Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “damping controller”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

A class of stable, robust feedback controllers for large space structures

A two-level control system design is considered for large space structures, which consists of a primary and a secondary controller. The secondary or damping enhancement controller is shown to be stable and robust, even when time-invariant nonlinearities are present in the actuators and/or sensors. The use of Annular Momentum Control Devices (AMCD's) is also considered for secondary control. The primary attitude controller using collocated torque actuators and attitude and rate sensors is stable and robust. The effect of actuator/sensor dynamics on the stability of the primary and secondary controllers is considered. The AMCD's used for secondary control actuation can also be used for the primary controller.

Joshi, S. M.↗
NASA NTRS1955

An Evaluation of the Roll-Rate Stabilization System of the Sidewinder Missile at Mach Numbers from 0.9 to 2.3

A linear stability analysis and flight-test investigation has been performed on a rolleron-type roll-rate stabilization system for a canard-type missile configuration through a Mach number range from 0.9 to 2.3. This type damper provides roll damping by the action of gyro-actuated uncoupled wing-tip ailerons. A dynamic roll instability predicted by the analysis was confirmed by flight testing and was subsequently eliminated by the introduction of control-surface damping about the rolleron hinge line. The control-surface damping was provided by an orifice-type damper contained within the control surface. Steady-state rolling velocities were at all times less than 1 radian per second between the Mach numbers of 0.9 to 2.3 on the configurations tested. No adverse longitudinal effects were experienced in flight because of the tendency of the free-floating rollerons to couple into the pitching motion at the low angles of attack and disturbance levels investigated herein after the introduction of control-surface damping.

Nason, Martin L.↗
NASA NTRS1988

Experimental and simulation studies of hard contact in force reflecting teleoperation

Experiments and simulations of a single-axis force-reflecting teleoperation system have been conducted to investigate the problem of contacting a hard environment and maintaining a controlled force in teleoperation in which position is fed forward from the hand controller (master) to the manipulator (slave), and force is fed back to the human operator through motors in the master. The simulations, using an electrical circuit model, reproduce the behavior of the real system, including effects of human operator biomechanics. It is shown that human operator properties, which vary as a result of different types of grasp of the handle, affect the stability of the system in the hard-contact task. The effect of a heavier grasp on the handle is equivalent to increased hand-controller velocity damping in terms of the systems stability in the contact task, but control system damping sufficient to guarantee stable contact results in perceptible sluggishness of the control handle's response in free motion. These results suggest that human operator biomechanics must be taken into account to guarantee stable and ergonomic performance of advanced teleoperators.

Hannaford, Blake↗
NASA NTRS1987

Adaptive damping for spacecraft by temperature control

In most structural response and stability problems, the structural damping is a significant parameter, and its prediction is often an educated guess because of uncertainties in damping values. Present practice is to assume a conservative lower bound of the damping value, which can result in the 'overdesign' of structures because the experimentally determined damping may be as much as an order of magnitude larger than the value used for the design. This paper presents the concept of adaptive damping, whose objective is to use the damping material's temperature dependence as a control parameter to adjust the damping value. The present application is to limit the response of a structure when subjected to high excitation forces. Preliminary results show a doubling of the damping ratio in a simple beam structure.

Wada, B. K.↗
NASA NTRS1988

Effect of natural damping on the dynamics and control of a class of optimally designed structures

In this study the vibration control of large space structures with structural damping is investigated. Emphasis is made on the control of both a class of optimally designed (stepped) structures and also the corresponding uniform structures using a cantilever beam as an example. The open loop and closed loop dynamics are compared and the transient responses are determined to study the effect of damping on the control system design.

Satyanarayana, K.↗
NASA NTRS1981

A controller design approach for large flexible space structures

A controller design approach for large space structures is presented, which consists of a primary attitude controller and a secondary or damping enhancement controller. The secondary controller, which uses several Annular Momentum Control Device (AMCD's), is shown to make the closed loop system asymptotically stable under relatively simple conditions. The primary controller using torque actuators (or AMCD's) and colocated attitude and rate sensors is shown to be stable. It is shown that the same AMCD's can be used for simultaneous actuation of primary and secondary controllers. Numerical results are obtained for a large, thin, completely free plate model.

Joshi, S. M.↗
NASA NTRS1987

Variable structure controller design for spacecraft nutation damping

Variable structure systems theory is used to design an automatic controller for active nutation damping in momentum biased stabilized spacecraft. Robust feedback stabilization of roll and yaw angular dynamics is achieved with prescribed qualitative characteristics which are totally independent of the spacecraft defining parameters.

Sira-Ramirez, Hebertt↗
NASA NTRS1982

Simulation and testing of digital control on a flexible beam

Large space structures are expected to have control problems due to low stiffness and damping, and control laws for these structures must deal with shape and configuration control as well as attitude and orbit maintenance. In general, these control tasks must be accomplished without adversely interacting with the lightly damped and low frequency vibration modes of the structure. Modal control schemes have been proposed to deal with these problems. A discrete time parameter adaptive control scheme which uses modal control has been proposed by Montgomery and Johnson (1978). In the present investigation the method considered by Montgomery and Johnson is applied to a homogeneous free-free beam in both numerical simulation and laboratory experimentation. Mathematical modeling of the beam is treated in a manner expedient for digital simulation and control implementation.

Williams, J. P.↗
NASA NTRS1966

Handling qualities and structural characteristics of the hingeless-rotor helicopter

Several advantages and potential problem areas associated with the hingeless-rotor helicopter are discussed. The extent to which two of the advantages - increased control and damping moments - can be obtained with the hingeless-rotor helicopter is established. The upper limit on the available control and damping moments is associated with the excessive gyroscopic coupling that is obtained with heavy rotor blades. The poten­tial problem areas identified include a structural mode of oscillation very similar to that of a pendulum, which causes undesirably large roll accelera­tions under certain flight conditions, and large cyclic chordwise bending moments that occur during severe maneuvers (the primary structural problem of concern). Solutions are proposed which should eliminate future concern with these problems.

HELICOPTER↗
NASA NTRS2003

Active/Passive Control of Sound Radiation from Panels using Constrained Layer Damping

A hybrid passive/active noise control system utilizing constrained layer damping and model predictive feedback control is presented. This system is used to control the sound radiation of panels due to broadband disturbances. To facilitate the hybrid system design, a methodology for placement of constrained layer damping which targets selected modes based on their relative radiated sound power is developed. The placement methodology is utilized to determine two constrained layer damping configurations for experimental evaluation of a hybrid system. The first configuration targets the (4,1) panel mode which is not controllable by the piezoelectric control actuator, and the (2,3) and (5,2) panel modes. The second configuration targets the (1,1) and (3,1) modes. The experimental results demonstrate the improved reduction of radiated sound power using the hybrid passive/active control system as compared to the active control system alone.

Gibbs, Gary P.↗
NASA NTRS1994

Software for continuum modeling of controls-structures interactions

It is clear that computer software is needed to assist in the generation of the equations of motion for complex, flexible spacecraft. Daniel Poelaert of ESTEC has developed the software DISTEL with which he has modeled the structural dynamics for different satellites. He is interested in expanding the capabilities of DISTEL to include structural damping and control systems. Unfortunately, the software has not been released. The author has developed similar software, PDEMOD, which has been used to model the Spacecraft control Laboratory Experiment (SCOLE), the Solar Array Flight Experiment (SAFE), the Mini-MAST truss, and the LACE satellite. PDEMOD has been used also for optimal parameter estimation and integrated control-structures design. PDEMOD is also being extended to include structural damping and control systems which are imbedded into the same equations for the structural dynamics. This paper will address the formulation of the equations for the structural dynamics of spacecraft structures which are constructed of a 3-dimensional arrangement of rigid bodies and flexible beam elements. Control system dynamics are imbedded into the same equations so that model order reduction approximations are not necessary. The input data consists of the physical data of the elements and the topological information describing how the elements are connected. PDEMOD accomplishes the following: (1) automatically assembles the equations of motion for the entire structural model; (2) calculates the modal frequencies; (3) calculates the mode shapes; (4) generates perspective views of the mode shapes; and (5) forms selected transfer functions. The software PDEMOD continues to be developed to provide additional features to assist in analyzing and synthesizing control and structural systems for flexible spacecraft.

Taylor, Lawrence W., Jr.↗
NASA NTRS1992

Solar sail attitude control including active nutation damping in a fixed-momentum wheel satellite

In geostationary cruise of a momentum biased satellite, it is necessary to stabilize the roll/yaw attitude due to disturbances, caused mainly by solar radiation pressure. This work presents a roll/yaw control which is obtained by the use of solar arrays and fixed flaps as actuators, with a horizon sensor for roll measurement. The design also includes an active nutation damping.

Azor, Ruth↗
NASA NTRS1974

An elementary magnetic attitude control system

A three-axis closed-loop attitude-control system for earth-observatory momentum-bias spacecraft is proposed. A horizon scanner and magnetometer are employed to measure attitude errors; no yaw sensor is required. Appropriate control signals are generated and used to command variable-strength electromagnets, which interact with the geomagnetic field to reduce observed errors. This system provides for initial acquisition, precession control, nutation damping, and pitch-axis momentum control. All functions are performed autonomously - no ground-station interaction is required. Analytical expressions predicting system response are compared with numerical solutions of the governing equations, and with the results of the application of Floquet Theory.-

Stickler, A. C.↗
NASA NTRS1977

Shuttle carrier aircraft flight tests

Since the Space Shuttle will need to be transported from its place of assembly to the launch site, a method has been developed whereby the Shuttle rides piggyback on a modified Boeing 747, called the Shuttle carrier aircraft (SCA). This paper describes tests of the SCA in its mated configuration. Tests include: flutter, found to decrease when fiberglass and wood fairings were added to the base of each supporting pylon; stability and control, found to be acceptable after damping with control pulses; noise and buffet, found high but acceptable; and climb, in which drag was marked but acceptable with the special rated thrust (SRT) power setting. Simulated launch maneuvers were undertaken at an airspeed of 273 KCAS. Transport of the Shuttle takes place with the Shuttle tail cone on, at a cruise speed of 288 KCAS at an altitude of 22,000 feet.

Fulton, F. L., Jr.↗
NASA NTRS1993

Optical pathlength control experiment on JPL phase B testbed

An experimental implementation of a nanometer level optical pathlength control for large baseline space interferometry is presented. The pathlength compensation system is installed on a large flexible experimental truss, thus structural motions play a dominant role in the control system design. The associated control structure interaction problem is addressed to maintain the optical pathlength within the prescribed variation of 10-15 nanometer rms. By a successful blend of a structural control for damping augmentation and a direct pathlength control for the pathlength compensation, the optical pathlength variation has been maintained with 6 nanometer rms under the laboratory ambient disturbance and within 9 nanometer rms under a severe forced resonant disturbance.

Rahman, Zahidul H.↗
NASA NTRS1993

Optical Pathlength Control Experiment on JPL Phase B Testbed

An experimental implementation of a nanometer level optical pathlength control for large baseline space interferometry is presented. The pathlength compensation system is installed on a large flexible experimental truss, thus structural motions play a dominant role in the control system design. The associated control structure interaction problem is addressed to maintain the optical pathlength within the prescribed variation of 10-15 nanometer rms. By a successful blend of a structural control for damping augmentation and a direct pathlength control for the pathlength compensation, the optical pathlength variation has been maintained within 6 nonometer rms under the laboratory ambient disturbance and within 9 nonmeter rms under a severe forced resonant disturbance.

interferometry↗