Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “slip”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 937 records · Page 52
All sourcesNASA NTRSDOE OSTI
NASA NTRS1983

Development of pull-apart basins

The development of pull-apart basins is discussed based on results of field studies in active and ancient strike-slip zones. The plate tectonic setting of active pull-aparts is described and field observations from mainly active basins are synthesized into a qualitative model of the continuous growth of pull-aparts from nucleation to extreme development. This model is compared with predictions from previously proposed qualitative, theoretical, and experimental models.

Mann, P.↗
NASA NTRS1982

Communication satellite ground station receiver performance at low data rates

Performance of satellite ground station receivers at low data rates is analyzed for power-limited satellites, when various amounts of frequency dynamics are present. Specifically, the lowest data rates for which the receiver can successfully demodulate suppressed-carrier BPSK data under a wide variety of conditions are determined. Minimum data rates on the order of 100 to 1400 bits per second are achievable with a bit error probability less than 0.00001 and with a mean time to cycle slip on the order of 1/2 hour or more, when Costas loops are employed for carrier extraction.

Riddle, L. P.↗
NASA NTRS1984

Studies of an artificially shock-loaded H group chondrite

SEM and TEM, together with thermoluminescence (TL), are used to study five samples of the naturally unshocked Kernouve (H6) meteorite that were shock-loaded to pressures of 70, 165, 270, and 390 kbar. Attention is given to olivine and orthopyroxene deformation mechanisms at these pressure levels. The microhardness of the kamacite in the samples increases with shock pressure, and it is noted that annealed kamacite displays incipient crystallinity, while alpha-martensite and taenite sometimes contain slip lines. At pressures over 200 kbar, there was a systematic decrease in both natural TL and TL sensitivity. Changes in the ratio of these two values for various regions of the TL glow curve suggest that two processes were effective during shock: thermal drainage of electron traps and a reduction in the effective trap density. Thermal effects with widespread annealing are noted in the case of a sample subjected to shock pulse.

Sears, D. W.↗
NASA NTRS1984

Fault friction, regional stress, and crust-mantle coupling in southern California from finite element models

To determine the correct fault rheology of the Transverse Ranges area of California, a new finite element to represent faults and a mangle drag element are introduced into a set of 63 simulation models of anelastic crustal strain. It is shown that a slip rate weakening rheology for faults is not valid in California. Assuming that mantle drag effects on the crust's base are minimal, the optimal coefficient of friction in the seismogenic portion of the fault zones is 0.4-0.6 (less than Byerly's law assumed to apply elsewhere). Depending on how the southern California upper mantle seismic velocity anomaly is interpreted, model results are improved or degraded. It is found that the location of the mantle plate boundary is the most important secondary parameter, and that the best model is either a low-stress model (fault friction = 0.3) or a high-stress model (fault friction = 0.85), each of which has strong mantel drag. It is concluded that at least the fastest moving faults in southern California have a low friction coefficient (approximtely 0.3) because they contain low strength hydrated clay gouges throughout the low-temperature seismogenic zone.

Bird, P.↗
NASA NTRS1984

An extensive region of off-ridge normal-faulting earthquakes in the southern Indian Ocean

A verified prediction of the theory of plate tectonics is that the focal mechanisms of earthquakes on the mid-ocean ridge system indicate either normal faulting on ridge segments or strike-slip faulting on transform faults. A broad region in the southern Indian Ocean which differs from typical ridge and intraplate regimes has been identified. In this region a number of large off-ridge earthquakes have occurred in the last 20 years. The mechanisms for these events, where known, all involve normal faulting. Nine of these earthquakes have been studied in detail using a formal inversion technique based on matching synthetic body waves to observed seismograms.

Bergman, E. A.↗
NASA NTRS1984

Elastic model of the traction behavior of two traction lubricants

In the analysis of rolling-sliding concentrated contacts, such as gears, bearings and traction drives, the traction characteristics of the lubricant are of prime importance. The elastic shear modulus and limiting shear stress properties of the lubricant dictate the traction/slip characteristics and power loss associated with an EHD contact undergoing slip and/or spin. These properties can be deducted directly from the initial slope m and maximum traction coefficient micron of an experimental traction curve. In this investigation, correlation equations are presented to predict m and micron for two modern traction fluids based on the regression analysis of 334 separate traction disk machine experiments. The effects of contact pressure, temperature, surface velocity, ellipticity ratio are examined. Problems in deducing lubricant shear moduli from disk machine tests are discussed. Previously announced in STAR as N83-20116

Loewenthal, S. H.↗
NASA NTRS1983

Two-phase turbine staging

Two-phase turbines would be useful in Rankine cycles using low-quality or saturated-liquid working fluids. The chief problem is low efficiency due to slip losses in nozzles and due to liquid impact and friction losses in rotors. To raise efficiency, a staging method was tested in which the first stage operated at high speed with low relative liquid velocity, and the second stage recovered the first-stage exit energy. The theoretical efficiency for an experimental turbine operating with Refrigerant-22 was raised from 55 percent to 66 percent, and the measured efficiency was raised from 52 percent to 57 percent.

Elliott, D. G.↗
NASA NTRS1983

Neogene Caribbean plate rotation and associated Central American tectonic evolution

A theoretical model of the opening of the Cayman Trough is developed on the basis of geological evidence from a wide area. It is proposed that strike slip motion began about 30 Myr ago and proceeded at a rate of 37 + or - 6 mm/yr for a total of 1100 km of relative plate displacement, and that Central America Underwent an anticlockwise rotation with internal plate deformation. Maps of the reconstructed motion are provided.

Wadge, G.↗
NASA NTRS1984

The structure of extruded NiAl

The deformation structure of Ni-rich NiAl extruded at 550 C has been characterized by transmission electron microscopy and by optical microscopy. Dislocations having a(100) Burgers vectors were found as complex networks, tangles, and prismatic loops. a(110) dislocations, which were rare, were concluded to arise from reactions of a(100) dislocations. Evidence of recovery and recrystallization was obtained. Extrusion was deemed to have been possible by the operation of (hko)(001) slip systems (often in plane strain flow) plus diffusion-assisted processes.

Baker, I.↗
NASA NTRS1984

Coherent tilt signals observed in the Shumagin seismic gap Detection of time-dependent subduction at depth?

Repeated surveys of short level lines in the Shumagin Islands, Alaska, reveal coherent tilt signals associated with subduction of the Pacific plate beneath the North American plate in the Shumagin seismic gap. Ten years of steady tilt down toward the trench is interrupted during 1978-1980 by a rapid episode of reverse tilt. The 'normal' tilt represents surface deformation as subduction occurs, with the plate boundary locked to at least 60 km depth. Using all available tilt, sea level, and seismic data, the tilt reversal is interpreted as due to an episodic reverse slip of about 80 cm magnitude on the plate boundary between about 70 km and 20 km depth, downdip from the main seismogenic zone, which remains locked. This event causes an increase of stress on the locked main thrust zone. It is speculated that such events may be a regular process at subduction zones, that great plate boundary earthquakes may be more common during their occurrence, and that their onset may be detectable early enough to give warning of an increase in probability for the occurrence of a great earthquake.

Beavan, J.↗
NASA NTRS1984

The structures and energetics of fully nonlinear symmetric baroclinic waves

Rotating baroclinic flow for Richardson number lower than about 1 is studied by means of a finite difference Navier-Stokes model assuming no variations except in the vertical plane that completely contains the density gradient vector. The horizontally infinite channel to which attention is given further assumes periodic boundary conditions at the vertical computational boundaries and no-slip conducting horizontal boundaries. Two configurations are considered. Symmetric baroclinic waves developed in the flows in a manner consistent with linear theory, and it is noted that the structures and energetics of the fully developed waves were dependent on the Prandtl number Pr. For Pr greater than 1, the conversion from potential energy to wave kinetic energy was direct, via temperature and vertical motion correlation, while for Pr of less than 1, conversion proceeded from potential energy to average kinetic energy by means of an induced meridional flow, and then to wave kinetic energy.

Miller, T. L.↗
NASA NTRS1984

On the prediction of auto-rotational characteristics of light airplane fuselages

A semi-empirical theory is presented for the estimation of aerodynamic forces and moments acting on a steadily rotating (spinning) airplane fuselage, with a particular emphasis on the prediction of its auto-rotational behavior. This approach is based on an extension of the available analytical methods for high angle of attack and side-slip and then coupling this procedure with strip theory for application to a rotating airplane fuselage. The analysis is applied to the fuselage of a light general aviation airplane and the results are shown to be in fair agreement with experimental data.

Pamadi, B. N.↗
NASA NTRS1984

Elevated temperature compressive steady state deformation and failure in the oxide dispersion strengthened alloy MA 6000E

The compressive flow strength-strain rate behavior of the oxide-dispersion-strengthened alloy MA 6000E has been studied in the temperature range 1144-1366 K, with strain rates ranging from 2.1 x 10 to the -5th to 2.1 x 10 to the -7th per s. It is found that the inherent strength of the alloy is essentially the same in all test directions and that the low strength observed in tensile tests results from the inability of grain boundaries to support high tensile stresses. The failure of MA 6000E under high-temperature, slow plastic flow conditions is shown to be the result of concentrated slip. Slow plastic deformation in MA 6000E can be described by a threshold stress model of creep where threshold stresses are calculated from relatively fast testing procedures and the effective stress exponent for creep is assumed to be 3.5.

Whittenberger, J. D.↗
NASA NTRS1984

The interaction between mistuning and friction in the forced response of bladed disk assemblies

This paper summarizes the results of an investigation to establish the impact of mistuning on the performance and design of blade-to-blade friction dampers of the type used to control the resonant response of turbine blades in gas turbine engines. In addition, it discusses the importance of friction slip force variations on the dynamic response of shrouded fan blades.

Griffin, J. H.↗
NASA NTRS1984

Progress in net shape fabrication of alpha sic turbine components

An update of the status of ceramic component development of the AGT Programs is presented. Activity on AGTO Program focussed on the following: successful transition from the prototype to engine configuration rotor, investigation of alternate rotor molding techniques, and completion of scroll assemblies. Progress on the Garrett AGT Program was highlighted by the introduction of plastic molding and extrusion to parts which were previously fabricated by slip casting and isopressing respectively.

Sweeting, T. B.↗
NASA NTRS1986

Dolly Swivel for Forklift

Adapter enables large dolly towed or pushed by forklift truck and swivel on forklift on turns. Adapter prevents dolly from slipping off forks and damaging loads. Swivel adapter rests on forklift and provides pivot for towing dolly.

Jones, J. T.↗
NASA NTRS1985

Effect of two inner-ring oil-flow distribution schemes on the operating characteristics of a 35 millimeter bore ball bearing to 2.5 million DN

Parametric tests were conducted with a 35-mm-bore, split-inner-ring ball bearing with a double-inner-land-guided cage. Provisions were made for through-the-inner-ring lubrication. Test condictions were either a thrust load of 667 N (150 lb) or a combined load of 667 N (150 lb) thrust and 222 N (50 lb) radial, shaft speeds from 32000 to 72000 rpm, and an oil-inlet temperature of 394 K (250 deg F). Outer ring cooling was used in some tests. Tests were run with either 50 or 75 percent of the total oil flow distributed to the inner-ring raceway. Successful operation was experienced with both 50% and 75% flow patterns to 2.5 million DN. Cooling the outer ring had little effect on inner-ring temperature; however, the outer-ring temperature decreased as much as 7% at 2.5 million DN. Maximum recorded power loss was 3.1 kW (4.2 hp), and maximum cage slip was 8.7 percent. Both occurred at a shaft speed of 72000 rpm, a lubricant flow rate of 1900 cu/min (0.50 gal/min), a combined load, and no outer-ring cooling.

Schuller, F. T.↗