Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “gain”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6

Broad-band gain in optically pumped S2

The broad fluorescence spectrum and Franck-Condon shift of the B-X system of S2 are exploited in broad-band-gain experiments using the absorption of 308-nm XeCl excimer radiation to pump the level (upsilon-prime = 4) in an S2 vapor with and without Ar. The fluorescence spectra are examined to determine the effects of gas collisions, and the intense near-UV and visible bands are attributed to the redistribution of the population among the upsilon-prime levels resulting from S2-Ar collisions. Broad-band gain is observed on the rare-gas relaxation bands (2,17) (about 475 nm) and (3,18) (480 nm), while absorption is found in the (0,6), (0,7), and (0,8) near-UV (about 360-380-nm) bands where a transient population cascading down the X-state manifold fills the lower levels. It is inferred from the achievement of gain over much of the S2 fluorescence bandwidth that nonselective pumping mechanisms like discharges, solar energy, or flashlamps can be used with S2 as the tunable, chemically stable 'dye'.

Epler, J. E.↗

Single contact tailored gain phased array of semiconductor lasers

A single contact tailored gain-guided array is demonstrated in which the gain profile across the array is made strongly asymmetric by varying the width of the contact stripes. A proton isolated arary of six (GaAl)As lasers with 5-micron separations and widths varying linearly between 3 and 8 microns had a single lobed far field 2 deg wide, close to the diffraction limit for a single supermode. Fabrication of this device is simple, and suited to large-scale processing techniques. It is also shown that in such an asymmetric gain-guided array the fundamental mode is favored over higher order modes, and that higher order modes can have single lobed far-field patterns differing only slightly from that of the fundamental.

Lindsey, C. P.↗

Gain Instabilities in Photomultipliers: How Accurate are Photon Counting Measurements?

Experiments performed on five commercially available photomultiplier tubes indicate that gain instabilities can be an important source of error in photon counting measurements at the 1% level. It is shown that the error cannot be significantly reduced by standard differential measurement techniques. Analysis of time variations in the pulse height distribution is shown to be a sensitive diagnostic tool for the measurement of gain variations. Using this technique it is found that gain variations occur at counting rates as low as 100 Hz. It is argued that such errors will be present at some level in all tubes. Several calibrating schemes capable of reducing the error to below the 0.1% level are discussed.

Rosen, W. A.↗

A design technique for determining actuator gains in spacecraft vibration control

A design procedure is described which determines the gains of a diagonal damping matrix to control the vibrations of a flexible structure with application to orbiting spacecraft. The procedure is based on minimizing the energy dissipated by control actuators using nonlinear mathematical programming. Each damping gain is assumed to be an active viscous damper and the design process is formulated so that the force or torque output of the actuator does not exceed a specified value. The response of the structure at some specified time after the termination of the disturbance is constrained to be less than some prescribed value based upon spacecraft mission performance requirements. A grillage example is used to demonstrate the design process for determining gains for two representative cases. Resulting designs are verified by a finite element analysis of the structure augmented by the control actuators.

Horner, G. C.↗

62-dB-gain multiple-pass slab geometry Nd:YAG amplifier

A flash-lamp-pumped slab Nd:YAG laser amplifier with 62 dB of gain is demonstrated. The amplifier remains linear for energy extraction up to 12 mJ, and the beam spatial quality remains good at repetition rates up to 10 Hz. The slab geometry provides for gain averaging in the zigzag dimension, thus eliminating the undesirable effects of nonuniform pumping. This averaging and the necessity for only a single compact gain element are valuable attributes that may allow for eventual laser-diode array pumping of the slab Nd:YAG amplifier.

Kane, T. J.↗

Ka-band monolithic gain control amplifier

A monolithic gain control amplifier for Ka-band has been developed based on 0.25 micron-gate-length dual-gate FETs fabricated on ion-implanted material. A single-stage monolithic amplifier gives a gain of 6 dB at 31 GHz including fixture losses with a gain control range of over 20 dB. The device and IC design and fabrication are described.

Geddes, J.↗

Direct analysis of gain-guided phase-locked semiconductor laser arrays

A method for analyzing arbitrary one-dimensional waveguides is described and applied to find the lateral modes of gain-guided laser arrays directly, without the need for a coupled-mode approximation. Detailed results are given for a four-element array for which experimental results are available, and the effect of varying device parameters on the relative gains of the modes is considered. The results show differences between gain-guided and real-index guided arrays which are not evident in prior analyses.

Marshall, W. K.↗

Rate of energy gain and maximum energy in diffusive shock acceleration

The problem of diffusive shock acceleration of fast charged particles is reexamined with emphasis on the rate of energy gain, and the maximum energy which can be attained in a given circumstance. The direction of the average magnetic field at the shock is shown to have a large effect. If the perpendicular diffusion coefficient is much smaller than the parallel coefficient, particles can gain much more energy if the shock is quasi-perpendicular than if it is quasi-parallel. The maximum energy attainable can be substantially higher (by a factor of 100 or more) than previous discussions would predict, in cases where the shock is quasi-perpendicular. The energy gain increases as kappa-perpendicular decreases. The principal limitation comes from the requirement that diffusion be a valid approximation to the particle motion, and that the particle be able to diffuse fast enough to encounter the shock many times.

Jokipii, J. R.↗

Two stage dual gate MESFET monolithic gain control amplifier for Ka-band

A monolithic two stage gain control amplifier has been developed using submicron gate length dual gate MESFETs fabricated on ion implanted material. The amplifier has a gain of 12 dB at 30 GHz with a gain control range of over 30 dB. This ion implanted monolithic IC is readily integrable with other phased array receiver functions such as low noise amplifiers and phase shifters.

Sokolov, V.↗

Perfluorobutyl iodides as gain media for a solar-pumped iodine laser amplifier

The effectiveness of t-C4F9I and n-C4F9I as gain media for a space-based solar-pumped iodine photodissociation laser is investigated experimentally. The optically coupled flashlamp/amplifier-tube apparatus described by Hwang et al. (1986) is employed, driving the amplifier with 4-microsec 4.2-mJ TEM(00) pulses from a flashlamp-pumped laser oscillator; the variation of amplification with energy-extraction time was monitored by inserting a delay of up to 1 msec between the firing of the two flashlamps and measuring the delay between the optical pulses. The results are presented graphically and briefly characterized. The performance of t-C4F9I is found to be better than that of n-C4F9I (or n-C3F7I), with an absorption band shifted toward the visible (for improved utilization of solar radiation), higher gain (by a factor of 2) at all delay times, and better chemical reversibility. The gain did not depend significantly on temperature in any of the iodides.

Tabibi, Bagher M.↗

Absolute gain measurement of microstrip antennas under mismatched conditions

The gain of a single microstrip patch and a two-layer parasitic array is measured using the image method under mismatched conditions. This method produces accurate results, even in the case of low-gain microstrip antennas. The advantages of this method over the gain comparison technique are discussed.

Lee, R. Q.↗

Gain enhancement of microstrip antennas with overlaying parasitic directors

An experimental study of gain enhancement in microstrip antennas using identical parasitic patch directors is reported. The results indicate that, with two overlying parasitic directors, the gain of a rectangular microstrip antenna is enhanced from 4.7 dB to 10.6 dB, while the 3 dB beamwidth is reduced from 103 deg to 30 deg for the E-plane and from 70 deg to 35 deg for the H-plane. The three-layer electromagnetically coupled patch antenna exhibits similar antenna characteristics to those of the Yagi array, with over 120 dB gain and with about 1 percent bandwidth.

Lee, R. Q.↗

Photorefractive gain in GaAs under a dc electric field

This paper reports on the first observation of a photorefractive gain coefficient as high as 2.6/cm in the undoped liquid-encapsulated Czochralski-grown GaAs crystals at 1.06 microns under a dc electric field of 13 kV/cm without using the moving grating technique.The absorption coefficient of the crystals used is 1.3/cm, showing that a net gain has been achieved. This measured gain coefficient is close to the predicted theoretical value.

Liu, Duncan T. H.↗

Guaranteed properties for nonlinear gain scheduled control systems

An analysis is presented of two types of nonlinear gain-scheduled control systems: scheduling on a reference trajectory and scheduling on the plant output. Conditions are given which guarantee stability, robustness, and performance properties of the global gain-scheduled designs. These conditions confirm and formalize popular notions regarding gain-scheduled designs; e.g., that the scheduling variable should vary slowly and capture the plant's nonlinearities. These results extend the work of Shamma and Athans (1987), which addressed the case of linear plants whose dynamics depends on exogenous parameters.

Shamma, Jeff S.↗

Application of variable-gain output feedback for high-alpha control

A variable-gain, optimal, discrete, output feedback design approach that is applied to a nonlinear flight regime is described. The flight regime covers a wide angle-of-attack range that includes stall and post stall. The paper includes brief descriptions of the variable-gain formulation, the discrete-control structure and flight equations used to apply the design approach, and the high performance airplane model used in the application. Both linear and nonlinear analysis are shown for a longitudinal four-model design case with angles of attack of 5, 15, 35, and 60 deg. Linear and nonlinear simulations are compared for a single-point longitudinal design at 60 deg angle of attack. Nonlinear simulations for the four-model, multi-mode, variable-gain design include a longitudinal pitch-up and pitch-down maneuver and high angle-of-attack regulation during a lateral maneuver.

Ostroff, Aaron J.↗

Effect of body weight gain on insulin sensitivity after retirement from exercise training

The effect of the body-weight gain after retirement from an exercise-training program on the retained increase in insulin sensitivity elicited by the training was investigated in exercise-trained (ET) rats. Insulin sensitivity was assessed by oral glucose tolerance and insulin suppression tests immediately after training and during retirement. Results show that, compared with sedentary controls, exercise training enhanced insulin-induced glucose uptake, but the enhanced sensitivity was gradually lost with the end of running activity until after seven days of retirement, when it became equal to that of controls. This loss of enhanced sensitivity to insulin was associated with an accelerated gain in body weight beginning one day after the start of retirement. However, those animals that gained weight only at rates similar to those of control rats, retained their enhanced sensitivity to insulin.

Dolkas, Constantine B.↗

Factorization and the synthesis of optimal feedback gains for distributed parameter systems

An approach based on Volterra factorization leads to a new methodology for the analysis and synthesis of the optimal feedback gain in the finite-time linear quadratic control problem for distributed parameter systems. The approach circumvents the need for solving and analyzing Riccati equations and provides a more transparent connection between the system dynamics and the optimal gain. The general results are further extended and specialized for the case where the underlying state is characterized by autonomous differential-delay dynamics. Numerical examples are given to illustrate the second-order convergence rate that is derived for an approximation scheme for the optimal feedback gain in the differential-delay problem.

Milman, Mark H.↗

A rate equation approach to gain saturation effects in laser mode calculations

Space exploration and research require large amounts of power. Solar pumped laser systems have been shown to have the potential for meeting the performance requirements necessary for power transmission in space. The successful design of laser systems for these applications will depend, in part, on having a clear understanding of the development of the dynamical processes in the laser cavity and on the effects that changes in physical and design parameters have on laser performance. In particular, it is necessary to know the amplitude and phase distributions of the laser beam at the output aperture when steady state operation is achieved in order to determine the far-field power distribution. The output from the laser will depend on the active medium, the optical environment of the active material and on the gain distribution in the active region as laser action builds up and reaches steady state. An important component in the design process will be a realistic model of the active laser cavity. A computer model of the laser cavity, based on Huygens' principle was developed. The code calculates the amplitude and phase of an optical wave reflected back and forth between the mirrors of a laser cavity. The original code assumes a gain distribution which does not change with the buildup of oscillations in the cavity. A step in the direction of realism is the inclusion of a saturable gain medium in the cavity. The objective is to incorporate saturation effects into the existing computer model.

Roberts, Lila F.↗