Results for “Antennas” — Page 60

NASA NTRS1988

Dynamic models for simulation of the 70-M antenna axis servos

Dynamic models for the various functional elements of the 70 m antenna axis servos are described. The model representing the digital position controller, the linear and nonlinear properties of the physical hardware, and the dynamics of the flexible antenna structure are encoded in six major function blocks. The general modular structure of the function blocks facilitates their adaptation to a variety of dynamic simulation studies. Model parameter values were calculated from component specifications and design data. A simulation using the models to predict limit cycle behavior produced results in excellent agreement with field test data from the DSS 14 70-m antenna.

Hill, R. E.↗

NASA NTRS1988

Pointing a ground antenna at a spinning spacecraft using Conscan-simulation results

The results are presented for an investigation of ground antenna pointing errors which are caused by fluctuations of the receiver AGC signal due to thermal noise and a spinning spacecraft. Transient responses and steady-state errors and losses are estimated using models of the digital Conscan (conical scan) loop, the FFT, and antenna characteristics. Simulation results are given for the on-going Voyager mission and for the upcoming Galileo mission, which includes a spinning spacecraft. The simulation predicts a 1 sigma pointing error of 0.5 to 2.0 mdeg for Voyager, assuming an AGC loop SNR of 35 to 30 dB with a scan period varying from 128 to 32 sec, respectively. This prediction is in agreement with the DSS 14 antenna Conscan performance of 1.7 mdeg for 32 sec scans as reported in earlier studies. The simulation of Galileo predicts 1 mdeg error with a 128 sec scan and 4 mdeg with a 32 sec scan under similar AGC conditions.

Mileant, A.↗

NASA NTRS1989

A comparison of reflector antenna designs for wide-angle scanning

Conventional reflector antennas are typically designed for up to + or - 20 beamwidths scan. An attempt was made to stretch this scan range to some + or - 300 beamwidths. Six single and dual reflector antennas were compared. It is found that a symmetrical parabolic reflector with f/D = 2 and a single circular waveguide feed has the minimum scan loss (only 0.6 dB at Theta sub 0 = 8 deg, or a 114 beamwidths scan). The scan is achieved by tilting the parabolic reflector by an angle equal to the half-scan angle. The f/D may be shortened if a cluster 7 to 19 elements instead of one element is used for the feed. The cluster excitation is adjusted for each new beam scan direction to compensate for the imperfect field distribution over the reflector aperture. The antenna can be folded into a Cassegrain configuration except that, due to spillover and blockage considerations, the amount of folding achievable is small.

Zimmerman, M.↗

NASA NTRS1989

Electronic compensation for reflector surface distortion to improve radiation pattern characteristics of antennas

A simple procedure is described for determining the excitation coefficients of an array feed which compensates for the surface distortion of a reflector antenna to improve the radiation pattern in such a way as to approximate the performance of the undistorted antenna. A computer simulation for a practical feed array is presented as an example of compensation for the distortion of an actual antenna.

Bailey, M. C.↗

NASA NTRS1989

Computed performance of the half-scale accurate antenna reflector

The performance of the half-scale, accurate antenna reflector was studied. The antenna is evaluated for use as a compact range reflector. The reflector is studied for use with three separate feed antennas.

Lambert, Kevin M.↗

NASA NTRS1989

The effects of atmospheric turbulence on precision optical measurements used for antenna-pointing compensation

Blind pointing of the Deep Space Network (DSN) 70-meter antennas can be improved if distortions of the antenna structure caused by unpredictable environmental loads can be measured in real-time, and the resulting boresight shifts evaluated and incorporated into the pointing control loops. The measurement configuration of a proposed pointing compensation system includes an optical range sensor that measures distances to selected points on the antenna surface. The effect of atmospheric turbulence on the accuracy of optical distance measurements and a method to make in-situ determinations of turbulence-induced measurement errors are discussed.

Nerheim, N.↗

NASA NTRS1989

The tapered slot antenna - A new integrated element for millimeter-wave applications

Tapered slot antennas (TSAs) with a number of potential applications as single elements and focal-plane arrays are discussed. TSAs are fabricated with photolithographic techniques and integrated in either hybrid or MMIC circuits with receiver or transmitter components. They offer considerably narrower beams than other integrated antenna elements and have high aperture efficiency and packing density as array elements. Both the circuit and radiation properties of TSAs are reviewed. Topics covered include: antenna beamwidth, directivity, and gain of single-element TSAs; their beam shape and the effect of different taper shapes; and the input impedance and the effects of using thick dielectrics. These characteristics are also given for TSA arrays, as are the circuit properties of the array elements. Different array structures and their applications are also described.

Yngvesson, K. Sigfrid↗

NASA NTRS1989

Compensation of reflector antenna surface distortion using an array feed

The dimensional stability of the surface of a large reflector antenna is important when high gain or low sidelobe performance is desired. If the surface is distorted due to thermal or structural reasons, antenna performance can be improved through the use of an array feed. The design of the array feed and its relation to the surface distortion are examined. The sensitivity of antenna performance to changing surface parameters for fixed feed array geometries is also studied. This allows determination of the limits of usefulness for feed array compensation.

Cherrette, Alan R.↗

NASA NTRS1990

Mechanically-Steered, Mobile Satellite-Tracking Antenna

Signal from satellite tracked in moving vehicle. L-band, mechanically-steered, medium-gain antenna part of prototype radio equipment mounted in vehicle to demonstrate concept of land-mobile/satellite communication system. Provides such services as mobile telephone, voice or alphanumeric dispatch, paging, position-location information, and low-rate data transmission, for users within continental United States and Alaska. Antenna rotated mechanically until it finds direction from which maximum signal comes. Rate sensors provide inertial frame of reference during acquisition, so antenna locks onto signal even when vehicle turning.

Bell, D. J.↗

NASA NTRS1990

Wideband Microstrip Antenna-Feeding Array

Special impedance-matching probes help reduce feed complexity. Lightweight array of microstrip antenna elements designed to transmit and illuminate reflector antenna with circularly polarized radiation at 1,545 to 1,550 MHz and to receive circularly polarized radiation at 1,646 to 1,660 MHz. Microstrip array is cluster of 7 subarrays containing total of 28 microstrip patches. Produces cicularly polarized beam with suitable edge taper to illuminate reflector antenna. Teardrop-shaped feed probe provides gradual change of field from coaxial transmission line into microstrip substrate. Intended to be part of larger overlapping-cluster array generating multiple contiguous beams.

Huang, John↗

NASA NTRS1989

Large antenna measurement and compensation techniques

Antennas in the range of 20 meters or larger will be an integral part of future satellite communication and scientific payloads. In order to commercially use these large, low sidelobe and multiple-beam antennas, a high level of confidence must be established as to their performance in the 0-g and space environment. It is also desirable to compensate for slowly varying surface distortions which could results from thermal effects. An overview of recent advances in performing rf measurements on large antennas is presented with emphasis given to the application of a space-based far-field range utilizing the Space Shuttle. The concept of surface distortion compensation is discussed by providing numerical and measurement results.

Rahmatsamii, Y.↗

NASA NTRS1989

A comparison of reflector antenna designs for wide-angle scanning

Conventional reflector antennas are typically designed for up to + or - 20 beamwidths scan. An attempt was made to stretch this scan range to some + or - 300 beamwidths. Six single and dual reflector antennas were compared. It is found that a symmetrical parabolic reflector with f/D = 2 and a single circular waveguide feed has the minimum scan loss (only 0.6 dB at Theta sub 0 = 8 deg, or a 114 beamwidths scan). The scan is achieved by tilting the parabolic reflector by an angle equal to the half-scan angle. The f/D may be shortened if a cluster 7 to 19 elements instead of one element is used for the feed. The cluster excitation is adjusted for each new beam scan direction to compensate for the imperfect field distribution over the reflector aperture. The antenna can be folded into a Cassegrain configuration except that, due to spillover and blockage considerations, the amount of folding achievable is small.

Zimmerman, M.↗

NASA NTRS1989

Antennas for 20/30 GHz and beyond

Antennas of 20/30 GHz and higher frequency, due to the small wavelength, offer capabilities for many space applications. With the government-sponsored space programs (such as ACTS) in recent years, the industry has gone through the learning curve of designing and developing high-performance, multi-function antennas in this frequency range. Design and analysis tools (such as the computer modelling used in feedhorn design and reflector surface and thermal distortion analysis) are available. The components/devices (such as BFN's, weight modules, feedhorns and etc.) are space-qualified. The manufacturing procedures (such as reflector surface control) are refined to meet the stringent tolerance accompanying high frequencies. The integration and testing facilities (such as Near-Field range) also advance to facilitate precision assembling and performance verification. These capabilities, essential to the successful design and development of high-frequency spaceborne antennas, shall find more space applications (such as ESGP) than just communications.

Chen, C. Harry↗

NASA NTRS1990

Application of inertial instruments for DSN antenna pointing and tracking

The feasibility of using inertial instruments to determine the pointing attitude of the NASA Deep Space Network antennas is examined. The objective is to obtain 1 mdeg pointing knowledge in both blind pointing and tracking modes to facilitate operation of the Deep Space Network 70 m antennas at 32 GHz. A measurement system employing accelerometers, an inclinometer, and optical gyroscopes is proposed. The initial pointing attitude is established by determining the direction of the local gravity vector using the accelerometers and the inclinometer, and the Earth's spin axis using the gyroscopes. Pointing during long-term tracking is maintained by integrating the gyroscope rates and augmenting these measurements with knowledge of the local gravity vector. A minimum-variance estimator is used to combine measurements to obtain the antenna pointing attitude. A key feature of the algorithm is its ability to recalibrate accelerometer parameters during operation. A survey of available inertial instrument technologies is also given.

Eldred, D. B.↗

NASA NTRS1989

A diagnostic technique used to obtain cross-range radiation centers from antenna patterns

A diagnostic technique for obtaining cross-range radiation centers based on antenna radiation patterns is presented. The method is similar to the synthetic aperture processing of scattered fields in the radar application. Coherent processing of the radiated fields is used to determine the various radiation centers associated with the far-zone pattern of an antenna for a given radiation direction. The technique can be used to identify an unexpected radiation center that creates an undesired effect in a pattern; on the other hand, it can improve a numerical simulation of the pattern by identifying other significant mechanisms. Cross range results for two 8' reflector antennas are presented to illustrate as well as validate that technique.

Lee, Teh-Hong↗

NASA NTRS1990

15 GHz space VLBI observations using an antenna on a TDRSS satellite

A 4.9 m diameter antenna in earth orbit, part of the Tracking and Data Relay Satellite System, was previously used for space VLBI observations at 2.3 GHz. It has now been used successfully with two ground antennas for VLBI measurements at 15 GHz. Although the sensitivity (gain/system temperature) of the orbiting antenna was a factor of 6 poorer at 15 GHz than at 2.3 GHz, 11 out of 22 extragalactic sources were detected on space-ground baselines, up to a maximum baseline of 1.63 earth diameters. The results suggest that the distribution of source visibilities at 15 and 2.3 GHz are similar for these baseline lengths. Model-dependent brightness temperatures of 1-2.5 x 10 to the 12th K were derived for six sources. This suggests that sources with brightness temperatures in this range are as common at 15 GHz as at 2.3 GHz. The coherence on space-ground baselines (this includes effects due to the phase transfer from the ground to the satellite and the reconstruction of the spacecraft orbit) was 0.76 for 340 s integrations.

Linfield, R. P.↗

NASA NTRS1989

Pointing a ground antenna at a spinning spacecraft using conical scan - Simulation results

The results are presented for an investigation of ground antenna pointing errors which are caused by fluctuations of the receiver AGC signal due to thermal noise and a spinning spacecraft. Transient responses and steady-state errors and losses are estimated using models of the digital Conscan (conical scan) loop, the FFT, and antenna characteristics. Simulation results are given for the on-going Voyager mission and for the upcoming Galileo mission, which includes a spinning spacecraft. The simulation predicts a 1 sigma pointing error of 0.5 to 2.0 mdeg for Voyager, assuming an AGC loop SNR of 35 to 30 dB with a scan period varying from 128 to 32 sec, respectively. This prediction is in agreement with the DSS 14 antenna Conscan performance of 1.7 mdeg for 32 sec scans as reported in earlier studies. The simulation of Galileo predicts 1 mdeg error with a 128 sec scan and 4 mdeg with a 32 sec scan under similar AGC conditions.

Mileant, Alexander↗

NASA NTRS1991

Analyzing Large Reflector Antenna Structures

Iterative Design of Antenna Structures (IDEAS) computer program performs finite-element analysis and optimization of design, with special features for analysis and design of microwave antennas and associated structural components. Primary feature to perform root-mean-square-best-fitting path-length-error and boresight-pointing-error analyses for Cassegrain microwave antenna structure loaded by gravity, wind, or other environmental effects. Flexible and easy to use. Written in ATHENA FORTRAN and ASSEMBLER.

Levy, Roy↗