Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Diffusivity”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,117 records · Page 62

Isotopic study of oxygen diffusion in oxide coatings

Diffusion of oxygen in thin films of silicon dioxide was studied using oxygen isotopically enriched in oxygen of atomic mass 18 (O-18). This subject is of interest because thin films of dielectrics such as SiO2 are proposed for use as a protective coatings for solar mirrors in low Earth orbit, which is a strongly oxidizing environment. Films of this material were prepared with a direct current magnetron using reactive sputtering techniques. To produce (O-18)- enriched SiO2, a standard 3.5-in.-diameter silicon wafer was reactively sputtered using (O-18)-enriched (95 percent) oxygen as the plasma feed gas. The films were characterized using Rutherford backscattering and Secondary Ion Mass Spectrometer (SIMS) to establish stoichiometry and purity. Subsequently, the films were exposed to an air-derived oxygen plasma in a standard laboratory plasma reactor for durations of up to 10 hr. The concentration ratio of O-16 as a function of depth was determined using SIMS profiling and compared to a baseline, nonplasma exposed sample. A value for the diffusivity of oxygen near the surface of these films was obtained and found to be about 10(-15)sq cm/sec.

Gulino, Daniel A.↗

Investigation of the flow in the diffuser section of the NASA Lewis icing research tunnel

The flow in the diffuser section of the Icing Research Wind Tunnel at NASA Lewis Research Center is investigated using both tunnel calibration measurements and numerical simulation techniques. Local pressure and temperature measurements are made to establish velocity and temperature profiles in the diffuser of the tunnel. These profiles are compared with similar measurements made prior to renovating the equipment which generates the tunnel's icing cloud. This comparison indicates the manner in which this change affected the flow. The measured data were also compared with a numerical simulation of the flow to help understand how such changes may favorably alter the tunnel flow.

Addy, Harold E., Jr.↗

Detection of a buried horizon with a high thermal diffusivity using thermal remote sensing

A field investigation using thermal remote sensing was performed to test the feasibility of detecting the surface topography of granite bedrock beneath a thin cover of alluvium. Imagery of a region of the Mojave Desert were taken with an airborne multispectral scanner with thermal spectral bandwidths of 10.4 and 12.5 microns an instantaneous field of view of 2.5 mrad. It is suggested that a buried high thermal diffusivity horizon measurably lowers the surface temperature of the overlying lower diffusivity material during the peak of the annual heating cycle.

Nash, David B.↗

Inverse gas chromatography. V - Computer simulation of diffusion processes on the column

The elution behavior of low molecular weight probes on inverse gas chromatography (IGC) columns is simulated using a computer. The IGC model is based on a polymer stationary phase of uniform thickness with a nonnegligible resitance to probe penetration. Three characteristic numbers are found to determine the whole process: Z(p) characterizing the distribution of the probe between phases, Z(f) describing the diffusion in the polymer phase, and Z(g) related to diffusion in the gaseous phase. For situations when Z(p)/Z(f) is less than 2, the standard evaluation procedures are virtually useless. The actual behavior of such systems is described.

Hattam, Paul↗

A method of boundary parameter estimation for a two-dimensional diffusion system under noisy observations

The purpose of this paper is to establish a method for identifying unknown parameters involved in the boundary state of a class of diffusion systems under noisy observations. A mathematical model of the system dynamics is given by a two-dimensional diffusion equation. Noisy observations are made by sensors allocated on the system boundary. Starting with the mathematical model mentioned above, an online parameter estimation algorithm is proposed within the framework of the maximum likelihood estimation. Existence of the optimal solution and related necessary conditions are discussed. By solving a local variation of the cost functional with respect to the perturbation of parameters, the estimation mechanism is proposed in a form of recursive computations. Finally, the feasibility of the estimator proposed here is demonstrated through results of digital simulation experiments.

Sunahara, Y.↗

Investigation of the flow in the diffuser section of the NASA Lewis Icing Research Tunnel

The flow in the diffuser section of the Icing Research Wind Tunnel at NASA Lewis Research Center is investigated using both tunnel calibration measurements and numerical simulation techniques. Local pressure and temperature measurements are made to establish velocity and temperature profiles in the diffuser of the tunnel. These profiles are compared with similar measurements made prior to renovating the equipment which generates the tunnel's icing cloud. This comparison indicates the manner in which this change affected the flow. The measured data were also compared with a numerical simulation of the flow to help understand how such changes may favorably alter the tunnel flow.

Addy, Harold E., Jr.↗

The effect of diffusive segregation on the fracture of hydrogen charged nickel

Hydrogen charged nickel was deformed in tension at a test temperature of 208 K to study the diffusive segregation of hydrogen during straining and the dependence of embrittlement on grain boundary hydrogen concentration and deformation rate. Tests were performed on samples in the as-quenched condition at various strain rates. An increase in the degree of embrittlement at slow strain rates can be attributed to diffusive segregation of hydrogen to grain boundaries during the test period. The embrittlement of samples with equal grain boundary hydrogen concentration was found to be relatively insensitive to strain rate, bulk hydrogen concentration and the total time at the test temperature.

Lassila, D. H.↗

Diffusion, phase equilibria and partitioning experiments in the Ni-Fe-Ru system

Results are presented on thin-film diffusion experiments designed to investigate phase equilibria in systems containing high concentrations of Pt-group elements, such as Ni-Fe-Ru-rich systems containing Pt, at temperatures of 1273, 1073, and 873 K. The rate of Ru diffusion in Ni was determined as a function of temperature, and, in addition, the degree of Pt and Ir partitioning between phases in a Ni-Fe-Ru-rich system and of V between phases in a Ni-Fe-O-rich system at 873 were determined. It was found that Pt preferentially partitions into the (gamma)Ni-Fe phase, whereas Ir prefers the (epsilon)Ru-Fe phase. V partitions strongly into Fe oxides relative to (gamma)Ni-Fe. These results have direct application to the origin and thermal history of the alloys rich in Pt-group elements in meteorites.

Blum, Joel D.↗

The diffusion approximation and transport theory for cosmic rays in relativistic flows

Equations describing the transport of cosmic rays in relativistic flows in the diffusion approximation are obtained. The analysis is based on the zeroth, first, and second differential moment equations of the relativistic Boltzmann equation with a BGK collision term. A perturbation solution of the moment equations in the diffusion approximation yields both the co-moving frame particle current and viscous stresses. The resultant cosmic-ray continuity equation contains three readily recognized energy change terms: the adiabatic energy change term; the viscous shear energy change term; and a term proportional to the scalar product of the acceleration vector of the scattering frame and the heat flux.

Webb, G. M.↗

Steady-state thermal-solutal diffusion in a float zone

A model for a float zone in a thin vertical sheet is used to study the formation of the zone configuration for both pure and binary systems of Si and GeGa. Equations describing the steady two-dimensional diffusion of solute in the melt and diffusion of heat in the feed material and the product crystal are presented. The material properties, asymptotic solutions for the temperature and concentration profiles, and melting, solidifying, and melt/gas interfacial shapes are determined in the small aspect ratio limit.

Young, G. W.↗

Radial diffusion and losses of energetic protons in the 5 to 12 R(S) region of Saturn's magnetosphere

Phase space density profiles for nearly equatorial mirroring energetic protons, derived from Pioneer 11 measurements during the 1979 Saturn encounter, were analyzed using solutions of the time-averaged radial diffusion equation in a dipolar planetary magnetic field. Then, several loss models were considered, ranging from a model that takes into account satellite absorption only to the one that accounts for satellite plus ring-E absorption plus added distributed losses, and the corresponding form of the time-averaged radial diffusion coefficient was determined for each case by a minimum-variance fit to the data-derived phase space densiy profiles. The model comparisons clearly indicated the need for distributed losses, in addition to satellite absorption, in order to explain the smooth decline of the experimental energetic proton phase space density profiles in the 5-12-Saturn radius region of Saturn's magnetosphere.

Hood, L. L.↗

An evaluation of the role of eddy diffusion in stratospheric interactive two-dimensional models

An interactive two-dimensional model of the stratosphere, consisting of a primitive equation dynamics module, a simplified HO(x) ozone model, and a full radiative transfer scheme, is used to study the effect of eddy diffusion in the model. Consideration is given to the effects of nonlocal forcing from dissipation in the model troposphere and frictional drag at mesospheric levels, mechanical damping in the stratosphere itself, and potential vorticity flux due to large scale waves. It is found that the ozone distributions generated with the model are very sensitive to the choice of values for the friction and the eddy diffusion coefficients. It is shown that reasonable latitudinal gradients of ozone may be obtained by using small values for the mechanical damping for the mid- and high-latitude stratopsphere.

Schneider, Hans R.↗

Rotor/Stator Interaction In A Diffuser Pump

Measurements of steady and fluctuating pressures reported. Report describes experiments designed to investigate interactions between blades of impeller and both vaned and vaneless diffuser (stator) in diffuser pump.

Acosta, A. J.↗

Superplastic forming and diffusion bonding of rapidly solidified, dispersion strengthened aluminum alloys for elevated temperature structural applications

Rapidly solidified alloys, based upon the Al-Fe-V-Si system and designed for elevated temperature applications, were evaluated for superplasticity and diffusion bonding behavior. Alloys with 8, 16, 27, and 36 volume percent silicide dispersoids were produced; dispersoid condition was varied by rolling at 300, 400, and 500 C (572, 752, and 932 F). Superplastic behavior was evaluated at strain rates from 1 x 10(exp -6)/s to 8.5/s at elevated temperatures. The results indicate that there was a significant increase in elongation at higher strain rates and at temperatures above 600 C (1112 F). However, the exposure of the alloys to temperatures greater than 600 C (1112 F) resulted in the coarsening of the strengthening dispersoid and the degradation of mechanical properties. Diffusion bonding was possible using low gas pressure at temperatures greater than 600 C (1112 F) which also resulted in degraded properties. The bonding of Al-Fe-V-Si alloys to 7475 aluminum alloy was performed at 516 C (960 F) without significant degradation in microstructure. Bond strengths equal to 90 percent that of the base metal shear strength were achieved. The mechanical properties and microstructural characteristics of the alloys were investigated.

Ting, E. Y.↗

The grand unified photon spectrum: A coherent view of the diffuse extragalactic background radiation

The spectrum of diffuse extragalactic background radiation (DEBRA) at wavelengths from 10(exp 5) to 10(exp -24) cm is presented in a coherent fashion. Each wavelength region, from the radio to ultra-high energy photons and cosmic rays, is treated both separately and as part of the grand unified photon spectrum (GUPS). A discussion of, and references to, the relevant literature for each wavelength region is included. This review should provide a useful tool for those interested in diffuse backgrounds, the epoch of galaxy formation, astrophysical/cosmological constraints to particle properties, exotic early Universe processes, and many other astrophysical and cosmological enterprises. As a worked example, researchers derive the cosmological constraints to an unstable-neutrino spies (with arbitrary branching ratio to a radiative decay mode) that follow from the GUPS.

Ressell, M. Ted↗

A numerical simulation of the flow in the diffuser of the NASA Lewis icing research tunnel

The flow in the diffuser section of the Icing Research Tunnel at the NASA Lewis Research Center is numerically investigated. To accomplish this, an existing computer code is utilized. The code, known as PARC3D, is based on the Beam-Warming algorithm applied to the strong conservation law form of the complete Navier-Stokes equations. The first portion of the paper consists of a brief description of the diffuser and its current flow characteristics. A brief discussion of the code work follows. Predicted velocity patterns are then compared with the measured values.

Addy, Harold E., Jr.↗

The temperature variation of hydrogen diffusion coefficients in metal alloys

Hydrogen diffusion coefficients were measured as a function of temperature for a few metal alloys using an electrochemical evolution technique. Results from these measurements are compared to those obtained by the time-lag method. In all cases, diffusion coefficients obtained by the electrochemical method are larger than those by the time-lag method by an order of magnitude or more. These differences are attributed mainly to hydrogen trapping.

Danford, M. D.↗

A model of the diffuse galactic gamma ray emission

The galaxy was observed to be a source of high energy gamma rays as shown by the two successful satellite experiments, SAS-2 and COS-B. It is generally understood that these diffuse gamma rays result from interactions between energetic cosmic rays and interstellar gas. This work makes use of the most recent data on the distribution of atomic and molecular hydrogen in the galaxy along with new estimates of gamma ray production functions to model the diffuse galactic gamma ray emission. The model allows various spatial distributions for cosmic rays in the Galaxy including non-axisymmetric ones. In the light of the expected data from EGRET (Energetic Gamma-Ray Experiment Telescope), an improved model of cosmic ray-matter-gamma ray interaction will provide new insights into the distribution of cosmic rays and the strength of its coupling to matter.

Sreekumar, Parameswaran↗