Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Amplifiers”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 991 records · Page 55
All sourcesNASA NTRSDOE OSTI
NASA NTRS1973

Amplified laser absorption - Detection of nitric oxide.

Experimental results are reported for the power loss of a carbon monoxide gas laser due to the absorption of small amounts of nitric oxide placed in an intra-laser-cavity absorption cell. It was found, for the particular experimental conditions employed, that the absorption coefficient of nitric oxide at 1900.04/cm is enhanced more than two orders of magnitude when it is in the intracavity cell. Finally, the experimental results are compared with theoretical calculations.

Chackerian, C., Jr.↗
NASA NTRS1975

Amplifying ribbon extensometer

Device provides accurate measurement of strain on flexible membranes and fabrics. It is compact and lightweight, has strain-amplification capability up to five, and has an accuracy better than one percent.

Alley, V. L., Jr.↗
NASA NTRS1975

Design, construction and evaluation of a 12.045 GHz, 2.0 kW-cw permanent-magnet focused klystron amplifier

An analytical and experimental program to demonstrate the technical feasibility of a lightweight, high-efficiency, 1-2 kW cw, permanent magnet focused klystron operating at 12.0 GHz was described. The design is based on use of a samarium-cobalt permanent magnet for focusing of the electron beam and choice of the most optimum parameters for maximum efficiency. A filter-loaded output circuit is used for the required bandwidth. The design incorporates a collector which is demountable from the tube to facilitate multistage depressed collector experiments, permitting replacement with a NASA-designed axisymmetric, electrostatic collector for linear beam microwave tubes. A further requirement is that the focusing field between the last interaction gap and the collector decay in a prescribed manner referred to as adiabatic expansion.

Nishida, J. M.↗
NASA NTRS1977

Wideband distribution amplifier

Device provides 12 outputs isolated from each other by 70 dB at 100 MHz, frequency range of 0.1 to 100 MHz, less than 2 deg phase shift over temperature change of 0 to 50 C, and computer level output to monitor module signal quality.

Foster, C. F.↗
NASA NTRS1976

Laser-electron beam interaction applied to optical amplifiers and oscillators

Momentum modulation of a relativistic electron beam by a Nd:YAG laser is demonstrated. The electrons, at 100 MeV energy, interact with the laser light in helium gas at standard temperature and pressure. At an angle of 6.55 mrad between the two wavevectors, corresponding to the Cerenkov angle, a given electron remains in a field of constant phase as it passes through the light beam. The experimental arrangement is illustrated showing the trajectories of the electron and light. The particle momentum is measured by a mass spectrometer, and the angle between the wavevectors is controlled by a rotatable mirror. Experimental results indicate that momentum modulation of an electron beam may be used for amplification. A possible configuration for an optical klystron is illustrated.

Pantell, R. H.↗
NASA NTRS1977

Charge-coupled differential amplifier

Device solves problem of differential voltage gain in sampled-data metal-oxide semiconductor, producing gain at any frequency compatible with CCD operation, with low noise, low power, good linearity, and high stability.

Hewes, C. R.↗
NASA NTRS1976

Low-noise video amplifiers for imaging CCD's

Various techniques were developed which enable the CCD (charge coupled device) imaging array user to obtain optimum performance from the device. A CCD video channel was described, and detector-preamplifier interface requirements were examined. A noise model for the system was discussed at length and laboratory data presented and compared to predicted results.

Scinicariello, F.↗
NASA NTRS1977

Development and performance of power processor system for 2-gigahertz, 200-watt amplifier for communications technology satellite

The electrical and environmental requirements for a power processor system (PPS) designed to supply the appropriate voltages and currents to a 200-watt traveling wave tube (TWT) for a communication technology satellite is described. A block diagram of the PPS, the interface requirements between the PPS and spacecraft, the interface requirements between the PPS and 200-watt TWT, and the environmental requirements of the PPS are presented. Also included are discussions of protection circuits, interlocking sequences, and transient requirements. Predictions of the flight performance, based on ground test data, are provided.

Siegert, C. E.↗
NASA NTRS1977

Secondary-electron-emission properties of conducting surfaces with application to multistage depressed collectors for microwave amplifiers

To improve the efficiency of high power microwave tubes, low secondary electron yield electrode surface for use in depressed collectors are needed. The secondary emission characteristics of a number of materials were investigated. The materials studied were beryllium, carbon (soot and pyrolytic graphite), copper, titanium carbide, and tantalum. Both total secondary yield delta and relative reflected primary yield were measured. These measurements were made in conjunction with Auger spectroscopy so that the secondary emission characteristics could be determined as a function of surface contamination or purity. The results show that low atomic weight elements, such as beryllium and carbon, have the lowest reflected primary yield and that roughening the surface of an electrode can markedly decrease secondary yield both for delta and reflected primaries. All factors considered, a roughened pyrolytic graphite surface showed the greatest potential for use as an electrode surface in depressed collectors.

Forman, R.↗
NASA NTRS1979

Comments on measuring the overall and the depressed collector efficiency in TWT's and klystron amplifiers

Kosmahl and Ramins (1977), who reported results achieved with broadband, high-performance TWT's, augmented with multistage depressed collectors for higher overall efficiency, have pointed out the necessity for accurately measuring and correctly defining the various power terms involved. In view of the now wide-spread use of depressed collectors and reported results, the definitions of tube and collector efficiency are restated and comments are provided on the sensitivity of these terms to various sources of experimental and definitional errors in order to permit a uniform evaluation of collector performance.

Kosmahl, H. G.↗
NASA NTRS1980

Ultra-low-noise microwave amplifiers

The highlights of 20 years of maser use and development are presented. Masers discussed include cavity, traveling wave, K band, and S band. Noise temperatures measured since 1960 are summarized. Use of masers in the Deep Space Network is presented. Costs associated with the construction of masers systems are given.

Clauss, R. C.↗
NASA NTRS1982

Wideband Amplifier With Subpicosecond Stability

RF circuit offers high isolation as well as phase stability. For temperature stability, all circuit components are contained in closed metal housing; packages of active circuit elements are embedded in common heat sink. Provisions not only slow down effect of ambient temperature changes on individual devices but also reduce temperature differences across devices so that differential temperature effects vanish.

Reinhardt, V. S.↗