Engineering PapersSearch

SEARCH · Engineering Papers

Results for “Intermediate”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6

Two-photon excitation cross section in light and intermediate atoms in frozen-core LS-coupling approximation

Using the method of explicit summation over the intermediate states two-photon absorption cross sections in light and intermediate atoms based on the simplistic frozen-core approximation and LS coupling have been formulated. Formulas for the cross section in terms of integrals over radial wave functions are given. Two selection rules, one exact and one approximate, valid within the stated approximations are derived. The formulas are applied to two-photon absorptions in nitrogen, oxygen, and chlorine. In evaluating the radial integrals, for low-lying levels, the Hartree-Fock wave functions, and for high-lying levels, hydrogenic wave functions obtained by the quantum-defect method have been used. A relationship between the cross section and the oscillator strengths is derived.

Omidvar, K.

Observations of the Ca/+/ twilight airglow from intermediate layers of ionization

Optical and incoherent scatter radar techniques are applied to detect the presence of Ca(+) in lower thermospheric intermediate layers over Arecibo. The Arecibo 430 MHz radar is used to measure electron densities, and the altitude distribution and density of the calcium ion is inferred from the variation of twilight resonant scattering with solar depression angle. Ca(+) and electron column densities are compared, and results indicate that the composition of low-altitude intermediate layers is 2% Ca(+), which is consistent with rocket mass spectrometer measurements. Fe(+) and Mg(+) ultraviolet resonance lines are not detected from the ground due to ozone absorbing all radiation short of 3000 A, and measurements of the neutral iron resonance line at 3860 A show that an atmospheric continuum may result in overestimations of emission rates at high solar depression angles.

Tepley, C. A.

Stability analysis of intermediate boundary conditions in approximate factorization schemes

In many cases, approximate factorization schemes have provided a significant increase in efficiency over previously used solution methods in certain problems. The present investigation is concerned with the importance of intermediate boundary conditions in approximate factorization schemes, taking into account a specific example regarding a boundary-induced stability restriction in a scheme for the transonic full-potential equation. The considered scheme has been discussed by Holst (1979). Holst's scheme is a variation of the AF2 schemes described by Ballhaus and Steger (1975). The application of the AF2 scheme to the two-dimensional Laplace equation in a rectangle is studied giving attention to the stability of the scheme in connection with various boundary conditions for the intermediate variable.

South, J. C., Jr.

Optimal symmetric flight with an intermediate vehicle model

The present investigation is concerned with an examination of optimal symmetry flight on the basis of the intermediate vehicle model. The analysis is partly based upon an exploration of Euler solutions for the path-angle-as-control model carried out by Kelley (1958). The current analysis takes into account higher-order optimality conditions and 'chattering-control' phenomena. Attention is given to details regarding the intermediate vehicle model, the Legendre-Clebsch necessary condition, the conjugate-point test, and the numerical solution of the time-range problem. It is found that the flight path angle takes on the role of control variable in the model. From physical considerations, it can be seen that when a positive margin of thrust over drag exists, the maximum-range climb trajectory without time or fuel constraints has no proper maximum nor an upper bound.

Kelley, H. J.

Optimal symmetric flight with an intermediate vehicle model

The present investigation is concerned with an examination of optimal symmetry flight on the basis of the intermediate vehicle model. The analysis is partly based upon an exploration of Euler solutions for the path-angle-as-control model carried out by Kelley (1958). The current analysis takes into account higher-order optimality conditions and "chattering-control' phenomena. Attention is given to details regarding the intermediate vehicle model, the Legendre-Clebsch necessary condition, the conjugate-point test, and the numerical solution of the time-range problem. It is found that the flight path angle takes on the role of control variable in the model. From physical considerations, it can be seen that when a positive margin of thrust over drag exists, the maximum-range climb trajectory without time or fuel constraints has no proper maximum nor an upper bound.

Menon, P. K. A.

Energy efficient engine: Turbine intermediate case and low-pressure turbine component test hardware detailed design report

A four stage, low pressure turbine component has been designed to power the fan and low pressure compressor system in the Energy Efficient Engine. Designs for a turbine intermediate case and an exit guide vane assembly also have been established. The components incorporate numerous technology features to enhance efficiency, durability, and performance retention. These designs reflect a positive step towards improving engine fuel efficiency on a component level. The aerodynamic and thermal/mechanical designs of the intermediate case and low pressure turbine components are presented and described. An overview of the predicted performance of the various component designs is given.

Leach, K.

Intermediate power conditioners - Where are we now?

It has been recognized in the photovoltaic (PV) industry that even in the event of a dramatic reduction in the price of generating PV cells, the costs for the other components of the system represent still a major obstacle towards commercialization. A project was, therefore, initiated with the aim to develop baseline and conceptual power conditioner designs which would attempt to meet a specified set of cost and performance goals in the 30 to 200 kW (Intermediate) size. Resulting Intermediate Size Power Conditioner Studies led to a number of conclusions. There is a need for a set of guidelines or standards for utility interconnection. The advent of new devices with more power handling capability will change the desired topology.

Klein, J. W.

Intermediate boundary conditions for LOD, ADI and approximate factorization methods

A general approach to determining the correct intermediate boundary conditions for dimensional splitting methods is presented. The intermediate solution U is viewed as a second order accurate approximation to a modified equation. Deriving the modified equation and using the relationship between this equation and the original equation allows us to determine the correct boundary conditions for U*. This technique is illustrated by applying it to locally one dimensional (LOD) and alternating direction implicit (ADI) methods for the heat equation in two and three space dimensions. The approximate factorization method is considered in slightly more generality.

Leveque, R. J.

Intermediate phases in some rare earth-ruthenium systems

The phase equilibria and crystal structures of intermediate phases were investigated in eight representative RE-Ru systems using powder X-ray diffraction and metallographic techniques. The Fe3C, Mn5C2 and Er5Ru3 structures occur in all but the Ce-Ru systems. Phases analogous to Er5Ru3 possess an unknown crystal structure similar to Er5Rh3(I). MgCu2 and MgZn2 type Laves phases are encountered in the light rare earth and heavy rare earth systems, respectively, and RERu2 phases, where RE = Nd and Sm, possess both the Laves phase structures. An intermediate phase, NdRu, with an unknown structure, occurs only in the Nd-Ru system. A bcc structure with 40 atoms per unit cell is encountered in the phases Er3Ru2 and Y3Ru2. The behavior of cerium in Ce-Ru alloys is unique in that four unidentified structures, not encountered in other RE-Ru systems, have been encountered. Also a phase designated as Ce3Ru is found with the Th7Fe3 type structure.

Sharifrazi, P.

High time resolution characteristics of intermediate ion distributions upstream of the earth's bow shock

High time resolution particle data upstream of the bow shock during time intervals that have been identified as having intermediate ion distributions often show high amplitude oscillations in the ion fluxes of energy 2 and 6 keV. These ion oscillations, observed with the particle instruments of the University of California, Berkeley, on the ISEE 1 and 2 spacecraft, are at the same frequency (about 0.04 Hz) as the magnetic field oscillations. Typically, the 6-keV ion flux increases then the 2-keV flux increases followed by a decrease in the 2-keV flux and then the 6-keV flux decreases. This process repeats many times. Although there is no entirely satisfactory explanation, the presence of these ion flux oscillations suggests that distributions often are misidentified as intermediate ion distributions.

Potter, D. W.

Intermediate-Frequency-to-Video-Band Converter

Analog and digital circuits combined to frequency-convert from intermediate frequencies directly to video-band frequencies to meet stringent requirements. IF-to-video-band converter operates on principle of signal-band cancellation in phase-quadrature circuits. Downconverts intermediate frequencies directly to video-band frequencies to near-zero frequency with good image-band rejection and low phase variation within passband.

Ham, N. C.

Intermediate and narrow band photometry of Epsilon Aurigae

Intermediate band blue (4530A), far red (7790A) and H-alpha intermediate and narrow band photoelectric observations of the peculiar, 27 year eclipsing binary, Epsilon Aurigae were made from December 1981 through the present (December 1984). BD +42 1170 served as the primary comparison star because of its angular proximity to the variable star. The analysis of this data along with other available photometry was undertaken to study the characteristics of the low amplitude, semi-regular light variations that appear inside and outside of eclipse. It appears that these short term light variations arise from nonradial pulsations of the luminous f supergiant in the system. Furthermore, the semi-regular light variations found for Epsilon Aurigae are similar to those found for other luminous A-F supergiants. Also, the preliminary results from the analyses of the light variations produced by the eclipse of the F-supergiant by the mysterious cooler component is discussed.

Donovan, R. A.

Studies of the marine crustal magnetization at intermediate wavelengths

The data can be filtered at intermediate wavelengths to provde a data set which complements the satellite fields of MAGSAT, TSS and GRM. The filtered marine data set provides a high resolution data set which is closer to the source bodies than satellite survey data. However, the GRM and TSS could provide the necessary resolution to match the filtered sea surface field. The added resolution determines the nature of crustal magnetizations which give rise to the intermediate wavelength field. It is found that remanent magnetization is an important component over the oceans. Crustal deformation and plate motions result in magnetization vectors which differ significantly from the present day field directions. Induced magnetization or GRM are important components over the oceanic plateaus and spreading centers.

Labrecque, J. L.

The source of the intermediate wavelength component of the Earth's magnetic field

The intermediate wavelength component of the Earth's magnetic field has been well documented by observations made by MAGSAT. It has been shown that some significant fraction of this component is likely to be caused within the core of the Earth. Evidence for this comes from analysis of the intermediate wavelength component revealed by spherical harmonics between degrees 14 and 23, in which it is shown that it is unlikely that all of this signal is crustal. Firstly, there is no difference between average continental source strength and average oceanic source strength, which is unlikely to be the case if the anomalies reside within the crust, taking into account the very different nature and thickness of continental and oceanic crust. Secondly, there is almost no latitudinal variation in the source strength, which is puzzling if the sources are within the crust and have been formed by present or past magnetic fields with a factor of two difference in intensity between the equator and the poles. If however most of the sources for this field reside within the core, then these observations are not very surprising.

Harrison, C. G. A.

On the constancy of intermediate-degree p-mode frequencies during the declining phase of solar cycle 21

A comparison was made between two sets of frequencies of intermediate-degree solar p-mode oscillations obtained in late 1981 and mid-1984. Good agreement was found at the 0.02 microHz level despite the 2.6 yr interval separating the two sets of observations. In particular, a comparison was made between the frequencies of 573 modes obtained at the South Pole during December 24-25, 1981 and those of the same modes as observed at the Mount Wilson Observatory 60-ft Solar Tower during July 29-August 13, 1984. The present results are consistent with no change in intermediate-degree p-mode frequencies between late 1981 and mid-1985.

Rhodes, Edward J., Jr.

Novel nitrogen-based organosulfur electrodes for advanced intermediate temperature batteries

Advanced secondary batteries operating at intermediate temperatures (100 to 200 C) have attracted considerable interest due to their inherent advantages (reduced corrosion and safety risks) over higher temperature systems. Current work in this laboratory has involved research on a class of intermediate temperature Na/beta double prime- alumina/RSSR batteries conceptually similar to Na/S cells, but operating within a temperature range of 100 to 150 C, and having an organosulfur rather than inorganic sulfur positive electrode. The organosulfur electrodes are based on the reversible, two electron eduction of organodisulfides to the corresponding thiolate anions, RSSR + 2 electrons yield 2RS(-), where R is an organic moiety. Among the advantages of such a generic redox couple for battery research is the ability to tailor the physical, chemical, and electrochemical properties of the RSSR molecule through choice of the organic moiety. The viscosity, liquidus range, dielectric constant, equivalent weight, and redox potential can in fact be verified in a largely predictable manner. The current work concerns the use of multiple nitrogen organosulfur molecules, chosen for application in Na/RSSR cells for their expected oxidizing character. In fact, a Na/RSSR cell containing one of these materials, the sodium salt of 5-mercapto 1-methyltetrazole, yielded the highest open circuit voltage obtained yet in the laboratory; 3.0 volts in the charged state and 2.6 volts at 100 percent discharge. Accordingly, the cycling behavior of a series of multiple nitrogen organodisulfides as well as polymeric organodisulfides are presented in this manuscript.

Visco, S. J.

Synthesis of Y1Ba2Cu3O(sub x) superconducting powders by intermediate phase reaction

One of the more striking problems for the synthesis of the Y1Ba2Cu3Ox compound is the high-temperature decomposition of the BaCO3. This compound is present as raw material or as an intermediate compound in chemical processes such as amorphous citrate, coprecipitation oxalate, sol-gel process, acetate pyrolisis, etc. This fact makes difficult the total formation reaction of the Y1Ba2Cu3Ox phase and leads to the presence of undesirable phases such as the BaCuO2 phase, the 'green phase', Y2BaCuO5 and others. Here, a new procedure to overcome this difficulty is studied. The barium cation is previously combined with yttrium and/or copper to form intermediate compounds which can react between them to give Y1Ba2Cu3Ox. BaY2O4 and BaCu2O3 react according to the equation BaY2O4+3BaCu2O3 yields 2Y1Ba2Cu3Ox. BaY2O4 is a stable compound of the Y2O3-BaO system; BaCu2O3 is an intimate mixture of BaCuO2 and uncombined CuO. The reaction kinetics of these phases have been established between 860 and 920 C. The phase evolution has been determined. The crystal structure of the Y1Ba2Cu3Ox obtained powder was studied. According to the results obtained from the kinetics study the Y1Ba2Cu3Ox the synthesis was performed at temperatures of 910 to 920 C for short treatment times (1 to 2 hours). Pure Y1Ba2Cu3Ox was prepared, which develops orthorombic type I structure despite of the cooling cycle. Superconducting transition took place at 91 K. The sintering behavior and the superconducting properties of sintered samples were studied. Density, microstructure and electrical conductivity were measured. Sintering densities higher than 95 percent D(sub th) were attained at temperatures below 940 C. Relatively fine grained microstructure was observed, and little or no-liquid phase was detected.

Moore, C.