A method of mapping Jupiter's gravitational potential by means of a proposed orbiting spacecraft
Jupiter gravitational potential mapping for Grand Tours spacecraft, discussing Jovian satellites effect on orbit and trajectory perturbations
SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Jupiter gravitational potential mapping for Grand Tours spacecraft, discussing Jovian satellites effect on orbit and trajectory perturbations
Angular dependence of specularity parameter /probability of specular scattering of electron incident upon surface/ via magnetic field dependence of magnetomorphic harmonic oscillations
Colorimetry of Mars surface from dual beam area scanner, considering light and dark areas contrast during 1969 opposition
Earth radiation budget measurements, noting planetary albedo, IR radiant emittance and net balance
Russell law validity of planet brightness dependence on phase integral, discussing backscattering surface and thick atmospheres effects
The Moire method experimental stress analysis is similar to a problem encountered in astrometry. It is necessary to extract accurate coordinates from images on photographic plates. The solution to the mutual problem found applicable to the field of experimental stress analysis is presented to outline the measurement problem. A discussion of the photo-reading device developed to make the measurements follows.
Changes in respiratory variance revealed by power spectral analysis of the pulmonary impedance pneumogram can be used to detect and measure stresses directly or indirectly affecting human respiratory function. When gastrointestinal distress occurred during a series of 5 total-body exposures of 30 R at a rate of 1.5 R/min, it was accompanied by typical shifts in pulmonary impedance power spectra. These changes did not occur after protracted exposure of 250 R (30 R daily) at 1.5 R/hr that failed to cause radiation sickness. This system for quantitating respiratory effort can also be used to detect alterations in one's ability to perform under controlled exercise conditions.
An experiment is proposed to test a first generation spacecraft-borne radar altimeter's capability to measure the topography of the sea surface. The initial radar altimeter will have an instrumental error of one meter and an overall accuracy to two to five meters. This instrument will thus improve the accuracy of the geoid from the present 10 to 20 meters to better than 5 meters. In order to detect storm surges, tidal forces, and ocean currents, an altimeter with an overall accuracy of at least ?1 meter will be required. The overall accuracy of the initial radar altimeter will thus primarily provide geodetic information and possible oceanographic information such as sea state.
The development of rapid and accurate wind tunnel techniques to measure convective heating distributions in complex reentry configurations is discussed. Major emphasis was put on the infrared camera technique. Its essence is the measurement of infrared emission from the surface of a wind tunnel model as a function of time. Prior calibration of the infrared camera relates the emission to the surface temperature of the model. The time history of the surface temperature can then be related to the heating rate by standard techniques. The output of the camera is an electrical signal that is tape-recorded in analog form, then digitized and processed by computer, so that automated and relatively rapid data reduction can be accomplished. In addition, the camera produces real-time visual displays of the infrared emission as pictures on an oscilloscope screen. These pictures give immediate indications of hot and cool spots on the model.
A preliminary mission study of a reusable vehicle from staging to orbit indicates payload advantages for a dual-propulsion system consisting of separate scramjet and rocket engines. In the analysis the scramjet operated continuously and the initiation of rocket operation was varied. For a stage weight of 500,000 lb the payload was 10.4 percent of stage weight or 70 percent greater than that of a comparable all-rocket-powered stage. When compared with a reusable two-state rocket vehicle having 50,000 lb payload, the use of the dual propulsion system for the second stage resulted in significant decreases in lift-off weight and empty weight, indicating possible lower hardware costs.
Two endurance tests of a 5-cm mercury bombardment thruster are reported. Both tests used a translational screen-grid system with the beam vectored 10 degrees. The first test lasted 141 hours and the second test operated for 2026 hours. In each test two fused silica samples (solar cell covers), 2.0 cm by 2.1 cm, were placed in shielded holders to detect materials sputtered from the thruster. Spectral optical properties between 0.398 and 2.16 microns were measured on each sample, both before and after the endurance tests. The deposition on each sample was spectrographically analyzed to determine the type of materials sputtered from the thruster. It was found that sputtering from the neutralizer is highly dependent on its position with respect to the beam edge. The sputtering from the accelerator grid of the translational screen-grid system of the 2026 hour test was sufficient to form an opaque film on the sample located in the direction opposite to the vectored beam.
Experimental intensity ratios of Auger transitions for Co, Ni, Cu, and Zn as well as the relative L sub 2 and L sub 3 level widths of Cu and Zn, derived from their photoelectron spectra, are presented. Evidence is presented that a great deal of vacancy reorganization took place following photoionization and prior to Auger emission. These reorganizations are assumed to be due to Coster-Kronig transitions f sub 23. These results are compared with theoretical calculations and agree with predicted discontinuity at Z = 30 where f sub 23 transitions become energetically impossible.
A model, based on Lighthill's theory, for predicting aerodynamic noise from a turbulent shear flow is developed. This model is a generalization of the one developed by Ribner. Unlike Ribner's model, it does not require that the turbulent correlations factor into space and time-dependent parts. It replaces his assumption of isotropic. turbulence by the more realistic one of axisymmetric turbulence. The implications of the model for jet noise are discussed.
The structure of the upper atmosphere can be indirectly probed by light in order to determine the global density structure of ozone, aerosols, and neutral atmosphere. Scattered and directly transmitted light is measured by a satellite and is shown to be a nonlinear function of the state which is defined to be a point-wise decomposition of the density profiles. Dynamics are imposed on the state vector and a structured estimation problem is developed. The estimation of these densities is then performed using a linearized Kalman-Bucy filter and a linearized Kushner-Stratonovich filter.
Large-scale averages of daily solar magnetograms have been compared by cross-correlation with the interplanetary magnetic sector pattern during a 2.5 yr interval. A significant correlation was found at a lag of about 4.5 days, with the amplitude of the correlation depending on the area included in the magnetogram averages. The highest correlation was found when an area of one quarter of the solar disk was used, which is consistent with the idea that the photospheric features which are to be associated with the interplanetary sector pattern are large scale features.
An assessment is made of the total supply of ionizing photons from hot stars, within several hundred parsecs of the sun. The resulting photoionized H II regions probably contribute an average emission measure of the order of 5 pc per cm to the 6th power, through the galactic disk; this is smaller than other recent estimates.
Explore the source record for details and available documents.
Null seeking system uses two transponders located at selected points on dish to detect phase-front of received signal. One signal line has continuously variable phase shifter driven by reversible stepmotor. Each of two transponders on dish is a dipole with mixer crystal between elements. Crystal is driven, in turn, by 181.6MHz signal carried by miniature coaxial cable.