Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “APERTURE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 973 records · Page 54

Aperture synthesis CO observations of the inner disk of NGC 1068

NGC 1068 is probably the nearest galaxy with both a high rate of star formation and a high luminosity active nucleus. About one-half of the total IR luminosity originates in a disk approximately 30 seconds in size, which has been taken as evidence for a high rate of massive star formation (Telesco et al. 1984). Previous CO line observations have shown the existence of a ring at the outer boundary of the inner disk (Myers and Scoville 1987). Although these observations have proved that this ring is extremely rich in molecular gas (as suggested by Scoville et al. 1983), the angular resolution (approx. 6 seconds) was not high enough to resolve its structure. New aperture synthesis observations of the CO (J=1 to 0) emission in the inner disk of NGC 1068 have been carried out with the Owens Valley Radio Observatory (OVRO) mm Interferometer. The new receivers installed for the 88/89 season have allowed researchers to obtain a high sensitivity map of the CO emission. The molecular cloud ring has been resolved and continuum as well as line emission from the nucleus of the galaxy have been detected.

Planesas, P.↗

Method for detecting surface motions and mapping small terrestrial or planetary surface deformations with synthetic aperture radar

A technique based on synthetic aperture radar (SAR) interferometry is used to measure very small (1 cm or less) surface deformations with good resolution (10 m) over large areas (50 km). It can be used for accurate measurements of many geophysical phenomena, including swelling and buckling in fault zones, residual, vertical and lateral displacements from seismic events, and prevolcanic swelling. Two SAR images are made of a scene by two spaced antennas and a difference interferogram of the scene is made. After unwrapping phases of pixels of the difference interferogram, surface motion or deformation changes of the surface are observed. A second interferogram of the same scene is made from a different pair of images, at least one of which is made after some elapsed time. The second interferogram is then compared with the first interferogram to detect changes in line of sight position of pixels. By resolving line of sight observations into their vector components in other sets of interferograms along at least one other direction, lateral motions may be recovered in their entirety. Since in general, the SAR images are made from flight tracks that are separated, it is not possible to distinguish surface changes from the parallax caused by topography. However, a third image may be used to remove the topography and leave only the surface changes.

Gabriel, Andrew K.↗

Synthetic aperture radar imagery of airports and surrounding areas: Study of clutter at grazing angles and their polarimetric properties

The statistical description of ground clutter at an airport and in the surrounding area is addressed. These data are being utilized in a program to detect microbursts. Synthetic aperture radar data were collected at the Denver Stapleton Airport. Mountain terrain data were examined to determine if they may potentially contribute to range ambiguity problems and degrade microburst detection. Results suggest that mountain clutter may not present a special problem source. The examination of clutter at small grazing angles was continued by examining data collected at especially low altitudes. Cultural objects such as buildings produce strong sources of backscatter at angles of about 85 deg, with responses of 30 dB to 60 dB above the background. Otherwise there are a few sources which produce significant scatter. The polarization properties of hydrospheres and clutter were examined with the intent of determining the optimum polarization. This polarization was determined to be dependent upon the ratio of VV and HH polarizations of both rain and ground clutter.

Onstott, Robert G.↗

Generation of topographic terrain models utilizing synthetic aperture radar and surface level data

Topographical terrain models are generated by digitally delineating the boundary of the region under investigation from the data obtained from an airborne synthetic aperture radar image and surface elevation data concurrently acquired either from an airborne instrument or at ground level. A set of coregistered boundary maps thus generated are then digitally combined in three dimensional space with the acquired surface elevation data by means of image processing software stored in a digital computer. The method is particularly applicable for generating terrain models of flooded regions covered entirely or in part by foliage.

Imhoff, Marc L.↗

Recent advances in airborne terrestrial remote sensing with the NASA airborne visible/infrared imaging spectrometer (AVIRIS), airborne synthetic aperture radar (SAR), and thermal infrared multispectral scanner (TIMS)

Significant progress in terrestrial remote sensing from the air has been made with three NASA-developed sensors that collectively cover the solar-reflected, thermal infrared, and microwave regions of the electromagnetic spectrum. These sensors are the airborne visible/infrared imaging spectrometer (AVIRIS), the thermal infrared mapping spectrometer (TIMS) and the airborne synthetic aperture radar (SAR), respectively. AVIRIS and SAR underwent extensive in-flight engineering testing in 1987 and 1988 and are scheduled to become operational in 1989. TIMS has been in operation for several years. These sensors are described.

Vane, Gregg↗

Observation of wave refraction at an ice edge by synthetic aperture radar

In this note the refraction of waves at the ice edge is studied by using aircraft synthesis aperture radar (SAR). Penetration of a dominant swell from open ocean into the ice cover was observed by SAR during the Labrador Ice Margin Experiment (LIMEX), conducted on the marginal ice zone (MIZ) off the east coast of Newfoundland, Canada, in March 1987. At an ice edge with a large curvature, the dominant swell component disappeared locally in the SAR imagery. Six subscenes of waves in the MIZ from the SAR image have been processed, revealing total reflection, refraction, and energy reduction of the ocean waves by the ice cover. The observed variations of wave spectra from SAR near the ice edge are consistent with the model prediction of wave refraction at the ice edge due to the change of wave dispersion relation in ice developed by Liu and Mollo-Christensen (1988).

Liu, Antony K.↗

Coded-aperture imaging of the Galactic center region at gamma-ray energies

The first coded-aperture images of the Galactic center region at energies above 30 keV have revealed two strong gamma-ray sources. One source has been identified with the X-ray source IE 1740.7 - 2942, located 0.8 deg away from the nucleus. If this source is at the distance of the Galactic center, it is one of the most luminous objects in the galaxy at energies from 35 to 200 keV. The second source is consistent in location with the X-ray source GX 354 + 0 (MXB 1728-34). In addition, gamma-ray flux from the location of GX 1 + 4 was marginally detected at a level consistent with other post-1980 measurements. No significant hard X-ray or gamma-ray flux was detected from the direction of the Galactic nucleus or from the direction of the recently discovered gamma-ray source GRS 1758-258.

Cook, Walter R.↗

A 29.3-GHz cavity-enclosed aperture-coupled circular-patch antenna for microwave circuit integration

A circular patch antenna fed by an aperture-coupled microstrip line has been demonstrated at 29.3 GHz. The patch was enclosed by a cavity to reduce surface-wave interactions in an array environment and to improve heat dissipation when using active devices. The antenna exhibited a 2:1 input VSWR (voltage standing wave ratio) over a bandwidth of 12 percent from 27.52 to 30.95 GHz. The antenna should have applications in conformal phased arrays at millimeter-wave frequencies.

Navarro, Julio A.↗

Experiments In Calibration Of Synthetic-Aperture Radar

Report describes international collaboration on experiments in calibration of synthetic-aperture radar (SAR) systems. Purposes of experiments were to: address problems associated with calibration of data, cross-calibrate between sets of imaging-radar data obtained by different systems, test designs of ground calibration equipment, and find candidate sites for calibration of future satellite-borne SAR systems.

Freeman, Anthony↗

Triangulation using synthetic aperture radar images

For the extraction of topographic information about Venus from stereoradar images obtained from the Magellan Mission, a Synthetic Aperture Radar (SAR) compilation system was developed on analytical stereoplotters. The system software was extensively tested by using stereoradar images from various spacecraft and airborne radar systems, including Seasat, SIR-B, ERIM XCL, and STAR-1. Stereomodeling from radar images was proven feasible, and development is on a correct approach. During testing, the software was enhanced and modified to obtain more flexibility and better precision. Triangulation software for establishing control points by using SAR images was also developed through a joint effort with the Defense Mapping Agency. The SAR triangulation system comprises four main programs, TRIDATA, MODDATA, TRISAR, and SHEAR. The first two programs are used to sort and update the data; the third program, the main one, performs iterative statistical adjustment; and the fourth program analyzes the results. Also, input are flight data and data from the Global Positioning System and Inertial System (navigation information). The SAR triangulation system was tested with six strips of STAR-1 radar images on a VAX-750 computer. Each strip contains images of 10 minutes flight time (equivalent to a ground distance of 73.5 km); the images cover a ground width of 22.5 km. All images were collected from the same side. With an input of 44 primary control points, 441 ground control points were produced. The adjustment process converged after eight iterations. With a 6-m/pixel resolution of the radar images, the triangulation adjustment has an average standard elevation error of 81 m. Development of Magellan radargrammetry will be continued to convert both SAR compilation and triangulation systems into digital form.

Wu, Sherman S. C.↗

Proceedings of the Third Airborne Synthetic Aperture Radar (AIRSAR) Workshop

The Third Airborne Synthetic Aperture Radar (AIRSAR) Workshop was held on 23-24 May 1991 at JPL. Thirty oral presentations were made and 18 poster papers displayed during the workshop. Papers from these 25 presentations are presented which include analyses of AIRSAR operations and studies in SAR remote sensing, ecology, hydrology, soil science, geology, oceanography, volcanology, and SAR mapping and data handling. Results from these studies indicate the direction and emphasis of future orbital radar-sensor missions that will be launched during the 1990's.

Jacob J Vanzy↗

A conceptual design of a large aperture microwave radiometer geostationary platform

A conceptual design of a Large Aperture Microwave Radiometer (LAMR) Platform has been developed and technology areas essential to the design and on-orbit viability of the platform have been defined. Those technologies that must be developed to the requirement stated here for the LAMR mission to be viable include: advanced radiation resistant solar cells, integrated complex structures, large segmented reflector panels, sub 3 kg/m(exp 2) areal density large antennas, and electric propulsion systems. Technology areas that require further development to enhance the capabilities of the LAMR platform (but are not essential for viability) include: electrical power storage, on-orbit assembly, and on-orbit systems checkout and correction.

Garn, Paul A.↗

The Earth Observing System Synthetic Aperture Radar (EOS SAR) mission

The EOS SAR mission under consideration as one element of the mission to planet earth, which will provide a long duration radar observing system with multipolarization and multifrequency capability, is presented. The payload consists of three synthetic aperture radar systems; a C-band radar with dual polarization, an L-band radar with quadruple polarization, and an X-band radar with dual polarization. Each radar system will be of the phased-array type, will have variable resolutions and swath widths and will be capable of steering the beam electronically in elevation.

Wellman, John B.↗

Performance predictions for spaceborne, long-lifetime helium dewars containing large-aperture telescopes

The evolution of design approaches for high-performance superfluid helium dewars containing large-aperture telescopes are discussed. Particular attention is given to thermal-math modeling for the IRAS and the Cosmic Background Explorer (COBE) dewars. Correlation of the recent COBE flight data with the dewar thermal-math model is presented, and apparent predictive deficiencies of the model are discussed.

Hopkins, Richard A.↗

Aperture synthesis concepts in microwave remote sensing of the earth

The application of aperture synthesis concepts, used for many years in radio astronomy to achieve high image resolution at a reasonable cost, to remote sensing technology is discussed. The electronically scanned thinned array radiometer (ESTAR) is put forward as a viable alternative to improve spatial resolution by an order of magnitude over what is presently achieved by microwave imaging systems that are collecting data from earth orbit. Future developments in airborne sensor technology and potential spacecraft application are described.

Swift, Calvin T.↗

Classification of multifrequency multilook synthetic aperture radar data

A technique for segmentation of multifrequency multilook intensity synthetic aperture radar (SAR) data into regions of homogeneous and similar backscatter characteristics is presented. Two statistical models, one for the multifrequency multilook SAR intensities and the other for the distribution of the region labels, are combined to obtain the a posteriori probability distribution function of the region labels given the multifrequency speckled intensities. As the maximization of the posterior distribution is computationally intensive, a suboptimal technique for region labeling is proposed. Several examples using both simulated and real multifrequency multilook imagery are given to illustrate the performance of the algorithm.

Rignot, Eric↗

Topography estimation with interferometric synthetic aperture radar using fringe detection

Methods are presented for using Synthetic Aperture Radar (SAR) interferometry data to estimate surface topography. An expression is given to relate the elevation of a ground point to the phase difference of SAR images received from two spatially separated antennas. An iterative algorithm which solves for the position and elevation of each point in the image simultaneously is developed. One of the critical issues that determines the accuracy of the terrain mapping is the phase unwrapping. An approach to the problem by fringe line detection is proposed. The algorithms are tested with two Seasat SAR images of terrain near Yellowstone National Park. The resultant elevation map is compared with a USGS terrain elevation model. The error of the SAR elevation with respect to the digital terrain map is about 8.2 percent of the total terrain variation.

Lin, Qian↗

Theory and design of interferometric synthetic aperture radars

A derivation of the signal statistics, an optimal estimator of the interferometric phase, and the expression necessary to calculate the height-error budget are presented. These expressions are used to derive methods of optimizing the parameters of the interferometric synthetic aperture radar system (InSAR), and are then employed in a specific design example for a system to perform high-resolution global topographic mapping with a one-year mission lifetime, subject to current technological constraints. A Monte Carlo simulation of this InSAR system is performed to evaluate its performance for realistic topography. The results indicate that this system has the potential to satisfy the stringent accuracy and resolution requirements for geophysical use of global topographic data.

Rodriguez, E.↗