Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “monotonicity”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 937 records · Page 52
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Absolute flux density calibrations: Receiver saturation effects

The effect of receiver saturation was examined for a total power radiometer which uses an ambient load for calibration. Extension to other calibration schemes is indicated. The analysis shows that a monotonic receiver saturation characteristic could cause either positive or negative measurement errors, with polarity depending upon operating conditions. A realistic model of the receiver was made by using a linear-cubic voltage transfer characteristic. The evaluation of measurement error for this model provided a means for correcting radio source measurements.

Freiley, A. J.↗
NASA NTRS1977

Tensile and compressive behavior of Borsic/aluminum

The results of an experimental investigation of the mechanical behavior of Borsic/aluminum are presented. Composite laminates were tested in tension and compression for monotonically increasing load and also for variable loading cycles in which the maximum load was increased in each successive cycle. It is shown that significant strain-hardening, and corresponding increase in yield stress, is exhibited by the metal matrix laminates. For matrix dominated laminates, the current yield stress is essentially identical to the previous maximum stress, and unloading is essentially linear with large permanent strains after unloading. For laminates with fiber dominated behavior, the yield stress increases with increase in the previous maximum stress, but the increase in yield stress does not keep pace with the previous maximum stress. These fiber dominated laminates exhibit smaller nonlinear strains, reversed nonlinear behavior during unloading, and smaller permanent strains after unloading. Compression results from sandwich beams and flat coupons are shown to differ considerably. Results from beam specimens tend to exhibit higher values for modulus, yield stress, and strength.

Herakovich, C. T.↗
NASA NTRS1977

Early evolution of an X-ray emitting solar active region

The birth and early evolution of a solar active region has been investigated using X-ray observations from the mapping X-ray heliometer on board the OSO-8 spacecraft. X-ray emission is observed within three hours of the first detection of H-alpha plage. At that time, a plasma temperature of four million K in a region having a density on the order of 10 to the 10th power per cu cm is inferred. During the fifty hours following birth almost continuous flares or flare-like X-ray bursts are superimposed on a monotonically increasing base level of X-ray emission produced by the plasma. If the X-rays are assumed to result from heating due to dissipation of current systems or magnetic field reconnection, it may be concluded that flare-like X-ray emission soon after active region birth implies that the magnetic field probably emerges in a stressed or complex configuration.

Wolfson, C. J.↗
NASA NTRS1978

Axial residual stresses in boron fibers

A method of measuring axial residual stresses in boron fibers is presented. With this method, the axial residual stress distribution as a function of radius is determined from the fiber surface to the core including the average residual stress in the core. Such measurements on boron on tungsten (B/W) fibers show that the residual stresses for 102, 142, 203, and 366 micron diam fibers are similar, being compressive at the surface and changing monotonically to a region of tensile stress within the boron. At approximately 25% of the original radius, the stress reaches a maximum tensile stress of about 860 MN sq m and then decreases to a compressive stress near the tungsten boride core. Data are presented for 203-micron diam B/W fibers that show annealing above 900 C reduces the residual stresses. A comparison between 102-micron diam B/W and boron on carbon (B/C) show that the residual stresses are similar in the outer regions of the fibers, but that large differences near and in the core are observed. Fracture of boron fibers is discussed.

Behrendt, D. R.↗
NASA NTRS1978

Extended observations of Vela X-1 by OSO 8

The Goddard Space Flight Center (GSFC) Cosmic X-Ray experiment aboard OSO 8 viewed the X-ray binary pulsar, Vela X-1, on three occasions from late 1975 through late 1976. The X-ray spectrum is well-represented by a power law modified by photoelectric absorption, a high-energy cutoff, and a line feature at about 6.8 keV. When combined with other observations, the reported measurements show that the pulse period is not decreasing monotonically. The three eclipses observed all indicate a significant eclipse flux.

Becker, R. H.↗
NASA NTRS1978

The artificial compression method for computation of shocks and contact discontinuities. III - Self-adjusting hybrid schemes

This paper presents a new computational method for the calculation of discontinuous solutions of hyperbolic systems of conservation laws, which deal effectively with both shock and contact discontinuities. The method consists of two stages: in the first stage a standard finite-difference scheme is hybridized with a nonoscillatory first order accurate method to provide for the monotonic variation of the solution near discontinuities, and in the second stage artificial compression is applied to sharpen transitions at discontinuities. This modification of a standard finite-difference method results in a scheme which preserves the order of truncation error of the original method and yet yields a sharp and oscillation free transition for both shocks and contact discontinuities. The modification can be easily implemented in existing computer codes.

Harten, A.↗
NASA NTRS1978

Tensile and compressive stress-strain behavior of heat treated boron-aluminum

An experimental study was conducted to assess the effects of heat treatment and cyclic mechanical loading on the tensile and compressive stress-strain behavior of six boron-aluminum composites having different laminate orientations and being subjected to different heat treatments. The heat treatments were as-fabricated, T6, and T6N consisting of T6 treatment followed by cryogenic quench in liquid nitrogen prior to testing. All laminates were tested in monotonic and cyclic compression, while the tensile-test data are taken from the literature for comparison purposes. It is shown that the linear elastic range of the T6- and T6N-condition specimens is larger than that of the as-fabricated specimens, and that cyclic loading in tension or compression strain hardens the specimens and extends the linear elastic range. For laminates containing 0-deg plies, the stress-strain behavior upon unloading is found to be nonlinear, whereas the other laminates exhibit a linear behavior upon unloading. Specimens in the T6 and T6N conditions show higher strain hardening than the as-fabricated specimens.

Kennedy, J. M.↗
NASA NTRS1978

Considerations of crack growth and plasticity in finite element analysis

A finite-element analysis was made of crack growth in a center-cracked specimen subjected to monotonically increasing load until the point of fast fracture. Since part of the specimen experienced unloading, the boundary value problem which was formulated was based upon incremental theory of plasticity. Experimental load and crack size records were utilized. Linear relations between plastic energy and crack growth were observed. Fracture toughness parameters, which were evaluated at the onset of unstable crack propagation from finite-element analysis, were in good agreement with those determined experimentally.

Lee, J. D.↗
NASA NTRS1977

On the comparison between equilibrium and disequilibrium condensation sequences of meteorites

A definition is presented of a simple formalism for calculating the condensation sequence of meteoritic minerals in a cooling vapor phase in temperature disequilibrium (between the vapor phase and the condensed phase) when such minerals condense congruently. Certain preliminary comments are made about the possibility of judging the relative plausibility of the equilibrium and the disequilibrium models from the observations in meteorites if a monotonic cooling were indeed the course of condensation in either case.

De, B. R.↗
NASA NTRS1978

Effect of cyclic loading and temper condition on the tensile behavior of boron-aluminum

Experimental results from monotonic and cyclic tension tests on six different 6061 boron-aluminum laminates show that the strength of fiber dominated laminates is decreased and the strength of matrix dominated laminates is increased by T6 heat treatment. Cyrogenic exposure and cyclic loading are shown to have little influence on strength. Cyclic loading is also shown to produce small reductions in modulus for some laminates and some temper conditions. The results are discussed in light of expected metallurgical and residual stress changes due to temperature excursions and loading cycles.

Herakovich, C. T.↗
NASA NTRS1979

Effects of noise frequency on performance and annoyance

Using a complex psychomotor task performed for 50 minutes in the presence of low frequency noise, high frequency noise, or ambient noise, annoyance ratings were obtained for noises of various frequencies by the method of magnitude estimation. The results suggest that high frequency noise affects female performance to a greater extent than male performance. Contrasted to these performance effects, the sexes did not differ in their annoyance ratings. A monotonically increasing relationship between annoyance and noise frequency was found (except for a decrease in annoyance at 8,000 Hz). It is concluded that both performance and annoyance responses may need to be assessed in certain situations to adequately describe human reaction to noise.

Key, K. F.↗
NASA NTRS1978

Narrow-band spectrophotometry of Ariel, Umbriel, Titania, Oberon, and Triton

The spectral reflectances of Ariel, Umbriel, Titania, Oberon, and Triton were measured in 28 bandpasses between lambda 326 and lambda 976 nm on the night of 28/29 June 1974. These observations were made with the 200-in. Hale telescope and multichannel spectrometer. Bandpasses of 8 nm from lambda 326 to lambda 566 nm and 16 nm from lambda 592 to lambda 976 nm were employed. The spectral reflectances of Ariel, Oberon, and Titania increase from lambda 342 to lambda 534 nm and are relatively flat from lambda 550 to lambda 976 nm. Umbriel's reflectance decreases monotonically with increasing wavelength through the entire range of measured wavelengths. Triton is found to have a constant spectral reflectance.

Johnson, P. E.↗
NASA NTRS1978

Structure of current sheets in magnetic holes at 1 AU

Current density profiles in several types of interplanetary magnetic holes have been calculated using high-resolution Imp 6 magnetic field data (12.5 vector measurements/s), assuming that the currents flow in planar sheets and that the magnetic field varies only in the direction normal to the sheet. The planarity was verified in four holes which were observed by two suitably spaced spacecraft. Four types of simple magnetic holes are discussed, in which B varies nearly monotonically on each side of the hole. In two of the holes, B varies in intensity but not in direction as a result of currents normal to B. In the other two holes, B changes in both magnitude and direction as a result of currents both normal and parallel to B. The observed structures are found to be qualitatively consistent with the models of Burlaga and Lemaire (1978). Examples of complex irregular magnetic holes are also presented, and they are shown to contain multiple current sheets in which currents flow parallel to one another at various angles with respect to B. There is no model of such magnetic holes at present.

Fitzenreiter, R. J.↗
NASA NTRS1979

Inverse multiple scattering problems. III - Inadequacy of certain limb darkening and phase curves for retrieving atmospheric information and limitations of approximate scattering models

The paper considers three complementary inverse multiple scattering problems relating to a uniquely defined atmospheric scattering model. Consideration is given to the appropriateness, for data inversion purposes, of intensities observed in diffuse reflection under a variety of experimental conditions; the uniqueness of the inverse solution is investigated. It is found that light curves representing monotonic variations, such as limb darkening curves and phase curves for a planetary (e.g., Venus) disk center are unsuitable for inferring atmospheric and scattering parameters.

Fymat, A. L.↗
NASA NTRS1979

Turbulent vortices in stratified fluids

In the present paper, calculations, made with the finite difference axisymmetric WAKE computer code, of the influence of turbulence and stratification on the behavior of vortex rings are compared with experimental data. Calculations, made with the two-dimensional version of the code, are used to study the behavior of vortex pairs in stably stratified atmospheres for a range of Froude numbers. Stratification is shown to have a profound effect on the radius of a vortex ring descending into a stably stratified fluid. The separation of the vortices of a vortex pair remains nearly constant or decreases monotonically with increasing penetration of a stably stratified fluid, depending on whether the stratification is discontinuous or linear. An analysis based on an energy balance is used to assess the maximum descent of a vortex pair in a stably stratified fluid.

Hecht, A. M.↗
NASA NTRS1978

The chaotic solar nebula - Evidence for episodic condensation in several distinct zones

Abundances of rare earth elements in Allende inclusions are considered along with the rim sequence on coarse-grained chondrules. It is found that in at least several zones the nebula went through episodes of condensation and gas/grain separation. Four separate zones are required to make the two types of fine-grained aggregates and the two types of coarse-grained chondrules. Other types of inclusions in Allende, such as the olivine aggregates, may well require additional condensation zones. All of these conclusions are based on data from one meteorite. Although the details of the gas/grain separation mechanism in these zones is not well understood, it is clear that a single monotonic-cooling condensation sequence followed by isolation of grains from gas cannot account for the observations.

Boynton, W. V.↗
NASA NTRS1979

Robotic vision

Robotic vision, involving the use of a vision system to control a process, is discussed. Design and selection of active sensors employing radiation of radio waves, sound waves, and laser light, respectively, to light up unobservable features in the scene are considered, as are design and selection of passive sensors, which rely on external sources of illumination. The segmentation technique by which an image is separated into different collections of contiguous picture elements having such common characteristics as color, brightness, or texture is examined, with emphasis on the edge detection technique. The IMFEX (image feature extractor) system performing edge detection and thresholding at 30 frames/sec television frame rates is described. The template matching and discrimination approach to recognize objects are noted. Applications of robotic vision in industry for tasks too monotonous or too dangerous for the workers are mentioned.

Williams, D. S.↗
NASA NTRS1979

Acceleration of linear and logarithmic convergence

Eleven different methods for accelerating convergence of sequences and series have been tested and compared on a wide range of test problems, including both linearly and logarithmically convergent series, monotone and alternating series. All but one of these methods are already in the literature, and they include both linear and nonlinear methods. The only methods found to accelerate convergence across the board were the u and v transforms of Levin and the theta algorithm of Brezinski. The paper gives detailed comparisons of all the tested methods on the basis of number of correct digits in the answer as a function of number of terms of the series used. A theorem of Germain-Bonne states that methods of a certain form which are exact on geometric series will accelerate linear convergence. The theorem applies to theta sub 2, and we have extended it to apply to Levin's transforms. No corresponding theorem is known for logarithmic convergence, but u, v, and theta are exact on certain large classes of logarithmic series, and all tested methods lacking this property failed to accelerate some logarithmically convergent series.

Smith, D. A.↗