Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “DUCTS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 991 records · Page 55

Radiation of cylindrical duct acoustic modes with flow mismatch

Motivated by the problem of Mach number and temperature discontinuity mismatch between the tailpipe and the surrounding medium, and the effect of this flow mismatch on aircraft engine noise, the radiation of spinning turbo-acoustic modes from a round duct is investigated. The model, based on a plug flow exhaust jet, solves the convected wave equations using Fourier transforms, inversion being accomplished via a coupled Wiener-Hopf and Carrier-Koiter technique. It is concluded that the Mach number discontinuity results in a conflict between convection and refraction effects, while the temperature mismatch results in a sharp beaming of sound off to the side.

Savkar, S. D.↗

Jet noise characteristics of unsuppressed duct burning turbofan exhaust system

Recent aero-acoustic tests of model coannular nozzles have shown that less noise is generated if the higher-velocity jet is exhausted from the outer annular passage rather than from the primary nozzle. These findings are of particular significance to a duct-burning turbofan (DBTF) engine being studied for application to an advanced supersonic transport. Unlike conventional turbofan engines that have peak velocities from the primary nozzle, it is possible to design a DBTF engine to have a fan velocity higher than that of the primary flow. Results are presented for a NASA-sponsored model test program that covers a range of fan to primary-area ratios from 0.75 to 1.2, and a range of fan to primary-velocity ratios from 0.4 to 2.8. Correlations are given that relate radiated sound power to fan velocity, fan to primary-velocity ratio, and fan to primary-area ratio. Corresponding exhaust-plume velocity-traverse data are presented which suggest that the observed noise benefits may be due to the more rapid decay of the annular flow because of shear stresses on the inner surface that result from the lower-velocity primary flow.

Packman, A. B.↗

Aero-acoustic performance characteristics of duct burning turbofan exhaust nozzles

A recent experimental investigation has identified the aero/acoustic characteristics of exhaust nozzles for duct heating turbofan engines over a range of simulated flow conditions. Jet noise and performance levels are summarized for a series of coannular nozzles representing both acoustically suppressed and unsuppressed designs operating in a static environment. The basic coannular nozzles were found to provide inherent noise suppression. Multi-element suppressor nozzles provided additional noise suppression, but with appreciable thrust loss. The impact of these results on the advanced supersonic transport studies is also presented, indicating potentially large reductions in take-off gross weight or community noise footprints.

Kozlowski, H.↗

Acoustic systems containing curved duct sections

The analysis of waves in bends in acoustical ducting of rectangular cross section is extended to the study of motion near discontinuities. This includes determination of the characteristics of the tangential and radial components of the non-propagating modes. It is established that attenuation of the non-propagating modes strongly depends on frequency and that, in general, the sharper the bend, the less attenuation may be expected. Evaluation of a bend's impedance and of impedance-generated reflections is also presented in detail.

Rostafinski, W.↗

A study of sound transmission in curved duct bends by the Galerkin method

A computational procedure based on the Galerkin method is developed to study the sound transmission and reflection characteristics of circularly curved bends of rectangular ducts. This procedure is adaptable to routine computer calculation. An important component of the computer program consists of a QR iterative algorithm which solves the matrix eigenvalue problem generated by the Galerkin method. The present procedure produced very satisfactory convergent results when applied even to cases where the incident wave has high frequency and high wave mode numbers. Some properties of the Galerkin solution are investigated. Its relationship to the classical solution by the method of separation of variables is discussed.

Tam, C. K. W.↗

An analysis of the generation of subharmonics in aeroengine ducts and methods of their prevention

When the fans of aero-engine ducts go supersonic they often produce radiation at the subharmonics of blade passage frequency known as Multiple Pure Tones. It has been shown that the conventional explanation that these MPTs are created by the shock waves is inadequate. An alternative mechanism based on the concept of 'strong interaction' between the harmonics during resonance is proposed. Expression for the governing equation for such an interaction is derived. The results show an improved agreement with observed data. The analysis has also led to several practical suggestions for the suppression of noise.

Vaidya, P. G.↗

Practical considerations for the design of two-element duct liner noise suppressors

The results of analytical and experimental design studies for two-segment treatment configurations in rectangular ducts with mean flow are presented. The practical significance of the design optimization method, executed at a single frequency for measured modal input, is considered in the light of sensitivity to variations in wall impedance components and source modal content. The results of analytical parametric studies of the effects of frequency and segment length ratio are presented. The importance of designing for a measured modal content and the importance of the order of the liners in providing the multi-element suppression enhancement effects are demonstrated.

Kraft, R. E.↗

Acoustic pulse propagation in a duct with flow

The effect of a mean flow on acoustic pulse propagation in a wind tunnel of rectangular cross-section is considered both experimentally and theoretically. Pulse shapes in the wind tunnel are recorded by microphones located upstream and downstream of a source. A theoretical model of pulse propagation from a point source located in an infinitely-long rectangular duct carrying a uniform flow is considered. The convective wave equation with boundary conditions appropriate to hard walls is solved by using the Laplace transform. For the input pulse shape used in the experiments, the solution is obtained by numerically evaluating the inverse Laplace transform. The results of experiment and theory are seen to be in good agreement.

Cole, J. E., III↗

A wave-envelope technique for wave propagation in non-uniform ducts

The method of variation of parameters is used to analyze wave propagation in variable area, plane ducts with no mean flow. The method has an explicit representation of the fast axial variation of the acoustic modes, and numerical integration is required only for the slower axial variations of the mode amplitudes and phases. Results are presented which demonstrate the numerical advantages of the method. Comparison of the results with those of a small perturbation theory are given. The relationship between this method and the method of weighted residuals is discussed.

Kaiser, J. E.↗

Modal density function and number of propagating modes in ducts

The question of the number of propagating modes within a small range of mode cut off ratio was raised. The population density of modes were shown to be greatest near cut off and least for the well propagating modes. It was shown that modes of nearly the same cut off ratio behave nearly the same in a sound absorbing duct as well as in the way they propagate to the far. Handling all of the propagating modes individually, they can be grouped into several cut off ratio ranges. It is important to know the modal density function to estimate acoustic power distribution.

Rice, E. J.↗

Optimal one-section and two-section circular sound-absorbing duct liners for plane-wave and monopole sources without flow

A discrete frequency study is made of the influence of source characteristics on the optimal properties of acoustically lined uniform and two section ducts. Two simplified sources, a plane wave and a monopole, are considered in some detail and over a greater frequency range than has been previously studied. Source and termination impedance effects are given limited examination. An example of a turbomachinery source and three associated source variants is also presented. Optimal liner designs based on modal theory approach the Cremer criterion at low frequencies and the geometric acoustics limit at high frequencies. Over an intermediate frequency range, optimal two section liners produced higher transmission losses than did the uniform configurations. Source distribution effects were found to have a significant effect on optimal liner design, but source and termination impedance effects appear to be relatively unimportant.

Lester, H. C.↗

Aerodynamic and acoustic tests of duct-burning turbofan exhaust nozzles

The static aerodynamic and acoustic characteristics of duct-burning turbofan (DBTF) exhaust nozzles are established. Scale models, having a total area equivalent to a 0.127 m diameter convergent nozzle, simulating unsuppressed coannular nozzles and mechanically suppressed nozzles with and without ejectors (hardwall and acoustically treated) were tested in a quiescent environment. The ratio of fan to primary area was varied from 0.75 to 1.2. Far field acoustic data, perceived noise levels, and thrust measurements were obtained for 417 test conditions. Pressure ratios were varied from 1.3 to 4.1 in the fan stream and from 1.53 to 2.5 in the primary stream. Total temperature varied from 395 to 1090 K in both streams. Jet noise reductions relative to synthesized prediction from 8 PNdB (with the unsuppressed coannular nozzle) to 15 PNdB (with a mechanically suppressed configuration) were observed at conditions typical of engines being considered under the Advanced Supersonic Technology program. The inherent suppression characteristic of the unsuppressed coannular nozzle is related to the rapid mixing in the jet wake caused by the velocity profiles associated with the DBTF. Since this can be achieved without a mechanical suppressor, significant reductions in aircraft weight or noise footprint can be realized.

Kozlowski, H.↗

Spectroscopic determination of electrical conductivity in an MHD duct from absolute intensity measurements

Measurements of the electrical conductivity in the NASA Lewis cesium seeded, H2-O2 MHD duct have been previously reported. In order to corroborate the above measurements and to analyze the possibility of nonuniform seed injection as a cause of the deviations, a spectroscopic investigation of the plasma conductivity has been undertaken. Transverse profiles of the absolute integrated intensity were measured from the optically thin lines of CSI-.5664 microns and .5636 microns. Radial profiles of emission coefficient were obtained from the measured transverse profiles of intensity by Abel inversion. Radial profiles of electrical conductivity were then obtained under two different assumptions. In the first, the Cs seed fraction is assumed uniform and equal to the measured flow rate at the time when the temperature and conductivity were obtained. In the second method, the local temperature and pressure are taken to be those given by a one-dimensional channel calculation including heat transfer and friction. In this case profiles of conductivity and seed fractions are obtained. The results of the two methods are compared to the previously measured conductivity.

Wang, S. Y.↗

A finite element algorithm for sound propagation in axisymmetric ducts containing compressible mean flow

An accurate mathematical model for sound propagation in axisymmetric aircraft engine ducts with compressible mean flow is reported. The model is based on the usual perturbation of the basic fluid mechanics equations for small motions. Mean flow parameters are derived in the absence of fluctuating quantities and are then substituted into the equations for the acoustic quantities which were linearized by eliminating higher order terms. Mean swirl is assumed to be zero from the restriction of axisymmetry. A linear rectangular serendipity element is formulated from these equations using a Galerkin procedure and assembled in a special purpose computer program in which the matrix map for a rectangular mesh was specifically coded. Representations of the fluctuating quantities, mean quantities and coordinate transformations are isoparametric. The global matrix is solved by foreward and back substitution following an L-U decomposition with pivoting restricted internally to the blocks. Results from the model were compared with results from several alternative analyses and yielded satisfactory agreement.

Abrahamson, A. L.↗

A length-scale model for developing turbulent flow in a rectangular duct

A three-dimensional mixing length model is proposed for modeling local Reynolds stress behavior in rectangular ducts of arbitrary aspect ratio. The model is applicable to both developing and fully-developed flows, and can be applied to other 90-degree corner flows with mild streamwise pressure gradients. Comparisons between theory and experiment show that all components of the Reynolds stress tensor are modeled reasonably well, both in the vicinity of a corner and in two-dimensional regions away from the corner.

Gessner, F. B.↗

Spectroscopic determination of electrical conductivity in an MHD duct from absolute intensity measurements

Measurements of the electrical conductivity in the NASA Lewis cesium seeded, H2-O2 MHD duct made by applying a voltage across the channel from one end electrode to the other, measuring the current, and using the inner electrodes as probes to monitor the voltage distribution along the channel were found to be in good agreement with theory except at low combustion pressures and/or high ratios of seed/oxygen mass flows. To corroborate these measurements and to analyze the possibility of nonuniform seed injection as a cause of the above deviations, a spectroscopic investigation of the plasma conductivity was undertaken. Radial profiles of emission coefficient were obtained from measured transverse profiles of the absolute integrated intensity by Abel inversion. Radial profiles of electrical conductivity were then obtained under two different assumptions. In the first the Cs seed fraction is assumed uniform and equal to the measured flow rate at the time when the temperature and conductivity were obtained. In the second method the local temperature and pressure are taken to be those given by a one-dimensional channel calculation including heat transfer and friction. The results of the two methods are compared to the previously measured conductivity.

Wang, S. Y.↗

Theoretical jet exhaust noise model for the duct burning turbofan

A model was developed to predict the acoustic power spectrum for a Duct Burning Turbofan (DBTF) whose cycle results in a high velocity, high temperature fan stream and a lower velocity, lower temperature primary stream. Model tests have demonstrated that a DBTF may produce substantially less noise than a conventional turbojet with the same thrust and weight flow. Predictions from the model agreed well with measured data from the model tests. The characteristics of the DBTF acoustic power spectrum were shown to be related to the rapid mixing of the fan and primary streams. The effects of fan to primary velocity ratio, temperature ratio, area ratio, and the effect of nozzle geometry on DBTF jet noise were determined.

Larson, R. S.↗

Nonlinear propagation of a wave packet in a two-dimensional acoustically lined duct

The method of multiple scales is used to analyze the nonlinear effects of the gas motion and the acoustic lining material on the propagation and attenuation of a wave packet in a two-dimensional duct of uniform cross section. The partial differential equations describing the space and time variation of amplitudes and phases are obtained and used to show that both the monochromatic waves and the pure amplitude modulated waves are stable. The spatial attenuation of the pure amplitude modulated waves is found to be lower than that of monochromatic waves, while the temporal attenuation of the former waves has a minimum value near the resonant frequency. The nonlinearity shifts the wavenumber and frequency to higher values without changing phase speed for the pure phase modulated waves.

Tsai, M.-S.↗