Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Experimental methods”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,009 records · Page 56

A preliminary in-duct measurement of spinning modes in the inlet of a rotating vehicle

Suppression of noise radiated from a jet engine duct is an important environmental problem. Results are presented for a study aimed at developing and evaluating an experimental method for measuring the complex acoustic pressure field at a plane in the inlet of a fan duct. The theory of modal propagation is outlined and related to the theory of measuring spinning modes in the duct. A spinning mode measurement apparatus is described, and preliminary test results of the modal measurement for several operating speeds are presented. The measurement of spinning modes is successfully carried out in the inlet of a rotating vehicle under conditions representative of an actual jet engine. Data repeatability and problems encountered in the measurement are examined. In particular, it is important to calibrate the probe systems for phase and level. Recommendations for future improvements in the method are made.

Kraft, R. E.↗

Sodium ions at defect sites at SiO2/Si interfaces as determined by X-ray photoelectron spectroscopy

X-ray photoelectron spectroscopy (XPS) is described in its application as a probe for studying defects such as sodium in SiO2 films. A general description is given of key experimental methods in XPS. Techniques are described for applying and monitoring a fixed bias at the surface of the oxide during the XPS measurement. These methods are shown to be capable of detecting extremely small Na and Cu concentrations in undoped samples (less than 10 to the 11th power per cu cm). In deliberately Na-doped samples, five spectral peaks are distinctly observed and related to different defect states at the vacuum/SiO2 and SiO2/Si interfaces. By applying a bias-temperature stress during the XPS measurements, these peaks change in relative intensity and can be related to the motion of the Na(+) ions between different states occurring at the two interfaces. An attempt is made to correlate the observations with previously reported models.

Grunthaner, F. J.↗

Tunnel injection into gate oxide traps

An experimental method is described for measuring the density of oxide traps in the gate oxide of an MOS transistor as a function of energy and position near the silicon interface. Measurements are obtained from different oxide growth processes and after Co-60 irradiation. The results are related to long-term drift of threshold voltage.

Maserjian, J.↗

Wind tunnel test and calibration techniques for the measurement of damping and dynamic cross derivatives due to pitching and yawing

The paper shows how the oscillatory apparatus described previously by Orlik-Rueckemann et al. (1974) for determining cross and cross-coupling moment derivatives due to pitching and yawing oscillation is strengthened, extensively modified, and adapted to permit operation in a large continuous-flow wind tunnel. Particular attention is given to an electromagnetic three-degrees-of-freedom calibrating system developed to verify the validity of the experimental method and the various aspects of data reduction procedure. Typical results from calibration tests and from a series of wind tunnel experiments are presented. The only significant limitation is that the apparatus can only be used for models that are relatively small and have a conically-shaped longitudinal cavity.

Hanff, E. S.↗

Bubble dielectrophoresis

The theoretical principles related to bubble dielectrophoresis are examined, taking into account the polarization force, aspects of bubble deformation, the electrostatic bubble levitation theorem, and the equation of motion. The measurement of the dielectrophoretic force on static and dynamic bubbles represents a convenient experimental method for the study of the general problem of dielectrophoresis. The experiments reported include static-force measurements, static-levitation experiments, and dynamic-force measurements.

Jones, T. B.↗

Gray-level transformations for interactive image enhancement

A gray-level transformation method suitable for interactive image enhancement is presented. It is shown that the well-known histogram equalization technique is a special case of this method. Experimental results which illustrate the enhancement capabilities of the procedure are also described.

Gonzalez, R. C.↗

Effects of forward velocity on noise for a J85 turbojet engine with multitube suppressor from wind tunnel and flight tests

Flight tests and wind tunnel noise tests using a J85 engine with some representative jet exhaust noise suppressors are reported. Capabilities and limitations of the two types of experimental methods are evaluated with emphasis on investigation of forward velocity effects. The suppressor arrangement was a 104-elliptical-tube nozzle configuration, with or without an acoustically lined shroud. The suppressor noise levels are found not reduced as much by forward velocity as expected for unsuppressed jets. The directivity and forward velocity effects appear more similar to predicted trends for internally generated noise than for unsuppressed jet noise.

Stone, J. R.↗

Tetroon evaluation program

The actual volume of a constant volume superpressured tetrahedron shaped balloon changes as the amount of superpressure is changed. The experimental methods used to measure these changes in volume are described and results are presented. The basic equations used to determine the amount of inflation gas required for a tetroon to float at a predetermined flight level are presented and inflation techniques discussed.

Beemer, J. D.↗

Transcutaneous measurement of volume blood flow

Blood flow velocity measurements, using Doppler velocimeter, are described. The ability to measure blood velocity using ultrasound is derived from the Doppler effect; the change in frequency which occurs when sound is reflected or transmitted from a moving target. When ultrasound of the appropriate frequency is transmitted through a moving blood stream, the blood cells act as point scatterers of ultrasonic energy. If this scattered ultrasonic energy is detected, it is found to be shifted in frequency according to the velocity of the blood cells, nu, the frequency of the incident sound, f sub o, the speed of sound in the medium, c, and the angle between the sound beam and the velocity vector, o. The relation describing this effect is known as the Doppler equation. Delta f = 2 f sub o x nu x cos alpha/c. The theoretical and experimental methods are evaluated.

Daigle, R. E.↗

Determination of the zincate diffusion coefficient and its application to alkaline battery problems

The diffusion coefficient for the zincate ion at 24 C was found to be 9.9 X 10 to the minus 7th power squared cm per sec + or - 30 percent in 45 percent potassium hydroxide and 1.4 x 10 to the minus 7 squared cm per sec + or - 25 percent in 40 percent sodium hydroxide. Comparison of these values with literature values at different potassium hydroxide concentrations show that the Stokes-Einstein equation is obeyed. The diffusion coefficient is characteristic of the zincate ion (not the cation) and independent of its concentration. Calculations with the measured value of the diffusion coefficient show that the zinc concentration in an alkaline zincate half cell becomes uniform throughout in tens of hours by diffusion alone. Diffusion equations are derived which are applicable to finite size chambers. Details and discussion of the experimental method are also given.

May, C. E.↗

The effect of load in a contact with boundary lubrication

The effect of the transition load on the wear in a contact with boundary lubrication was investigated. An experimental method was developed for this purpose, and parameters affecting the boundary lubrication under industrial operating conditions were identified. These parameters are the adsorbed boundary film, the contact microgeometry (surface roughness), macrogeometry, and hardness of materials used. It was found that the curve of the tops of the surface protrustion affect the transition load, and thus the boundary lubrication. The transition load also depends on the chemical nature of the contact and its geometrical and mechanical aspects.

Georges, J. M.↗

Residual stresses in angleplied laminates and their effects on laminate behavior

NASA Lewis Research Center research in the field of composite laminate residual stresses is reviewed and summarized. The origin of lamination residual stresses, evidence of their presence, experimental methods for measuring them, and theoretical methods for predicting them are described. Typical results are presented which show the magnitudes of residual stresses in various laminates including hybrids and superhybrids, and in other complex composite components. Results are also presented which show the effects of lamination residual stresses on laminate warpage and on laminate mechanical properties including fracture stresses. Finally, the major findings and conclusions derived therefrom are summarized.

Chamis, C. C.↗

Toxicity of pyrolysis products: Influence of experimental conditions - The MSTL/UT and NASA/JSC Procedures

Ten sample materials of various polymeric composition were evaluated for toxicity of pyrolysis products utilizing two significantly different experimental methods, the MSTL/UT and NASA/JSC Procedures. A comparison of the LD(50) values obtained by the two methods for these ten samples did not yield a significant correlation. However, when the samples were ranked in order of increasing toxicity by each method independently, a comparison of their rank order toxicity improved the correlation. Because of interlaboratory variations in pyrolysis/combustion test procedures, it is suggested a series of standard materials be adopted to facilitate interlaboratory comparisons of data on pyrolysis toxicity.

Lawrence, W. H.↗

On the detection of newly created CN radicals in comets

A description is presented of laboratory measurements concerning the amount and the distribution of energy released into newly formed radicals by the photodissociation process. The experimental method used involved flash photolysis of the parent compound followed by laser induced fluorescence detection of the CN fragment. This method allowed the detection of individual rotational lines and, thereby, a monitoring of the relative populations of the vibrational-rotational levels of the CN ground state. The results obtained in the investigation suggest the possibility of observing emission lines in cometary spectra from newly formed CN radicals. Calculations show that it is feasible with present observational techniques to detect photochemically excited lines in the 0-0 band of the violet system.

Donn, B.↗

Aircraft Engine Sump Fire Mitigation, Phase 2

The effect of changes in the input parameters (air leakage flow rate and temperature and lubricating oil inlet flow rate and temperature) over a specified range on the flammability conditions within an aircraft engine bearing sump was investigated. An analytical study was performed to determine the effect of various parameters on the generation rate of oil vapor from oil droplets in a hot air stream flowing in a cylindrical tube. The ignition of the vapor-air mixture by an ignition source was considered. The experimental investigation demonstrated that fires would be ignited by a spark ignitor over the full range of air and oil flow rates and air temperatures evaluated. However, no fires could be ignited when the oil inlet temperature was maintained below 41.7 K (290 F). The severity of the fires ignited were found to be directly proportional to the hot air flow rate. Reasonably good correlation was found between the mixture temperature in the sump at the ignitor location and the flammability limits as defined by flammability theory; thus a fairly reliable experimental method of determining flammable conditions within a sump was demonstrated. The computerized mathematical model shows that oil droplet size and air temperature have the greatest influence on the generation rate of oil vapor.

Rosenlieb, J. W.↗

NASA research objectives and roles

A chronology of airfoil development is presented in order to put the present NASA airfoil program in perspective. The impact of the NACA series airfoils is considered. Development of advanced analytical and experimental methods for the design and for the determination of the characteristics of not only single element airfoils, but of multielement airfoil combinations used in aerodynamic controls and high lift systems is emphasized along with applications.

Gessow, A.↗

Potential mapping with charged-particle beams

Experimental methods of mapping the equipotential surfaces near some structure of interest rely on the detection of charged particles which have traversed the regions of interest and are detected remotely. One method is the measurement of ion energies for ions created at a point of interest and expelled from the region by the fields. The ion energy at the detector in eV corresponds to the potential where the ion was created. An ionizing beam forms the ions from background neutrals. The other method is to inject charged particles into the region of interest and to locate their exit points. A set of several trajectories becomes a data base for a systematic mapping technique. An iterative solution of a boundary value problem establishes concepts and limitations pertaining to the mapping problem.

Robinson, J. W.↗

Determination of the zincate diffusion coefficient and its application to alkaline battery problems

The diffusion coefficient for the zincate ion at 24 C was found to be 9.9 x 10 to the -7th power sq cm/sec + or - 30% in 45% potassium hydroxide and 1.4 x 10 to the -7th power sq cm/sec + or - 25% in 40% sodium hydroxide. Comparison of these values with literature values at different potassium hydroxide concentrations show that the Stokes-Einstein equation is obeyed. The diffusion coefficient is characteristic of the zincate ion (not the cation) and independent of its concentration. Calculations with the measured value of the diffusion coefficient show that the zinc concentration in an alkaline zincate half-cell becomes uniform throughout in tens of hours by diffusion alone. Diffusion equations are derived which are applicable to finite-size chambers. Details and discussion of the experimental method are also given.

May, C. E.↗