SEARCH · Engineering Papers

Results for “Notes”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6

All sources NASA NTRS DOE OSTI

DOE OSTI2023

Flow friction in a wide rectangular duct with a beveled inlet: Informal Notes of Fundamental Fluid Physics Studies

Fundamental streamwise pressure distributions were measured at Idaho State University to address a primary objective of obtaining insight into the apparent evolution of air flow regimes at moderate Reynolds numbers in thin, wide rectangular ducts with converging inlets. Ducts of 3.030 and 4.077 mm spacings s (called three and four mm), having non-dimensional lengths of (L/s) ≈ 500.8 and 372.2 and widths (W/s) ≈ 114.6 and 83.2, respectively, were compared. Flow rates ranged from Reynolds numbers based on hydraulic diameter (Re Dh ) of about 980 to 10,000 and corresponding non-dimensional downstream pressure gradient parameters (-K p ) covered the range 0.038 to 0.0061, respectively.

77 NANOSCIENCE AND NANOTECHNOLOGY↗

DOE OSTI2024

Notes on Amplitude versus Phase Comparison Monopulse Antennas for Radar

Monopulse is a technique for determining the Direction of Arrival (DOA) of a radar echo by comparing the simultaneous signal responses from two or more antenna beams or apertures. Two principal architectures are employed: 1) amplitude-comparison monopulse, and 2) phase-comparison monopulse. For a constrained-size fully and uniformly illuminated aperture, there is no meaningful difference between the DOA angle precision achievable by an amplitude monopulse architecture versus a phase monopulse architecture. DOA angle estimation precision is almost exclusively a function of antenna size, operating wavelength, and SNR, regardless of amplitude versus phase monopulse architectures.

47 OTHER INSTRUMENTATION↗

DOE OSTI2024

Notes on Linear FM Chirp for Radar

One of the most iconic of radar waveforms is the Linear FM chirp. It is well-behaved and well-understood, and has become the gold standard against which other radar waveforms are measured. It has a number of desirable attributes, but is not without some issues. It may be processed by a number of techniques with many variations. Details of the Linear FM chirp are presented and discussed in this report.

42 ENGINEERING↗

DOE OSTI2023

Xyce™ Parallel Electronic Simulator Version 7.8 Release Notes

The Xyce™ Parallel Electronic Simulator has been written to support the simulation needs of Sandia National Laboratories’ electrical designers. Xyce™ is a SPICE-compatible simulator with the ability to solve extremely large circuit problems on large-scale parallel computing platforms, but also includes support for most popular parallel and serial computers.

97 MATHEMATICS AND COMPUTING↗

DOE OSTI2023

Notes on Minimum Area for Radar Antenna

Perhaps no single radar component has a more profound effect on Synthetic Aperture Radar (SAR) performance than the antenna. Especially for spaceborne SAR, one particular common design constraint for the antenna is the minimum antenna area constraint. While useful, it relies on a number of assumptions and approximations that may not always be valid or applicable. Indeed, useful operational systems have been built and flown that do not strictly adhere to this constraint. A closer examination of this constraint yields insights into what the real limitations are, or might be.

42 ENGINEERING↗

DOE OSTI2023

Notes on Regression Analysis for Radar Parameter Estimation

A fundamental task of radar, beyond merely detecting a target, is to estimate some parameters associated with it. For example, this might include range, direction, velocity, etc. In any case, multiple measurements, often noisy, need to be processed to yield a ‘best estimate’ of the parameter. A common mathematical method for doing so is called “Regression” analysis. The goal is to minimize the expected squared error in the estimate. Even when alternate algorithms are considered, the least squared-error regression analysis is the benchmark against which alternatives are compared.

47 OTHER INSTRUMENTATION↗

DOE OSTI2024

Mechanical Engineering Safety Note 1012910313-AA: CEA LTIC Structural Integrity

The LRU Target Insert Cryostat (LTIC) is the end effector of the NIF Cryogenic Target Positioner (CryoTarpos), which houses a cooling system to support cryogenic target experiments at NIF. The LTIC maintains a target at micron level positional stability and millikelvin level temperature stability during a NIF shot and is also subject to a portion of the blast load governed by the solid angle subtended by the blast shield at the front of the system. This MESN evaluates loading of the CEA LTIC, a redesigned LTIC to be fielded at Laser Megajoule (LMJ) in France, which has been designed to lay out requirements agreed upon between LLNL and CEA personnel. The LMJ version of CryoTarpos is referred to as the PCC. A high-level system overview of the LTIC on the PCC is shown.

42 ENGINEERING↗

DOE OSTI2024

Q & A Notes by Ramona Vogt, FPY CRP3, IAEA, 2-6 December 2024

Abstract not provided.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

DOE OSTI2024

Notes on Synthetic Aperture Radar Image Quality

Synthetic Aperture Radar (SAR) creates an image of a target scene by coherently processing radar echo returns collected along a flightpath. The quality of the SAR image is inextricably linked to the utility of the image for exploitation supporting the task at hand. Aspects of quality include the fidelity with which it can render the scene being imaged, to include the system’s Impulse Response (IPR) and underlying noise levels/characteristics. Other factors also impact utility.

47 OTHER INSTRUMENTATION↗

DOE OSTI2024

Notes on Real-Beam Ground Mapping with Monopulse Radar

The spatial awareness required of modern flight systems is facilitated by images generated by ground-mapping radar. In the forward and aft directions, synthetic aperture techniques are not viable, leaving us with enhancing real aperture radar data. Enhancing real aperture radar data with monopulse information can be achieved with any of several monopulse beam sharpening techniques. Two such algorithms are discussed.

47 OTHER INSTRUMENTATION↗

DOE OSTI2025

Notes on Tapered Active Array Antenna Performance

Modern Active Electronically Steerable Array (AESA) antennas offer substantial control over transmit and receive antenna beam forming, including via elemental weighting to achieve a desired tapered aperture. However, these tapers also have the adverse side effect of diminishing total transmitted power and/or raising the system noise figure. This is readily calculated, and must be considered for overall radar performance prediction. Independent tapers for transmit and receive arrays might be play.

42 ENGINEERING↗

DOE OSTI2025

MCNP® Code Version 6.3.1 Release Notes

The Monte Carlo N-Particle® (MCNP® ) code is a general-purpose, continuous-energy, generalized-geometry, time-dependent, radiation transport code developed by the MCNP development team. MCNP calculations provide predictive capabilities that can replace expensive or impossible-to-perform experiments. Specific application problems include simulations of experimental diagnostics, intrinsic radiation, radiation detection and measurement, criticality safety, nuclear threat reduction and response, radiation health protection, nuclear weapons effects, and nuclear forensics. This MCNP code, version 6.3.1, follows the MCNP6.3.0 version. Since the release of MCNP6.3.0, a variety of bug fixes and code enhancements have been completed for MCNP6.3.1. A few new features have also been added to this release to support both ongoing research and the release of the latest ENDF/B-VIII.1 nuclear data library. The MCNP code, version 6.3.1, theory and user input information is documented in MCNP® Code Version 6.3.1 Theory & User Manual, the build guidance for various platforms is documented in MCNP® Code Version 6.3.1 Build Guide, and the verification and validation testing for various application benchmark test suites is documented in MCNP® Code Version 6.3.1 Verification & Validation Testing.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

DOE OSTI2025

U.S. Efforts in Support of Examinations at Fukushima Daiichi - September 2024 Meeting Notes

Information obtained from Fukushima Daiichi Nuclear Power Station (Daiichi) is required to inform future Decontamination and Decommissioning (D&D) activities, improving the ability of the Tokyo Electric Power Company Holdings, Incorporated (TEPCO Holdings) to characterize potential hazards and to ensure the safety of workers involved with cleanup activities. This information also has important implications for the safety and operation of U.S. Commercial nuclear power plants. A collaborative U.S. and Japanese effort was initiated in 2014 by the Department of Energy Office of Nuclear Energy to identify Daiichi examination needs and evaluate recent Daiichi examination data to address these needs. This document summarizes information presented at and findings, action items, and recommendations by U.S. and Japanese experts in reactor safety and plant operations during the September 2024 Forensics Effort meeting. Significant safety insights were obtained in several areas: system and component performance, radionuclide surveys and sampling, debris end-state location, combustible gas effects, and plant operations and maintenance. In addition to reducing uncertainties and knowledge gaps in severe accident modeling progression, these insights continue to be used to assess whether additional updates are needed in guidance for severe accident prevention, mitigation, and emergency planning. Furthermore, Daiichi-related activities, such as code modeling improvements and analysis, testing, and new technology deployment efforts, have the potential to offer additional safety and economic benefits to the operating fleet and new light water reactor (LWR) and non-LWR designs.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

DOE OSTI2025

Notes on Bayliss Taper for Monopulse Radar

A radar system’s antenna characteristics are fundamental to its performance. A principal defining feature of an antenna’s performance are its often problematic sidelobes. Often in monopulse antenna topologies, the emphasis has been on the sum channel sidelobes at the expense of difference channel sidelobes. Edward Bayliss published a paper detailing a design procedure for managing the difference channel sidelobes. The resulting aperture taper now is identified by his name. This report analyzes his taper derivation, and resulting performance attributes, after which some implementation comments are rendered.

42 ENGINEERING↗

DOE OSTI2025

Xyce™ Parallel Electronic Simulator Version 7.10 Release Notes

97 MATHEMATICS AND COMPUTING↗

DOE OSTI2020

Watchmen v2.5.2 Release Notes

This document describes the changes to Watchmen. This includes improvements to stability and the importation of station data from non-standard #RASAData block to standard #ProcessSensor block.

97 MATHEMATICS AND COMPUTING↗

DOE OSTI2022

Watchmen v3.1.0 Release Notes

This document describes the changes to Watchmen. This includes improvements to stability, search features, display of more detailed sample information and user access via authentication.

97 MATHEMATICS AND COMPUTING↗

DOE OSTI2022

Watchmen v3.2.0 Release Notes

This document describes the changes to Watchmen. This includes improvements to stability, search features, display of more detailed sample information and user access via authentication.

97 MATHEMATICS AND COMPUTING↗