SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Simulated multispectral data sets used in the Thematic Mapper design parameter investigation are analyzed. The sets were produced by processing high-resolution digital multispectral data through models of the various Thematic Mapper configurations and then through three resampling techniques as a simulation of ground processing. Emphasis is placed on classification processing and analysis of results.
The SL-3 flight on the Space Shuttle will carry a 25 mW He-Ne laser holographic recorder for recording the solution growth of triglycine sulfate (TGS) crystals under low-zero gravity conditions. Three hundred holograms (two orthogonal views) will be taken (on SO-253 film) of each growth experiment. Processing and analysis (i.e., reconstructed imagery, holographic schlieren, reverse reference beam microscopy, and stored beam interferometry) of the holographic records will be done at NASA/MSFC. Other uses of the recorder on the Shuttle have been proposed.
The transmission loss concept is used in the evaluation of an acoustic filter for liquid-borne transverse modes. Tests are conducted to determine the nature of filter element designs required to suppress transverse modes, to verify the presence of transverse modes in the test assembly, to define the acoustic wave incident, and to establish data recording, processing and analysis techniques providing transmission wave filter data. The first, second, and third tangential modes, and the first radial mode are found at frequencies of 2150, 3330, 4420, and 4110 Hz, respectively, and peaks of the tangential modes recede while the radial mode peak remains, demonstrating agreement with theoretical nodal patterns. The present design is found applicable to a liquid-oxygen system, and allows the easy-to-fabricate filter to fit within the available space envelope.
Techniques and applications of radar observation from Earth satellites are discussed. Images processing and analysis of these images are discussed. Also discussed is radar imaging from aircraft. Uses of this data include ocean wave analysis, surface water evaluation, and topographic analysis.
Specific recommendations for environmental test criteria, data acquisition procedures, and instrument performance requirements for measurement of noise levels produced by aircraft in flight are provided. Recommendations are also given for measurement of associated airplane and engine parameters and atmospheric conditions. Recommendations are based on capabilities which were available commercially in 1981; they are applicable to field tests of aircraft flying subsonically past microphones located near the surface of the ground either directly under or to the side of a flight path. Aircraft types covered by the recommendations include fixed-wing airplanes powered by turbojet or turbofan engines or by propellers. The recommended field-measurement procedures are consistent with assumed requirements for data processing and analysis.
In the early years of remote sensing, emphasis was placed on the processing and analysis of data from a single multispectral sensor, such as the Landsat Multispectral Scanner System (MSS). However, in connection with attempts to use the data for resource management, it was realized that many deficiencies existed in single data sets. A need was established to geographically reference the MSS data and to register with it data from disparate sources. Technological transfer activities have required systems concepts that can be easily transferred to computers of different types in other organizations. ELAS (Earth Resources Laboratory Applications Software), a geographically based information system, was developed to meet the considered needs. ELAS accepts data from a variety of sources. It contains programs to geographically reference the data to the Universal Transverse Mercator grid. One of the primary functions of ELAS is to produce a surface cover map.
Procedures necessary for the development of a generalized three-dimensional perspective software capability in support of graphic, topographic, and color mapping of Landsat data are reviewed. The NASA Earth Resources Laboratory developed the procedures in order to facilitate the processing and analysis of disparate, geographically oriented base maps from aircraft and satellite sensors. Perspective displays are obtained through a translation of the space-viewed object to a vantage point coordinate system, followed by a rotation through two angles for alignment along the vantage line of sight, and finally a perspective transformation to yield two-dimensional displays with no hidden lines. Matrix equations for the transformations are reviewed, including scaling, and block diagrams are provided of the data and perspective software systems. The classification data plane may be mapped onto a topographic elevation data plane.
Explore the source record for details and available documents.
A university project to develop land cover classification capabilities is discussed. Specific objectives were to: (1) demonstrate the feasibility of using LANDSAT data for resource management; (2) establish projects and meet state needs for specific resource information; and (3) assist state personnel in obtaining technical expertise in the processing and analysis of LANDSAT data.
Computer programs for large systems of normal equations, an interactive digital signal process, structural analysis of cylindrical thrust chambers, swirling turbulent axisymmetric recirculating flows in practical isothermal combustor geometrics, computation of three dimensional combustor performance, a thermal radiation analysis system, transient response analysis, and a software design analysis are summarized.
Crack growth retardation following overloads can result in overly conservative life predictions in structures subjected to variable amplitude fatigue loading when linear damage accumulation procedures are employed. Crack closure is believed to control the crack growth retardation, although the specific closure mechanism is debatable. Information on the relative contributions to crack closure from: (1) plasticity left in the wake of the advancing crack and (2) crack tip residual stresses is provided. The delay period and corresponding crack growth rate transients following overloads are systematically measured as a function of load ratio (R) and overload magnitude. These responses are correlated in terms of the local 'driving force' for crack growth as measured by crack tip opening loads and delta K sub eff. The latter measurements are obtained using a scanning electron microscope equipped with a cyclic loading stage; measurements are quantified using a relatively new stereoimaging technique. Combining experimental results with analytical predictions suggests that both plastic wake and residual stress mechanism are operative, the latter becoming predominate as R increases.
The processing and analysis results from 87 radio occultation experiments performed with the Pioneer Venus Orbiter are detailed. Atmospheric structure data were obtained with S-band (2293 MHz) and X-band (8407 MHz) signals transmitted through the 40 and 85 km levels of the Venus atmosphere. Latitudes of -68 to 88 deg at solar zenith angles of 8-166 deg were explored. The conversion of the data into acceptable form for the barometric equation to use the perfect gas law to obtain the temperature profiles is described. The temperature structures were more dependent on latitude than solar illumination conditions, with the greatest changes occurring in the circumpolar region. The polar tropopause altitude was about 4.8 km above its value at lower altitudes, with a temperature drop of 60 K and a pressure drop of 240 mb.
A comprehensive set of scaling parameters is developed for the ice accretion process by analyzing the energy equations of the dynamic freezing zone and the already frozen ice layer, the continuity equation associated with supercooled liquid droplets entering into and impacting within the dynamic freezing zone, and energy equation of the ice layer. No initial arbitrary judgments are made regarding the relative magnitudes of each of the terms. The method of intrinsic reference variables in employed in order to develop the appropriate scaling parameters and their relative significance in rime icing conditions in an orderly process, rather than utilizing empiricism. The significance of these parameters is examined and the parameters are combined with scaling criteria related to droplet trajectory similitude.
This paper describes an approach for compositing digital radar data and GOES satellite data for meteorological analysis. The processing is performed on a user-oriented image processing system, and is designed to be used in the research mode. It has a capability to construct PPIs and three-dimensional CAPPIs using conventional as well as Doppler data, and to composite other types of data. In the remapping of radar data to satellite coordinates, two steps are necessary. First, PPI or CAPPI images are remapped onto a latitude-longitude projection. Then, the radar data are projected into satellite coordinates. The exact spherical trigonometric equations, and the approximations derived for simplifying the computations are given. The use of these approximations appears justified for most meteorological applications. The largest errors in the remapping procedure result from the satellite viewing angle parallax, which varies according to the cloud top height. The horizontal positional error due to this is of the order of the error in the assumed cloud height in mid-latitudes. Examples of PPI and CAPPI data composited with satellite data are given for Hurricane Frederic on 13 September 1979 and for a squall line on 2 May 1979 in Oklahoma.
The simultaneous diffusion of liquid boron and liquid phosphorus dopants into N-type dendritic silicon web for solar cells was investigated. It is planned that the diffusion parameters required to achieve the desired P(+)NN(+) cell structure be determined and the resultant cell properties be compared to cells produced in a sequential differential process. A cost analysis of the simultaneous junction formation process is proposed.
A passivation process (hydrogenation) that will improve the power generation of solar cells fabricated from presently produced, large grain, cast polycrystalline silicon (Semix), a potentially low cost material are developed. The first objective is to verify the operation of a DC plasma hydrogenation system and to investigate the effect of hydrogen on the electrical performance of a variety of polycrystalline silicon solar cells. The second objective is to parameterize and optimize a hydrogenation process for cast polycrystalline silicon, and will include a process sensitivity analysis. The sample preparation for the first phase is outlined. The hydrogenation system is described, and some early results that were obtained using the hydrogenation system without a plasma are summarized. Light beam induced current (LBIC) measurements of minicell samples, and their correlation to dark current voltage characteristics, are discussed.
Image analysis techniques applicable to remote sensing data and covering image models, feature detection, segmentation and classification, texture analysis, and matching are studied. Model types for characterizing images examined include random-field, mosaic, and facet models. Edge and corner detection as well as global extraction of linear features are discussed. Pixel clustering and classification are covered in addition to the regional approach to segmentation. Autocorrelation, second-order gray level probability density, and the use of primitive element statistics are discussed in relation to texture analysis. Finally, reducing the cost of (sub)imaging matching methods (e.g., pixelwise comparison of gray levels and normalized cross-correlation between two images) as well as improving match sharpness is considered.
Lintz (1972) has defined remote sensing for petroleum exploration as the detection from a distance of variations of the earth's surface or properties. Possibilities foreseen by Lintz could be realized with the Lander satellite. When used in 'phase-one' exploration programs, Landsat data have been effective in 'zeroing-in' on potential hydrocarbon traps, and later, when supplemented by more conventional exploration procedures, have led to the discovery of these resources. The present investigation is concerned with an overview of the methods utilized in 'phase-one' hydrocarbon exploration programs. The considered methods are to serve as an initial tool to aid the more conventional exploration procedures. Attention is given to visual interpretations, digital image processing, lineament analysis, surface anomalies, and geomorphology and topography.