Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “DEEP SPACE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,027 records · Page 57

Design and analysis of low-loss linear analog phase modulator for deep space spacecraft X-band transponder (DST) application

This paper summarizes the design concepts, analyses, and the development of an X-band transponder low-loss linear phase modulator for deep space spacecraft applications. A single section breadboard circulator-coupled reflection phase modulator has been analyzed, fabricated, and evaluated. Two- and three-cascaded sections have been modeled and simulations performed to provide an X-band DST phase modulator with +/- 2.5 radians of peak phase deviation to accommodate down-link signal modulation with composite telemetry data and ranging with a deviation linearity tolerance +/- 8 percent and insertion loss of less than 10 +/- 0.5 dB. A two-section phase modulator using constant gamma hyperabrupt varactors and an efficient modulator driver circuit was breadboarded. The measured results satisfy the DST phase modulator requirements, and excellent agreement with the predicted results.

Mysoor, Narayan R.↗

Design and application of electromechanical actuators for deep space missions

This progress report documents research and development efforts performed from August 16, 1993 through February 15, 1994 on NASA Grant NAG8-240, 'Design and Application of Electromechanical Actuators for Deep Space Missions.' Following the executive summary are four report sections: Motor Selection, Tests Stand Development, Health Monitoring and Fault Management, and Experiment Planning. Three specific motor types have been considered as prime movers for TVC EMA applications: the brushless dc motor, the permanent magnet synchronous motor, and the induction motor. The fundamental finding was that, in general, the primary performance issues were energy efficiency and thermal dissipation (rotor heating). In terms of all other issues, the three motor types were found to compare quite equally. Among the design changes made to the test stand since the last progress report is the addition of more mounting holes in the side beams. These additional holes allow the movable end beam to be attached in a greater number of positions than previously. With this change the movable end beam can move from full forward to full back in three inch increments. Specific mathematical details on the approach that have been employed for health monitoring and fault management (HMFM) have been reported previously. This approach is based on and adaptive Kalman filter strategy. In general, a bank of filters can be implemented for each primary fault type. Presently under consideration for the brushless dc machine are the following faults: armature winding open-circuits, armature winding short-circuits (phase-to-phase and phase-to-ground), bearing degradation, and rotor flux weakening. The mechanically oriented experiments include transient loading experiments, transverse loading experiment, friction experiment, motor performance experiment, and HMFM experiment.

Haskew, Tim A.↗

Design and application of electromechanical actuators for deep space missions

This progress report documents research and development efforts performed from August 16, 1993 through August 15, 1994 on NASA Grant NAG8-240, 'Design and Application of Electromechanical Actuators for Deep Space Missions.' Since the submission of our last progress report in February 1994, our efforts have been almost entirely focused on final construction of the test stand and experiment design. Hence, this report is dedicated solely to these topics. However, updates on our research personnel and our health monitoring and fault management efforts are provided in this summary. Following this executive summary are two report sections. The first is devoted to the motor drive being constructed for the test stand. The thrust of the next section is the mechanical and hydraulic design and construction based on the planned experimental requirements. Following both major sections are three appendices.

Haskew, Tim A.↗

Evolutionary Scheduler for the Deep Space Network

A computer program assists human schedulers in satisfying, to the maximum extent possible, competing demands from multiple spacecraft missions for utilization of the transmitting/receiving Earth stations of NASA s Deep Space Network. The program embodies a concept of optimal scheduling to attain multiple objectives in the presence of multiple constraints.

Guillaume, Alexandre↗

Deep Space Mission Applications for NEXT: NASA's Evolutionary Xenon Thruster

NASA's Evolutionary Xenon Thruster (NEXT) is designed to address a need for advanced ion propulsion systems on certain future NASA deep space missions. This paper surveys seven potential missions that have been identified as being able to take advantage of the unique capabilities of NEXT. Two conceptual missions to Titan and Neptune are analyzed, and it is shown that ion thrusters could decrease launch mass and shorten trip time, to Titan compared to chemical propulsion. A potential Mars Sample return mission is described, and compassion made between a chemical mission and a NEXT based mission. Four possible near term applications to New Frontiers and Discovery class missions are described, and comparisons are made to chemical systems or existing NSTAR ion propulsion system performance. The results show that NEXT has potential performance and cost benefits for missions in the Discovery, New Frontiers, and larger mission classes.

low thrust trajectories↗

Deep-Space Ka-Band Link Priority Data Protection: Pre-Emptive Retransmission vs. Margin

In this paper the performance of two preemptive retransmission schemes for protection of priority data over deep-space Ka-band links is evaluated. The first scheme merges the correctly received bit from each transmission to create the most complete set of priority data for each pass (bit merge). The second scheme (symbol combining) combines the soft symbols received from each transmission of the priority data to increase the priority data's signal to noise ratio (SNR), thus increasing the liklihood of the correct reception.

Shambayati, Shervin↗

The Opportunity in Commercial Approaches for Future NASA Deep Space Exploration Elements

This work joins two events, showing the potential for commercial, public private partnerships, modeled on programs like COTS, to reduce the cost to NASA significantly for other required deep space exploration capabilities. These other capabilities include landers, stages and more. We mature the concept of costed baseball cards, adding cost estimates to NASAs space systems baseball cards.

cost modeling estimation↗

Comparative Analysis of Thermal Conversion Technologies for Deep Space Missions

Radioisotope power systems (RPS) utilizing Plutonium-238 as a heat source for thermal-to-electric energy conversion have been used as a reliable power source for NASA’s deep space missions for sixty years. Recent innovations and improvements to thermal energy technologies show potential increases to radioisotope system efficiencies from current measurements of ~5-7% to efficiencies upwards of 20%. This report surveys and ranks recent, innovative thermal-to-electric energy conversion research technologies. Technologies being developed at universities and industry are compared with respect to thermal conversion method and relevant key performance parameters. Key performance parameters are identified as system specific power per kg, efficiency, power output, technology readiness level, and system mass. Analytical Hierarchy Process (AHP) was utilized to create weighted values for each evaluation criterion. The AHP tables combined with decision matrices create table scores for past, present, and potential future systems. The table score was combined with a conversion method score in an adjustable system to add value to flight-proven or well-tested thermal conversion technologies such as thermoelectrics. While the three highest-ranking systems reviewed are currently being developed by NASA’s RPS Program, the additional highest-ranking systems not under-development by RPS could warrant further research.

Radioisotope Power System↗

Reliability, Safety, and Performance for Two Aerospace Revolutions - UAS/ODM and Commercial Deep Space

Aerospace is in the midst of a renaissance, expanding on both the air and space side into major new commercial areas including unmanned air systems (UAS), on demand mobility (ODM), personal air vehicles (PAV), and commercial deep space. These new areas require, in the initial planning, consideration of new safety, reliability, and in some cases, enabling performance approaches for viability. For example, due to their huge numbers, if current accident rates prevail, UAS/ODM/PAV aircraft could crash at an unacceptable rate, causing life and property damage. Also, if humans in commercial space activities have serious health issues and/or there are unacceptable rocket viability issues/crash rates, these new, major markets (order of 1 trillion dollars per year) could be rapidly curtailed until agreeable and effective changes are instituted, producing additional expense, delay, and reduced revenue. This report addresses such safety and reliability issues and includes: performance enhancement possibilities such as an enabling Air Traffic Control System (ATC), crash proof vehicles, increased range for aero, space debris removal, and human health for space.

Crash Proof↗

The operational performance of hydrogen masers in the deep space network: The performance of laboratory reference frequency standards in an operational environment

Hydrogen masers used as aids in meeting the routine frequency and time operational requirements within the 64 m antenna Deep Space Network. Both the operational syntonation (frequency synchronization) and the the clock (epoch) synchronization requirements were established through the use of specifically calibrated H-P E215061A flying clock. The sync/synt to UTC was maintained using LORAN and TV in simultaneous reception mode. The sync/synt within the 64 m net was maintained through the use of very long base interferometry. Results indicate that the hydrogen masers perform well within the required specifications.

Ward, S. C.↗

An OSI architecture for the deep space network

The flexibility and robustness of a monitor and control system are a direct result of the underlying inter-processor communications architecture. A new architecture for monitor & Control at the Deep Space Network Communications Complexes has been developed based on the Open System Interconnection (OSI) standards. The suitability of OSI standards for DSN M&C has been proven in the laboratory. The laboratory success has resulted in choosing an OSI-based architecture for DSS-13 M&C. DSS-13 is the DSN experimental station and is not part of the 'operational' DSN; it's role is to provide an environment to test new communications concepts can be tested and conduct unique science experiments. Therefore, DSS-13 must be robust enough to support operational activities, while also being flexible enough to enable experimentation. This paper describes the M&C architecture developed for DSS-13 and the results from system and operational testing.

Heuser, W. Randy↗

Parametric Study of Radiator Concepts for a Stirling Radioisotope Power System Applicable to Deep Space Mission

The Department of Energy (DOE) and the NASA Glenn Research Center are developing a Stirling converter for an advanced radioisotope power system to provide spacecraft onboard electric power for NASA deep space missions. This high-efficiency converter is being evaluated as an alternative to replace the much lower efficiency radioisotope thermoelectric generator (RTG). The current power requirement (six years after beginning of mission (BOM) for a mission to Jupiter) is 210 W(sub e) (watts electric) to be generated by two separate power systems, one on each side of the spacecraft. Both two-converter and four-converter system designs are being considered, depending on the amount of required redundancy.

Juhasz, Albert J.↗

Power Management and Distribution Trades Studies for a Deep-Space Mission Scientific Spacecraft

As part of NASA's Project Prometheus, the Nuclear Systems Program, NASA GRC performed trade studies on the various Power Management and Distribution (PMAD) options for a deep-space scientific spacecraft which would have a nominal electrical power requirement of 100 kWe. These options included AC (1000Hz and 1500Hz and DC primary distribution at various voltages. The distribution system efficiency, reliability, mass, thermal, corona, space radiation levels and technology readiness of devices and components were considered. The final proposed system consisted of two independent power distribution channels, sourced by two 3-phase, 110 kVA alternators nominally operating at half-rated power. Each alternator nominally supplies 50kWe to one half of the ion thrusters and science modules but is capable of supplying the total power re3quirements in the event of loss of one alternator. This paper is an introduction to the methodology for the trades done to arrive at the proposed PMAD architecture. Any opinions expressed are those of the author(s) and do not necessarily reflect the views of Project Prometheus.

Kimnach, Greg L.↗

Tone-Based Command of Deep Space Probes using Ground Antennas

A document discusses a technique for enabling the reception of spacecraft commands at received signal levels as much as three orders of magnitude below those of current deep space systems. Tone-based commanding deals with the reception of commands that are sent in the form of precise frequency offsets using an open-loop receiver. The key elements of this technique are an ultrastable oscillator and open-loop receiver onboard the spacecraft, both of which are part of the existing New Horizons (Pluto flyby) communications system design. This enables possible flight experimentation for tone-based commanding during the long cruise of the spacecraft to Pluto. In this technique, it is also necessary to accurately remove Doppler shift from the uplink signal presented to the spacecraft. A signal processor in the spacecraft performs a discrete Fourier transform on the received signal to determine the frequency of the received signal. Due to the long-term drift in the oscillators and orbit prediction model, the system is likely to be implemented differentially, where changes in the uplink frequency convey the command information.

Bokulic, Robert S.↗

Mariner II Deep Space Telecommunications

Two major telecommunication activities were in process during the Venus encounter of 1962, the largest, activity involved the two-way communications and tracking of the Mariner spacecraft from the DSIF (Deep Space Instrumentation Facility) stations on the earth. The first, and by far the largest activity involved the two-way communications and tracking of the Mariner spacecraft from the DSIF stations on the earth. The DSIF includes stations at Goldstone, California; Woomera, Australia; and Johannesburg, South Africa. The second activity involved an earth-based radar which reflected signals off the planet Venus during the same month that the Mariner spacecraft was traveling toward the planet.

TELECOMMUNICATION↗