Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “PITCHES”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,009 records · Page 56

Preliminary Measurement of Pitch Damping of Blunt Entry Vehicles in a Subsonic Magnetic Suspension Wind Tunnel

The yaw damping coefficients of two blunt entry vehicle models, measured from free-to-oscillate tests in the ODU/NASA subsonic magnetic suspension wind tunnel are presented. Multiple repeat trials were conducted for both models. Two separate data reduction methods were used to extract damping coefficients and yaw moment slope. Both methods identified similar damping and stability values, with differences being consistent with their known limitations.

magnetic suspension↗

Probing Dark Current Random Telegraph Signal in a Small Pitch Vertically Pinned Photodiode CMOS Image Sensor after Proton Irradiation

Dark Current degradation and Dark Current Ran- dom Telegraph Signal after proton irradiation are studied in new scale silicon microvolumes by using a commercial CMOS Image Sensor. Results show that previously reported empirical models describing the Displacement Damage induced degradations are still valid despite the 10 to 100 times smaller depletion volume used. In addition, no evidence of significant Total Ionizing Dose effects is observed. Finally the reduction of the fraction of Random Telegraph Signal (RTS) pixels detected and of the fraction of multi-level RTS pixels is directly linked to the reduction in pixel volume.

CMOS Image Sensor (CIS)↗

Printability and inspectability of Defects on the EUV Mask for sub32nm Half Pitch HVM Application

The availability of defect-free masks remains one of the key challenges for inserting extreme ultraviolet lithography (EUVL) into high volume manufacturing, yet little data is available for understanding native defects on real masks. In this paper, a full field EUV mask is fabricated to see the printability of various defects on the mask. Programmed pit defect shows that minimum printable size of pits could be 17 nm of SEVD from the AIT. However 23.1nm in SEVD is printable from the EUV ADT. Defect printability and identification of its source along from blank fabrication to mask fabrication were studied using various inspection tools. Capture ratio of smallest printable defects was improved to 80% using optimized stack of metrical on wafer and state-of-art wafer inspection tool. Requirement of defect mitigation technology using fiducial mark are defined.

36 MATERIALS SCIENCE↗