Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “favorability”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6

Use of the space shuttle to avoid spacecraft anomalies

An existing data base covering 304 spacecraft of the U.S. space program was analyzed to determine the effect on individual spacecraft failures and other anomalies that the space shuttle might have had if it had been operational throughout the period covered by the data. By combining the results of this analysis, information on the prelaunch activities of selected spacecraft programs, and shuttle capabilities data, the potential impact of the space shuttle on future space programs was derived. The shuttle was found to be highly effective in the prevention or correction of spacecraft anomalies, with 887 of 1,230 anomalies analyzed being favorably impacted by full utilization of shuttle capabilities. The shuttle was also determined to have a far-reaching and favorable influence on the design, development, and test phases of future space programs. This is documented in 37 individual statements of impact.

Source record↗

Location of energy barriers. IV - Effect of rotation and mass on the dynamics of reactions A + BC.

Examination of the effect of the inclusion of a small but significant amount of rotational energy in the reagents, and of a change in reagent masses in a previous study of the effect of barrier location on the dynamics of thermonuclear reaction A + BC yields AB + C. The qualitative generalizations introduced in the previous study are found to remain valid despite the introduction of the variables. Of these generalizations the most important is that reagent translational energy favors reaction on surface I, whereas reagent vibration is the most favorable to reaction on surface II.

Hodgson, B. A.↗

Absolute intensity and polarization of rotational Raman scattering from N2, O2, and CO2

An experimental examination of the absolute intensity, polarization, and relative line intensities of rotational Raman scattering (RRS) from N2, O2, and CO2 is reported. The absolute scattering intensity for N2 is characterized by its differential cross section for backscattering of incident light at 647.1 nm, which is calculated from basic measured values. The ratio of the corresponding cross section for O2 to that for N2 is 2.50 plus or minus 5 percent. The intensity recent for N2, O2, and CO2 are shown to compare favorably to values calculated from recent measurements of the depolarization of Rayleigh scattering plus RRS. Measured depolarizations of various RRS lines agree to within a few percent with the theoretical value of 3/4. Detailed error analyses are presented for intensity and depolarization measurements. Finally, extensive RRS spectra at nominal gas temperatures of 23 C, 75 C, and 125 C are presented and shown to compare favorably to theoretical predictions.

Penney, C. M.↗

Structural aspects of Imbrium sculpture, part G

Apollo 16 metric photographs taken at low to high sun angles provided the first stereographic coverage of the distinctive landforms collectively referred to as Imbrium sculpture. The sculpture consists of a series of nearly linear ridges and troughs extending radially outward for more than 1000 km from the rim of the Imbrium Basin. The origin of the ridges and troughs, whether by deposition and impact scoring by fluidized clouds of ejecta from the Imbrium Basin or by faulting and volcanism during and subsequent to basin formation, is controversial. Evidence indicative of the mode of origin of Imbrium sculpture is summarized as follows. Evidence of volcano-tectonic mode of origin is favored by: (1) wide variation in relative age of parts of the sculpture; (2) furrows without rims; (3) absence of ballistic shielding; (4) asymmetry of sculpture; (5) absence of randomly oriented clusters; and (6) association with other features of structural origin. An origin by ejecta scoring and deposition is favored by the gradational ejecta with a Fra Mauro-type texture. Features that are ambiguous as to mode or origin are furrows made of coalesced crater chains and prominent rims on furrows.

Scott, D. H.↗

Electromagnetic position sensor for a magnetically supported model in a wind tunnel

An investigation was undertaken to determine the feasibility of using superconducting force-producing coils for positioning a model in a wind tunnel. The cryostat containing the forcing coils surrounded the test section of the tunnel, thus favoring an electromagnetic position sensor. Another reason favoring this choice was the fact that the performance of an electromagnetic sensor is essentially unaffected by the shape of the model.

Towler, W. R.↗

Application of the hydrogen-bubble technique for velocity measurements in thin liquid films.

A unique adaptation of the hydrogen-bubble flow visualization method was applied to measure velocity profiles and film thicknesses of very thin films on an inclined plane wall. Data were obtained in the three flow regions for a developing falling film with an initially uniform velocity profile and thickness less than or equal to 0.1 in. The measured profiles compared more favorably with parabolic profiles in the intermediate fully developed region than in the initial developing region. However, measured film thicknesses compared favorably with a simplified solution of the integral momentum equation based on parabolic velocity profiles. The results confirm the theoretical prediction that a relatively long distance may be required even for a thin film before nonaccelerating flow with a constant film thickness is obtained and Nusselt's classical analysis applies. The experimental technique was shown to be a practical experimental method for obtaining data for the two-dimensional laminar flow of thin liquid films.

Thomas, W. C.↗

Organic analysis of lunar samples and the Martian surface.

In addition to the organogenic elements (H, C, N, O, S, P) which are necessary for the synthesis of organic molecules, the lunar samples from Apollo 11, 12, 14, and 15 contain substantial amounts of CO, N2, and CO2 which are released at relatively high temperatures and smaller amounts of more complex organic compounds (e.g., benzene). The lunar surface provides one of the less favorable solar system models for the synthesis of organic compounds; yet small amounts of these compounds have been detected in the returned samples. It is reasonable to assume that the different physical and developmental features of the planet Mars (increased gravitational field, presence of an atmosphere with CO2, CO, and H2O, recent volcanic and tectonic activity, etc.) would favor an increased organic content of the surface of this planet relative to the moon. Therefore the organic molecules present in the Martian soil should be measurable by miniaturized mass spectrometers after fractional distillation or gas chromatographic separation of the volatiles released by moderate heating.

Oro, J.↗

Effects of ultrasonic fields in the phosphoric acid process

A process of apatite decomposition with sulfuric acid was studied under the influence of ultrasound in the phosphoric acid production process. The studies were carried out with and without ultrasonic fields in the reaction mixture, which resembled the mixing ratio used in technical production processes. Ultrasound with a frequency of 20 kHz and an intensity of 1 W/sq cm was used in the studies. A very favorable ultrasonic effect upon the degree of apatite decomposition was observed. The ultrasonic field affects the shape of byproduct gypsum crystals. In the H3PO4 production process without ultrasound, the byproduct gypsum crystallizes as long, thin needles which cause problems in filtration. In the trials involving the application of wound, gypsum crystallized in the form of small platelets possessing a favorable ratio of length to width.

Kowalska, E.↗

The application of ERTS-1 data to the land use planning process

Land resource data has been extracted on a percent of cell basis from ERTS imagery, RB-57 color infrared imagery and best available conventional sources for a 10,000 square kilometer test area in eastern Wisconsin. First, the data from the three sources is compared on a spatial basis for a 300 square kilometer portion of the test area. For those land resource variables associated with cover, ERTS derived resource data compared favorably with both the RB-57 and conventional data. Second, the effect of the data source on land use decisions is examined. Three interstate highway corridors are located through the same region based upon data extracted from each of the three sources. A policy of preserving natural environmental systems was used as a basis for the corridors selection in each case. The resulting three corridors compare favorably.

Clapp, J. L.↗

Application of Markov chain theory to ASTP natural environment launch criteria at Kennedy Space Center

To aid the planning of the Apollo Soyuz Test Program (ASTP), certain natural environment statistical relationships are presented, based on Markov theory and empirical counts. The practical results are in terms of conditional probability of favorable and unfavorable launch conditions at Kennedy Space Center (KSC). They are based upon 15 years of recorded weather data which are analyzed under a set of natural environmental launch constraints. Three specific forecasting problems were treated: (1) the length of record of past weather which is useful to a prediction; (2) the effect of persistence in runs of favorable and unfavorable conditions; and (3) the forecasting of future weather in probabilistic terms.

Graves, M. E.↗

Flight investigation of installation effects on a wedge nozzle installed on an underwing nacelle

A flight research program was conducted using a modified F-106B aircraft with an underwing-nacelle - engine installation to investigate installation effects on a wedge nozzle with retracted shrouds from Mach 0.70 to 1.10. These configurations simulated the subsonic flight geometries of a variable-geometry wedge nozzle design for Mach 2.70 operation. The nozzle was tested with a J85-GE-13 turbojet engine, and data were compared with that of 0.34-scale isolated wind tunnel model. Data are also compared with the flight results of a boattail plug nozzle and a cylindrical nacelle plug nozzle. A favorable installation effect occurred from Mach 0.82 to 0.96 with a nominal 4-percent corrected secondary weight-flow ratio. This favorable effect resulted from changes in pressure forces on the nozzle surfaces. The wedge nozzle gross thrust coefficient was about the same as the boattail nacelle plug nozzle and 2.50 to 1.30 percent higher than the cylindrical nacelle plug nozzle over the subsonic Mach number range.

Johns, A. L.↗

Planetary magnetism

The origin and maintenance of planetary magnetic fields are discussed. The discussion is not limited to dynamo theories, although these are almost universally favored. Thermoelectric currents are found to be a possible alternative for Jupiter. Two energy sources for dynamos are considered: convection and precessionally induced fluid flow. The earth is the most favorable planet for precessionally driven dynamo, although Neptune is a possibility. Jupiter is likely to have a convectionally driven dynamo, as may Saturn, but the relevant properties of Saturn are not yet well known. Conclusions for each planet are given.

Stevenson, D.↗

Studies of cluster X-ray sources, energy spectra for the Perseus, Virgo, and Coma clusters

Final Uhuru X-ray differential-energy spectra are presented for the Perseus, Virgo, and Coma clusters. Power-law and isothermal bremsstrahlung model spectra with low-energy cutoffs are given, and the energy-dependent Gaunt factor is calculated for the bremsstrahlung. The spectra, which are best fits to the Uhuru data between 2 and 10 keV, are compared with previous observations of these sources in the energy range from 0.1 to 100 keV. The problem of parameter estimation is discussed, error bars with 68% confidence are given for the independently determined slope and cutoff parameters, and the 68% confidence limits are plotted for the fitted spectral functions. The data for Perseus above 20 keV marginally favor the bremsstrahlung fit, those for Virgo between 0.25 and 1.0 keV clearly favor that curve, and those for Coma indicate a low-energy turnover or cutoff. Implications of such a cutoff are briefly discussed.

Kellogg, E.↗

Application of LANDSAT data to delimitation of avalanche hazards in Montane, Colorado

The author has identified the following significant results. Photointerpretation of individual avalanche paths on single band black and white LANDSAT images is greatly hindered by terrain shadows and the low spatial resolution of the LANDSAT system. Maps produced in this way are biased towards the larger avalanche paths that are under the most favorable illumination conditions during imaging; other large avalanche paths, under less favorable illumination, are often not detectable and the smaller paths, even those defined by sharp trimlines, are only rarely identifiable.

Knepper, D. H.↗

Mineral target areas in Nevada from geological analysis of LANDSAT-1 imagery

Geological analysis of LANDSAT-1 Scene MSS 1053-17540 suggests that certain known mineral districts in east-central Nevada frequently occur near faults or at faults or lineament intersections and areas of complex deformation and flexures. Seventeen (17) areas of analogous characteristics were identified as favorable targets for mineral exploration. During reconnaissance field trips eleven areas were visited. In three areas evidence was found of mining and/or prospecting not known before the field trips. In four areas favorable structural and alteration features were observed which call for more detailed field studies. In one of the four areas limonitic iron oxide samples were found in the regolith of a brecciated dolomite ridge. This area contains quartz veins, granitic and volcanic rocks and lies near the intersection of two linear fault structures identified in the LANDSAT-1 imagery. Semiquantitative spectroscopic analysis of selected portions of the samples showed abnormal contents of arsenic, molybdenum, copper, lead, zinc, and silver. These limonitic samples found were not in situ and further field studies are required to assess their source and significance.

Abdel-Gawad, M.↗

Lineaments on Skylab photographs: Detection, mapping, and hydrologic significance in central Tennessee

The author has identified the following significant results. Lineaments were detected on Skylab photographs by stereo viewing, projection viewing, and composite viewing. Sixty-nine percent more lineaments were found by stereo viewing than by projection, but segments of projection lineaments are longer; total length of lineaments found by these two methods is nearly the same. Most Skylab lineaments consist of topographic depression: stream channel alinements, straight valley walls, elongated swales, and belts where sinkholes are abundant. Most of the remainder are vegetation alinements. Lineaments are most common in dissected areas having a thin soil cover. Results of test drilling show: (1) the median yield of test wells on Skylab lineaments is about six times the median yield of all existing wells; (2) three out of seven wells on Skylab lineaments yield more than 6.3 1/s (110 gal/min): (3) low yields are possible on lineaments as well as in other favorable locations; and (4) the largest well yields can be obtained at well locations of Skylab lineaments that also are favorably located with respect to topography and geologic structure, and are in the vicinity of wells with large yields.

Moore, G. K.↗

Increase in effectiveness of low frequency acoustic liners by use of coupled Helmholtz resonators

Coupling of Helmholtz resonators in a low-frequency absorber array was studied as a means for increasing the effectiveness for absorbing low-frequency core engine noise. The equations for the impedance of the coupled-resonator systems were developed in terms of uncoupled-resonator parameters, and the predicted impedance for a parallel-coupled scheme is shown to compare favorably with measurements from a test model. In addition, attenuation measurements made in a flow duct on test coupled-resonator panels are shown to compare favorably with predicted values. Finally, the parallel-coupled concept is shown to give significantly more attenuation than that of a typical uncoupled resonator array of the same total volume.

Dean, L. W.↗

A technique for the determination of Louisiana marsh salinity zone from vegetation mapped by multispectral scanner data: A comparison of satellite and aircraft data

Vegetation in selected study areas on the Louisiana coast was mapped using low altitude aircraft and satellite (LANDSAT) multispectral scanner data. Fresh, brackish, and saline marshes were then determined from the remotely sensed presence of dominant indicator plant associations. Such vegetational classifications were achieved from data processed through a standard pattern recognition computer program. The marsh salinity zone maps from the aircraft and satellite data compared favorably within the broad salinity regimes. The salinity zone boundaries determined by remote sensing compared favorably with those interpolated from line-transect field observations from an earlier year.

Butera, M. K.↗