-to-diameter ratios. Generally the results indicate that prerotating the fluid significantly increases the cross-coupled stiffness but has little effect on the other coefficients, and increasing the convergent taper increases the direct stiffness while decreasing the direct damping and cross-coupled stiffness.

Nelson, C. C.↗

Seebeck Coefficient Measured With Differential Heat Pulses

Common experimental errors reduced because pulse technique suppresses drifts in thermoelectric measurements. Differential-heat-pulse apparatus measures Seebeck coefficient in semiconductors at temperatures up to 1,900 K. Sample heated to measuring temperature in furnace. Ends of sample then differentially heated a few degrees more by lamps. Differential temperature rise and consequent Seebeck voltage measured via thermocouple leads. Because pulse technique used, errors that often arise from long-term drifts in thermoelectric measurements suppressed. Apparatus works with temperature differences of only few degrees, further increasing accuracy of coefficients obtained.

Zoltan, L.↗

Senstitivity analysis of horizontal heat and vapor transfer coefficients for a cloud-topped marine boundary layer during cold-air outbreaks

The effects of external parameters on the surface heat and vapor fluxes into the marine atmospheric boundary layer (MABL) during cold-air outbreaks are investigated using the numerical model of Stage and Businger (1981a). These fluxes are nondimensionalized using the horizontal heat (g1) and vapor (g2) transfer coefficient method first suggested by Chou and Atlas (1982) and further formulated by Stage (1983a). In order to simplify the problem, the boundary layer is assumed to be well mixed and horizontally homogeneous, and to have linear shoreline soundings of equivalent potential temperature and mixing ratio. Modifications of initial surface flux estimates, time step limitation, and termination conditions are made to the MABL model to obtain accurate computations. The dependence of g1 and g2 in the cloud topped boundary layer on the external parameters (wind speed, divergence, sea surface temperature, radiative sky temperature, cloud top radiation cooling, and initial shoreline soundings of temperature, and mixing ratio) is studied by a sensitivity analysis, which shows that the uncertainties of horizontal transfer coefficients caused by changes in the parameters are reasonably small.

Chang, Y. V.↗

Measuring dynamic oil film coefficients of sliding bearing

A method is presented for determining the dynamic coefficients of bearing oil film. By varying the support stiffness and damping, eight dynamic coefficients of the bearing were determined. Simple and easy to apply, the method can be used in solving practical machine problems.

Feng, G.↗

Electron and hole impact ionization coefficients in GaAs-Al(x)Ga(1-x)As superlattices

Electron and hole multiplication and impact ionization coefficients have been measured with pure carrier injection in p(+)-n(-)-n(+) diodes grown by molecular beam epitaxy. Values of the electron and hole ionization coefficient ratio alpha/beta = 2-5 are measured for superlattices with well width Lz greater than or equal to 100 A and alpha/beta greater than 10 is measured in a graded band-gap superlattice with a total well and barrier width LB + LZ = 120 A. The ratio decreases and becomes less than unity for smaller well sizes. This is caused by an increase in beta (E) while alpha (E) remains fairly constant. The results have been interpreted by considering varying hole confinement and scattering in the coupled quantum wells.

Juang, F.-Y.↗

Limits on ion radial diffusion coefficients in Saturn's inner magnetosphere

The development of upper and lower limits for the rate of radial diffusion of energetic ions in Saturn's inner magnetosphere is discussed. Improved calculations of the satellite-sweeping rate and phase space density profiles for a wide range of ion invariants are utilized to determine the limits. The lower limit for the radial diffusion coefficient is established by requiring the rate of inward diffusion to be large enough to balance satellite sweeping losses; the upper limit is obtained by requiring the rate of inward diffusion to be less than the observable ultraviolet aurora on plasma torus L shell. It is concluded that the radial diffusion coefficient for ions in Saturn's inner magnetosphere is calculated to about two orders of magnitude.

Paonessa, M.↗

Experimental rotordynamic coefficient results for teeth-on-rotor and teeth-on-stator labyrinth gas seals

An experimental test facility is used to measure the rotordynamic coefficients of teeth-on-rotor and teeth-on-stator labyrinth gas seals. Direct damping coefficients are presented for these seals for the first time. The results are presented for the two seal configurations at identical operating conditions, and show that, in a rotordynamic sense, the teeth-on-stator seal is more stable than the teeth-on-rotor seal, for inlet tangential velocity in the direction of rotation.

Childs, D. W.↗

Three-dimensional boundary layer on a compressor rotor blade at peak pressure rise coefficient

A comprehensive study of the three-dimensional turbulent boundary layer on a compressor rotor blade at peak pressure rise coefficient is reported in this paper. The measurements were carried out at various chordwise and radial locations on a compressor rotor blade using a rotating miniature 'V' configuration hot-wire probe. The data are compared with the measurement at the design condition. Substantial changes in the blade boundary layer characteristics are observed, especially in the outer sixteen percent of the blade span. The increased chordwise pressure gradient and the leakage flow at the peak pressure coefficient have a cumulative effect in increasing the boundary layer growth on the suction surface. The leakage flow has a beneficial effect on the pressure surface. The momentum and boundary layer thicknesses increase substantially from those at the design condition, especially near the outer radii of the suction surface.

Lakshminarayana, B.↗

Wavelength dependence of aerosol backscatter coefficients obtained by multiple wavelength Lidar measurements

Aerosols are often classified into several general types according to their origins and composition, such as maritime, continental, and stratospheric aerosols, and these aerosol types generally have different characteristics in chemical and physical properties. The present study aims at demonstrating the potential for distinguishing these aerosol types by the wavelength dependence of their backscatter coefficients obtained from quantitative analyses of multiple wavelength lidar signals. Data from the NASA Airborne Differential Abosrption lidar (DIAL) S ystems, which can measure aerosol backscatter profiles at wavelenghts of 300, 600, and 1064 nm and ozone profiles of backscatter coefficients for these three wavelength were derived from the observations of aerosols of different types. Observations were performed over the Atlantic Ocean, the Southwestern United States, and French Guyana.

Sasano, Y.↗

Measurement of airfoil heat transfer coefficients on a turbine stage

The primary basis for heat transfer analysis of turbine airfoils is experimental data obtained in linear cascades. A detailed set of heat transfer coefficients was obtained along the midspan of a stator and a rotor in a rotating turbine stage. The data are to be compared to standard analyses of blade boundary layer heat transfer. A detailed set of heat transfer coefficients was obtained along the midspan of a stator located in the wake of a full upstream turbine stage. Two levels of inlet turbulence (1 and 10 percent) were used. The analytical capability will be examined to improve prediction of the experimental data.

Dring, R. P.↗