Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “RINGS - STRESSES”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,117 records · Page 62

On the combination of kinematics with flow visualization to compute total circulation - Application to vortex rings in a tube

To date the computation of the total circulation, or strength of a vortex has required detailed measurements of the velocity field within the vortex. In this paper a method is described in which the kinematics of the vortical flow field is exploited to calculate the strength of a vortex from relatively simple flow visualization measurements. There are several advantages in the technique, the most important being the newly acquired ability to calculate the transient changes in strength of a single vortex as it evolves. The method is applied to the study of vortex rings, although the development can be carried over directly to study vortex pairs, and it is expected that it can be generalized to other flows which contain regions of concentrated vorticity. The accuracy of the method as applied to vortex rings, assessed in part by comparing with the laser Doppler velocimeter (LDV) measurements of Sullivan et al., is shown to be excellent.

Brasseur, J. G.↗

High-Pressure Hot-Gas Self-Acting Floating Ring Shaft Seal for Liquid Rocket Turbopumps

Design analysis, detail design, fabrication, and experimental evaluation was performed on two self acting floating ring shaft seals for a rocket engine turbopump high pressure 24132500 n/sq m (3500 psig) hot gas 533 K 9500 F) high speed 3142 rad/sec (30000 rmp) turbine. The initial design used Rayleigh step hydrodynamic lift pads to assist in centering the seal ring with minimum rubbing contact. The final design used a convergent tapered bore to provide hydrostatic centering force. The Rayleigh step design was tested for 107 starts and 4.52 hours total. The leakage was satisfactory; however, the design was not acceptable due to excessive wear caused by inadequate centering force and failure of the sealing dam caused by erosion damage. The tapered bore design was tested for 370 starts and 15.93 hours total. Satisfactory performance for the required life of 7.5 hours per seal was successfully demonstrated.

Burcham, R. E.↗

Brightness temperatures of Saturn's disk and rings at 400 and 700 micrometers

Observations at wavelengths longer than 300 microns provide temperature measurements at deeper layers in the atmosphere of giant planets because opacities are reduced. Submillimeter observations of Saturn were made in November 1979 when the inclination angle of the rings was 1.2 degrees. A 55 sec focal plane aperture was used along with two filters with spectral passbands of 300 to 800 microns (mean wavelength approximately 400 microns) and 500 to 850 microns (mean wavelength approximately 700). Mean brightness temperatures of 121 + or - 12 K at 400 microns and 139 + or - 15 K at 700 microns are reported. The brightness temperatures fall below predictions of atmospheric models at shorter wavelengths, requiring an opacity source besides the pressure-broadened hydrogen lines. In combination with measurements at larger inclination angles, the results yield a 400 micrometer brightness temperature for the rings of approximately 75 K.

Whitcomb, S. E.↗

High-energy trapped radiation penetrating the rings of Saturn

Electrons and protons of energies from 2 to 25 MeV and greater than 67 MeV, respectively, have been discovered throughout the entire equatorial region inward from the outer edge of the A ring at L = 2.3 to the periapsis of the Pioneer trajectory at L = 1.3. The trapped radiation found in Saturn's magnetosphere beyond L = 2.3 is totally absent here. The present paper deals with the measurements in this region under the rings, and their interpretation.

Chenette, D. L.↗

Phase space variations of near equatorially mirroring ring current ions

Observations of near equatorially mirroring ring current ions before and after a magnetic storm are presented in the form of phase space densities with respect to the first adiabatic invariant. Particle densities were obtained from the medium energy particles instrument covering the energy range 24-2081 keV on ISEE 1 at L values between 3 and 8 earth radii and ratios of the magnetic field at the satellite position to the magnetic field at the magnetic equator less than 1.2. Analysis of the phase space densities through the magnetosphere reveals a well-defined high magnetic moment peak in the prestorm near-equatorial ring current ion phase space density distribution, with the magnetic storm resulting from an enhancement of phase space densities at magnetic moment values below the peak and phase space densities remaining constant above the peak. Results are found to be in good agreement with those obtained by Explorer 45 six years previously, indicating that the observed phase space density variations are characteristic of energetic ion behavior during magnetic storms.

Williams, D. J.↗

A three-ring circuit model of the magnetosphere

The magnetosphere is modeled by superimposing a dipole field, a uniform field and a perturbation field due to a simple current system. This current system comprises a ring current in the neutral line of the dipole plus uniform fields, together with vertical currents representing field-aligned currents to the neutral line. The current circuit is closed through two additional ring currents above and below the equatorial plane representing distributed adiabatic perpendicular currents. This system produces many magnetospheric features, among them a magnetopause, bending of magnetic field lines in the anti-solar direction, a magnetotail, and cusps in the day-side of the earth. The objective is to demonstrate that it is not necessary to think of the magnetic field topology as being caused by the flowing plasma carrying field lines. The primary physical problem is to derive the current system from the self-consistent interaction of the solar-wind and magnetospheric plasmas and fields.

Whipple, E. C., Jr.↗

Inference of the ring current ion composition by means of charge exchange decay

The analysis of data from the Explorer 45 (S3-A) electrostatic analyzer in the energy range 5-30 keV has provided some new results on the ring current ion composition. It has been well established that the storm time ring current has a decay time of several days, during which the particle fluxes decrease nearly monotonically. By analyzing the measured ion fluxes during the several day storm recovery period and assuming that beside hydrogen other ions were present and that the decays were exponential in nature, three separate lifetimes for the ions were established. These fitted decay lifetimes are in excellent agreement with the expected charge exchange decay lifetimes for H(+), O(+) and He(+) in the energy and L value range of the data.

Smith, P. H.↗

Density waves in Saturn's rings

Certain radial brightness variations in the outer Cassini division of Saturn's rings may be spiral density waves driven by Saturn's large moon Iapetus, in which case a value of approximately 16 g/sq cm for the surface density is calculated in the region where the waves are seen. The kinematic viscosity in the same region is approximately 170 sq cm/s and the vertical scale height of the ring is estimated to be a maximum of approximately 40 m.

Cuzzi, J. N.↗

Dipole-Excited Ring Antenna

Dipole radiator drives ring radiator in compact C-band antenna. Antenna can be mounted flush with surface. Compared with horn or parabolic dish with same aperature, new ring antenna has greater gain, lower side lobes, and narrower beam width. Used on vehicles requiring flush-mounted antennas with very directive signals. Used as radar altimeter antenna for aircraft.

Ellis, H., Jr↗

Ring current impoundment of the Io plasma torus

A newly discovered feature in the Io plasma formation that may be described as a ramp separating a high-density plasma ledge on its Jupiterward side from the lower-density radially distended Io plasma disc on its anti-Jupiterward side is observed to coincide with a marked inward decrease in the ring current population. The spatial congruency of the counter-directed maximal gradients in both plasma bodies reveals a profound coupling between them. The existence of the ramp requires a local order-of-magnitude reduction in the diffusion coefficient that governs radial mass transport. It is demonstrated that the diminished diffusive efficiency there is caused by strong pressure gradient inhibition of the interchange instability that underlies mass transport. The Io plasma torus, which is defined as the region of strong ultraviolet emissions, is identified as the plasma ledge. The plasma density in the ledge is high and, incidentally therefore, able to emit strongly because it is impounded against rapid, centrifugal expulsion by the inwardly directed pressure of the ring current at its inner edge.

Siscoe, G. L.↗

A possible link between the rotation of Saturn and its ring structure

Evidence is presented that two previously unidentified, yet conspicuous gaps in Saturn's rings lie at distances corresponding to 2/3 and 4/3 of the planet's rotation period. Gaps such as these can be produced in a ring of large bodies or small uncharged particles by a nonaxisymmetric gravitational field (both of the above can be associated with the l = m = 3 harmonic), a fact that is relevant to models of planetary interiors.

Franklin, F. A.↗

Origin of bright ring-shaped craters in radar images of Venus

Radar images of the Venusian surface taken at the Arecibo Observatory are examined in the context of recent study of the radar appearance of lunar craters to provide insight into the formation and evolution of Venusian features and to propose the thesis that bright ring-shaped features contain information about the rate at which Venus is being modified by depositional or erosional processes. Radar crater signatures are analyzed by crater floor and interior properties and by properties of ejecta deposits. Morphological comparisons with radar images of lunar craters are made, as well as morphometric comparisons with lunar radar crater haloes. The populations of radar bright craters on the moon and Venus is analyzed using a Monte Carlo simulation. It is concluded that the bright ring crater population does not resemble an impact crater production population.

Cutts, J. A.↗

Ground-based observations of the Jovian ring and inner satellites

Ground-based 0.9-micron observations of the Jovian ring and inner satellites are reported. The ring observations substantially confirm those obtained by the Voyager spacecraft. The first ground-based detection of 1979J2 suggests a geometric albedo of about 0.10 and a new value for its orbit period of 16 hr 11 min 23.5 + or - 0.5 sec.

Jewitt, D. C.↗

The spokes in Saturn's rings - A new approach

It is proposed that zonal winds in Saturn's atmosphere cause superrotation of the ionosphere and, by virtue of field-aligned currents, generate a potential of about 16 kV across the B-ring. Such a potential can momentarily polarize 1-10-micron ice particles in a radial sense, and thus create the spectacular spokes. A resulting current flowing radially through the B-ring would give rise to a power of approximately 10 million W, which is close to that dissipated in a Saturn electrostatic discharger burst.

Carbary, J. F.↗

Microwave edge diffraction by features in Saturn's rings - Observations with Voyager 1

Classical edge diffraction patterns are formed at centimeter wavelengths by several features of Saturn's rings. These patterns were discovered in 3.6- and 13-centimeter radio signals from Voyager 1 during occultation by the rings. The observed shapes are in agreement with theoretical patterns computed for screens of perfectly abrupt edges having large but finite opacity. Comparison with models in which the opacity at the edge tapers to zero from a finite value sets a new bound of less than about 200 meters on the microwave edge thickness. Certain features of the data suggest a smaller upper bound of about 130 meters on the edge thickness.

Marouf, E. A.↗

Resonances in Saturn's rings

The locations and strengths of the major resonances of Saturn's known moons with particles orbiting within Saturn's rings are calculated. The resonant effects of an outer satellite on Saturn's rings is analyzed by Fourier expanding the satellite's potential, and it is found that the forcing at an l:(m-1) resonance depends on the moon's eccentricity to the (l-m) power. As most of Saturn's inner moons are in very nearly circular orbits, only their strongest resonances, with l = m and l = m+1, are calculated. For Mimas, which has a somewhat larger eccentricity, resonances with l = m+2 are also computed. All of the resonances of these forms which are located between Saturn's cloud tops and 2.267 Saturn radii are tabulated, except some of those due to tiny 1980 S28.

Lissauer, J. J.↗

Modification of multi-ring basins - The Imbrium model

It is shown that the gross variations in wall height around Imbrium result largely from intersection of the Imbrium basin with pre-existing basins and faulting: angle of impact and slumping played a lesser modifying role. The gross irregularities in plan of the northern part of Imbrium is hypothesized to result from the collapse of large crustal blocks into the Imbrium and Serenitatis cavities. Lithosphere thickness is believed to play an important role in the mechanisms of formation and modification of large craters and basins. The deduction of slow sub-lithospheric flow of material toward the cavity centers does not lend support to the tsunami model, requires a minor modification of the nested-crater model and provides a mechanism for the production of megaterraces. Spatial and temporal lithosphere variations satisfy constraints requiring the overlap of morphology/diameter characteristics, variable onset diameters between planets, variable ring spacings from planet to planet and provide a mechanism for producing local irregularities in ring structures.

Whitford-Stark, J. L.↗

Possible terrestrial analogs of Valhalla and other ripple-ring basins

The most remarkable feature on Callisto is Valhalla, a 3000 km wide structure comprised of dozens of concentric ridges and scarps surrounding a central smooth zone. Conventionally, Valhalla is interpreted as a multi-ring impact basin (similar to those on the terrestrial planets) whose morphology has been strongly effected by a thin and weak icy lithosphere in which it formed. Alternatively, Valhalla may have been formed by some non-impact related processes. In particular, ice cauldrons formed in Iceland by subsidence of glacier ice into voids created by geothermal melting are grossly similar to Valhalla in that both formed in ice and have multiple rings. Theoretical support for a similar subsidence mode of origin for Valhalla is provided by models of the thermal evolution of ice-silicate planets that result in diapiric sinking of lithospheric material into a water mantle (e.g., Paramentier and Head, 1979).

Wood, C. A.↗