Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “difference frequency”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,009 records · Page 56

Superconducting gravimeter

The superconducting gravimeter was developed and applied to field measurements. The stability of the instrument yielded the highest precision measurements of the Earth tides ever attained. It revealed unprecedented details about the effect of the atmosphere on gravity. Secular variations in gravity and the stability of the instruments were measured by comparing records from co-located instruments. These efforts have resulted in substantial reductions in the noise level at very low frequencies so that the peak differences between two instruments at the same location can be reduced to 0.1 micron gal.

Goodkind, J. M.↗

Dynamic-pressure measurements using an electronically scanned pressure module

Frequency response was measured for different lengths and diameters of tubing between a sinusoidal pressure source and a pressure sensing module from an electronically scanned pressure measuring system. Measurements were made for straight runs of both steel and vinyl tubing. For steel tubing, measured results are compared with results calculated by using equations developed by Tijdeman and Bergh. Measurements were also made with a bend in the vinyl tubing at the module. In addition, measurements were made with two coils placed in the tubing near the middle of the run.

Chapin, W. G.↗

Application of matrix singular value properties for evaluating gain and phase margins of multiloop systems

A stability margin evaluation method in terms of simultaneous gain and phase changes in all loops of a multiloop system is presented. A universal gain-phase margin evaluation diagram is constructed by generalizing an existing method using matrix singular value properties. Using this diagram and computing the minimum singular value of the system return difference matrix over the operating frequency range, regions of guaranteed stability margins can be obtained. Singular values are computed for a wing flutter suppression and a drone lateral attitude control problem. The numerical results indicate that this method predicts quite conservative stability margins. In the second example if the eigenvalue magnitude is used instead of the singular value, as a measure of nearness to singularity, more realistic stability margins are obtained. However, this relaxed measure generally cannot guarantee global stability.

Mukhopadhyay, V.↗

Flight effects on fan noise with static and wind tunnel comparisons

A flight test program utilizing a JT15D-1 turbofan engine has been conducted with the objectives of studying flight effects on fan noise and evaluating the simulation effectiveness of both a wind tunnel and a static test configuration that incorporated an inlet control device (ICD). In conjunction with synchronized laser-radar tracking and meteorological profile information, data obtained from a linear array of ground microphones was narrowband-analyzed and ensemble-averaged to yield highly accurate far-field flight acoustic results. Utilizing appropriate corrections, flight, wind tunnel, and static acoustic data were normalized to a static-equivalent, 100-foot radius, lossless reference condition. Data comparisons showed that both the static test with ICD and wind tunnel were generally very effective in simulating flight blade-passage-frequency (BPF) noise levels. However, differences were observed in broadband noise levels and in the details of the multiple-pure-tone harmonics.

Preisser, J. S.↗

Seasonal and geographical variation of blocking

An examination of grid point values of daily 500 mb geopotential height over the Northern Hemisphere for the 1963-1977 period has been conducted in order to calculate the seasonal frequency blocking variation and its geographical location, where blocking events require the persistence of a large positive anomaly for seven days or more. The geographical locations of the maximum frequency, characterized by three distinctly different maxima, remain nearly the same for all four seasons. Large persistent negative anomalies during the winter season are mostly associated with local high index flow. An examination of the seasonal variability of persistent characteristics of wave numbers 1-4, for 500 mb geopotential height between 50 and 70 deg N, shows that the large scale planetary waves have preferred phase locations for persistence beyond seven days.

Shukla, J.↗

Some properties of transient phenomena in the extra-tropical region and their importance in the seasonal mean flow

When studying data for one season, it is convenient to divide transient eddies into those of the synoptic time scale and those of lower frequency. Where the dividing line is placed is not crucial, but a 10-day period is used in a study of the 1979-1980 Northern Hemisphere winter. The synoptic time scale eddies exhibit maximum kinetic energy in stormtracks slightly downstream from and poleward of the Atlantic and Pacific jet maximum. An alternative approach is via the anisotropic part of the horizontal velocity correlation tensor, the axis of which gives the local orientation of the eddies and the magnitude a measure of the extension of the eddies. When the man velocity field is almost that of the plane waves, the horizontal group velocity relative to the mean field is also related to this tensor. The synoptic time scale eddies force the mean flow in the sense of reducing the baroclinic component in the upstream of the region of the stormtrack. The lower frequency eddies have a very different signature.

Hoskins, B. J.↗

Narrow-band radio flares from red dwarf stars

VLA observations of narrow-band behavior in 20 cm flares from two red dwarf stars, L726 - 8A and AD Leo, are reported. The flare on L726 - 8A was observed at 1415 and 1515 MHz; the flux and the evolution differed significantly at the two frequencies. The flare on AD Leo lasted for 2 hr at 1415 MHz but did not appear at 1515 MHz. The AD Leo flare appears to rule out a source drifting through the stellar corona and is unlikely to be due to plasma emission. In the cyclotron maser model the narrow-band behavior reflects the range of magnetic fields present within the source. The apparent constancy of this field for 2 hr is difficult to understand if magnetic reconnection is the source of energy for the flare. The consistent polarization exhibited by red dwarf flares at 20 cm may be related to stellar activity cycles, and changes in this polarization will permit measuring the length of these cycles.

White, Stephen M.↗

The theoretical model for the annular jet instability - Revisited

The theoretical model of Lee and Wang (1986) for the instability of an annular jet, in which the jet's liquid layer is treated as a thin liquid sheet, is examined. It is suggested that the model should be altered so that when the envelope is closing its bottleneck during collapse, the new envelope experiences a sharp pressure pulse from its gaseous core, reversing the normal velocity of the sheet enough to maintain continuous constant gas flow. Using this improved version of the model, it is shown that if the liquid velocity is high enough and the gas velocity is greater than the liquid velocity, the bubble-formation frequency varies linearly with the difference between the two velocities, but not with their individual values.

Lee, C. P.↗

Microwave response of a HEMT photoconductive detector

Interdigitated photoconductive detectors with 5-micron geometry have been fabricated on HEMT material and their optical response characteristics at 820 nm have been examined at dc and in the frequency range of 2-8 GHz. These have been compared with characteristics of similar 1-micron devices on MESFET material. The shapes of the frequency responses were found to differ, but the useful bandwidth of both types of devices was found to be similar.

Claspy, P. C.↗

Power and stability limitations of resonant tunneling diodes

Stability criteria for resonant tunneling diodes are investigated. Details of how extrinsic elements, such as series inductance and parallel capacitance, affect the stability are presented. A GaAs/AlAs/InGaAs/AlAs/GaAs double-barrier diode is investigated, showing the effect of different modes of low-frequency oscillation and the extrinsic circuit required for stabilization. The effect of device stabilization on high-frequency power generation is described. The main conclusions of the paper are: (1) stable resonant tunneling diode operation is difficult to obtain, and (2) the circuit and device conditions required for stable operation greatly reduce the amount of power that can be produced by these devices.

Kidner, C.↗

A study of rotor broadband noise mechanisms and helicopter tail rotor noise

The rotor broadband noise mechanisms considered are the following: (1) lift fluctuation due to turbulence ingestion; (2) boundary layer/trailing edge interaction; (3) tip vortex formation; and (4) turbulent vortex shedding from blunt trailing edge. Predictions show good agreement with available experimental data. The study shows that inflow turbulence is the most important broadband noise source for typical helicopters' main rotors at low- and mid-frequencies. Due to the size difference, isolated helicopter tail rotor broadband noise is not important compared to the much louder main rotor broadband noise. However, the inflow turbulence noise from a tail rotor can be very significant because it is operating in a highly turbulent environment, ingesting wakes from upstream components of the helicopter. The study indicates that the main rotor turbulent wake is the most important source of tail rotor broadband noise. The harmonic noise due to ingestion of main rotor tip vortices is studied.

Chou, Shau-Tak Rudy↗

The photoelectron spectroscopy of ZnCl2

The ionization energies (IEs) corresponding to the Cl ligand electrons and the Zn 3d electrons in ZnCl2, computed using large Gaussian basis sets and a high level of correlation treatment, are presented. The IEs for the Cl ligand electrons are in excellent agreement with those determined from photoelectron spectra. The IEs corresponding to the Zn 3d electrons agree with experiment relatively well in absolute magnitude, but differ in order. The vibrational frequencies of the ground state agree very well with experiment, and predictions are made for the corresponding frequencies in the positive ion.

Bauschlicher, Charles W., Jr.↗

Structural damage identification using mathematical optimization techniques

An identification procedure is proposed to identify damage characteristics (location and size of the damage) from dynamic measurements. This procedure was based on minimization of the mean-square measure of difference between measurement data (natural frequencies and mode shapes) and the corresponding predictions obtained from the computational model. The procedure is tested for simulated damage in the form of stiffness changes in a simple fixed free spring mass system and symmetric cracks in a simply supported Bernoulli Euler beam. It is shown that when all the mode information is used in the identification procedure it is possible to uniquely determine the damage properties. Without knowing the complete set of modal information, a restricted region in the initial data space has been found for realistic and convergent solution from the identification process.

Shen, Mo-How Herman↗

Subsurface emissions from Mercury - VLA radio observations at 2 and 6 centimeters

Radio observations of Mercury made with the VLA; once in 1986, and on two dates in February of 1988 are presented. These observations are the first to spatially map both hot regions associated with the theoretical hot poles. These 'hot poles' are separated by 180 deg and are a result of the unusual diurnal heating from Mercury's 3/2 spin-orbit resonance and eccentric orbit. The highest resolution data maps areas of the planet as small as 330 km. Maps of total intensity, brightness temperature, polarized intensity, fractional polarization, depolarization, and spectral index are included. It is found that the subsurface thermal emissions from Mercury are characteristic of blackbody reradiation from the solar insolation over a diurnal cycle. These observations to produce full-disk thermophysical models are used. The one-dimensional, time-dependent heat-diffusion equation for all observed disk elements at each epoch in order to constrain thermophsyical parameters and properties of the subsurface material are solved. Using typical lunar values for several of the parameters, it is possible to reproduce the temperature morphology and most of the observed temperature values. It is found that the best-fit models require a substantial contribution of the heat transport in the subsurface to be radiative in nature. The primary difficulty in the models is in predicting the observed temperature differences as a function of frequency.

Ledlow, Michael J.↗

Slosh wave excitation in a partially filled rotating tank due to gravity jitters in a microgravity environment

The dynamical behavior of fluids, in particular the effect of surface tension on partially-filled rotating fluids (cryogenic liquid helium and helium vapor), in a full-scale Gravity Probe-B Spacecraft propellant tank without probe imposed by various frequencies of gravity jitters have been investigated. Twelve case studies of slosh wave excitation due to various frequencies of gravity jitters under different rotating speeds of propellant tank and different levels of background gravity environment have been numerically simulated. Results disclose the conditions for the excitation of large amplitude slosh waves which shall be avoided in the design of cryogenic liquid propellant system.

Hung, R. J.↗

Perceiving the coherent movements of spatially-separated features

When a partially-occluded object is represented in an image, it is defined by a set of spatially-separated features that may be registered at different spatial scales. To understand the image, human vision must organize these fragmented optical features into common and distinct object surfaces. Although the common fate of moving features often is considered a primary source of reliable information for image segmentation, little is known of the visual system's capacity to discriminate the coherent relative movements of spatially-separated features. In a series of experiments, observers viewed elements whose movements were correlated (direction and magnitude) or were uncorrelated. Our results indicate that observers can discriminate the two types of movement about as well as they can detect any movement at all. Moreover, the ability to perceive coherent movements is maintained under a variety of conditions including differences in the elements' spatial frequency content, spatial position and contrast, and temporal phase shifts between the spatially-correlated displacements. These results suggest that coherent relative motion may be a fundamental source of information exploited by vision, despite considerable variability in the spatial and temporal characteristics of the individual features.

Mowafy, Lyn↗

Theoretical and Measured Attenuation of Mufflers at Room Temperature Without Flow, with Comments on Engine-exhaust Muffler Design

Equations are presented for the attenuation characteristics of several types of mufflers. Experimental curves of attenuation plotted against frequency are presented for 77 different mufflers and the results are compared with theory. The experiments were made at room temperature without flow and the sound source was a loud-speaker. A method is given for including the tail pipe in the calculations. The application of the theory to the design of engine-exhaust mufflers is discussed, and charts have been included for the assistance of the designer.

NOISE↗

Theoretical and Experimental Investigation of Mufflers with Comments on Engine-Exhaust Muffler Design

Equations are presented for the attenuation characteristics of single-chamber and multiple-chamber mufflers of both the expansion-chamber and resonator types, for tuned side-branch tubes, and for the combination of an expansion chamber with a resonator. Experimental curves of attenuation plotted against frequency are presented for 77 different mufflers with a reflection-free tailpipe termination. The experiments were made at room temperature without flow; the sound source was a loud-speaker. A method is given for including the tailpipe reflections in the calculations. Experimental attenuation curves are presented for four different muffler-tailpipe combinations, and the results are compared with the theory. The application of the theory to the design of engine-exhaust mufflers is discussed, and charts are included for the assistance of the designer.

Davis, Don D , Jr↗