Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “PILOT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 955 records · Page 53

SPS pilot signal design and power transponder analysis, volume 2, phase 3

The problem of pilot signal parameter optimization and the related problem of power transponder performance analysis for the Solar Power Satellite reference phase control system are addressed. Signal and interference models were established to enable specifications of the front end filters including both the notch filter and the antenna frequency response. A simulation program package was developed to be included in SOLARSIM to perform tradeoffs of system parameters based on minimizing the phase error for the pilot phase extraction. An analytical model that characterizes the overall power transponder operation was developed. From this model, the effects of different phase noise disturbance sources that contribute to phase variations at the output of the power transponders were studied and quantified. Results indicate that it is feasible to hold the antenna array phase error to less than one degree per power module for the type of disturbances modeled.

Lindsey, W. C.↗

Design of a nonlinear adaptive filter for suppression of shuttle pilot-induced oscillation tendencies

Analysis of a longitudinal pilot-induced oscillation (PIO) experienced just prior to touchdown on the final flight of the space shuttle's approach landing tests indicated that the source of the problem was a combination of poor basic handling qualities aggravated by time delays through the digital flight control computer and rate limiting of the elevator actuators due to high pilot gain. A nonlinear PIO suppression (PIOS) filter was designed and developed to alleviate the vehicle's PIO tendencies by reducing the gain in the command path. From analytical and simulator studies it was shown that the PIOS filter, in an adaptive fashion, can attenuate the command path gain without adding phase lag to the system. With the pitch attitude loop of a simulated shuttle model closed, the PIOS filter increased the gain margin by a factor of about two.

Smith, J. W.↗

Pilot assessment of two computer-generated display formats for helicopter instrument approach

Two computer generated display formats were evaluated as primary displays by six research pilots in a fixed base simulator. One of the computer generated display formats was an electronic attitude director indicator (EADI) which featured three cue flight director, command information, superimposed on true perspective runway symbology. The other computer generated display format featured separate horizontal and vertical situation information with vector predictors. A baseline display, consisting of an electromechanical attitude director indicator (ADI) with a three cue flight director and a moving map, was used as a reference for the pilot evaluations.

Niessen, F. R.↗

Head-up transition behavior of pilots during simulated low-visibility approaches

Each of 13 commercial pilots from four airlines flew a total of 108 manual flight director approaches in a moving base simulation of a medium-sized turbojet (95,000 lb gross weight) which had a day and night Redifon external scene. Three levels of runway visual range (RVR) (1,600; 2,400; and greater than 8,000 ft), three wind-shear profiles, nine ceiling heights, and continuous and intermittent visibility after initial breakout were tested. The results indicated that: (1) mean decision time ranged from 2 to 4.6 sec for ceilings under 380 ft across the three RVR conditions; (2) mean vertical distance traveled during the visual-cue assessment period was a relatively constant proportion below the existing ceiling; (3) a significant three way interaction in mean decision time between wind shear, day-night, and ceiling RVR variables occurred; (4) mean number of head-up transitions to VFR conditions after breakout ranged from 4.6 to 13.4 and increased as a function of ceiling and severity of wind shear; the typical duration of fixation out the window was 1.5 sec; and (5) subjective pilot ratings of controllability and precision of control as well as amount of skill, attention, or effort required to make the landing were influenced significantly by the wind shear, night conditions, and low breakout ceiling conditions.

Haines, R. F.↗

Exploratory piloted simulator study of the effects of winglets on handling qualities of a representative agricultural airplane

The effects on handling qualities of adding winglets to a representative agricultural aircraft configuration during swath-run maneuvering were evaluated. Aerodynamic data used in the simulation were based on low-speed wind tunnel tests of a full scale airplane and a subscale model. The Cooper-Harper handling qualities rating scale, supplementary pilot comments, and pilot vehicle performance data were used to describe the handling qualities of the airplane with the different wing-tip configurations. Results showed that the lateral-directional handling qualities of the airplane were greatly affected by the application of winglets and winglet cant angle. The airplane with winglets canted out 20 deg exhibited severely degraded lateral directional handling qualities in comparison to the basic airplane. When the winglets were canted inward 10 deg, the flying qualities of the configuration were markedly improved over those of the winglet-canted-out configuration or the basic configuration without winglets, indicating that proper tailoring of the winglet design may afford a potential benefit in the area of handling qualities.

Ogburn, M. E.↗

Effect of cursor characteristics on pilots' tracking performance on a cathode-ray tube in dynamic simulation

The effects of cursor configuration, size, and orientation on the performance of 11 commercial airline pilots were investigated in a difficult compensatory tracking task in a moving-base aircraft simulator. Three levels of congruent cab motion (0, 1, and 2 times the visual motion) were superimposed on the tracking task. Data analysis of the mean tracking error scores revealed no significant effects of cursor size, orientation, or configuration on pilots' tracking performance. Mean tracking error did not significantly differ between the three levels of motion for the conditions with a single dot as the cursor. However, for the dotted and solid line cursors, tracking error significantly decreased from the no motion condition to the motion conditions. The addition of simulator motion significantly reduced tracking error for large cursors, but not for small ones such as a single dot

Junge, M. K.↗

Backup flight control system for a highly maneuverable remotely piloted research vehicle

NASA is currently conducting flight tests of a remotely piloted subscale advanced fighter configuration as part of the Highly Maneuverable Aircraft Technology (HiMAT) program. This paper describes the initial development, user modification, and flight test experience of a back-up control system (BCS) contained within one of two onboard microprocessors. The development of the BCS proceeded in two distinct steps: the initial contractor development of control laws and logic to satisfy BCS design objectives, and user modifications required to satisfy operational requirements. A brief resume of flight qualification procedures and pilot comments is presented.

Hoyt, C. E.↗

Stall/spin flight results for the remotely piloted spin research vehicle

The unmanned, remotely piloted, unpowered, spin research vehicle was used to evaluate the effects of the nose boom and of a wind tunnel-designed nose strake on the vehicle's stall/spin characteristics. The flight-determined directional stability derivatives and the attempted spin entries indicated that the vehicle with a nose strake had increased resistance to departure and spin. The acquisition of high quality steady spin data for this vehicle was made possible by the remotely piloted technique. The zero control smooth spin modes were found to be highly repeatable for a given configuration and to vary with forebody configuration. Several spin recovery techniques, including a nose parachute, are also evaluated.

Iliff, K. W.↗

Pilot signals for large active retro-directive arrays

It has been suggested that for large active retrodirective arrays, as in the solar power system, a two tone uplink pilot signal with frequencies symmetrically situated around the downlink frequency be used in order to reduce ionospheric biases and to lower the cost since a two tone receiver is economically much cheaper than a single tone phase locked receiver. Such a system now faces two difficulties: the Pi-ambiguity; and a large phase difference between the downlink and uplink signals. The Pi-ambiguity is shown to be easily removed by using a two tone uplink signal with both frequencies situated at one side of the downlink frequency, and the phase difference can be greatly reduced with a three tone or a four tone uplink pilot signal.

Chan, C. H.↗

Pilot signals for large active retrodirective arrays

It was suggested that for large active retrodirective arrays, as in the solar power system, a two tone uplink pilot signal with frequencies symmetrically situated around the downlink frequency be used in order to reduce ionospheric biases and to lower the cost. Unfortunately such a system faces the following difficulties: (1) the pi-ambiguity, and (2) a large phase difference between the downlink and uplink signals. It is shown how the pi-ambiguity can be easily removed by using a two tone uplink signal with both frequencies situated at one side of the downlink frequency, and the phase difference can be greatly reduced with a three tone or a four tone uplink pilot signal.

Chan, C. H.↗

Turbulence: From a pilot's viewpoint

The measurement of atmospheric turbulence is discussed in terms of a pilots viewpoint. Two areas of measurement are considered: frequency and severity of turbulence. Suggestions are given for helping the pilot solve the turbulence problem.

Pocock, C. L.↗

The DAST-1 remotely piloted research vehicle development and initial flight testing

The development and initial flight testing of the DAST (drones for aerodynamic and structural testing) remotely piloted research vehicle, fitted with the first aeroelastic research wing ARW-I are presented. The ARW-I is a swept supercritical wing, designed to exhibit flutter within the vehicle's flight envelope. An active flutter suppression system (FSS) designed to increase the ARW-I flutter boundary speed by 20 percent is described. The development of the FSS was based on prediction techniques of structural and unsteady aerodynamic characteristics. A description of the supporting ground facilities and aircraft systems involved in the remotely piloted research vehicle (RPRV) flight test technique is given. The design, specification, and testing of the remotely augmented vehicle system are presented. A summary of the preflight and flight test procedures associated with the RPRV operation is given. An evaluation of the blue streak test flight and the first and second ARW-I test flights is presented.

Kotsabasis, A.↗

Pilot Fatigue and Circadian Desynchronosis

Pilot fatigue and circadian desynchronosis, its significance to air transport safety, and research approaches, were examined. There is a need for better data on sleep, activity, and other pertinent factors from pilots flying a variety of demanding schedules. Simulation studies of flight crew performance should be utilized to determine the degree of fatigue induced by demanding schedules and to delineate more precisely the factors responsible for performance decrements in flight and to test solutions proposed to resolve problems induced by fatigue and desynchronosis. It was concluded that there is a safety problem of uncertain magnitude due to transmeridian flying and a potential problem due to fatigue associated with various factors found in air transport operations.

Source record↗

Effects of ionospheric turbulence on SPS pilot signal

The spatial variation of the electron density was studied by monitoring the differential Doppler on radio beacons aboard the Navy navigation satellites. The radio frequency heater was used to deposit energy in the F-region ionosphere with the heating frequency above peak plasma frequency. The effects of the solar power satellite power beam on the pilot signal were simulated. It was found that a small depletion was formed in the beam and that there was turbulence in the elctron density up the magnetic field line from the beam. It is suggested that the depletion will not seriously affect the power or pilot beams of the solar power satellite.

Clynch, J. R.↗

A piloted simulator investigation of static stability and stability/control augmentation effects on helicopter handling qualities for instrument approach

A ground simulator experiment was conducted on the Flight Simulator for Advanced Aircraft at Ames Research Center to investigate the influence of several static stability and stability/control augmentation design parameters on helicopter flying qualities during terminal area operations in instrument conditions. Effects of light turbulence were included. Two levels of static stability in each rotational axis (pitch, roll, yaw) were examined for a hingeless rotor configuration. The variations in pitch and roll were: (1) stable and (2) neutral static stability; in yaw there were two stable levels. Four types of stability/control augmentation were also examined for the lower level of static stability in each axis. This latter investigation covered three helicopter rotor types: hingeless, articulated, and teetering. Four pilots performed a total of 105 evaluations of these parameters for a representative VOR instrument approach task. Pilot rating results indicate the acceptability of neutral static stability longitudinally and laterally and the need for pitch-roll attitude augmentation to achieve a satisfactory system.

Lebacqz, J. V.↗

Aircraft control-display analysis and design using the optimal control model of the human pilot

The use of the optimal control model (OCM) of the human pilot as a design tool is discussed. A novel procedure for the assignment and selection of model parameters in the absence of experimental data is proposed. A technique for partitioning a weakly coupled, multiaxis task into approximate state-uncoupled, single-axis tasks is introduced. The resulting modeling technique is utilized in the design and analysis of an aircraft flight-director system. This flight-director design technique differs from previous related work using the OCM in that considerable effort is devoted to ensuring that the OCM-designed director exhibits the desirable frequency-domain characteristics associated with experimentally verified classical designs (e.g., K/s 'effective vehicle' characteristics, noninteracting controls). The implications of the technique in the design of automatic flight control systems which employ the human pilot as a performance assessor and failure detector are briefly discussed.

Hess, R. A.↗

An investigation into pilot and system response to critical in-flight events. Volume 2: Appendix

Materials relating to the study of pilot and system response to critical in-flight events (CIFE) are given. An annotated bibliography and a trip summary outline are presented, as are knowledge surveys with accompanying answer keys. Performance profiles of pilots and performance data from the simulations of CIFE's are given. The paper and pencil testing materials are reproduced. Conditions for the use of the additive model are discussed. A master summary of data for the destination diversion scenario is given. An interview with an aircraft mechanic demonstrates the feasibility of system problem diagnosis from a verbal description of symptoms and shows the information seeking and problem solving logic used by an expert to narrow the list of probable causes of aircraft failure.

Rockwell, T. H.↗