Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “VOLT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 991 records · Page 55
All sourcesNASA NTRSDOE OSTI
NASA NTRS1982

Kilovolt dc solid state remote power controller development

The experience gained in developing and applying solid state power controller (SSPC) technology at high voltage dc (HVDC) potentials and power levels of up to 25 kilowatts is summarized. The HVDC switching devices, power switching concepts, drive circuits, and very fast acting overcurrent protection circuits were analyzed. A 25A bipolar breadboard with Darlington connected switching transistor was built. Fault testing at 900 volts was included. A bipolar transistor packaged breadboard design was developed. Power MOSFET remote power controller (RPC) was designed.

Mitchell, J. T.↗
NASA NTRS1983

Two hundred passage three-way valve: Fraction collector

This paper describes the design and operation of a fraction collector used to direct flow of separated biological materials from 197 capillary tubes to either a collection tray or to a waste tank. This mechanism uses a 28-volt dc gear motor driving twin cams to force 197 needles through a self-sealing silicone rubber septum, where they inject the material in 197 separate pockets in a collection tray. The position of the collector tray is sensed by two optical limit switches. The time sequences are controlled automatically by an electronics control monitoring module.

Keffer, J. L.↗
NASA NTRS1983

Test results of a ten cell bipolar nickel-hydrogen battery

A ten cell bipolar nickel hydrogen 6.5 ampere-hour battery demonstrated over 2000 low Earth orbit cycles at an 80 percent depth-of-discharge. Charge/discharge cyclic ampere-hour and watt-hour efficiencies of 88 and 76 percent, respectively, observed. Peak power capability was determined at 1.1 kW. A 10C discharge rate yields 83 percent of the nominal stark capacity to the 1.0 volt cut off in just under 6 minutes.

Cataldo, R. L.↗
NASA NTRS1983

Assessment of flywheel energy storage for spacecraft power systems

The feasibility of inertial energy storage in a spacecraft power system is evaluated on the basis of a conceptual integrated design that encompasses a composite rotor, magnetic suspension, and a permanent magnet (PM) motor/generator for a 3-kW orbital average payload at a bus distribution voltage of 250 volts dc. The conceptual design, which evolved at the Goddard Space Flight Center (GSFC), is referred to as a Mechanical Capacitor. The baseline power system configuration selected is a series system employing peak-power-tracking for a Low Earth-Orbiting application. Power processing, required in the motor/generator, provides a potential alternative configurations that can only be achieved in systems with electrochemical energy storage by the addition of power processing components. One such alternative configuration provides for peak-power-tracking of the solar array and still maintains a regulated bus, without the expense of additional power processing components. Precise speed control of the two counterrotating wheels is required to reduce interaction with the attitude control system (ACS) or alternatively, used to perform attitude control functions. Critical technologies identified are those pertaining to the energy storage element and are prioritized as composite wheel development, magnetic suspension, motor/generator, containment, and momentum control. Comparison with a 3-kW, 250-Vdc power system using either NiCd or NiH2 for energy storage results in a system in which inertial energy storage offers potential advantages in lifetime, operating temperature, voltage regulation, energy density, charge control, and overall system weight reduction.

Rodriguez, G. E.↗
NASA NTRS1983

A mathematical model for the doubly fed wound rotor generator

A mathematical analysis of a doubly-fed wound rotor machine used as a constant frequency generator is presented. The purpose of this analysis is to derive a consistent set of circuit equations which produce constant stator frequency and constant stator voltage. Starting with instantaneous circuit equations, the necessary rotor voltages and currents are derived. The model, thus obtained, is assumed to be valid, since the resulting relationships between mechanical power and active volt-amperes agrees with the results of others. In addition, the model allows for a new interpretation of the power flow in the doubly-fed generator.

Brady, F. J.↗
NASA NTRS1983

Unique battery reconditioning cycle for RCA's geostationary satellites and its applicability for low Earth satellite

Six (6) geostationary spacecraft, manufactured by RCA Astro, are presently operating in orbit. All of their batteries are performing well. They all contain unique battery reconditioning circuitry, permitting individual cell reconditioning to practically zero volts without the danger of cell reversal. This reconditioning is performed just prior to start of each eclipse season. This technique has maintained the battery's end-of-discharge voltage with mission life. The oldest operating RCA Astro geostationary spacecraft, Satcom F1 and F2, have now completed almost 7 and 6-3/4 years in orbit, respectively. Their battery performance, reported herein, show that a major milestone in the mission longevity of nickel-cadmium batteries has heen achieved. Low earth orbit test data show a long lasting effect of maintaining end-of-discharge voltages for nickel cadmium cells using periodic reconditioning. The unique RCA light-weight reconditioning circuitry can accomplish a quick reconditioning and prevent cell reversal. Reconditioning, thus, has the potential for extending mission life of geostationary as well as low earth orbit spacecraft, when two or more batteries are present.

Gaston, S. J.↗
NASA NTRS1983

Test methods and results of the 10-cell bipolar Ni-H2 battery

Characterization tests were carried out at three charge levels and four discharge levels. The "c' or capacity of the battery is designated at 6.5 ampere-hours. The recharge ampere-hours was the same for all test conditions, 6.5 A-H, regardless of the discharge capacity removed for any particular discharge rate. Less capacity can be removed at higher discharge rates to the same termination voltage, which was 0.50 volts for the weakest (lowest voltage) cell. The general trend of efficiencies increases as the charge rate increases as noted in results of the table included in the handout package. The data also indicate the efficiency increases as the discharge rate decreases. This is true; however, efficiencies at the discharge rates of c and 2c are penalized because these cycles received more overcharge than necessary.

Cataldo, R.↗
NASA NTRS1982

Theory of electron-positron showers in double radio sources

A black hole of mass of about 300 million solar masses is assumed to be present in the nucleus of an active galaxy or quasar. With an axial magnetic field near 1000 gauss, a potential drop 10 to the 19th volts is generated by the unipolar induction of a rotating accretion disk surrounding the black hole. The possibility that the acceleration of electrons or positrons in the unipolar fields initiates an electromagnetic cascade shower at distances at least 10 to the 16th cm from the black hole is investigated. The scattering medium for the shower is considered to be the spectrum of low energy photons originating from the inner region of the disk. It is found that at completion of the cascade, power-law energy spectra of relativistic electrons and positrons and of gamma-rays emerge under appropriate conditions. If the cascade-initiating particles are collimated, the electrons and positrons emerge in a collimated beam. Such beams may power extragalactic double radio sources.

Burns, M. L.↗
NASA NTRS1982

Layered transition metal thiophosphates /MPX3/ as photoelectrodes in photoelectrochemical cells

Layered crystals of the transition metal thiophosphates were synthesized and characterized for use as photoelectrodes in photoelectrochemical cells. Crystals incorporating tin and manganese show n-type response while those with iron and nickel show p-type response. These materials have a measured indirect bandgap of about 2.1 eV. They show ability to photoelectrolyze water in acid solutions with onset potentials which change in a Nernstian way as the PH of the solution changes. The onset potential is near zero volts versus a saturated calomel electrode at pH 2. At n-type crystals, oxygen could be evolved upon irradiation at underpotentials of 850 mV and at p-type crystals, hydrogen could be evolved at underpotentials of 400 mV, indicating a net gain in energy conversion. All crystals were unstable in basic solution. Liquid junction photovoltaic cells in iodide-triiodide acid solution using these layered materials were also constructed and found to have low efficiences.

Byvik, C. E.↗
NASA NTRS1983

Particle and wave observations of low-altitude ionospheric ion acceleration events

Two sounding rockets were launched into the expansive phases of two auroral substorms and passed through source regions of transversely accelerated ionospheric ions. Energetic ion and electron, wave, and ambient plasma observations were made. The events were observed in the 400-600 km range and resulted in the ion energization of hundreds of electron volts. In the acceleration region the ionospheric ion velocity distribution function in the direction perpendicular to the local magnetic field showed a non-Maxwellian, high-energy tail. Plasma density was lower than theoretical quiescent values. Strong thermal ion drift was observed only in the perpendicular direction. Large-amplitude, low-frequency fluctuations in plasma density were present along with a number of different wave modes. The characteristics of the ion energy spectra agreed with a model of ion cyclotron acceleration and energy loss due to ion-neutral collisions.

Yau, A. W.↗
NASA NTRS1982

Charge neutralization as studied experimentally and theoretically

Problems regarding an isolated sphere which emits negative charge are considered. Such a sphere could charge up to large potentials which would inhibit the electron beam from leaving the vicinity of the body. In order to avoid charging to high potentials, a vehicle must attract a return current equal to the emitted current. The present investigation is concerned with theoretical models of some processes believed to be important for the vehicle neutralization problem under various conditions. Attention is given to general time-scale considerations, the low-altitude regime, the high-altitude regime, vehicle-induced discharge, and beam-plasma discharge. The general pattern which emeres as a result of measurements is that below altitudes of approximately 125 + or - 5 km the vehicle potential rarely rises more than several tens of volts.

Linson, L. M.↗
NASA NTRS1985

Battery-Operated High-Voltage Power Supply

Circuitry allows large multiplication of voltage. Filament voltage is -80kV. Potential difference between terminals P3 and P4 adjusted to make grid 80 to 150 volts more negative than filament enabling grid to focus electrons from filament into stream impinging on anode, which then emits x-rays. Circuitry provides independently adjustable voltages in kilovolt range for x-ray tubes and other instruments.

Ruitberg, A. P., Kennethm.↗
NASA NTRS1985

Circuit for Monitoring Cell Voltages

Circuit monitors voltage of each cell in electrical battery within few millivolts. Circuit includes two bipolar analog multiplexers: repeatedly sample outputs of 12 1.5 volt cells. Terminals of multiplexer 1 connected to positive sides of cells and terminals of multiplexer 2 connected to negative sides. Outputs of multiplexers connected to differential operational amplifier: provides signals for recording and display.

Lepisto, J. W.↗
NASA NTRS1985

Fresnel-Lens/Heat-Storage System

Self-contained solar-thermal power-plant uses Fresnel lenses to deliver up to 100 kilowatts. Proposed 200-volt system uses about 800 Fresnel lenses.

Turner, R. H.↗
NASA NTRS1980

Apparatus and method for destructive removal of particles contained in flowing fluid

An apparatus and method for destructively removing particles from a flowing gas containing the particles is described. In the specific embodiments disclosed the apparatus is adapted to remove carbon particles from diesel engine exhaust products. The exhaust products are directed to a predetermined location where they are rapidly vaporized and combine with oxygen in the exhaust products to form carbon dioxide. Vaporization in one embodiment is effected by a discharge grid located within an exhaust conduit, the grid being chosen so that alternate conductors defining the grid are spaced apart a distance approximately 125 times the mean diameter of the particles to be removed. A voltage differential of approximately 690 volts is applied across adjacent conductors.

Yang, L. C.↗
NASA NTRS1983

Double-injection, deep-impurity switch development

The overall objective of this program is the development of device design and process techniques for the fabrication of a double-injection, deep-impurity (DI)(2) silicon switch that operates in the 1-10 kV range with conduction current of 10 and 1A, respectively. Other major specifications include a holding voltage of 0 to 5 volts at 1 A anode current, 10 microsecond switching time, and power dissipation of 50 W at 75 C. This report describes work that shows how the results obtained at the University of Cincinnati under NASA Grant NSG-3022 have been applied to larger area and higher voltage devices. The investigations include theoretical, analytical, and experimental studies of device design and processing. Methods to introduce deep levels, such as Au diffusion and electron irradiation, have been carried out to "pin down' the Fermi level and control device-switching characteristics. Different anode, cathode, and gate configurations are presented. Techniques to control the surface electric field of planar structures used for (DI)(2) switches are examined. Various sections of this report describe the device design, wafer-processing techniques, and various measurements which include ac and dc characteristics, 4-point probe, and spreading resistance.

Selim, F. A.↗
NASA NTRS1984

Evaluation program for secondary spacecraft cells. Initial evaluation tests of General Electric Company 4.0 ampere-hour nickel-cadmium spacecraft cells for the AMPTE satellite program

Cells found to have electrolyte leakage, internal shorts, low capacity, or inability of any cell to recover its open circuit voltage above 1.150 volts during the internal short test are addressed. The Active Magnetic Particle Tracer Explorer (AMPTE) cell design was characterized and the effects of specific mission parameters on cell life were demonstrated.

Harkness, J. D.↗
NASA NTRS1983

Discharges on a negatively biased solar array in a charged particle environment

The charging behavior of a negatively biased solar cell array when subjected to a charged particle environment is studied in the ion density range from 200 to 12 000 ions/sq cm with the applied bias range of -500 to -1400 V. The profile of the surface potentials across the array is related to the presence of discharges. At the low end of the ion density range the solar cell cover slides charge to from 0 to +5 volts independent of the applied voltage. No discharges are seen at bias voltages as large as -1400 V. At the higher ion densities the cover slide potential begins to fluctuate, and becomes significantly negative. Under these conditions discharges can occur. The threshold bias voltage for discharges decreases with increasing ion density. A condition for discharges emerging from the experimental observations is that the average coverslide potential must be more negative than -4 V. The observations presented suggest that the plasma potential near the array becomes negative before a discharge occurs. This suggests that discharges are driven by an instability in the plasma.

Snyder, D. B.↗