Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “TUNNEL EFFECT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,117 records · Page 62
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

Ground effect for V/STOL aircraft configurations and its simulation in the wind tunnel. Part 1: Introduction and theoretical studies

Theoretical studies are made of three dimensional turbulent boundary layer behavior on fixed grounds and on moving grounds of the type used in wind tunnel tests. It is shown that, for several widely-varying STOL configurations, the ground static pressure distributions possess a remarkable degree of fore-aft symmetry about the center of lift. At low Renolds number, corresponding to small-tunnel testing, the boundary layer displacement surface reflects to a large degree the symmetry of the pressure distribution. For this reason, induced incidence at the model is small for unseparated ground flow. At high Reynolds number, the displacement thickness decrease aft of the static pressure maximum is noticeably more rapid than the corresponding rise. This is attributed to trailing-vortex-induced spanwise pumping within the boundary layer.

Hackett, J. E.↗
NASA NTRS1974

Aerodynamic results of support system interference effects tests conducted in NASA/ARC 6 by 6-foot supersonic wind tunnel using an 0.015-scale model of the configuration 14OA/B SSV orbiter (OA59), volume 1

An experimental aerodynamic investigation was conducted in the NASA/ARC 6- by 6-foot supersonic wind tunnel on an 0.015-scale configuration 140A/B SSV Orbiter model. The primary objective was to determine the extent aerodynamic simulation is compromised by sting base mounting with MPS nozzles removed. Both a conventional sting (through the base) and an alternate model mounting system were utilized. The alternate mounting system consisted of a non-metric blade strut, which approximated the vertical tail and entered the model through the upper aft section of its fuselage. The model was tested both in and out of the presence of a dummy sting with and without MPS nozzles when on the alternate mounting system. Data were obtained at Mach numbers from 0.6 through 2.0, a Reynolds number of 2.5 million per foot, angles of attack from -4 through 14 degrees, angles of sideslip from -15 through 15 degrees, elevon deflections of 0 and 15 degrees, and bodyflap deflections of -11.7, 0, and 16.3 degrees.

Campbell, J. H., II↗
NASA NTRS1978

A parametric experimental study of the interference effects and the boundary-condition coefficient of slotted wind-tunnel walls

An experimental study of slotted upper and lower walls in a two-dimensional transonic wind tunnel with solid sidewalls is reported. Results are presented for several slot spacings and slot openness ratios. The experimental data are pressure measurements which were made on an airfoil model and on a sidewall near one of the slotted walls. The slotted-wall boundary-condition coefficient, which relates the pressure and streamline curvature near the wall, is determined from the wall pressure measurements. The measured wall-induced interference is correlated with the experimental values for the boundary-condition coefficient. This correlation is compared with theory.

Everhart, J. L.↗
NASA NTRS1989

Sidewall boundary-layer removal effects on wall adaptation in the Langley 0.3-meter transonic cryogenic tunnel

This paper describes the Langley 0.3-m transonic cryogenic tunnel sidewall boundary-layer removal system and is integrated operation with the adaptive wall adjustment. Empty test section measurements show the sidewall boundary-layer displacement thickness at the model station is reduced from about 1.0 to 0.6 percent of the test section width when the maximum boundary-layer removal conditions are applied. Tests with a supercritical airfoil model show the iterative top and bottom wall adaptation process performs satisfactorily with sidewall boundary-layer removal.

Murthy, A. V.↗
NASA NTRS2007

Active Control of Flow Separation on a High-Lift System with Slotted Flap at High Reynolds Number

The NASA Energy Efficient Transport (EET) airfoil was tested at NASA Langley's Low- Turbulence Pressure Tunnel (LTPT) to assess the effectiveness of distributed Active Flow Control (AFC) concepts on a high-lift system at flight scale Reynolds numbers for a medium-sized transport. The test results indicate presence of strong Reynolds number effects on the high-lift system with the AFC operational, implying the importance of flight-scale testing for implementation of such systems during design of future flight vehicles with AFC. This paper describes the wind tunnel test results obtained at the LTPT for the EET high-lift system for various AFC concepts examined on this airfoil.

Khodadoust, Abdollah↗
NASA NTRS1984

Assessment of lift- and blockage-induced wall interference in a three-dimensional adaptive-wall tunnel

A three-dimensional adaptive-wall wind tunnel experiment was conducted at Ames Research Center. This experiment demonstrated the effects of wall interference on the upwash distribution on an imaginary surface surrounding a lifting wing. This presentation demonstrates how the interference assessment procedure used in the adaptive-wall experiments to determine the wall adjustments can be used to separately assess lift- and blockage-induced wall interference in a passive-wall wind tunnel. The effects of lift interference on the upwash distribution and on the model lift coefficient are interpreted by a simple horseshoe vortex analysis.

Schairer, E. T.↗
NASA NTRS1974

Effects of reaction control system jet simulation on the stability and control characteristics of a 0.015 scale space shuttle orbiter model tested in the Langley Research Center unitary plan wind tunnel

An experimental investigation was performed in the Langley Research Center Unitary Plan Wind Tunnel (Test 0A70) to obtain the detailed effects that RCS jet flow interactions with local orbiter flow field have on supersonic stability and control characteristics of the space shuttle orbiter. Six-component force data were obtained through an angle-of-attack range from 15 to 35 degrees at angles of sideslip of 0, +5, and -5 degrees. The test was conducted with yaw jet simulation at free-stream Mach numbers of 2.5 and 4.6, simulating SSV re-entry flight conditions at these Mach numbers. In addition to the basic force measurements, fuselage base pressures and pressures on the non-metric RCS pods were obtained.

Daileda, J. J.↗
NASA NTRS1975

Acoustical modeling study of the open test section of the NASA Langley V/STOL wind tunnel

An acoustic model study was carried out to identify effective sound absorbing treatment of strategically located surfaces in an open wind tunnel test section. Also an aerodynamic study done concurrently, sought to find measures to control low frequency jet pulsations which occur when the tunnel is operated in its open test section configuration. The acoustical modeling study indicated that lining of the raised ceiling and the test section floor immediately below it, results in a substantial improvement. The aerodynamic model study indicated that: (1) the low frequency jet pulsations are most likely caused or maintained by coupling of aerodynamic and aeroacoustic phenomena in the closed tunnel circuit, (2) replacing the hard collector cowl with a geometrically identical but porous fiber metal surface of 100 mks rayls flow resistance does not result in any noticable reduction of the test section noise caused by the impingement of the turbulent flow on the cowl.

Ver, I. L.↗
NASA NTRS1984

Effects of streamwise variations in noise levels and spectra on supersonic boundary-layer transition

Transition data for sharp cones in two quiet wind tunnels at Mach numbers 3.5 and 5.0 have been correlated in terms of noise parameters with data from several conventional wind tunnels and from the flight data for the AEDC transition cone. The noise parameters were developed to account for the large axial variations of the rms stream noise and the high frequency noise spectra that occurred in the quiet tunnels for some test conditions. The correlation results indicated transition in the quiet tunnels was dominated by the local stream noise that was incident on the cone boundary layer upstream of the neutral stability point. The correlation results also suggested that the energy in high frequency components of the quiet tunnel noise spectra had significant adverse effects on transition when the noise was incident on the boundary layer both upstream and downstream of the neutral stability point.

Chen, F.-J.↗
NASA NTRS1976

The rationale and design features for the 40 by 80/80 by 120 foot wind tunnel

A substantial increase in the test capability of full scale wind tunnels is considered. In order to determine the most cost effective means for providing this desired increase in test capability, a series of design studies were conducted of various new facilities as well as of major modifications to the existing 40- by 80-foot wind tunnel. The most effective trade between test capability and facility cost was provided by repowering the existing 40 by 80 foot wind tunnel to increase the maximum speed from 200 knots to 300 knots and by the addition of a new 80- by 120-foot test section having a 110 knot maximum speed. The design of the facility is described with special emphasis on the unique features, such as the drive system which absorbs nearly four times the power without an increase in noise, and the large flow diversion devices required to interface the two test sections to a single drive.

Mort, K. W.↗
NASA NTRS1990

Is it possible to create a universe in the laboratory by quantum tunneling?

We explore the possibility that a new universe can be created by producing a small bubble of false vacuum. The initial bubble is small enough to be produced without an initial singularity, but classically it could not become a universe - instead it would reach a maximum radius and then collapse. We investigate the possibility that quantum effects allow the bubble to tunnel into a larger bubble, of the same mass, which would then classically evolve to become a new universe. The calculation of the tunneling amplitude is attempted, in lowest order semiclassical approximation (in the thin-wall limit), using both a canonical and a functional integral approach. The canonical approach is found to have flaws, attributable to our method of space-time slicing. The functional integral approach leads to a Euclidean interpolating solution that is not a manifold. To describe it, we define an object which we call a 'pseudomanifold', and give a prescription to define its action. We conjecture that the tunneling probability to produce a new universe can be approximated using this action, and we show that this leads to a plausible result.

Farhi, Edward↗
DOE OSTI2022

Simultaneous Optimization of Nuclear–Electronic Orbitals

Accurate modeling of important nuclear quantum effects, such as nuclear delocalization, zero-point energy, and tunneling, as well as non-Born-Oppenheimer effects, requires treatment of both nuclei and electrons quantum mechanically. The nuclear–electronic orbital (NEO) method provides an elegant framework to treat specified nuclei, typically protons, on the same level as the electrons. In conventional electronic structure theory, finding a converged ground state can be a computationally demanding task; converging NEO wavefunctions, due to their coupled electronic and nuclear nature, is even more demanding. Herein, we present an efficient simultaneous optimization method that uses the direct inversion in the iterative subspace method to simultaneously converge wavefunctions for both the electrons and quantum nuclei. In conclusion, benchmark studies show that the simultaneous optimization method can significantly reduce the computational cost compared to the conventional stepwise method for optimizing NEO wavefunctions for multicomponent systems.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
NASA NTRS1925

Propeller scale effect and body interference

This note shows that the main part of the discrepancy between full flight propeller performance and the performance of models in a wind tunnel is due to a scale effect, and that a minor part is caused by body interference. Analyses are made of propeller performances on several standard airplanes, and the actual brake horsepower compared with the power as calculated from model test data. The calculated power is based on that absorbed by a wind tunnel propeller model which is geometrically similar to the full scale propeller and is operating under the same ratio of V/nD.

Weick, Fred E↗