Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “range prediction”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 991 records · Page 55

Computational Analysis of the Large Scale Low-Boom Supersonic Inlet

This presentation describes two computational fluid dynamic (CFD) analyses done in support of a supersonic inlet test performed at NASA Glenn Research Center in the fall of 2010. The large-scale-low-boom supersonic inlet was designed for a small supersonic aircraft that would cruise at a Mach number of 1.6. It uses an axisymmetric, external compression spike to reduce the Mach number to 0.65 at the fan face. The inlet was tested in the 8x6 supersonic wind tunnel at NASA GRC using conventional pressure probes, pressure sensitive paint, and high-speed schlieren. Two CFD analyses of the inlet were performed before the test, and compared to the experimental data afterwards. Both analyses used the WIND-US code. First, an axisymmetric analysis of the inlet, diffuser, cold pipe, and mass flow plug was performed to predict the performance of the entire system in the wind tunnel. Then a 3-D analysis of the inlet with all its interior struts was performed to predict details of the flow field and effects of angle of attack. Test results showed that the inlet had excellent performance, with a peak total pressure recovery of 96 percent, and a buzz point far outside the engine operating range. The computations agreed very well with the data, with predicted recoveries within 0.3 - 0.5 points of the measurements.

Chima, ROdrick V.↗

Elastohydrodynamic film thickness measurements with advanced ester, fluorocarbon, and polyphenyl ether lubricants to 589 K (600 F)

Elastohydrodynamic (EHD) film thicknesses have been measured, by means of an X-ray technique, under conditions that closely simulate the ball-race contact in advanced turbine engine thrust bearings. The experiments were conducted with a rolling-disk machine using disks which yield a contact zone similar to that in the actual bearing. Both the rolling and spinning motions of the ball relative to the race were simulated by the apparatus. Four lubricants were evaluated at temperatures to 600 F and maximum Hertz stresses to 350,000 psi. The X-ray film thickness data correlated well with observations of surface distress (or lack thereof) in full-scale bearing tests with the same lubricants under similar conditions of temperature and load. The predicted variation of film thickness with speed and viscosity as verified, although the magnitude of measured film thickness was generally one-half to one-third of predicted values. An effect of stress greater than predicted was consistently observed in the higher stress range.

Parker, R. J.↗

Twilight and nighttime ionospheric temperatures from oxygen 6300- and 5577-A spectral-line profiles.

Use of Fabry-Perot interferometer measurements of atomic-oxygen 6300- and 5577-A line profiles from twilight and nightglow to determine the neutral temperatures in the F2 and E regions of the earth's ionosphere. The exospheric temperatures determined from the 6300-A profiles are usually somewhat higher than the temperatures calculated from Jacchia's model, and differences as large as about 300 K are noted when the exospheric temperature equals 1500 to 1600 K. The postsunset and predawn rate of change of the exospheric temperature is often substantially larger than the Jacchia prediction. The 5577-A (E region) measured temperatures range from 200 to 220 K on quiet nights to 500 to 600 K during geomagnetic storms.

Feibelman, W. A.↗

The lithium-like spectra of K XVII through Mn XXIII in the extreme-ultraviolet region.

Identifications and classifications of spectral lines in the lithium-like spectra of the elements K through Mn is presented for the first time. The extrapolation procedures used to calculate these spectra are presented in detail. The excellent agreement between the predicted and measured lines establish the long-range extrapolation.

Goldsmith, S.↗

Investigation of responsivity and noise in a direct-coupled photodetector-preamplifier for facsimile cameras

The direct-coupled (DC) mode of detector operation is evaluated for use in a facsimile camera. Photodiode-preamplifier sensitivity is described in terms of photodiode responsivity and possible noise sources resulting from the photodiode and preamplifier. Responsivity and noise limitations are experimentally verified and used to predict photodiode-preamplifier sensitivity under a wide range of operating conditions. Results demonstrate that the DC mode offers advantages in sensitivity and reduced mechanical complexity for facsimile cameras over the more common technique of chopping the radiation and ac amplifying the resultant signal.

Kelly, W. L., IV↗

Solutions of the chemical kinetic equations for initially inhomogeneous mixtures.

Following the recent discussions by O'Brien (1971) and Donaldson and Hilst (1972) of the effects of inhomogeneous mixing and turbulent diffusion on simple chemical reaction rates, the present report provides a more extensive analysis of when inhomogeneous mixing has a significant effect on chemical reaction rates. The analysis is then extended to the development of an approximate chemical sub-model which provides much improved predictions of chemical reaction rates over a wide range of inhomogeneities and pathological distributions of the concentrations of the reacting chemical species. In particular, the development of an approximate representation of the third-order correlations of the joint concentration fluctuations permits closure of the chemical sub-model at the level of the second-order moments of these fluctuations and the mean concentrations.

Hilst, G. R.↗

Wide deviation phase modulator

Modulator produces phase-modulated waveform having high modulating linearity. Technique is inherently wideband with respect to carrier frequency and can operate over decade carrier frequency range without adjustments. Circuit performance is both mathematically predictable and highly reproducible.

Couch, R. H.↗

Study to define unsteady flow fields and their statistical characteristics

Preliminary estimates of space shuttle fluctuating pressure environments were made based on analyses of wind tunnel data, and empirical prediction techniques. Particular emphasis was given to the external tank and solid rocket boosters for the transonic speed regime during launch of a parallel-burn space shuttle configuration. Predicted environments are presented as space-averaged zonal profiles with progressive shading from zone to zone to illustrate spatial variations in the magnitude of the fluctuating pressure coefficient over the surfaces of the external tank and solid rocket boosters. Predictions are provided for the transonic Mach number range from 0.8 equal to or less than M sub infinity equal to or less than 1.5, and for supersonic Mach numbers of 2.0 and 3.0.

Robertson, J. E.↗

Stellar evolution at high mass with semiconvective mixing according to the Schwarzschild criterion

Evolutionary sequences for stellar models with 10, 15, 30, and 60 solar masses, as well as four different initial chemical compositions, are calculated to the end of core helium burning using the Schwarzschild criterion for convection. The results are analyzed in terms of the modifications of interior structure and surface parameters induced by semiconvective mixing as a result of adopting the Schwarzschild criterion. It is found that the main differences from results based on the Ledoux criterion are the great extent of the convectively unstable layers in the intermediate zone and the eventual development of a fully convective zone at the base of the semiconvective one. It is shown that semiconvection develops outside the convective core just after the ZAMS stage for masses greater than 12 solar masses and just before the stage of central hydrogen exhaustion for masses greater than 6 solar masses. The present models are found to be insufficiently hot in comparison with the bulk of observed stable blue supergiants and to predict far too many red supergiants fro the range above 20 solar masses. It is concluded that something is fundamentally wrong with the models, the most likely suspects being the stellar opacities adopted and the neglect of mass loss.

Stothers, R.↗

Aerodynamic performance of jet-flap wings

Computer program analyzes performance of jet-flap wings. Fast and easy-to-use prediction technique, it generates accurate solutions for wide range of wing geometries and trailing-edge jet momentum distributions. Analysis is based on optimized vortex-lattice approach and results in rapid convergence of both overall and distributed loadings.

Hough, G. R.↗

A statistical method for time-continuous assimilation of remote sounding temperatures

A time-continuous statistical method is presented for the four-dimensional assimilation of remote sounding temperatures based on radiometric measurements from polar-orbiting satellites. This method is applied to DST-6 data from the NOAA-4 and Nimbus-6 satellites. Experiments are reported in which the state of the atmosphere throughout the test period was determined using a varying amount of satellite data and in which different methods were used for their assimilation. Data from the NOAA-4 satellite only, from Nimbus-6 only, and from both satellites together were used; the methods tested include different variations of the statistical method as well as more traditional methods. The conclusions are that: (1) satellite-derived temperature data can have a modest, but statistically significant positive impact on numerical weather prediction in the two-to-three day range; (2) this impact is highly sensitive to the quantity of data available; and (3) the assimilation method plays a major role in the magnitude of the impact for the same data.

Ghil, M.↗

Acoustic behavior of a fibrous bulk material

A semiempirical model is presented describing the acoustic behavior of Kevlar 29, a bulk absorbing material. The model is based on an approximate solution to the one-dimensional equations representing conservation of fluctuating mass, momentum and energy. By treating the material as a momentum sink, theoretical expressions of the material complex propagation constants and characteristic impedance were derived in terms of a single constant. Evaluating the constant at a single frequency for a particular specimen, excellent agreement between prediction and measurement was achieved for a large range of sound frequencies and material porosities and thicknesses. Results show that Kevlar 29 absorbs sound efficiently even at low frequencies. This is explained in terms of a frequency dependent material phase speed.

Hersh, A. S.↗

An evaluation of recent internal field models

The paper reviews the current status of internal field models and evaluates several recently published models by comparing their predictions with annual means of the magnetic field measured at 140 magnetic observatories from 1973 to 1977. Three of the four models studied, viz. AWC/75, IGS/75, and Pogo 8/71, were nearly equal in their ability to predict the magnitude and direction of the current field. The fourth model, IGRF 1975, was significantly poorer in its ability to predict the current field. All models seemed to be able to extrapolate predictions quite well several years outside the data range used to construct the models.

Mead, G. D.↗

SAS 3 and related observations of Abell 2029

X-ray and radio observations of the cluster of galaxies show that the central cD galaxy dominates the emissions. Resolution of the X-ray source shows that its extent is significantly greater than that of the profile of surface brightness of the cD galaxy. Dressler's model of most of the cluster mass with very high M/L(v) is similarly extended. The optically dark mass may provide low-energy X-ray emission of the coronae of 5 x 10 to the 16th stars with very high M/L(v), but in the 2-10 keV range the data are consistent with current theoretical predictions for hot intracluster gas.

Johnson, H. M.↗

IUE observations of WZ Sagittae in outburst

Preliminary results of the analysis of the low resolution spectra from the recurring nova WZ Sagittae are discussed with reference to the similarity between WZ Sge and dwarf novae and the applicability of accretion disk models. It is found that the spectrum observed on Dec. 1, 1978, is in very good agreement with a simple steady-state disk model of Lynden-Bell (1969) which predicts a power law spectrum over a limited range of frequency. Analysis of the observations within the framework of this model gives a value of the mass of the white dwarf larger than that estimated by Robinson et al (1978).

Holm, A. V.↗

Prediction of fatigue-crack growth under variableamplitude and spectrum loading using a closure model

An existing analytical crack closure model was used to study crack growth under various load histories. The model was based on a concept like the Dugdale model, but modified to leave plastically deformed material in the wake of the advancing crack tip. The model was used to correlate crack growth rates under constant amplitude loading, and to predict crack growth under variable amplitude and aircraft spectrum loading on 2219-T851 aluminum alloy sheet material. The predicted crack growth lives agreed well with experimental data. For 80 crack growth tests subjected to various load histories, the ratio of predicted-to-experimental lives (N(P)/n(T)) ranged from 0.5 to 1.8. The mean value of N(P)/N(T) was 0.97 and the standard deviation was 0.27.

Newman, J. C., Jr.↗

Plasmaspheric helium ion distribution from satellite observations of He II 304-A

High sensitivity and spatial resolution observations of the He II 304-A emission line intensity in the earth's nightglow have been carried out by the extreme ultraviolet telescope on the Apollo-Soyuz mission in July, 1975. The data, obtained over a wide range of plasmasphere parameters, are compared to the predictions of a kinetic equilibrium model of plasmaspheric ion density. Excellent agreement between observation and theory is found using as inputs a temperature model, solar flux and H(+) and O(+) number densities determined by extrapolating nearly simultaneous Atmospheric Explorer C measurements at 300 km. The observations in the Northern Hemisphere are well fit by a model having 285 He(+) ions/cu cm at 500 km independent of latitude or longitude, while those in the south require 430 He(+) ions/cu cm at the same altitude. This result is consistent with available information on the interhemispheric asymmetry of He(+) observed by a mass spectrometer on Explorer 32 and on the winter neutral helium bulge.

Chakrabarti, S.↗

Mathematical modeling of ice accretion on airfoils

The progress toward development of a computer model suitable for predicting icing behavior on airfoils over a wide range of environmental conditions and airfoils shapes is reported. The LEWICE program was formulated to solve a set of equations which describe the physical processes which occur during accretion of ice on an airfoil, including heat transfer in a time dependent mode, with the restriction that the flow must be describable by a two-dimensional flow code. Input data comprises the cloud liquid water content, mean droplet diameter, ambient air temperature, air velocity, and relative humidity. A potential flowfield around the airfoil is calculated, along with the droplet trajectories within the flowfield, followed by local values of water droplet collection efficiency at the impact points. Both glaze and rime ice conditions are reproduced, and comparisons with test results on icing of circular cylinders showed good agreement with the physical situation.

Macarthur, C. D.↗