Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “methods: analytical methods”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,081 records · Page 60
All sourcesNASA NTRSDOE OSTI
NASA NTRS1984

Electrical self-calibration of nonideal bolometers

An analytical method for determining the absorbed energy calibration of an IR bolometer from purely electrical measurements is presented. The technique is targeted at detectors with purely electrical nonlinearities. It is shown that the responsivity can be derived from the I-V plot if the limiting high-frequency impedance is measured. The electrical nonlinearity is then the difference between the impedance and the dc resistance. The model is used for designing a circuit for measuring the relative impedance parameters. The results are applicable to studies of IR sources and the detection of energy pulses with bolometers.

Mather, J. C.↗
NASA NTRS1985

Resin Characterization in Cured Composite Materials

Molecular-level characterization of polymeric matrix resin in cured graphite-reinforced composite materials now determined through analysis of diffuse reflectance (DR) with Fourier Transform Infrared (FTIR) spectroscopy. Improved analytical method based on diffuse reflectance. DR/ FTIR technique successfully applied to analysis of several different composites and adhesives impossible to analyze by conventional methods.

Young, P. R.↗
NASA NTRS1985

The space shuttle ascent vehicle aerodynamic challenges configuration design and data base development

The phase B Space Shuttle systems definition studies resulted in a generic configuration consisting of a delta wing orbiter, and two solid rocket boosters (SRB) attached to an external fuel tank (ET). The initial challenge facing the aerodynamic community was aerodynamically optimizing, within limits, this configuration. As the Shuttle program developed and the sensitivities of the vehicle to aerodynamics were better understood the requirements of the aerodynamic data base grew. Adequately characterizing the vehicle to support the various design studies exploded the size of the data base to proportions that created a data modeling/management challenge for the aerodynamicist. The ascent aerodynamic data base originated primarily from wind tunnel test results. The complexity of the configuration rendered conventional analytic methods of little use. Initial wind tunnel tests provided results which included undesirable effects from model support tructure, inadequate element proximity, and inadequate plume simulation. The challenge to improve the quality of test results by determining the extent of these undesirable effects and subsequently develop testing techniques to eliminate them was imposed on the aerodynamic community. The challenges to the ascent aerodynamics community documented are unique due to the aerodynamic complexity of the Shuttle launch. Never before was such a complex vehicle aerodynamically characterized. The challenges were met with innovative engineering analyses/methodology development and wind tunnel testing techniques.

Dill, C. C.↗
NASA NTRS1984

Aerodynamic heating rate distributions induced by trailing edge controls on hypersonic aircraft configurations at Mach 8

Aerodynamic surface heating rate distributions in three dimensional shock wave boundary layer interaction flow regions are presented for a generic set of model configurations representative of the aft portion of hypersonic aircraft. Heat transfer data were obtained using the phase change coating technique (paint) and, at particular spanwise and streamwise stations for sample cases, by the thin wall transient temperature technique (thermocouples). Surface oil flow patterns are also shown. The good accuracy of the detailed heat transfer data, as attested in part by their repeatability, is attributable partially to the comparatively high temperature potential of the NASA-Langley Mach 8 Variable Density Tunnel. The data are well suited to help guide heating analyses of Mach 8 aircraft, and should be considered in formulating improvements to empiric analytic methods for calculating heat transfer rate coefficient distributions.

Kaufman, L. G., II↗
NASA NTRS1985

Thrust chamber life prediction

The reusable life of the Space Shuttle main engine (SSME) is influenced by the cyclic life of the regeneratively liquid cooled main combustion chamber (MCC). During an operational duty cycle the MCC liner is subjected to a large transient thermal gradient that imparts a high thermal cyclic strain to the liner hot gas wall. Life predictions of such chambers have usually been based on low cycle fatigue (LCF) evaluations. Hot-fire testing, however, has shown significant mid-channel wall deformation and thinning during accrued cyclic testing. This phenomenon is termed cyclic creep and appears to be significantly accelerated at elevated temperatures. An analytical method that models the cyclic creep phenomenon and its application to thrust chamber life prediction is presented. The chamber finite element geometry is updated periodically to account for accrued wall thinning and distortion. Failure is based on the tensile instability failure criterion. Cyclic life results for several chamber life enhancing coolant channel designs are compared to the typically used LCF analysis that neglects cyclic creep. The results show that the usable cyclic creep life is approximately 30 to 50% of the commonly used LCF life.

Kasper, H. J.↗
NASA NTRS1985

Fault detection and accommodation testing on an F100 engine in an F-15 airplane

The fault detection and accommodation (FDA) methodology for digital engine-control systems may range from simple comparisons of redundant parameters to the more complex and sophisticated observer models of the entire engine system. Evaluations of the various FDA schemes are done using analytical methods, simulation, and limited-altitude-facility testing. Flight testing of the FDA logic has been minimal because of the difficulty of inducing realistic faults in flight. A flight program was conducted to evaluate the fault detection and accommodation capability of a digital electronic engine control in an F-15 aircraft. The objective of the flight program was to induce selected faults and evaluate the resulting actions of the digital engine controller. Comparisons were made between the flight results and predictions. Several anomalies were found in flight and during the ground test. Simulation results showed that the inducement of dual pressure failures was not feasible since the FDA logic was not designed to accommodate these types of failures.

Myers, L. P.↗
NASA NTRS1985

Numerical Descriptions of Cosmic-Ray Transport

The behavior of energetic particles in the solar system is described by a well known Fokker-Planck equation. Although analytic methods yield insight into the nature of its solutions, especially in the diffusion regime, calculations that go beyond diffusion are very complicated. The reliability of these calculations is of concern, because numerical methods are notorious for their errors and artifacts. The well known Milne problem of classical transport theory was analyzed with the aid of three different numerical methods. These are: (1) The method of eigenfunctions in which the distribution function is approximated by a sum of eigenfunctions of the scattering operator, (2) Numerical solutions of a finite difference aquation; and (3) Direct simulation of the scattering and streaming of individual particles with the aid of Monte Carlo methods.

Earl, J. A.↗
NASA NTRS1985

Range fluctuations of high energy muons passing through matter

The information about energy spectrum of sea level muons at high energies beyond magnetic spectrographs can be obtained from the underground intensity measurements if the fluctuations problems are solved. The correction factor R for the range fluctuations of high energy muons were calculated by analytical method of Zatsepin, where most probable energy loss parameter are used. It is shown that by using the R at great depth together with the slope, lambda, of the vertical depth-intensity (D-I) curve in the form of exp(-t/lambda), the spectral index, gamma, in the power law energy spectrum of muons at sea level can be obtained.

Minorikawa, Y.↗
NASA NTRS1984

Center-to-limb variation of a sunspot-associated microwave source

Observations of the simple bipolar active region McMath 16862, obtained with the Westerbork Synthesis Radio Telescope at 6.16 cm over six consecutive days, indicate two bright sources associated with the region's two main spots, as well as some weaker emission that may be associated with loop structures. Application of a novel analytical method has allowed the mapping of the vertical as well as the horizontal component of the sunspot magnetic field at specific locations in the low corona. While the vertical component decreases away from the source's center, the horizontal component has both a radial and an azimuthal part. These results are interpreted in terms of a force-free magnetic field model, as well as in terms of a dipole whose axis is inclined to the vertical.

Alissandrakis, C. E.↗
NASA NTRS1985

Coupled atmosphere/canopy model for remote sensing of plant reflectance features

Solar radiative transfer through a coupled system of atmosphere and plant canopy is modeled as a multiple-scattering problem through a layered medium of random scatterers. The radiative transfer equation is solved by the discrete-ordinates finite-element method. Analytic expressions are derived that allow the calculation of scattering and absorption cross sections for any plant canopy layer form measurable biophysical parameters such as the leaf area index, leaf angle distribution, and individual leaf reflectance and transmittance data. An expression for a canopy scattering phase function is also given. Computational results are in good agreement with spectral reflectance measurements directly above a soybean canopy, and the concept of greenness- and brightness-transforms of Landsat MSS data is reconfirmed with the computed results. A sensitivity analysis with the coupled atmosphere/canopy model quantifies how satellite-sensed spectral radiances are affected by increased atmospheric aerosols, by varying leaf area index, by anisotropic leaf scattering, and by non-Lambertian soil boundary conditions. Possible extensions to a 2-D model are also discussed.

Gerstl, S. A.↗
NASA NTRS1985

Transient motion of hypersonic vehicles including time history effects

An analytic method is developed for calculating the transient pitching motion of a wedge in hypersonic flow, taking into account fully the interaction between its motion and the unsteady air flow passing it. The effects of past motion history on the present state of motion are shown to be caused by the wave reflection from the bow shock. In the Newtonian limit they are equivalent to that of an added moment of inertia. The time history effects generally tend to decrease the damping, rendering the oscillatory motion more persistent. Numerical examples are given.

Hui, W. H.↗
NASA NTRS1984

The 'North American shale composite' - Its compilation, major and trace element characteristics

North American shale composite (NASC) major element composition and compilation are presented, together with rare earth element (REE) redeterminations obtained by high precision analytical methods. The major element composition of the NASC compares closely with other average shale compositions, and significant portions of the REE and some other trace elements are contained in minor phases. The uneven REE distribution in NASC powder appears to yield the heterogeneity in analyzed aliquants. REE distributions of detrital sediments may to some extent be dependent on their minor mineral assemblages and the sedimentological factors controlling these assemblages.

Gromet, L. P.↗
NASA NTRS1984

Secular rotational motions and the mechanical structure of a dynamical viscoelastic earth

A survey is presented of analytical methods for computing the linear responses of the rotational axis of a layered viscoelastic earth to surface loading. Theoretical research in this area is first summarized, and the differences between the mechanical boundary conditions to be applied at the interface separating the upper and lower mantles for an adiabatically and chemically stratified mantle are discussed. Some examples of polar wander and secular variation of the spin rate from glacial excitation are presented for various types of chemical and viscosity stratifications. The effects of an artificial density jump at the base of the lithosphere in models are examined, and certain issues concerning the fluid tidal Love number for different types of density stratification are addressed. The meaning of effective plate thickness over geological time scales for rotational dynamics is discussed.

Yuen, D. A.↗
NASA NTRS1985

Noble gas component organization in Apollo 14 breccia 14318 I-129 and Pu-244 regolith chronology

Drozd et al. (1972) have first detected the presence of Xe-129 in lunar material. Bernatowicz et al. (1979, 1980) established that this xenon component resides exclusively on grain surfaces and confirmed previous observations that it is less tightly bound than other surface components. The present investigation extends many of the observations made on the basis of a study of the 14301 to 14318, which is the only other lunar regolith breccia for which the isotopic structure of 'parentless xenon' has been accurately resolved. Actually this isotope has two parents, including Pu-244 and I-129, which are both now extinct. Attention is given to the analyzed samples, the employed analytical methods, the petrology and chemistry of the grain size separates, and stepwise heating experiments. On the basis of the obtained results, it is concluded that the I-Pu-Xe system can be used as a chronometer.

Swindle, T. D.↗
NASA NTRS1985

Optimal design of a thermally stable composite optical bench

The Lidar Atmospheric Sensing Experiment will be performed aboard an ER-2 aircraft; the lidar system used will be mounted on a lightweight, thermally stable graphite/epoxy optical bench whose design is presently subjected to analytical study and experimental validation. Attention is given to analytical methods for the selection of such expected laminate properties as the thermal expansion coefficient, the apparent in-plane moduli, and ultimate strength. For a symmetric laminate in which one of the lamina angles remains variable, an optimal lamina angle is selected to produce a design laminate with a near-zero coefficient of thermal expansion. Finite elements are used to model the structural concept of the design, with a view to the optical bench's thermal structural response as well as the determination of the degree of success in meeting the experiment's alignment tolerances.

Gray, C. E., Jr.↗
NASA NTRS1985

Flutter of swept fan blades

The effect of sweep on fan blade flutter is studied by applying the analytical methods developed for aeroelastic analysis of advance turboprops. Two methods are used. The first method utilizes an approximate structural model in which the blade is represented by a swept, nonuniform beam. The second method utilizes a finite element technique to conduct modal flutter analysis. For both methods the unsteady aerodynamic loads are calculated using two dimensional cascade theories which are modified to account for sweep. An advanced fan stage is analyzed with 0, 15 and 30 degrees of sweep. It is shown that sweep has a beneficial effect on predominantly torsional flutter and a detrimental effect on predominantly bending flutter. This detrimental effect is shown to be significantly destabilizing for 30 degrees of sweep.

Kielb, R. E.↗