Satellite and space probe telemetry.
Space modulation systems characteristics, considering data flow rate, spacecraft weight and power, antenna gain, noise figure, etc
SPACE COMMUNICATION↗
SEARCH · Engineering Papers
Results for “Data Communications”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Serial data transmission between redundant channels
Data is communicated between redundant channels formatted in blocks having an initial command word followed by a destination code, starting address and a variable number of data words including a word count. The blocks are transmitted between each channel and all of the channels over cross-channel data links, each channel receiving the data blocks and determining the validity thereof by counting the number of data words received and comparing that number to the word count transmitted for that block. An interrupt signal indicative of invalidity of a block is provided in the event of a miscompare. A stop address is generated for each block received for storage at the start address. A memory address is generated for each valid word received for storage in sequence starting immediately after the start address. The next block received has its start address placed immediately at the end of the previously received block.
Tulpule, Bhalchandra R.↗
Flight Crew Workload, Acceptability, and Performance When Using Data Comm in a High-Density Terminal Area Simulation
This document describes a collaborative FAA/NASA experiment using 22 commercial airline pilots to determine the effect of using Data Comm to issue messages during busy, terminal area operations. Four conditions were defined that span current day to future flight deck equipage: Voice communication only, Data Comm only, Data Comm with Moving Map Display, and Data Comm with Moving Map displaying taxi route. Each condition was used in an arrival and a departure scenario at Boston Logan Airport. Of particular interest was the flight crew response to D-TAXI, the use of Data Comm by Air Traffic Control (ATC) to send taxi instructions. Quantitative data was collected on subject reaction time, flight technical error, operational errors, and eye tracking information. Questionnaires collected subjective feedback on workload, situation awareness, and acceptability to the flight crew for using Data Comm in a busy terminal area. Results showed that 95% of the Data Comm messages were responded to by the flight crew within one minute and 97% of the messages within two minutes. However, post experiment debrief comments revealed almost unanimous consensus that two minutes was a reasonable expectation for crew response. Flight crews reported that Expected D-TAXI messages were useful, and employment of these messages acceptable at all altitude bands evaluated during arrival scenarios. Results also indicate that the use of Data Comm for all evaluated message types in the terminal area was acceptable during surface operations, and during arrivals at any altitude above the Final Approach Fix, in terms of response time, workload, situation awareness, and flight technical performance. The flight crew reported the use of Data Comm as implemented in this experiment as unacceptable in two instances: in clearances to cross an active runway, and D-TAXI messages between the Final Approach Fix and 80 knots during landing roll. Critical cockpit tasks and the urgency of out-the window scan made the additional head down time to respond to Data Comm messages undesirable during these events. However, most crews also stated that Data Comm messages without an accompanying audio chime and no expectation of an immediate response could be acceptable even during these events.
Norman, R. Michael↗
A guide to onboard checkout. Volume 7: RF communications
The radio frequency communications subsystem for a space station is considered, with respect to onboard checkout requirements. The subsystem comprises all equipment necessary for transmitting and receiving, tracking and ranging, command, multiple voice and television information, and broadband experiment data. The communications subsystem provides a radio frequency interface between the space station and ground stations, either directly or indirectly, through a data relay satellite system, independent free-flying experiment modules, and logistics vehicles. Reliability, maintenance, and failure analyses are discussed, and computer programming techniques are presented.
Source record↗
Rendering and Compositing Infrastructure Improvements to VisIt for Insitu Rendering
Compared to posthoc rendering, insitu rendering often generates larger numbers of images, as a result rendering performance and scalability are critical in the insitu setting. In this work we present improvements to VisIt's rendering and compositing infrastructure that deliver increased performance and scalability in both posthoc and insitu settings. We added the capability for alpha blend compositing and use it with ordered compositing when datasets have disjoint block domain decomposition to optimize the rendering of transparent geometry. We also made improvements that increase overall efficiency by reducing communication and data movement and have addressed a number of performance issues. We structured our code to take advantage of SIMD parallelization and use threads to overlap communication and compositing. We tested our improvements on a 20 core workstation using 8 cores to render geometry generated from a $256^3$ cosmology dataset and on a Cray XC31 using 512 cores to render geometry generated from a $2000^2 \times 800$ plasma dataset. Our results show that ordered compositing provides a speed up of up to $4 \times$ over the current sort first strategy. The other improvements resulted in modest speed up with one notable exception where we achieve up to $40 \times$ speed up of rendering and compositing of opaque geometry when both opaque and transparent geometry are rendered together. We also investigated the use of depth peeling, but found that the implementation provided by VTK is substantially slower,both with and without GPU acceleration, than a local camera order sort.
97 MATHEMATICS AND COMPUTING↗
Comparison of the information contents of Landsat TM and MSS data
A communications-theory approach is taken to analyze the dispersion and concentration of signal values in various data spaces, irrespective of specific class membership. Entropy is used to quantify information, and mutual information is used to measure the information represented by subsets of spectral variables. Several different comparisons of information content are made. These include comparisons of system design capacities, of data volumes occupied by agricultural data in the spaces defined by original bands and by transformed spectral (Tasseled Cap) variables, of the information contents of original bands and Tasseled Cap variables, and of the information contents of TM and MSS for the given agricultural data sets. Also, the effects of sample size, scene content, and quantization level are examined.
Malila, W. A.↗
Comparison of the information contents of LANDSAT TM and MSS data
A communications-theory approach is taken to analyze the dispersion and concentration of signal values in various data spaces, irrespective of specific class membership. Entropy is used to quantify information, and mutual information is used to measure the information represented by subsets of spectral variables. Several different comparisons of information content are made. These include comparisons of system design capacities, of data volumes occupied by agricultural data in the spaces defined by original bands and by transformed spectral (Tasseled Cap) variables, of the information contents of original bands and Tasseled Cap variables, and of the information contents of TM and MSS for the given agricultural data sets. Also, the effects of sample size, scene content, and quantization level are examined.
Malila, W. A.↗
Non-Repudiation for Drone-Related Data
Concepts for the management of Uncrewed Aircraft Systems (UAS) at scale rely on the exchange of data amongst multiple stakeholders. Even as these concepts vary from State to State and company to company as of today, the movement of data between different entities is a common theme. While there is universal agreement on the necessity of appropriate cybersecurity applied to the various systems involved in communicating these data, there has been little focus on a feasible implementation of non-repudiation in these systems. This paper highlights the current and future need for non-repudiation, supported by references to multiple international organizations, and an approach to implementing non-repudiation leveraging open standards.
Unmanned Aviation Systems Traffic Management↗
Architecting Communication Network of Networks for Space System of Systems
The National Aeronautics and Space Administration (NASA) and the Department of Defense (DoD) are planning Space System of Systems (SoS) to address the new challenges of space exploration, defense, communications, navigation, Earth observation, and science. In addition, these complex systems must provide interoperability, enhanced reliability, common interfaces, dynamic operations, and autonomy in system management. Both NASA and the DoD have chosen to meet the new demands with high data rate communication systems and space Internet technologies that bring Internet Protocols (IP), routers, servers, software, and interfaces to space networks to enable as much autonomous operation of those networks as possible. These technologies reduce the cost of operations and, with higher bandwidths, support the expected voice, video, and data needed to coordinate activities at each stage of an exploration mission. In this paper, we discuss, in a generic fashion, how the architectural approaches and processes are being developed and used for defining a hypothetical communication and navigation networks infrastructure to support lunar exploration. Examples are given of the products generated by the architecture development process.
Bhasin, Kul B.↗
GPU remote communication with triggered operations
Methods, devices, and systems for transmitting data over a computer communications network are disclosed. A queue of communications commands can be pre-generated using a central processing unit (CPU) and stored in a device memory of a network interface controller (NIC). Thereafter, if a graphics processing unit (GPU) has data to communicate to a remote GPU, it can store the data in a send buffer, where the location in the buffer is pointed to by a pre-generated command. The GPU can then signal to the interface device that the data is ready, triggering execution of the pre-generated command to send the data.
LeBeane, Michael W.↗
RFID Transponders' RF Emissions in Aircraft Communication and Navigation Radio Bands
Radiated emission data in aircraft communication and navigation bands are presented for several active radio frequency identification (RFID) tags. The individual tags are different in design, operation and transmitting frequencies. The process for measuring the tags emissions in a reverberation chamber is discussed. Measurement issues dealing with tag interrogation, low level measurement in the presence of strong transmissions, and tags low duty factors are discussed. The results show strong emissions, far exceeding aircraft emission limits and can be of potential interference risks.
Nguyen, Truong X.↗
Connectivity, Centrality, and Bottleneckedness: On Graph Theoretic Methods for Power Systems
This report provides an introduction to selected graph theoretic topics with pertinence to the structural analysis of electric power grid and communication systems. We focus on methodologies for defining, scoring, and identifying connectivity, spectral, and bottleneckeness properties in graphs, as well as vertex and edge importance measures such as centrality. We apply these measures to power systems and communications graph data, discuss and visualize the results, and comment on computational aspects of these methods. We show that graph theoretic methods can provide useful insights into grid and communication network structure, leading to tools and methods that could be used by electric utility engineers to improve key grid and communication network characteristics, such as resilience and scalability.
24 POWER TRANSMISSION AND DISTRIBUTION↗
Advanced Communication Technology Satellite (ACTS) Very Small Aperture Terminal (VSAT) Network Control Performance
This paper discusses the performance of the network control function for the Advanced Communications Technology Satellite (ACTS) very small aperture terminal (VSAT) full mesh network. This includes control of all operational activities such as acquisition, synchronization, timing and rain fade compensation as well as control of all communications activities such as on-demand integrated services (voice, video, and date) connects and disconnects Operations control is provided by an in-band orderwire carried in the baseboard processor (BBP) control burst, the orderwire burst, the reference burst, and the uplink traffic burst. Communication services are provided by demand assigned multiple access (DAMA) protocols. The ACTS implementation of DAMA protocols ensures both on-demand and integrated voice, video and data services. Communications services control is also provided by the in-band orderwire but uses only the reference burst and the uplink traffic burst. The performance of the ACTS network control functions have been successfully tested during on-orbit checkout and in various VSAT networks in day to day operations. This paper discusses the network operations and services control performance.
Coney, T. A.↗
Realistic training scenario simulations and simulation techniques
In one embodiment, a system includes a signal generator operatively coupleable to one or more detectors; and a controller, the controller being both operably coupled to the signal generator and configured to cause the signal generator to: generate one or more signals each signal being representative of at least one emergency event; and communicate one or more of the generated signal(s) to a detector to which the signal generator is operably coupled. In another embodiment, a method includes: receiving data corresponding to one or more emergency events; generating at least one signal based on the data; and communicating the generated signal(s) to a detector.
99 GENERAL AND MISCELLANEOUS↗
Digital data command bus
Command bus constructed from coaxial cable has short segments of its outer jacket and shield removed and replaced with small ferrite cores carrying multiturn windings connected to decoder. Device reduces number of wire pairs required to communicate command data to systems and subsystems.
Milligan, G. C.↗
Nonlinear analysis of phased-locked loops with rapidly varying phase
The performance of command and telemetry systems, useful in deep-space communications, is frequently affected by the radio-frequency phase error which is introduced at the point of reception by means of the carrier tracking loop. In low data rate communications, this phase error may vary rapidly over the duration of the signaling interval. In this paper such phase variation is characterized by a sinusoidal input phase, K sin (omega sub o t+, pi/6), which models a typical phase variation in communication over turbulent media. Conditions for synchronization stability and the acquisition behavior are examined by detailed computer study of the phase-plane trajectories for the second and third-order loops with perfect integrator. It is demonstrated that for the phase variation considered the third-order loop has no real advantage over the second-order loop. Finally, it is shown that nonzero initial conditions may result in large steady-state phase error.
Chen, C.↗
Lunar Command and Control Interoperability (LuCCI) Project Overview
The Lunar Command and Control Interoperability (LuCCI) project was formed to address a gap in how Lunar Surface Systems (LSS) would interoperate across multiple programs, commercial partners, and international partners. The project objective is to define, prototype, integrate, and evaluate an interoperable lunar command, control, data, and software reference architecture to enable autonomy and informatics capability through common standards across LSS.
Communications↗
Power requirements for commercial communications spacecraft
Historical data on commercial spacecraft power systems are presented and their power requirements to the growth of satellite communications channel usage are related. Some approaches for estimating future power requirements of this class of spacecraft through the year 2000 are proposed. The key technology drivers in satellite power systems are addressed. Several technological trends in such systems are described, focusing on the most useful areas for research and development of major subsystems, including solar arrays, energy storage, and power electronics equipment.
Billerbeck, W. J.↗