Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “VORTEX”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 955 records · Page 53

Identifying Anticyclonic Vortex Features Produced by the Rossby Wave Instability in Protoplanetary Disks

Several nearby protoplanetary disks have been observed to display large-scale crescents in the (sub)millimeter dust continuum emission. One interpretation is that these structures correspond to anticyclonic vortices generated by the Rossby wave instability within the gaseous disk. Such vortices have local gas overdensities and are expected to concentrate dust particles with a Stokes number around unity. This process might catalyze the formation of planetesimals. Whereas recent observations showed that dust crescents are indeed regions where millimeter-size particles have abnormally high concentration relative to the gas and smaller grains, no observations have yet shown that the gas within the crescent region counterrotates with respect to the protoplanetary disk. Here we investigate the detectability of anticyclonic features through measurement of the line-of-sight component of the gas velocity obtained with ALMA. We carry out 2D hydrodynamic simulations and 3D radiative transfer calculations of a protoplanetary disk characterized by a vortex created by the tidal interaction with a massive planet. As a case study, the disk parameters are chosen to mimic the IRS 48 system, which has the most prominent crescent observed to date. We generate synthetic ALMA observations of both the dust continuum and 12 CO emission around the frequency of 345 GHz. We find that the anticyclonic features of the vortex are weak but can be detected if both the source and the observational setup are properly chosen. We provide a recipe for maximizing the probability of detecting such vortex features and present an analysis procedure to infer their kinematic properties.

79 ASTRONOMY AND ASTROPHYSICS↗

Magnetospheric Multiscale Observations of Electron Vortex Magnetic Hole in the Turbulent Magnetosheath Plasma

We report on the observations of an electron vortex magnetic hole corresponding to a new type of coherent structure in the turbulent magnetosheath plasma using the Magnetospheric Multiscale mission data. The magnetic hole is characterized by a magnetic depression, a density peak, a total electron temperature increase (with a parallel temperature decrease but a perpendicular temperature increase), and strong currents carried by the electrons. The current has a dip in the core region and a peak in the outer region of the magnetic hole. The estimated size of the magnetic hole is about 0.23 ρ {sub i} (∼30 ρ {sub e}) in the quasi-circular cross-section perpendicular to its axis, where ρ {sub i} and ρ {sub e} are respectively the proton and electron gyroradius. There are no clear enhancements seen in high-energy electron fluxes. However, there is an enhancement in the perpendicular electron fluxes at 90° pitch angle inside the magnetic hole, implying that the electrons are trapped within it. The variations of the electron velocity components V {sub em} and V {sub en} suggest that an electron vortex is formed by trapping electrons inside the magnetic hole in the cross-section in the M – N plane. These observations demonstrate the existence of a new type of coherent structures behaving as an electron vortex magnetic hole in turbulent space plasmas as predicted by recent kinetic simulations.

79 ASTRONOMY AND ASTROPHYSICS↗

Probing the Cold Dust Emission in the AB Aur Disk: A Dust Trap in a Decaying Vortex?

One serious challenge for planet formation is the rapid inward drift of pebble-sized dust particles in protoplanetary disks. Dust trapping at local maxima in the disk gas pressure has received much theoretical attention but still lacks observational support. The cold dust emission in the AB Aur disk forms an asymmetric ring at a radius of about 120 au, which is suggestive of dust trapping in a gas vortex. We present high spatial resolution (0.″58 × 0.″78 ≈ 80 × 110 au) NOEMA observations of the 1.12 mm and 2.22 mm dust continuum emission from the AB Aur disk. Significant azimuthal variations of the flux ratio at both wavelengths indicate a size segregation of the large dust particles along the ring. Our continuum images also show that the intensity variations along the ring are smaller at 2.22 mm than at 1.12 mm, contrary to what dust trapping models with a gas vortex have predicted. Our two-fluid (gas+dust) hydrodynamical simulations demonstrate that this feature is well explained if the gas vortex has started to decay due to turbulent diffusion, and dust particles are thus losing the azimuthal trapping on different timescales depending on their size. The comparison between our observations and simulations allows us to constrain the size distribution and the total mass of solid particles in the ring, which we find to be of the order of 30 Earth masses, enough to form future rocky planets.

79 ASTRONOMY AND ASTROPHYSICS↗

Investigation of rotor blade tip-vortex aerodynamics

Several aspects of the aerodynamics of rotor blade tip vortices are examined. Two particular categories are dealt with; (1) dynamic loads on a blade passing close to or intersecting a trailing vortex, and (2) the response of the trailing vortex core to changes in the flow. Results for both categories are in reasonable agreement with existing data, although lower pressure gradients were obtained than anticipated for category one. A correlation between trailing edge sweep angle at the tip and vortex core size was noted for category two.

Lewellen, W. S.↗

Exploratory flight investigation of aircraft response to the wing vortex wake generated by jet transport aircraft

The effect of intercepting wing tip vortices generated by large jet transports, including jumbo jets, over separation distances from 1 nautical mile to 15 nautical miles is evaluated on the basis of the response of a vortex probe airplane in the roil mode. The vortex probe test aircraft included a representative general aviation airplane, an executive jet, a fighter, and light and medium weight jet transports. The test conditions and airplane configurations were comparable to those normally used during takeoff, landing, or holding pattern operations. For flight safety the tests were performed at altitudes from 9500 feet to 12,500 feet. In addition to an evaluation of the probe airplane response, a flight test technique is suggested for determining minimum separation distance, using as variable the ratio of vortex-induced roll acceleration to maximum lateral control acceleration and the gross weight of the generating aircraft.

Andrews, W. H.↗

Avoidance of Trailing Vortex Hazard by Airport Warning System

In an effort to improve airport traffic operation near jumbo jets, an airport trailing vortex warning system (ATVWS) was developed to predict trailing vortex turbulence. The ATVWS consists of a computer simulator which is compatible with a vortex sensor such as a laser Doppler velocimeter or an acoustic radar. A study of the traffic in one of the ten busiest airports, Atlanta Municipal Airport, provided information on traffic patterns of a statistical nature. With this information, airport traffic patterns can be studied and hazard statistics developed. Based on a careful study of this simulation model, requirements for the development and testing of an ATVWS can be accurately specified.

Rudland, R. S.↗

Study of the far wake vortex field generated by a rectangular airfoil in a water tank

Underwater towing experiments were carried out with a rectangular airfoil of aspect ratio 5.3 at 4 and 8 deg angles of attack and at chord-based Reynolds numbers between 2 x 100,000 and 7.5 x 100,000. Quantitative measurements by means of the hydrogen bubble technique indicated lower peak swirl velocities in the range of 100 to 1000 lenghts downstream than have been measured in wind tunnel of flight tests. The maximum circumferential velocity decayed whereas the turbulent eddy viscosity increased. This behavior and other known rates of vortex decay are explained in terms of an analytical solution for the vortex problem with time varying eddy viscosity. It is shown that this case corresponds to nonequilibrium turbulent vortex flow.

Lezius, D. K.↗

Preliminary results of flight tests of vortex attenuating splines

Flight tests have been conducted to evaluate the effectiveness of a wingtip vortex attenuating device, referred to as a spline. Vortex penetrations were made with a PA-28 behind a C-54 aircraft with and without wingtip splines attached and the resultant rolling acceleration was measured and related to the roll acceleration capability of the PA-28. Tests were conducted over a range of separation distances from about 5 nautical miles (n. mi.) to less than 1 n. mi. Preliminary results indicate that, with the splines installed, there was a significant reduction in the vortex induced roll acceleration experienced by the PA-28 probe aircraft, and the distance at which the PA-28 roll control became ineffective was reduced from 2.5 n. mi. to 0.6 n. mi., or less. There was a slight increase in approach noise (approximately 4 db) with the splines installed due primarily to the higher engine power used during approach. Although splines significantly reduced the C-54 rate of climb, the rates available with four engines were acceptable for this test program. Splines did not introduce any noticeable change in the handling qualities of the C-54.

Hastings, E. C., Jr.↗

Effect of inlet ingestion of a wing tip vortex on turbojet stall margin

A two-dimensional inlet and a turbojet engine were investigated in a Mach 0.4 stream so as to ingest the tip vortex of a forward mounted wing. Results show that ingestion of a wing tip vortex by a turbojet engine can cause a large reduction in engine stall margin. The loss in stall compressor pressure ratio was primarily dependent on vortex location and rotational direction and not on total-pressure variations across the compressor face.

Mitchell, G. A.↗

A vortex entrainment model applied to slender delta wings

A mathematical model of the vortex flow over a slender sharp-edged delta wing is proposed, and is shown to provide good agreement with the experiment. Although the technique requires experimental data in the form of the vortex core locations, it does account for the previously ignored mass entrainment of the vortex core.

Coe, P. L., Jr.↗

Vortex age as a wake turbulence scaling parameter

Tests were conducted in the Virginia Tech Stability Wind Tunnel to determine the significance of vortex age as a scaling parameter in wake turbulence development and dissipation. Vortex structure was measured over a range of three angles of attack, three free-stream speeds, and seven downstream positions from 2 to 30 chordlengths using an NACA 0012 wing and a five hole yawhead probe. The resulting data indicates that vortex age is not a self-sufficient scaling parameter but a free-stream velocity influence also exists at higher angles of attack which cannot be explained in terms of Re or M.

Marchman, J. F., III↗

Vortex-induced heating to a cone-cylinder body at Mach 6

Presented data on vortex-induced heating in a cone-cylinder body at Mach 6 show that the most severe heating need not occur as a result of the interaction of the primary vortices with the lee surface, even though this interaction produces a large, well-defined featherline oil smear. It is pointed out that the severity of vortex-induced heating is extremely sensitive to Reynolds number and geometry and that there exists a 'threshold Reynolds number' below which vortex-induced heating decreases abruptly.

Hefner, J. N.↗

Results of full-scale vortex attenuation flight experiments

Flight tests have been conducted to evaluate the effectiveness of a wing-tip vortex attenuating device, referred to as a spline. Vortex penetrations were made with a PA-28 behind a C-54 aircraft with and without wing-tip splines attached, and the resultant rolling acceleration was measured and related to the roll acceleration capability of the PA-28. Tests were conducted over a range of separation distances from about 5 n mi to less than 1 n mi. Preliminary results indicate that, with the splines installed, there was a significant reduction in the vortex-induced roll acceleration experienced by the PA-28 probe aircraft, and the distance at which the PA-28 roll control became ineffective was reduced from 2.5 n mi to less than 1 n mi. Although splines significantly reduced the C-54 rate of climb, the rates available with four engines were acceptable for this test program.

Hastings, E. C., Jr.↗

Acoustic scattering from a turbulent vortex

With the aid of the Born approximation, the time autocorrelation and power spectral density are calculated for the received acoustic signal scattered from velocity fluctuations in a turbulent aircraft trailing vortex. The turbulence is required to be globally stationary, but only locally homogeneous. The treatment includes the effects of spectral broadening due to convection of the scattering eddies by a spatially varying mean flow and by macroeddies. The 3 db bandwidth of the received signal is related to the scattering angle and the core Mach number of the vortex. A primary feature of the analysis is that it provides a method for inferring the radial intensity distribution of turbulence in a vortex. The analysis technique is also applicable to scattering from other turbulent flows where significant variations of turbulence level occur over distances on the order of the macroeddy size.

Ramsey, V. W.↗

Effect of symmetrical vortex shedding on the longitudinal aerodynamic characteristics of wing-body-tail combinations

An engineering prediction method for determining the longitudinal aerodynamic characteristics of wing-body-tail combinations is developed. The method includes the effects of nonlinear aerodynamics of components and the interference between components. Nonlinearities associated with symmetrical vortex shedding from the nose of the body are considered as well as the nonlinearities associated with the separation vortices from the leading edges and side edges of the lifting surfaces. The wing and tail characteristics are calculated using lifting surface theories which include effects of incidence, camber, twist, and induced velocities from external sources of disturbance such as bodies and vortices. The lifting surface theories calculate the distribution of leading edge and side edge suction which is converted to vortex lift using the Polhamus suction analogy. Correlation curves are developed to determine the fraction of the theoretical suction force which is converted into vortex lift. The prediction method is compared with experimental data on a variety of aircraft configurations to assess the accuracy and limitations of the method.

Mendenhall, M. R.↗

A Model for the Vortex Pair Associated with a Jet in a Cross Flow

A model is presented for the contrarotating vortex pair that is formed by a round, turbulent, subsonic jet directed normally into a uniform, subsonic cross flow. The model consists of a set of algebraic equations that describe the properties of the vortex pair as a function of their location in the jet plume. The parameters of the model are physical characteristics of the vortices such as the vortex strength, spacing, and core size. These parameters are determined by velocity measurements at selective points in the jet plume.

Sellers, William L.↗

Performance of vortex generators in a Mach 2.5 low-bleed full scale 45-percent-internal-contraction axisymmetric inlet

Steady-state and dynamic flow characteristics associated with two sets of vortex generators having different mixing criteria were determined. The inlet performance with and without these vortex generators is presented. The vortex generators were successful in eliminating separation, increasing area-weighted total pressure recovery, and decreasing distortion. Transmission times obtained from cross-correlations of the wall static pressures and the diffuser exit total pressure showed no effect of the upstream flow characteristics on the diffuser exit pressures when generators were used. Without generators, separation occurred and the upstream pressure characteristics had immediate effects on the diffuser exit pressure characteristics.

Neumann, H. E.↗