Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “GAS DISCHARGE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6
All sourcesNASA NTRSDOE OSTI
NASA NTRS1973

Excitation of atomic nitrogen by electron impact.

Measurement of the absolute cross sections for the excitation of a number of N I multiplets by electron impact on atomic nitrogen. Two of these cross sections - 1134 and 1200 A - are found to be large, reaching 2.0 x 10 to the minus 16th and 2.5 x 10 to the minus 16th sq cm at their peaks, respectively. The presence of vibrationally excited molecular nitrogen in the discharged gas is confirmed, and its effect on the measurements is discussed. The ratio of the oscillator strengths of the 1200- and 1134-A resonance transitions is measured to be 2.6 plus or minus 0.3.

Stone, E. J.↗
NASA NTRS1973

On the minimization of the prime power consumption of a coupling-modulated gas laser transmitter

The prime power requirements of a coupling-modulated gas laser transmitter are presented. The latter consists of a gas discharge tube and electro-optic modulator inside a laser resonator. In performing the calculations, the laser discharge length and the modulator voltage are simultaneously varied so that the transmitted power remains constant. In this way, tradeoffs can be made between the prime power supplied individually to the discharge tube and to the modulator driver to obtain a transmitter configuration which minimizes the total prime power consumption. An analytical expression is derived which describes the effects of information bandwidth and transmitter output power on the prime power requirements. Specific numerical results are obtained for a CO2 laser transmitter based on presently available experimental data.

Degnan, J. J.↗
NASA NTRS1974

Cold cathodes for sealed-off CO2 lasers

Cold cathodes for CO2 lasers should possess a very low sputtering rate, have a minimum of negative ions in the sputtering products, and consume no oxygen. These conditions can be satisfied by selecting cathode materials from those elements of group I in the periodic table which form semiconducting oxide layers and then exposing these elements to a reducing gas mixture. Experimental results show that silver, internally oxidized silver-copper alloys, and pure copper satisfy most of these requirements in He-CO2-CO-Xe gas mixtures. Infrared CO and CO2 gas analysis performed on simple gas discharge tubes using such cathodes indicate that laser lives of 10,000 hr can be expected.

Hochuli, U. E.↗
NASA NTRS1974

Minimization of the prime power consumption of a coupling-modulated gas laser transmitter

The present article addresses itself to the prime power requirements of a coupling-modulated gas laser transmitter. The latter consists of a gas discharge tube and electrooptic modulator inside a laser resonator. In performing the calculations, the laser discharge length and the modulator voltage are simultaneously varied so that the transmitted power remains constant. In this way, tradeoffs can be made between the prime power supplied individually to the discharge tube and to the modulator driver to obtain a transmitter configuration that minimizes the total prime power consumption. An analytical expression is derived that describes the effects of information bandwidth and transmitter output power on the prime power requirements. Specific numerical results are obtained for a CO2 laser transmitter based on presently available experimental data.

Degnan, J. J.↗
NASA NTRS1975

Moisture resistant and anti-reflection optical coatings produced by plasma polymerization of organic compounds

The need for protective coatings on critical optical surfaces, such as halide crystal windows or lenses used in spectroscopy, has long been recognized. It has been demonstrated that thin, one micron, organic coatings produced by polymerization of flourinated monomers in low temperature gas discharge (plasma) exhibit very high degrees of moisture resistence, e.g., hundreds of hours protection for cesium iodide vs. minutes before degradation sets in for untreated surfaces. The index of refraction of these coatings is intermediate between that of the halide substrate and air, a condition for anti-reflection, another desirable property of optical coatings. Thus, the organic coatings not only offer protection, but improved transmittance as well. The polymer coating is non-absorbing over the range 0.4 to 40 microns with an exception at 8.0 microns, the expected absorption for C-F bonds.

Hollahan, J. R.↗
NASA NTRS1976

Theoretical investigations of plasma processes

System analyses are presented for electrically sustained, collision dominated plasma centrifuges, in which the plasma rotates under the influence of the Lorentz forces resulting from the interaction of the current density fields with an external magnetic field. It is shown that gas discharge centrifuges are technically feasible in which the plasma rotates at speeds up to 1 million cm/sec. The associated centrifugal forces produce a significant spatial isotope separation, which is somewhat perturbed in the viscous boundary layers at the centrifuge walls. The isotope separation effect is the more pronounced. The induced magnetic fields have negligible influence on the plasma rotation if the Hall coefficient is small. In the technical realization of collision dominated plasma centrifuges, a trade-off has to be made between power density and speeds of rotation. The diffusion of sputtered atoms to system surfaces of ion propulsion systems and the deposition of the atoms are treated theoretically by means of a simple model which permits an analytical solution. The problem leads to an inhomogeneous integral equation.

Wilhelm, H. E.↗
NASA NTRS1977

Technology of GaAs metal-oxide-semiconductor solar cells

The growth of an oxide interfacial layer was recently found to increase the open-circuit voltage (OCV) and efficiency by up to 60 per cent in GaAs metal-semiconductor solar cells. Details of oxidation techniques to provide the necessary oxide thickness and chemical structure and using ozone, water-vapor-saturated oxygen, or oxygen gas discharges are described, as well as apparent crystallographic orientation effects. Preliminary results of the oxide chemistry obtained from X-ray, photoelectron spectroscopy are given. Ratios of arsenic oxide to gallium oxide of unity or less seem to be preferable. Samples with the highest OVC predominantly have As(+3) in the arsenic oxide rather than As(+5). A major difficulty at this time is a reduction in OCV by 100-200 mV when the antireflection coating is vacuum deposited.

Stirn, R. J.↗
NASA NTRS1976

Life problems of small CO2 waveguide lasers

Gas discharge tube results, using the cathode technology developed for the ordinary one watt CW CO2 laser, promise life of at least a few thousand hours for the longitudinally excited waveguide laser. Actual lasers still suffer from excessive cathode sputtering, mirror deposits, and cathode flickering. The present state of this technology offers no easy solutions to extend the life of the transversely excited, pulsed CO2 waveguide laser.

Hochuli, U. E.↗
NASA NTRS1978

Flow of viscous gas in the region of a slot with strong suction

The flow of a perfect viscous gas was studied in the region of a slot with strong suction. Velocity and temperature distribution fields are computed of the case of thermally insulated and heat conducting surfaces. The dependence of the flow characteristics on the suction gas discharge is obtained for a single slot with strong suction.

Kozlov, L. P.↗
NASA NTRS1979

Trajectories of charged particles in radial electric and uniform axial magnetic fields

Trajectories of charged particles were determined over a wide range of parameters characterizing motion in cylindrical low-pressure gas discharges and plasma heating devices which have steady radial electric fields perpendicular to uniform steady magnetic fields. Consideration was given to radial distributions characteristic of fields measured in a modified Penning discharge, in two NASA Lewis burnout-type plasma heating devices, and that estimated for the Ixion device. Numerical calculations of trajectories for such devices showed that differences between cyclotron frequency and qB/m and between azimuthal drift and a guiding center approximation are appreciable.

Englert, G. W.↗
NASA NTRS1983

The development, performance, and potential application of the copper halide laser

The copper halide laser (CHL) is an efficient gas discharge laser that emits short pulses at two discrete wavelengths in the yellow and green spectral region. The laser pulse results from transitions in excited copper atoms. The CHL has produced pulses of up to 10 mJ in a double-pulsed mode at low repetition rates and has been operated at very high repetition rates (8 to over 35 kHz) in a continuously pulsed mode with a maximum average-power of 15 watts. In this paper, the development of the copper halide laser is reviewed along with a brief description of the copper laser operating principles. In the final section, a number of applications of the CHL are identified.

Pivirotto, T. J.↗
NASA NTRS1984

Fracto-emission - The role of charge separation

Fracto-emission is the emission of particles (e.g., electrons, ions, ground state and excited neutrals, and photons) during and following fracture. It is found that during fracture in vacuum of adhesive bonds and crystalline materials involving large amounts of charge separation on the surface the emission of charged particles, excited neutrals, light, and radio waves occurs with unique and revealing time dependencies. Simultaneous fracto-emission measurements on several systems are reported. The results are interpreted in terms of a conceptual model involving the following steps: (1) charge separation due to fracture, (2) desorption of gases from the material into the crack tip, (3) a gas discharge in the crack, (4) energetic bombardment of the freshly created crack walls, and (5) thermally stimulated electron emission, accompanied by electron stimulated desorption of ions and excited neutrals. In addition to evidence from fracture experiments, results from studies of electron bombardment of a polymer surface are presented.

Dickinson, J. T.↗
NASA NTRS1985

Variations of the cosmic ray general component in Antarctica

A cosmic ray variations, zonal cosmic ray modulation, was found in the lower atmosphere from the sonde measurement results. The variations give rise to anomalies in the latitude distributions of the cosmic ray charged component and the anomalous north-south asymmetry. To find the nature of the variations, the cosmic ray general component was measured with the same detectors as in the sonde measurements gas discharge counters and the counter telescopes with 7-mm Al filters detecting the electrons of energy above 200 keV and 5 MeV. The measurement data obtained in Antarctica in the years 1978 to 1983 are presented and discussed.

Charakhchyan, T. N.↗
NASA NTRS1985

Diurnal effect in cosmic rays at middle latitudes according to stratospheric measurements

Results of measurements of the diurnal wave of the cosmic ray (CR) intensity in stratosphere at the latitude with the geomagnetic cutoff rigidity R sub c = 7.6 GV are presented. Measurements of diurnal variation of the CR intensity were carried by means of radiosondes: by a detector composed of a gas discharge counter CTC-6 and a telescope containing two counters with a 7 mm aluminum filter between them.

Asatryan, G. A.↗
NASA NTRS1986

Solid-state radio frequency oscillator for optogalvanic spectroscopy - Detection of nitric oxide using the 2-0 overtone transition

A compact, solid-state radio-frequency oscillator of low-power consumption is described, which allows quantitative measurement of the optogalvanic effect in low-pressure gas discharges. The oscillator has been used to record a portion of the 2-0 overtone band of nitric oxide at a pressure of about 1 Torr using a tunable color-center laser operating at 2.65 microns.

May, R. D.↗
NASA NTRS1987

Microwave electrothermal thruster performance in helium gas

The microwave electrothermal thruster presented uses an internally tuned, single-mode cylindrical cavity applicator to focus and match microwave energy into an electrodeless, high pressure flowing gas discharge that is located within a quartz discharge chamber. Experimental measurements of microwave coupling efficiency, thruster energy efficiency, and specific impulse, are obtained for N and He discharges; the efficiency of microwave energy transfer to the discharge is found to be of the order of 95 percent. Higher temperature nozzle materials and more efficient discharge chambers will further enhance performance.

Whitehair, S.↗
NASA NTRS1988

Experimental results on atomic oxygen corrosion of silver

The results of an experimental study of the reaction kinetics of silver with atomic oxygen in 10 degree increments over the temperature range of 0 to 70 C is reported. The silver specimens, of the order of 10,000 A in thickness, were prepared by thermal evaporation onto 3 inch diameter polished silicon wafers. There were later sliced into pieces having surface areas of the order of 1/4 to 1/2 square inch. Atomic oxygen was generated by a gas discharge in a commercial plasmod asher operating in the megahertz frequency range. The sample temperature within the chamber was controlled by means of a thermoelectric unit. Exposure of the silver specimens to atomic oxygen was incremental, with oxide film thickness measurements being carried out between exposures by means of an automated ellipsometer. For the early growth phase, the data can be described satisfactorily by a logarithmic growth law: the oxide film thickness increases as the logarithm of the exposure time. Furthermore, the oxidation process is thermally activated, the rate increasing with increasing temperature. However, the empirical activation energy parameter deduced from Arrhenius plots is quite low, being of the order of 0.1 eV.

Fromhold, Albert T.↗
NASA NTRS1988

A high voltage power converter for space astronomy applications

A dc-dc low-power, high-voltage converter for use in space is described which furnishes a commandable, low-noise dc output in the range of 0 to -7500 V. The converter is suitable for biasing of detectors commonly employed in space astronomy, microchannel plates, photomultipliers, and gas discharge detectors. The converter's reliability has been demonstrated by accelerated life testing under thermal vacuum. The electrical and mechanical design, packaging, layout and fabrication techniques, and tests employed are described.

Ray, David C.↗