Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “DOD”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,027 records · Page 57
All sourcesNASA NTRSDOE OSTI
NASA NTRS1970

Data relay satellite phased array

S band communications repeater using retrodirective phased array on synchronous altitude data relay satellite /DRS/ for intersatellite and ground links

Dod, L. R.↗
NASA NTRS1972

In-flight aeroacoustic environments on prospective space shuttle vehicles

The problem of in-flight aerodynamic noise has been studied by reliable estimates of full scale surface-pressure fluctuations from scale model tests in wind tunnels. Scaling relationships have been verified, and many details of the fluctuating pressure characteristics such as spatial correlation and convection velocities are understood. The effects of the wind tunnel environmental turbulence and noise have also been investigated sufficiently so that threshold levels of usable data are known.

Dods, J. B., Jr.↗
NASA NTRS1972

Wind tunnel measurements of surface pressure fluctuations at Mach numbers of 1.6, 2.0, and 2.5 using 12 different transducers

The turbulent boundary layer on the wall of a 9 by 7 foot wind tunnel was measured with 12 different transducers at Mach numbers of 1.6, 2.0, and 2.5. The results indicated that the wall surface-pressure-fluctuation field was more homogeneous at a Mach number of 2.5 than at Mach numbers of 1.6 or 2.0. A comparison of power-spectral-density data at Mach 2.5 with a summary of similar data (Mach 0.1 to 3.45) showed good agreement. The measurement uncertainty was greatest when frequencies were low and the surface-pressure-fluctuation field was homogeneous. The uncertainty at higher frequencies increased as the surface-pressure-fluctuation field became more inhomogeneous. Since transducer mounting effects and system noise levels were determined not to have contributed appreciably to measurement uncertainties, the result was attributed to an interaction between the surface-pressure-fluctuation field and the transducers. Corcos' correction for size effects improved the comparison between transducers at the high frequencies, but did not eliminate an apparent size effect at the lower frequencies.

Lewis, T. L.↗
NASA NTRS1973

Measurements of surface-pressure fluctuations on the XB-70 airplane at local Mach numbers up to 2.45

Measurements of surface-pressure fluctuations were made at two locations on the XB-70 airplane for nine flight-test conditions encompassing a local Mach number range from 0.35 to 2.45. These measurements are presented in the form of estimated power spectral densities, coherence functions, and narrow-band-convection velocities. The estimated power spectral densities compared favorably with wind-tunnel data obtained by other experimenters. The coherence function and convection velocity data supported conclusions by other experimenters that low-frequency surface-pressure fluctuations consist of small-scale turbulence components with low convection velocity.

Lewis, T. L.↗
NASA NTRS1973

Plural beam antenna

An antenna capable of deriving several beams about a single boresight axis including a focusing means, such as a parabolic reflector or a lens is described. Plural arrays, each including plural radially aligned antenna elements extending from the boresight axis, are located in proximity to a focal point for the focusing means. The elements of the plural arrays are independently excited as each of the arrays is independently rotated about the boresignt axis.

Keller, G. C.↗
NASA NTRS1973

Overall fluctuating pressure levels on prospective space shuttle launch configurations at Mach numbers from 0.8 to 2.2

Overall fluctuating pressure levels of seven space shuttle launch configurations are presented. The model was a 4-percent-scale space shuttle vehicle, tested in both a 11- by 11-foot transonic wind tunnel and a 9- by 7-foot supersonic wind tunnel. Mach numbers varied from 0.8 to 2.2, and the angle of attack range was from -8 deg to 8 deg at angles of sideslip of -5 deg, and 5 deg. The model configurations included both series-burn and parallel-burn configurations, two canopy configurations, two positions of the orbiter nose relative to the HO tank nose and two HO tank nose-cone angles (15 deg and 20 deg). The fluctuating pressure levels are presented in three forms.

Dods, J. B., Jr.↗
NASA NTRS1974

Effect of gaseous and solid simulated jet plumes on an 040A space shuttle launch configuration at m=1.6 to 2.2

The effect of plume-induced flow separation and aspiration effects due to operation of both orbiter and the solid rocket motors on a 0.019-scale model of the launch configuration of the Space Shuttle Vehicle is determined. Longitudinal and lateral-directional stability data were obtained at Mach numbers of 1.6, 2.0, and 2.2 with and without the engines operating. The plumes exiting from the engines were simulated by a cold-gas jet supplied by an auxiliary 200-atm air supply system and solid-body plume simulators. The aerodynamic effects produced by these two simulation procedures are compared. The parameters most significantly affected by the jet plumes are pitching moment, elevon control effectiveness, axial force, and orbiter wing loads. The solid rocket motor (SRM) plumes have the largest effect on the aerodynamic characteristics. The effect of the orbiter plumes in combination with the SRM plumes is also significant. Variations in the nozzle design parameters and configuration changes can reduce the jet plume-induced aerodynamic effects.

Dods, J. B., Jr.↗
NASA NTRS1975

Shadowgraphs of air flow over prospective space shuttle configurations at Mach numbers from 0.8 to 1.4

Shadowgraphs of five space shuttle launch configurations are presented. The model was a 4 percent-scale space shuttle vehicle, tested in the 11- by 11-foot Transonic Wind Tunnel at Ames Research Center. The Mach number was varied from 0.8 to 1.4 with three angles of sideslip (0 deg, 5 deg and -5 deg) that were used in conjunction with three angles of attack (4 deg, -4 deg, and 0 deg). The model configurations included both series-burn and parallel-burn configurations, two canopy configurations, two positions of the orbiter nose relative to the HO tank nose, and two HO tank nose-cones angles (15 deg and 20 deg). The data consist entirely of shadowgraph photographs.

Dods, J. B., Jr.↗
NASA NTRS1976

The Effects of Blowing Over Various Trailing-edge Flaps on an NACA 0006 Airfoil Section, Comparisons with Various Types of Flaps on other Airfoil Sections, and an Analysis of Flow and Power Relationships for Blowing Systems

The results are presented of a two-dimensional investigation conducted to determine the effect of blowing over various types of trailing-edge flaps on a wing having the NACA 0006 airfoil section and a drooped-nose flap. The position and profile of the trailing-edge flap, the nozzle height, and the location of the flap with respect to the nozzle were found to be important variables. Data from many investigations were used to make an evaluation of the effects of blowing on lift. An analysis was made of flow and power relationships for blowing systems.

Dods, J. B., Jr.↗
NASA NTRS1976

The ubiquitous solar electric propulsion stage

Mission analyses indicate there are several near-term interplanetary missions that cannot be performed with any degree of sophistication without electric propulsion. Cost and performance benefits are suggested when this same technology is included in the Shuttle-based earth-orbital transportation system. Specific earth-orbital payload programs gain from increased weight allowances, decreased costs through simplification, and reduced numbers of spacecraft due to on-orbit servicing. More ambitious mission planners looking toward space industrialization will find uses ranging from GSO debris clearance to a versatile support element for a multipurpose manned space station.

Austin, R. E.↗
NASA NTRS1977

An analysis of the rotor blade stresses of the three stage compressor of the Ames Research Center 11- by 11-foot transonic wind tunnel

The static and dynamic rotor blade stresses of the three stage compressor were measured. Data are presented in terms of total blade stress for the complete operational range of compressor speeds and tunnel total pressures. Modal frequencies and variations with tunnel conditions were measured. Phase angles and coherences between various gage combinations are also presented. Recommendations for improvements are given for future rotor blade experimental investigations.

Dods, J. B., Jr.↗