Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “VAPOR PRESSURE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,099 records · Page 61

An equation of state for oxygen and nitrogen

Recent measurements of thermodynamic properties of oxygen and nitrogen have provided data necessary for development of a single equation of state for both fluids. Data are available in summary report and two-part detailed study on thermodynamic properties of oxygen and nitrogen. Same data are used to develop vapor-pressure equation and heat-capacity equation.

Jacobsen, R. T.↗

Determination of contamination character of materials in space technology testing

The contamination character of selected materials used in space technology testing is presented. Many of these materials contain components that become volatile in a space environment. Most previous data were limited to weight loss or vapor pressure. However, these parameters are not necessarily a direct measure of the contamination character of these materials. Selected materials were exposed to a thermal-vacuum environment, and the degree of contamination was measured by collecting the outgases from these materials on a cold test mirror surface. The degradation of reflectivity of the mirror was measured over a spectral range from 1100 A to 2.5 microns. Half the mirror's surface was also exposed to UV irradiation to determine its effects on the contaminative character of the depositing outgases. The amount of deposit per unit area was measured by microbalances mounted near the mirror; the sensor of one microbalance was UV irradiated. A quadrupole mass spectrometer was used to determine the composition of the outgases.

Haynes, D. L.↗

Startup analysis for a high temperature gas loaded heat pipe

A model for the rapid startup of a high-temperature gas-loaded heat pipe is presented. A two-dimensional diffusion analysis is used to determine the rate of energy transport by the vapor between the hot and cold zones of the pipe. The vapor transport rate is then incorporated in a simple thermal model of the startup of a radiation-cooled heat pipe. Numerical results for an argon-lithium system show that radial diffusion to the cold wall can produce large vapor flow rates during a rapid startup. The results also show that startup is not initiated until the vapor pressure p sub v in the hot zone reaches a precise value proportional to the initial gas pressure p sub i. Through proper choice of p sub i, startup can be delayed until p sub v is large enough to support a heat-transfer rate sufficient to overcome a thermal load on the heat pipe.

Sockol, P. M.↗

Cold trap fractionation as an organic analysis technique.

A highly simplified, alternate approach to the gas chromatograph-mass spectrometer has been developed. In this approach, a low temperature trap replaces the entire GC portion of the combined GC-MS instrument and no carrier gas is necessary. Using the cold trap technique, the sample is first passed into a chilled trap. Depending on the trap temperature, many compounds are condensed or trapped out (most at -196 C). Those which are not, such as helium, neon, and nitrogen, pass through the trap directly into the spectrometer for analysis. Then the trap is programmed to increase in temperature at an appropriate rate. This allows evaporation (or sublimation) of the trapped materials according to the specific vapor pressure characteristics of the compound, providing some temporal separation between constituents. These partially resolved components are directed to the MS as they evolve from the trap.

Crosmer, W. E.↗

Heat-transfer thermal switch

Thermal switch maintains temperature of planetary lander, within definite range, by transferring heat. Switch produces relatively large stroke and force, uses minimum electrical power, is lightweight, is vapor pressure actuated, and withstands sterilization temperatures without damage.

Friedell, M. V.↗

Lamp pumped Nd:YAG laser. Space-qualifiable Nd:YAG laser for optical communications

Results are given of a program concerned with the design, fabrication, and evaluation of alkali pump lamps for eventual use in a space qualified Nd:YAG laser system. The study included evaluation of 2mm through 6mm bore devices. Primary emphasis was placed upon the optimization of the 4mm bore lamp and later on the 6mm bore lamp. As part of this effort, reference was made to the Sylvania work concerned with the theoretical modeling of the Nd:YAG laser. With the knowledge gained, a projection of laser performance was made based upon realistic lamp parameters which should easily be achieved during following developmental efforts. Measurements were made on the lamp performance both in and out of the cavity configuration. One significant observation was that for a constant vapor pressure device, the spectral and fluorescent output did not vary for vacuum or argon environment. Therefore, the laser can be operated in an inert environment (eg. argon) with no degradation in output. Laser output of 3.26 watts at 430 watts input was obtained for an optimized 4mm bore lamp.

Ward, K. B.↗

Role of physical properties of liquids in cavitation erosion

The dependence of erosion rates on the ambient temperature of water is discussed. The assumption that the gas inside the bubble is compressed adiabatically during collapse gives better agreement with experiments than the assumption that the gas is isothermally compressed. Acoustic impedance is an important liquid parameter that governs the erosion intensity in vibratory devices. The investigation reveals that the major physical properties of liquids governing the intensity of erosion include density, sound speed, surface tension, vapor pressure, gas content, and nuclei distribution.

Thiruvengadam, A.↗

Grain boundary mobility in anion doped MgO

Certain anions OH(-), F(-) and Gl(-) are shown to enhance grain growth in MgO. The magnitude of their effect decreases in the order in which the anions are listed and depends on their location (solid-solution, second phase) in the MgO lattice. As most anions exhibit relatively high vapor pressures at sintering temperatures, they retard densification and invariably promote residual porosity. The role of anions on grain growth rates was studied in relation to their effect on pore mobility and pore removal; the atomic process controlling the actual rates was determined from observed kinetics in conjunction with the microstructural features. With respect to controlling mechanisms, the effects of all anions are not the same. OH(-) and F(-) control behavior through creation of a defect structure and a grain boundary liquid phase while Cl(-) promotes matter transport within pores by evaporation-condensation. Studies on an additional anion, S to the minus 2nd power gave results which were no different from undoped MgO, possibly because of evaporative losses during hot pressing. Hence, the effect of sulphur is negligible or undetermined.

Kapadia, C. M.↗

Beading and spiking phenomena in the M551 metals melting experiment

A study was made regarding the beading and spiking phenomena observed in the M551 metals melting experiment conducted during the Skylab I mission in June 1973. An analysis was made of the beading phenomenon based on the Karman vortex shedding theory. The results tend to support the hypothesis that beading which occurred in the stainless and tantalum samples was a Karman vortex street formation. A dynamic model of cavity oscillation is discussed to explain the spiking phenomenon which was observed in the stainless steel and tantalum samples. Calculations of spiking frequency indicate that the intensity of spiking depends primarily on the vapor pressure and surface tension properties of the material, and is only slightly affected by the level of gravitation acceleration.

Fan, C.↗

Opportunities for space surveys of moisture anomalies

Review of a combination of infrared scanning, unsupervised spectroscopic classification, change detection, and perturbation spectroscopy for monitoring anomalous moisture exchange from space. Infrared sensors have been developed which can monitor the solar reflectance from droplet distributions in vegetation and clouds, the absorption of thermal radiation by water vapor, and the microwave attenuation by atmospheric water. Unsupervised spectroscopic classification techniques are emerging which have the potential to subdivide strip maps from infrared scanners into different moisture targets. Intersecting and parallel spacecraft orbits provide opportunities to study the change of recognized targets between two scans and to recognize anomalous moisture exchange from those changes which significantly exceed the statistical uncertainty of the spectroscopic target signature. The new concept of perturbation spectroscopy shows a potential to quantitatively determine the change of integrated water vapor pressure with a minimum of 'atmospheric truth' and with low spectroscopic resolution that is typical of simple interference filters.

Krause, F. R.↗

Manganese laser using manganese chloride as lasant

A manganese vapor laser utilizing manganese chloride as a lasant has been observed and investigated. Lasing is attained by means of two consecutive electrical discharges. The maximum laser output is obtained at a vapor pressure of about 3 torr, a temperature of 680 C, and a time delay between electrical discharges of 150 microsec. The maximum energy density is 1.3 microjoule per cu cm.

Chen, C. J.↗

The effect of temperature induced surface tension gradients on bubble mechanics

Experiments were conducted to examine in detail the influence of surface tension gradient induced flow, the Marangoni effect. One set of studies provided visual results that demonstrated the occurrence and magnitude of the Marangoni effect. Another portion of the work was directed to bubble force measurements. These studies used in deflection of a very fine cantilevered wire with an attached bubble as a means of measuring force with and without temperature gradients. The experimental force data were found to check existing theoretical predictions reasonably well except for the case where the test fluid had a sizeable vapor pressure. In this situation the thermophoretic force on the bubble was much higher than predicted.

Mcgrew, J. L.↗

Emission spectrometric arcing procedure with minimal effect of chemical form of sample

Matrix effects related to the chemical form of analyzed materials were studied. An arc in argon was used which was buffered with silver chloride. The effect of chemical form was minimal for a variety of metals, oxides, and carbides representing the most refractory compounds and thermally stable metal-containing molecules. Only four of the most refractory materials known showed significant emission depressions due to incomplete volatilization in the arc system. These results are discussed in terms of vapor pressures of the solid materials placed on the anodes and dissociation reactions of the molecules in the gaseous environment.

Gordon, W. A.↗

Ice particulates in the mesosphere

The observations of noctilucent clouds, the measurements of hydrated and of large immobile ions, and the light-scattering layer detected by the OGO-6 satellite suggest the presence of particulates, probably ice, in the mesosphere. The correlation between temperature and positive ion conductivity where the vapor pressure over ice becomes greater than atmospheric pressure in the stratopause region indicates the presence of ice crystals throughout the mesosphere over a wide range of latitudes during all seasons. Between one and ten billion ice crystals per cubic meter of order 10 nanometers in diameter can dominate ionization loss processes in the mesosphere, and can explain a variety of experimental observations, including observed solar angle dependence and seasonal variability of electron density.

Chesworth, E. T.↗

Forearm blood flow during body temperature transients produced by leg exercise

Subjects exercised for 30 min on a bicycle ergometer at 30, 50, and 70% of maximal aerobic power in ambient temperatures of 15, 25, and 35 C and vapor pressures of less than 18 torr. Exercise was used to vary internal temperature during an experiment, and different ambient temperatures were used to vary skin temperatures independently of internal temperature. Forearm skin temperature was fixed at about 36.5 C. Esophageal temperature was measured with a thermocouple at the level of the left atrium, and mean skin temperature was calculated from a weighted mean of thermocouple temperatures at eight skin sites. Forearm blood flow was measured by electrocapacitance plethysmography. Data are well accounted for by a linear equation independent of exercise intensity, although some subjects showed an equivocal vasodilator effect of exercise.

Wenger, C. B.↗

Edge-defined film-fed growth of beta-alumina and Mg-substituted beta-alumina

High Na vapor pressure, peritectic decomposition, and high reactivity of the melt complicate the growth of beta-alumina crystals. These difficulties were overcome by using a high-pressure (300 psig) growth chamber, Na2O-rich melts, and Ir for all surfaces in contact with the melt. These procedures were combined with the edge-defined film-fed growth technique to produce single-crystal beta-alumina tubes and ribbons.

Morrison, A. D.↗

Stimulated Stokes emission with a dye laser - Intense tuneable radiation in the infrared

Tunable stimulated Stokes emission is generated at approximately 2.9 microns in barium vapor with an oscillator-amplifier dye laser. The conversion efficiency is as high as 40% and the energy output as high as 30 mJ. The emission is tuneable over about 100 wavenumbers. At high vapor pressures the tuning profile is markedly asymmetric.

Carlsten, J. L.↗

Release of volatile mercury from vascular plants

Volatile, organic solvent soluble mercury has been found in leaves and seeds of several angiosperms. Leaves of garlic vine, avocado, and haole-koa release mercury in volatile form rapidly at room temperature. In garlic vine, the most active release is temperature dependent, but does not parallel the vapor-pressure temperature relationship for mercury. Mercury can be trapped in nitric-perchloric acid digestion fluid, or n-hexane, but is lost from the hexane unless the acid mixture is present. Seeds of haole-koa also contain extractable mercury but volatility declines in the series n-hexane (90%), methanol (50%), water (10%). This suggests that reduced volatility may accompany solvolysis in the more polar media.

Siegel, S. M.↗