Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “rapid”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,099 records · Page 61
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

On the coronae of rapidly rotating stars. II - A period-activity relation in G stars

Observational evidence supporting the contention that coronal activity in G stars obeys the same relation with angular velocity as that observed in RS CVn systems is presented. It is found, however, that the level of the quiescent coronal activity, as measured by the ratio of the X-ray luminosity to the bolometric luminosity, at a given angular velocity is approximately one order of magnitude lower in G stars than in the RS CVn systems. Data on additional K stars indicate that these stars are indistinguishable from the K components of RS CVn systems. No evidence is found that the surface gravity has any appreciable effect on the level of coronal activity. The observation that the ratio of the X-ray luminosity to the bolometric luminosity is directly proportional to the product of the angular velocity and some function of the depth of the convective zone is seen as supporting a dynamo mechanism for the generation of the stellar magnetic flux.

Walter, F. M.↗
NASA NTRS1951

An Empirical Method Permitting Rapid Determination of the Area, Rate and Distribution of Water-Drop Impingement on an Airfoil of Arbitrary Section at Subsonic Speeds

An empirical method for the determination of the area, rate, and distribution of water-drop impingement on airfoils of arbitrary section is presented. The procedure represents an initial step toward the development of a method which is generally applicable in the design of thermal ice-prevention equipment for airplane wing and tail surfaces. Results given by the proposed empirical method are expected to be sufficiently accurate for the purpose of heated-wing design, and can be obtained from a few numerical computations once the velocity distribution over the airfoil has been determined. The empirical method presented for incompressible flow is based on results of extensive water-drop. trajectory computations for five airfoil cases which consisted of 15-percent-thick airfoils encompassing a moderate lift-coefficient range. The differential equations pertaining to the paths of the drops were solved by a differential analyzer. The method developed for incompressible flow is extended to the calculation of area and rate of impingement on straight wings in subsonic compressible flow to indicate the probable effects of compressibility for airfoils at low subsonic Mach numbers.

Bergrun, N. R.↗
NASA NTRS1982

The structure and properties of rapidly solidified high alloy aluminum materials

A series of 2024 type aluminum alloys modified by additions of 1 to 2% Li were studied to determine the role of the Cu:Li and the (Cu + Mg):Li ratios on resultant strength, ductility, notch-tensile behavior, and crack propagation rates. Ultrasonically gas atomized powders with quench rates of 10 to 100 thousand degrees/s were atomized in an argon atmosphere, producing yields of powder such that almost 100% was finer than 250 microns. The powders are free of gases and porosity, are quite spherical, have few satellites (adhering fine powder particles) and are of uniform microstructure. Strength properties are such that yield strength is 20% greater than for lithium-free 2024 ingot alloy, tensile strength is 10% greater than that of 2024 ingot material, and ductilities are comparable. In terms of specific strength and specific modulus, these RS 2024-Li alloys are significantly better than IM 2024.

Grant, N. J.↗
NASA NTRS1980

Detection of heavy convective precipitation using rapid interval digital radar and satellite data

A study was carried out to investigate the evolution of thunderstorms with short-interval (5 min) geosynchronous digital satellite data and with digital radar data (12 min interval) in order to determine the potential and limitations of using the satellite data to detect regions of heavy convective precipitation. Initial results indicate that satellite-based estimates of thunderstorm updraft intensity are related to storm precipitation rate as indicated in the digital radar data. The conclusions give support to the effort to use satellite data for detection of heavy convective precipitation, but emphasize the need for high time resolution (5 min) data.

Negri, A. J.↗
NASA NTRS1981

Laser electro-optic system for rapid three-dimensional /3-D/ topographic mapping of surfaces

It is pointed out that the generic utility of a robot in a factory/assembly environment could be substantially enhanced by providing a vision capability to the robot. A standard videocamera for robot vision provides a two-dimensional image which contains insufficient information for a detailed three-dimensional reconstruction of an object. Approaches which supply the additional information needed for the three-dimensional mapping of objects with complex surface shapes are briefly considered and a description is presented of a laser-based system which can provide three-dimensional vision to a robot. The system consists of a laser beam array generator, an optical image recorder, and software for controlling the required operations. The projection of a laser beam array onto a surface produces a dot pattern image which is viewed from one or more suitable perspectives. Attention is given to the mathematical method employed, the space coding technique, the approaches used for obtaining the transformation parameters, the optics for laser beam array generation, the hardware for beam array coding, and aspects of image acquisition.

Altschuler, M. D.↗
NASA NTRS1981

On the dust zoning of rapidly rotating cometary nuclei

The effects of nuclear rotation on the surface of a cometary nucleus (a comet at 1 AU that is H2O dominated and has a radius of 1 km) are considered. It is shown that this dust does not accumulate uniformly on the surface, which here is considered spherical. While dust particles in the two polar cap regions and an equatorial belt remain at rest on the surface, those in two midlatitude bands migrate toward the equator, stopping at the two low latitudes to form dust ridges. As the nucleus spins up, both the polar caps and the equatorial belt shrink in size, and the dust ridges move toward the equator, eventually spinning off the dust from the nucleus when the nuclear rotation period is less than about 3.3 hr. For larger particles for which the gas buoyancy is negligible, migration takes place only if the rotation period is not significantly larger than the critical value of 3.3 hr or if the surface friction is abnormally small.

Houpis, H. L. F.↗
NASA NTRS1981

Rapid X-ray and optical flares from Scorpius X-1

A 1 second time structure in X-ray flares from Sco X-1 and simultaneous optical flares with time structures no faster than 20 s are reported. The shortest reported time scale in the X-ray emission from Sco X-1 is decreased by a factor of 10, while remaining consistent with the parameters of the standard plasma model from Sco X-1. Different mechanisms for the production of X-ray flares and optical flares are suggested, and the production of optical flares by reprocessing on the surface of the binary companion of Sco X-1 is ruled out by the X-ray/optical flare time delay.

Petro, L. D.↗
NASA NTRS1981

Image tube spectroscopic studies of rapid variables. IV - Spectroscopic and photometric observations of AE Aquarii

Photoelectric and time-resolved spectroscopic observations of the short-period eruptive binary AE Aqr are presented. The system has a period of 0.4116537 days, and emission and absorption-line components equal to 135 km/sec and 159 km/sec, respectively. The spectral type of the absorption-line component is found to be K5V, from which M1 = 0.82 solar mass, M2 = 0.69 solar mass, and i = 64 deg. A predominantly Ca II emission region occurs on the hemisphere of the K5V star facing the broad emission-line component, whose center of light is located 0.64 of the way from the inner Lagrangian point to the center of mass of the K star. This emission appears to be associated with the transfer of mass from the K5V star to the accretion disk surrounding the primary. In the absence of flare activity, the light of the system is variable in the orbital period with a range in V of about 0.16 mag; maxima occurs near the times of maximum recession velocity and during the approach of each of the two components of the system (0.25 P and 0.80 P).

Chincarini, G.↗
NASA NTRS1982

On the coronae of rapidly rotating stars. III - An improved coronal rotation-activity relation in late type dwarfs

While it has previously been claimed that X-ray luminosity, or surface flux, varies as a power of the rotational velocity in G dwarfs, it is demonstrated that a single power law does not provide an acceptable fit to all the data. The data are describable by a power law, with a break in slope near a 12-day period which occurs at the same rotational period as the bifurcation in Vaughan and Preston's (1980) chromospheric study of G dwarfs. It is speculated that the two breaks are both related and due to a change in the stellar dynamo mode, which, at a rotation period of 12 days, corresponds to an age of one billion years for single G dwarfs.

Walter, F. M.↗
NASA NTRS1982

Subsonic 3-D surface panel method for rapid analysis of multiple geometry perturbations

For any baseline aircraft configuration, a matrix of partial derivatives of surface velocity potential with respect to geometry coordinates is calculated. Linear extrapolation is then used to analyze the subcritical potential flow corresponding to a series of arbitrary small geometry perturbations. Each perturbation analysis is more than an order of magnitude more efficient than a conventional panel method solution because no influence coefficients are calculated and no large system of linear algebraic equations is solved. Wing and wing-fuselage examples are presented to demonstrate that the predicted pressure distributions are nearly exact for large changes to wing camber, thickness, and leading edge radius.

Bristow, D. R.↗
NASA NTRS1982

Rapid approximate determination of nonlinear solutions - Application to aerodynamic flows and design/optimization problems

Stahara et al. (1978) have considered the use of an approximation technique which employs two or more nonlinear base solutions determined by the full computational method to predict entire families of related nonlinear solutions. The present investigation provides results for several applications of that method which demonstrate both its accuracy and its utility for engineering applications. Attention is given to the perturbation concept and methods, aspects of coordinate straining, aspects of analytical formulation, and an application to surface properties. In a discussion of the results, single and multiple parameter perturbations are considered along with a combination of the approximation method with optimization procedures. The results show that it is possible to combine in certain cases large savings in computational cost with improved optimization.

Stahara, S. S.↗
NASA NTRS1982

Rapid perceptual adaptation to high gravitoinertial force levels Evidence for context-specific adaptation

Subjects exposed to periodic variations in gravitoinertial force (2-G peak) in parabolic flight maneuvers quickly come to perceive the peak force level as having decreased in intensity. By the end of a 40-parabola flight, the decrease in apparent force is approximately 40%. On successive flight days, the apparent intensity of the force loads seems to decrease as well, indicating a cumulative adaptive effect. None of the subjects reported feeling abnormally 'light' for more than a minute or two after return to 1-G background force levels. The pattern of findings suggests a context-specific adaptation to high-force levels.

Lackner, J. R.↗
NASA NTRS1984

Rapid Circuit Breadboarding

Cost of one-of-a-kind circuit board reduced. Circuits assembled quickly by using prototyping board in conjunction with copper-clad circuit board that has same hole pattern.

Ethridge, E. C.↗
NASA NTRS1984

Furnace for Rapid Heating and Cooling

Furnace heats specimen to above 1,200 degrees C and then cools it to below 900 degrees C in just a few minutes. Compressed solid reactant provides heat; liquid carbon dioxide provides cold.

Poorman, R. M.↗
NASA NTRS1984

Preventing Motor Damage Due to Rapid Reversal

Reversal switch takes more time to operate, allows gentler deceleration before reversal. Switch requires both twisting and pulling motion, giving motor time to decelerate gradually.

Fetters, R.↗
NASA NTRS1983

Rapid X-ray variability from the Seyfert 1 Galaxy NGC 4051

Strong variable X-ray emission from the nearby low luminosity Seyfert 1 galaxy NGC 4051 was discovered during observations with the imaging proportional counter of the Einstein Observatory. During one 2304 second observation, the X-ray flux more than doubled in an approximately linear fashion, and a 70% increase for 150 seconds was seen during another 968 second observation. Evidence is presented which demonstrates that the X-ray spectrum of NGC 4051 is unusually soft compared to Seyfert 1 galaxies or QSOs. The emission mechanism is probably not synchrotron or synchrotron self-Compton, but the emission can be plausibly explained by various black hole accretion models.

Marshall, F. E.↗
NASA NTRS1978

Rapid, quantitative determination of bacteria in water

A bioluminescent assay for ATP in water borne bacteria is made by adding nitric acid to a water sample with concentrated bacteria to rupture the bacterial cells. The sample is diluted with sterile, deionized water, then mixed with a luciferase-luciferin mixture and the resulting light output of the bioluminescent reaction is measured and correlated with bacteria present. A standard and a blank also are presented so that the light output can be correlated to bacteria in the sample and system noise can be substracted from the readings. A chemiluminescent assay for iron porphyrins in water borne bacteria is made by adding luminol reagent to a water sample with concentrated bacteria and measuring the resulting light output of the chemiluminescent reaction.

Chappelle, E. W.↗