Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “maximum”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,045 records · Page 58

Observations of Low-degree Modes from the Solar Maximum Mission (extended Abstract)

Mean frequencies, amplitudes, and linewidths for the solar 5 min p mode oscillations of degree 0, 1, and 2 have been obtained from approx. 280 days of SMM-ACRIM total irradiance data. The frequencies are in good agreement with measurements obtained from velocity data. The amplitudes of the modes lie along a well defined envelope of power vs. frequency, which peaks at 3.1 mHz and has a width of 0.7 mHz (FWHM). The r.m.s. amplitude of the highest peak in the spectrum (n=21, l=1) is approx. 3 ppm of the total flux. The linewidths of the narrowest l=O modes are approx. 1 micro Hz (FWHM). A broad continuum of power caused both by solar surface granulation and by instrumental noise interferes with the analysis of 5 min modes. The continuum spectral power in a 1 micro Hz band near 3 mHz corresponds to an apparent r.m.s. variation of approx. 0.5 parts per million of the mean solar flux.

Woodard, M.↗

Soft X-ray polychromator for the Solar Maximum Mission

The XRP was designed to measure the following temporal and spatial properties of the active and flaring Sun: electron temperature, departures from steady state, ion kinetic temperatures, and electron density. The Bent Crystal Spectrometer (BCS) is capable of measuring the broadening and blue shifts often observed in the impulsive phase of flares. The six simultaneous line fluxes indicative of six different temperatures of formation observable by the Flat Crystal Spectrometer (FCS) allows the derivation of the differential emission measure of the plasma at each raster point. During the operational periods of the XRP hundreds of flares of C-level (GOES classification) were observed and brighter in both the FCS and BCS, including 5 X-flares. Associated theoretical work in atomic physics, stimulated in part by the promise of XRP measurements, has benefitted from the experimental data on solar plasmas which the XRP has provided in abundance.

Haisch, B. M.↗

Gamma-ray burst high time-resolution spectral observations made with the Solar Maximum Mission

The gamma-ray bursts of April 19 and 21, 1980, and March 1, 1981, are characterized on the basis of observations obtained at 25-500 keV and time resolution 128 msec using the hard-X-ray-burst spectrometer of the SMM satellite. The data are presented graphically, and the parameters determined by fitting three theoretical models to the data for each phase (rising phase, decay phase, and valleys between pulses) are given in tables. Models used are thin thermal bremsstrahlung with or without absorption lines, thermal synchrotron with or without absorption lines, and power law with exponential cutoff.

Desai, U. D.↗

Maximum mass of objects that constitute unseen disk material

It is suggested that the mass of the individual unseen 'disk things' which furnish unseen mass satisfies an inequality that is based on the demonstrated existence of a large number of wide binary stars in the Galaxy whose projected separations are as large as 0.1 pc. Since these binaries are weakly bound, with orbital velocities of 0.3 km/sec and periods of the order of 1 million years, they can be disrupted by passing stars or other pointlike objects. This implies that the mass of the unseen disk objects, which provide about half the local mass density, must be less than 2 solar masses.

Bahcall, J. N.↗

Studies on maximum yield of wheat for the controlled environments of space

The economic feasibility of using food-producing crop plants in a closed ecological Life-Support System (CELSS) will ultimately depend on the energy and area (or volume) required to provide the nutritional requirements for each person. Energy and area requirements are, to some extent, inversely related; that is, an increased energy input results in a decreased area requirement and vice versa. A major goal of the research effort was to determine the controlled-environment good-production efficiency of wheat per unit area, per unit time, and per unit energy input.

Bugbee, B. G.↗

Results from the solar maximum mission

The major results from SMM (Solar Max Mission) are presented as they relate to the understanding of the energy release and particle transportation processes that led to the high energy X-ray aspects of solar flares. Evidence is reviewed for a 152- to 158-day periodicity in various aspects of solar activity including the rate of occurrence of hard X-ray and gamma-ray flares. The statistical properties of over 7000 hard X-ray flares detected with the Hard X-Ray Burst Spectrometer are presented including the spectrum of peak rates and the distribution of the photo number spectrum. A flare classification scheme is used to divide flares into three different types. Type A flares have purely thermal, compact sources with very steep hard X-ray spectra. Type B flares are impulsive bursts which show double footpoints in hard X-rays, and soft-hard-soft spectral evolution. Type C flares have gradually varying hard X-ray and microwave fluxes from high altitudes and show hardening of the X-ray spectrum through the peak and on the decay. SSM data are presented for examples of Type B and Type C events. New results are presented showing coincident hard X rays, O V, and UV continuum observations in Type B events with a time resolution of 128 ms. The subsecond variations in the hard X-ray flux during 10% of the stronger events are discussed and the fastest observed variation in a time of 20 ms is presented. The properties of Type C flares are presented as determined primarily from the non-imaged hard X-ray and microwave spectral data. A model based on the association of Type C flares and coronal mass ejections is presented to explain many of the characteristics of these gradual flares.

Dennis, B. R.↗

Review and evaluation of recent developments in melic inlet dynamic flow distortion prediction and computer program documentation and user's manual estimating maximum instantaneous inlet flow distortion from steady-state total pressure measurements with full, limited, or no dynamic data

A review of the Melick method of inlet flow dynamic distortion prediction by statistical means is provided. These developments include the general Melick approach with full dynamic measurements, a limited dynamic measurement approach, and a turbulence modelling approach which requires no dynamic rms pressure fluctuation measurements. These modifications are evaluated by comparing predicted and measured peak instantaneous distortion levels from provisional inlet data sets. A nonlinear mean-line following vortex model is proposed and evaluated as a potential criterion for improving the peak instantaneous distortion map generated from the conventional linear vortex of the Melick method. The model is simplified to a series of linear vortex segments which lay along the mean line. Maps generated with this new approach are compared with conventionally generated maps, as well as measured peak instantaneous maps. Inlet data sets include subsonic, transonic, and supersonic inlets under various flight conditions.

Schweikhard, W. G.↗

The solar maximum satellite capture cell: Impact features and orbital debris and micrometeoritic projectile materials

The physical properties of impact features observed in the Solar Max main electronics box (MEB) thermal blanket generally suggest an origin by hypervelocity impact. The chemistry of micrometeorite material suggests that a wide variety of projectile materials have survived impact with retention of varying degrees of pristinity. Impact features that contain only spacecraft paint particles are on average smaller than impact features caused by micrometeorite impacts. In case both types of materials co-occur, it is belevied that the impact feature, generally a penetration hole, was caused by a micrometeorite projectile. The typically smaller paint particles were able to penetrate though the hole in the first layer and deposit in the spray pattern on the second layer. It is suggested that paint particles have arrived with a wide range of velocities relative to the Solar Max satellite. Orbiting paint particles are an important fraction of materials in the near-Earth environment. In general, the data from the Solar Max studies are a good calibration for the design of capture cells to be flown in space and on board Space Station. The data also suggest that development of multiple layer capture cells in which the projectile may retain a large degree of pristinity is a feasible goal.

Mckay, D. S.↗

Maximum-Likelihood Decoder on a Hypercube Multiprocessor

Efficient parallel processing used to implement complex decoders. Hypercube multiprocessor connection scheme practical to decode long convolutional codes with efficient use of hardware. Hypercube design reduces both communication time among processors and space needed for interconnection. Decoding concept applicable to concurrent processing of digital signals using convolutional codes for error correction.

Pollara, F.↗

Results of examination of materials from the solar maximum recovery mission

Four years and two months in space at 310 nautical miles orbit has produced different effects on Kapton, silver/Teflon, and on aluminum. Kapton, a polyimide, lost up to 31% in thickness, though other locations showed much less loss. The degradation of silver/Teflon was drastic but very localized, due perhaps to the formation of silver oxide, Ag2O, through cracks in the protective Inconel layer which exposed the silver to the oxygen atom environment. Penetrations of the thin aluminum sheet in the form of thermal louvers and also of the thermal blanket material due to unknown particles were unexpected, making the debris a potentially serious problem because of the threat of damage to components.

Park, J. J.↗

Ephemeral active regions and coronal bright points: A solar maximum Mission 2 guest investigator study

A dominate association of coronal bright points (as seen in He wavelength 10830) was confirmed with the approach and subsequent disappearance of opposite polarity magnetic network. While coronal bright points do occur with ephemeral regions, this association is a factor of 2 to 4 less than with sites of disappearing magnetic flux. The intensity variations seen in He I wavelength 10830 are intermittent and often rapid, varying over the 3 minute time resolution of the data; their bright point counterparts in the C IV wavelength 1548 and 20 cm wavelength show similar, though not always coincident time variations. Ejecta are associated with about 1/3 of the dark points and are evident in the C IV and H alpha data. These results support the idea that the anti-correlation of X-ray bright points with the solar cycle can be explained by the correlation of these coronal emission structures with sites of cancelling flux, indicating that, in some cases, the process of magnetic flux removal results in the release of energy. That the intensity variations are rapid and variable suggests that this process works intermittently.

Harvey, K. L.↗

The gamma-ray spectrometer experiment on the solar maximum mission satellite

The major activities summarized include: Gamma-Ray Spectrometer (GRS) instrument response and flight operation; solar flare studies; cosmic gamma-ray studies; summary of computer operations; search for flare-precursor protons; diffuse galactic annihilation radiation; cosmic ray bursts; atmospheric gamma ray spectrum; gamma ray line emission from supernovae and novae; improved angular resolutions using Earth occultation; and production processing of NASA IPD data. In addition, an updated list of published papers and invited papers or contributed papers presented at scientific meetings is provided.

Chupp, E. L.↗

Maximum Entropy/Optimal Projection (MEOP) control design synthesis: Optimal quantification of the major design tradeoffs

The underlying philosophy and motivation of the optimal projection/maximum entropy (OP/ME) stochastic modeling and reduced control design methodology for high order systems with parameter uncertainties are discussed. The OP/ME design equations for reduced-order dynamic compensation including the effect of parameter uncertainties are reviewed. The application of the methodology to several Large Space Structures (LSS) problems of representative complexity is illustrated.

Hyland, D. C.↗

Data analysis and interpretation of UVSP and other experiments on board solar maximum mission

During the period of this contract (February 1 1980 to February 1987) there were two separate efforts involved: one was programmetric, i.e., the coordination of scientific working groups and the organization of workshops in the solar physics discipline; the second was scientific, i.e., to perform research to investigate the fundamental physical mechanisms of the energy and momentum transport from the solar surface to interplanetary space. In the former, 19 workshops, involving 88 scientists were organized. In the latter aspect, the following were investigated: solar flare energy buildup and release, coronal dynamics, energy and momentum transport from lower solar atmosphere to interplanetary space, numerical methods for the calculation of the nonlinear force-free field, and the evolution of the solar magnetic field.

Wu, S. T.↗

Correlated observations of impulsive UV and hard X-ray bursts from the solar maximum mission

The spatially resolved UV observations and hard X-ray observations are analyzed in order to study the spatial structure and physical conditions in the UV and hard X-ray sources. The data reveal that impulsive UV emissions and hard X-ray bursts occur in small kernels. Individual light curves for Si IV and hard X-ray emissions are compared and it is detected that the individual peaks in the curves correspond. The dynamic evolution and density diagnostics of the transition zone plasmas are examined.

Cheng, C.-C.↗

Spectral line profiles of Fe XXI 1354.1 A from the Solar Maximum Mission

Observations of the Fe XXI 1354.1 A line were obtained for several flares using the SMM-UVSP instrument with varying spectral and spatial resolution. Of special interest are spectral line profiles from the footpoints of flare loops taken during the impulsive phase. These data show blueshifted Fe XXI profiles coincident and cospatial with the impulsive brightening of chromospheric material. The present analysis supports the hypothesis that the blueshifted component of the high temperature emission is an integral part of the flare, possibly associated with chromospheric evaporation.

Mason, H. E.↗