SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Techniques are presented for detecting and correcting errors in a vector field. These methods employ median filters which are frequently used in image processing to enhance edges and remove noise. A detailed example is given for wind field maps produced by a spaceborne scatterometer. The error detection and replacement algorithm was tested with simulation data from the NASA Scatterometer (NSCAT) project.
Scalar and vector Magsat anomalies over the west African craton are analyzed by forward and inverse models. A forward model of the Man shield is based on Liberia. Induced magnetization contrasts due to sporadic iron-formations and to regional metamorphic rocks, and a contrast in remanent magnetization within the lower crust are included. This combination reproduces the location, magnitude and adopted local zero level of anomalies in the initial Magsat maps. An inverse model of the Reguibat shield estimates the magnetization contrast of its lithosphere, and when magnetism is restricted to shallower than 75 km both shields can be represented by a susceptibility contrast of +0.02. A residual anomaly between the shields involves a relative deficiency of induced magnetization along with other causes.
The hardware and software characteristics of a time division multiplex system are described. The system is used to sample analog and digital data. The data is merged with synchronization information to produce a serial pulse coded modulation (PCM) bit stream. Information presented herein is required by users to design compatible interfaces and assure effective utilization of this encoder system. GSFC/Wallops Flight Facility has flown approximately 50 of these systems through 1984 on sounding rockets with no inflight failures. Aydin Vector manufactures all of the components for these systems.
An implicit finite volume method is investigated for the solution of the compressible Navier-Stokes equations for flows within thrust reversing and thrust vectoring nozzles. Thrust reversing nozzles typically have sharp corners, and the rapid expansion and large turning angles near these corners are shown to cause unacceptable time step restrictions when conventional approximate factorization methods are used. In this investigation these limitations are overcome by using second-order upwind differencing and line Gauss-Siedel relaxation. This method is implemented with a zonal mesh so that flows through complex nozzle geometries may be efficiently calculated. Results are presented for five nozzle configurations including two with time varying geometries. Three cases are compared with available experimental data and the results are generally acceptable.
A parametric investigation of the static internal performance of multifunction two-dimensional convergent-divergent nozzles has been made in the static test facility of the Langley 16-Foot Transonic Tunnel. All nozzles had a constant throat area and aspect ratio. The effects of upper and lower flap angles, divergent flap length, throat approach angle, sidewall containment, and throat geometry were determined. All nozzles were tested at a thrust vector angle that varied from 5.60 tp 23.00 deg. The nozzle pressure ratio was varied up to 10 for all configurations.
A vector-based failure detection and isolation technique for a skewed array of two degree-of-freedom inertial sensors is developed. Failure detection is based on comparison of parity equations with a threshold, and isolation is based on comparison of logic variables which are keyed to pass/fail results of the parity test. A multi-level approach to failure detection is used to ensure adequate coverage for the flight control, display, and navigation avionics functions. Sensor error models are introduced to expose the susceptibility of the parity equations to sensor errors and physical separation effects. The algorithm is evaluated in a simulation of a commercial transport operating in a range of light to severe turbulence environments. A bias-jump failure level of 0.2 deg/hr was detected and isolated properly in the light and moderate turbulence environments, but not detected in the extreme turbulence environment. An accelerometer bias-jump failure level of 1.5 milli-g was detected over all turbulence environments. For both types of inertial sensor, hard-over, and null type failures were detected in all environments without incident. The algorithm functioned without false alarm or isolation over all turbulence environments for the runs tested.
The stiffness-matrix formulation for the rectangular finite element described by Melosh (1963) and Weaver and Johnston (1984) is generalized to orthotropic materials with material axes not necessarily coincident with the x and y axes; i.e., the condition d(13) = d(23) = 0 is removed. Also included are explicit expressions for the element load vector associated with nonuniform temperature increase in the element. Applications to the analysis of thermal stresses in thin Si-crystal ribbons subjected to temperature changes with highly nonuniform lengthwise and transverse gradients (Utku et al., 1986) and to the simulation of the thermoviscoelastic behavior of growing Si ribbons (Utku and Ray, 1986) are indicated.
In this paper, an algorithm is presented for image data compression based upon vector quantization of the two-dimensional discrete cosine transformed coefficients. The ac energies of the transformed blocks are used to classify them into eight different ac classes. The ac coefficients of the transformed blocks of class one are set to zero, while those of classes two through eight are transmitted by seven different code books. The dc coefficients of all eight classes are scalar quantized by an adaptive uniform quantizer. As a result, only 4.5 bits instead of eight bits are required to transmit the dc coefficient with negligible additional degradation. Overall, this algorithm requires approximately 0.75 bits per pixel and gives an average reconstruction error of 7.1.
The magnetic and dynamical circumstances leading to the 1B/M4 flare of November 5, 1980 are studied, and a strong association is found between the buildup of magnetic shear and the onset of flare activity within the active region. The development of shear, as observed directly in vector magnetograms, is consistent in detail with the dynamical history of the active region and identifies the precise location of the optical and hard-X-ray kernels of the flare emission.
The changes that occur in measured magnetic fields when they are transformed into a heliographic coordinate system are investigated. To carry out this investigation, measurements of the vector magnetic field of an active region that was observed at 1/3 the solar radius from disk center are taken, and the observed field is transformed into heliographic coordinates. Differences in the calculated potential field that occur when the heliographic normal component of the field is used as the boundary condition rather than the observed line-of-sight component are also examined. The results of this analysis show: (1) that the observed fields of sunspots more closely resemble the generally accepted picture of the distribution of umbral fields if they are displayed in heliographic coordinates; (2) that the differences in the potential calculations are less than 200 G in field strength and 20 deg in field azimuth outside sunspots; and (3) that differences in the two potential calculations in the sunspot areas are no more than 400 G in field strength but range from 60 to 80 deg in field azimuth in localized umbral areas.
The Van Leer method of flux-vector splitting for the Euler equations is extended for use on moving meshes and all the properties of the original splittings are maintained. The solution is advanced in time with an implicit, approximately factored algorithm. The use of multiple grids to reduce the computer time is investigated. A substantial reduction in computer time to resolve a pitching cycle is easily obtained with virtually no loss in accuracy. A subiterative procedure to eliminate factorization and linearization errors so that larger time steps can be used is also investigated. Subsequent computations show good agreement with experimental data for transonic and supersonic airfoils and wings undergoing forced pitching oscillation.
Transonic wind tunnel tests are conducted to determine the flow-turning capabilities and nozzle internal performance of axisymmetric and nonaxisymmetric nozzles employing postexit vanes for multiaxis thrust-vectoring. The geometric parameters investigated for the axisymmetric nozzle installation were number of vanes, vane curvature, vane location relative to nozzle exit, and vane deflection angle; for the nonaxisymmetric cases, the parameters were vane planform and curvature, nozzle type, and nozzle exit aspect ratio. Nozzle pressure ratio was varied from 1.5 to 6.0, using high pressure air.
The design and implementation of a digital (numerical) optical matrix-vector multiplier are presented. The objective is to demonstrate the operation of an optical processor designed to minimize computation time in performing a practical computing application. This is done by using the large array of processing elements in a Hughes liquid crystal light valve, and relying on the residue arithmetic representation, a holographic optical memory, and position coded optical look-up tables. In the design, all operations are performed in effectively one light valve response time regardless of matrix size. The features of the design allowing fast computation include the residue arithmetic representation, the mapping approach to computation, and the holographic memory. In addition, other features of the work include a practical light valve configuration for efficient polarization control, a model for recording multiple exposures in silver halides with equal reconstruction efficiency, and using light from an optical fiber for a reference beam source in constructing the hologram. The design can be extended to implement larger matrix arrays without increasing computation time.
The class of all linear predictors of minimal order for a stationary vector-valued process is specified in terms of linear transformations on the associated Hankel covariance matrix. Two particular transformations, yielding computationally efficient construction schemes, are proposed.
The Stochastically Excited Linear Prediction (SELP) algorithm is described as a speech coding method employing a two-stage vector quantization. The first stage uses an adaptive codebook which efficiently encodes the periodicity of voiced speech, and the second stage uses a stochastic codebook to encode the remainder of the excitation signal. The adaptive codebook performs well when the pitch period of the speech signal is larger than the frame size. An extension is introduced, which increases its performance for the case that the frame size is longer than the pitch period. The performance of the stochastic stage, which improves with frame length, is shown to be best in those sections of the speech signal where a high level of short-term correlations is present. It can be concluded that the SELP algorithm performs best during voiced speech where the pitch period is longer than the frame length.
Excellent results for optimization of one all-reflective system are gained by choosing a limited number of variables as indicated by vector aberration theory. An aberration analysis shown here can be used to extend the method to other systems.
Two-dimensional subsonic laminar compressible base flow has been studied using numerical solutions of the time-dependent Navier-Stokes equations. These solutions were obtained using an explicit finite-difference scheme which is highly efficient on a vector processor. The organization of the code for a CDC CYBER-205 computer is described. Solutions were obtained for Mach 0.4 and 0.6 flows past a slender blunt-based model at moderately high Reynolds numbers. The flow in the wake is unsteady with periodic shedding of vortices from the trailing edge. The computed shedding frequency was found to increase with increasing Reynolds number.
The design and implementation of a digital (numerical) optical matrix-vector multiplier are presented. A Hughes liquid crystal light valve, the residue arithmetic representation, and a holographic optical memory are used to construct position coded optical look-up tables. All operations are performed in effectively one light valve response time with a potential for a high information density.