SEARCH · Engineering Papers

Results for “multiplexing”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,045 records · Page 58

All sources NASA NTRS DOE OSTI

NASA NTRS1976

A five-frequency radiometer antenna system feed horn

The feasibility of operating a five frequency feed as a radiometer for use on board a Nimbus type satellite was investigated. Five narrow band frequencies (6.6, 10.7, 18.5, 21.5 and 33 GHz) were multiplexed onto a single receive feed employing dual linear polarization at each frequency with a better than 25 db isolation between each polarization. The production of a horn design which can illuminate a parabolic reflector segment with an f/D ratio of approximately 0.4, producing an edge illumination of approximately -20 db is described. The final overall design is presented with results showing that this design concept has an acceptable electrical performance.

Source record↗

NASA NTRS1977

Study to investigate and evaluate means of optimizing the Ku-band combined radar/communication functions for the space shuttle

The performance of the space shuttle orbiter's Ku-Band integrated radar and communications equipment is analyzed for the radar mode of operation. The block diagram of the rendezvous radar subsystem is described. Power budgets for passive target detection are calculated, based on the estimated values of system losses. Requirements for processing of radar signals in the search and track modes are examined. Time multiplexed, single-channel, angle tracking of passive scintillating targets is analyzed. Radar performance in the presence of main lobe ground clutter is considered and candidate techniques for clutter suppression are discussed. Principal system parameter drivers are examined for the case of stationkeeping at ranges comparable to target dimension. Candidate ranging waveforms for short range operation are analyzed and compared. The logarithmic error discriminant utilized for range, range rate and angle tracking is formulated and applied to the quantitative analysis of radar subsystem tracking loops.

Weber, C. L.↗

NASA NTRS1975

Command and data handling of science signals on Spacelab

The Orbiter Avionics and the Spacelab Command and Data Management System (CDMS) combine to provide a relatively complete command, control, and data handling service to the instrument complement during a Shuttle Sortie Mission. The Spacelab CDMS services the instruments and the Orbiter in turn services the Spacelab. The CDMS computer system includes three computers, two I/O units, a mass memory, and a variable number of remote acquisition units. Attention is given to the CDMS high rate multiplexer, CDMS tape recorders, closed circuit television for the visual monitoring of payload bay and cabin area activities, methods of science data acquisition, questions of transmission and recording, CDMS experiment computer usage, and experiment electronics.

Mccain, H. G.↗

NASA NTRS1975

Digital speech processing for the Space Shuttle program

This paper describes the voice digitization technique which has been selected for the Space Shuttle program. The selected approach is compatible with a time-division multiplexing scheme which combines one or two digital voice channels with commands prior to transmission over an RF uplink or with telemetry prior to transmission over an RF downlink.

Batson, B. H.↗

NASA NTRS1977

Formation of integrated optics components by multiphoton photorefractive processes

Phase holograms have been formed in pure outdiffused LiNbO3 waveguides using the photorefractive effect initiated by two-photon absorption. Efficient holograms were recorded with two guided waves, of less than 100 W peak power, and less than 10 microJ optical energy. This technique automatically compensates for wave front perturbations in the guide and allows the formation of various integrated components such as wavelength multiplexers and optical switches.

Verber, C. M.↗

NASA NTRS1976

Telemetry packetization for improved mission operations

The requirements for mission-operations data management will accelerate sharply when the Space Transportation System (i.e., Space Shuttle) becomes the primary vehicle for research from space. These demands can be satisfied most effectively by providing a higher-level source encoding function within the spaceborne vehicle. An Instrument Telemetry Packet (ITP) concept is described which represents an alternative to the conventional multiplexed telemetry frame approach for acquiring spaceborne instrument data. By providing excellent data-integrity protection at the source and a variable instrument bandwidth capability, this ITP concept represents a significant improvement over present data acquisition procedures. Realignments in the ground telemetry processing functions are described which are intended to take advantage of the ITP concept and to make the data management system more responsive to the scientific investigators.

Greene, E. P.↗

NASA NTRS1976

A wideband-PCM recorder for the Space Shuttle orbiter

The Shuttle wideband-PCM recorder accomplishes recording on up to 14 data tracks with analog or digital data inputs. FM multiplexed analog frequencies of up to 2 MHz and digital rates of 1 Mb/s are accommodated at a tape speed of 120 in/s. Recording time in analog mode varies between 4 min for 2 MHz data to 80 min for 100 kHz data. The total digital data storage is 3.44 x 10 to the 9th bits with recording times from 1 hour for 1 Mb/s to 19 hours for 50 Kb/s data in the serial track switching mode. A versatile command decoder and control interface are used for eight primary modes of operation.

Petit, R. D.↗

NASA NTRS1978

Accurate positioning of characters on CRT displays

Two systems, one digital and one analog, improve positioning of characters in cathode-ray tube (CRT) display systems. Circuits minimize effects of amplifier settling times--effects that can displace and distort characters in high-speed multiplexed systems.

Damian, J. R.↗

NASA NTRS1978

Hybrid random-sound test-control system

Controller develops gain-control signals by comparing detected sound levels in each band with reference set levels. By eliminating multiplexing network and single clock used in digital system, design allows servocontrol rate for each band to be adjusted independently.

Woodbury, R. C.↗

NASA NTRS1979

Data reformatting with less hardware

Dual-function integrated circuits use one shift register array instead of two to feed video data to seven tape channels thereby making system more reliable and less expensive than predecessor. Basic principle of reformatter is also applicable to multiplexing and frequency conversion circuits.

Engel, A.↗

NASA NTRS1979

High-sampling-rate pressure transducer has in situ calibration

High-data-rate pressure sensor module can be calibrated after it is attached to an experimental setup. Electrically multiplexed sensor is designed for use in wind-tunnels and other applications requiring accurate measurement of many pressures in a short period of time.

Gross, C.↗

NASA NTRS1977

A review of NASA fiber optics tasks

The status of on-going NASA tasks involving fiber optic data transmission, and related topics is given. Ground based applications, including a multiplexed wideband 2 km prototype link and a building-to-building video link, are described. In connection with the use of fibers in space, the effects to be expected from the space environment are touched on, particularly radiation darkening of fibers and temperature effects. Laboratory results on performance of fibers at cryogenic temperatures are also presented. Finally, some thoughts on future applications are given.

Johnston, A. R.↗

NASA NTRS1978

A modular minicomputer based Navier-Stokes solver

The basic module consists of a minicomputer, low cost peripheral storage device (disk) and a modest number (8-12) of microcomputer modules. A simple arrangement, where the microcomputers are connected to a single time multiplexed bus, only communicating to the host minicomputer, will be efficient. By running the machine in a dedicated mode for long periods of time, it will be possible to obtain a large number of solutions. As such, the device should be useful as a research tool. A scheme is outlined to assemble a number of these computing modules in parallel to decrease computing time. The advantages and disadvantages are discussed of using a number of these systems assembled in a loosely coupled configuration, each independently computing a separate flow, to give a very high throughput.

Steinhoff, J.↗

NASA NTRS1978

A rotor-mounted digital instrumentation system for helicopter blade flight research measurements

A rotor mounted flight instrumentation system developed for helicopter rotor blade research is described. The system utilizes high speed digital techniques to acquire research data from miniature pressure transducers on advanced rotor airfoils which are flight tested on an AH-1G helicopter. The system employs microelectronic pulse code modulation (PCM) multiplexer digitizer stations located remotely on the blade and in a hub mounted metal canister. As many as 25 sensors can be remotely digitized by a 2.5 mm thick electronics package mounted on the blade near the tip to reduce blade wiring. The electronics contained in the canister digitizes up to 16 sensors, formats these data with serial PCM data from the remote stations, and transmits the data from the canister which is above the plane of the rotor. Data are transmitted over an RF link to the ground for real time monitoring and to the helicopter fuselage for tape recording. The complete system is powered by batteries located in the canister and requires no slip rings on the rotor shaft.

Knight, V. H., Jr.↗

NASA NTRS1978

Spacelab uplink/downlink data flow and formats

The results of an analysis of the Spacelab (SL) data uplink/downlink structure and those data system elements associated with the support of this data flow are presented. Specific objectives of this report are to present the results of the following analyses: (1) operations of the SL high rate multiplexer, including format structure, data rates, format combinations, format switching, etc.; (2) operations of SL data recorders to include the definition of modes, data rates and forms; (3) operations of the high rate demultiplexer as described above; (4) potential experiment data formats defining formatting parameters to be considered in decommutation analysis; (5) SL computer input/output (I/O) decommutation channels, including the definition of structure, quantity and use of this I/O data; (6) detailed requirements of the data quality monitoring philosophy for this function.

Kandefer, F.↗

NASA NTRS1978

Escort: A data acquisition and display system to support research testing

Primarily designed to acquire data at steady state test conditions, the system can also monitor slow transients such as those generated in moving to a new test condition. The system configuration makes use of a microcomputer at the test site which acts as a communications multiplexer between the measurement and display devices and a centrally located minicomputer. A variety of measurement and display devices are supported using a modular approach. This allows each system to be configured with the proper combination of devices to meet the specific test requirements, while still leaving the option to add special interfaces when needed. Centralization of the minicomputer improves utilization through sharing. The creation of a pool of minis to provide data acquisition and display services to a variable number of running tests also offers other important advantages.

Miller, R. L.↗

NASA NTRS1977

A miniature 48-channel pressure sensor module capable of in situ calibration

A new high data rate pressure sensor module with in situ calibration capability has been developed by the Langley Research Center to help reduce energy consumption in wind-tunnel facilities without loss of measurement accuracy. The sensor module allows for nearly a two order of magnitude increase in data rates over conventional electromechanically scanned pressure sampling techniques. This module consists of 16 solid state pressure sensor chips and signal multiplexing electronics integrally mounted to a four position pressure selector switch. One of the four positions of the pressure selector switch allows the in situ calibration of the 16 pressure sensors; the three other positions allow 48 channels (three sets of 16) pressure inputs to be measured by sensors. The small size of the sensor module will allow mounting within many wind-tunnel models, thus eliminating long tube lengths and their corresponding slow pressure response.

Gross, C.↗

NASA NTRS1978

A packet telemetry system employing ARQ error control

A proposed packet telemetry system employing automatic retransmission request (ARQ) mode of error control is characterized. Limitations of the present multiplexing/demultiplexing approach are considered, and the use of the proposed system in near-earth satellites in the 1980s is suggested. Onboard processing and an adaptive multiplexing technique are described, as is an elastic buffer, required because the instantaneous data rate will be different from the telemetry transmission rate. The telemetry packets would be encoded into a powerful error-detection block code. A mechanism involving temporary buffering in a long shift register will permit retransmission request from the ground station for packets received in error. The ARQ mode of operation should ensure essentially error-free transmission at lower signal-to-noise ratios and at considerably higher transmission rates than are usually used.

Greene, E. P.↗