Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “VOLT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 919 records · Page 51
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

NASCAP modelling of high-voltage power system interactions with space charged-particle environments

A simple space power system operating in geosynchronous orbit was analyzed. This system consisted of two solar array wings and a central body. Each solar array wing was considered to be divided into three regions operating at 2000 volts. The center body was considered to be an electrical ground with the array voltages both positive and negative relative to ground. The system was analyzed for both a normal environment and a moderate geomagnetic substorm environment. Initial results indicate a high probability of arcing at the interconnects on the negative operating voltage wing. The dielectric strength of the substrate may be exceeded giving rise to breakdown in the bulk of the material. The geomagnetic substorm did not seem to increase the electrical gradients at the interconnects on the negative operating voltage wing but did increase the gradients on the positive operating voltage wing which could result in increased coupling current losses.

Stevens, N. J.↗
NASA NTRS1979

ATS-5 and ATS-6 potentials during eclipse

The ATS 5 and ATS 6 data for spacecraft charging during eclipse conditions is analyzed. The ATS 5 and ATS 6 charged to voltages greater than 100 volts for about 55 percent of the eclipse periods examined. The mean spacecraft potential during eclipse was 2 keV for ATS 5, and the highest potential measured was 10 kilovolts. For ATS 6, the mean potential during eclipse was 4 keV, the highest potential measured 20 keV. The average measured spacecraft potentials for both ATS 5 and 6 depend approximately linearly upon Kp. This relationship is due mainly to the dependence of electron current density on Kp near midnight. Spacecraft potentials at geosynchronous orbit may, to a rough approximation, thus be inferred from ground-based measurements of Kp, the planetary 3-hour index.

Rubin, A. G.↗
NASA NTRS1978

Microprocessor controlled advanced battery management systems

The advanced battery management system described uses the capabilities of an on-board microprocessor to: (1) monitor the state of the battery on a cell by cell basis; (2) compute the state of charge of each cell; (3) protect each cell from reversal; (4) prevent overcharge on each individual cell; and (5) control dual rate reconditioning to zero volts per cell.

W. T. Payne↗
NASA NTRS1979

Optically isolated logarithmic nanoammeter capable of floating to 5 kilovolts

A logarithmic current-measuring instrument was developed to measure plasma coupling currents at a common mode voltage of 5 kilovolts. Positive or negative currents can be measured from 10 to the -9th power to .001 ampere direct current. Optical isolation is used to control input switching and to provide data referenced to ground potential. Analog meter readouts as well as zero to five volt outputs are provided for peripheral data collection. Six independent channels are provided. Three measure positive currents, and three measure negative currents. Although designed for vacuum operation, it can be used equally well in air to measure low currents at high common mode voltages.

Sturman, J. C.↗
NASA NTRS1979

A study of the deposition of carbide coatings on graphite fibers

The chemical vapor deposition of boron carbide and silicon carbide on graphite fibers to increase their electrical resistance was studied. Silicon carbide coatings were applied without degradation of the mechanical properties of the filaments. These coatings typically added 1000 ohms to the resistance of a filament as measured between two mercury pools. When SiC-coated filaments were oxidized by refluxing in boiling phosphoric acid, average resistance increased by an additional 1000 ohms; in addition resistance increases as high as 150 K ohms and breakdown voltages as high as 17 volts were noted. Data on boron carbide coatings indicated that such coatings would not be effective in increasing resistance, and would degrade the mechanical properties.

Suplinskas, R. J.↗
NASA NTRS1978

Extended X-ray observations of Scorpius X-1 with a Bragg crystal spectrometer

Observations covering multiple orbital periods of the X-ray source Sco X-1 were carried out in 1975 and 1976 with the graphite crystal spectrometer aboard OSO 8. Time-averaged continuum spectra are featureless and are reasonably well described in terms of a Comptonized thermal bremsstrahlung spectrum in which kT is about 1.5-2 keV and in which the number of electron scatterings that each photon is assumed to have undergone is of the order of 100. Line limits, typically with equivalent widths of a few electron volts, are established for important emission lines of Si XIII, Si XIV, S XV, S XVI, and Fe XXV as a function of binary phase.

Long, K. S.↗
NASA NTRS1978

Metastable oxygen emission bands

Recombination of ground-state oxygen atoms populates six different bound electronic states of molecular oxygen. Of the six optical transitions expected between the three upper states at 4 to 4.5 electron volts and the two lowest states, five have been observed in the afterglow of a conventional helium-oxygen microwave discharge in both (O-16)2 and (O-18)2, three of them for the first time in gas-phase spectra. Generation of these emissions from oxygen atoms in a system free of molecular oxygen establishes that atom recombination is the production mechanism.

Slanger, T. G.↗
NASA NTRS1979

NASCAP modelling of high-voltage power system interactions with space charged-particle environments

The NASA Charging Analyzer Program (NASCAP), an engineering tool capable of analyzing the impact of the charged particle environment on spacecraft surfaces and systems, is described. NASCAP is a quasi-static computational program which analyzes the charging of a 3-dimensional complex body as a function of time and system-generated voltages for given space environmental conditions. The material properties of the surfaces are taken into account; the surface potentials, low energy sheath, potential distribution in space and particle trajectories are calculated. An application of NASCAP to a simple space solar power station consisting of two 6 m by 18 m solar array wings surrounding a central body is presented. Each solar array wing is considered to be divided into three regions operating at 2000 volts. Results of NASCAP analysis of the system for a normal environment and a moderate geomagnetic substorm environment are discussed.

Stevens, N. J.↗
NASA NTRS1979

Transversely accelerated ions - An ionospheric source of hot magnetospheric ions

The paper considers observational data on transversely accelerated ion (TAI) events observed from the Isis 1 and 2 satellites. A source of hot magnetospheric ions was discovered in the auroral topside ionosphere, and a part of the cold ionospheric ion distribution is transversely accelerated within a source region as low as 1000 km. Subsequent to transverse acceleration, the ions are driven upward into the magnetosphere by the gradient B mirror force; they are observed by the soft particle spectrometers on the Isis 1 and 2 satellites, with sharply defined pitch angle distributions centered between 90 and 120 deg, and with energy distributions up to several hundred electron volts. Observations at 1400 km indicate that the transversely accelerated ion (TAI) events are predominantly a winter nightside auroral zone phenomenon, but in the summertime TAI events were observed at altitudes above 2750 km on the day-side within the cleft. Typical intensities exceeding 10 to the 8th power ions/sq cm s sr during TAI events suggest that they may be a significant source of hot ions for the magnetosphere.

Klumpar, D. M.↗
NASA NTRS1979

A power extension package /PEP/ for the Shuttle Orbiter

A concept for solar array augmentation of the power normally provided by the Shuttle Orbiter fuel cells in support of payloads is discussed. Justification for the use of solar arrays rather than additional cryogenic fuel kits for extension of on-orbit stay time is presented. This is followed by a description of the array power system and an examination of its interfaces with the existing Orbiter fuel cell system. The system produces 29 kW total with 14 kW allocated to the Orbiter and 15 kW to payloads and permits an increase in on-orbit mission duration from 6 to approximately 20 days at 21 kW with four cryo kits. It is capable of producing full output in diverse vehicle orientations since the array is deployed and oriented by the Orbiter remote manipulator system (RMS). Power produced by the arrays is reduced to 32.25 to 32.5 volts by pulse-width-modulated buck voltage regulators to force the Orbiter fuel cells into an idle mode during the sunlighted portions of the orbit.

Ness, H. C.↗
NASA NTRS1981

Low-resistance continuity tester

IC printed-circuit board tester measures resistance as low as 0.1 ohm but uses little power. Two 4.7 kilohm resistors and connected transistors prevent current flow through operational amplifier until probe circuit is complete, eliminating need for on/off switch. Zener diode in series with amplifier output prevents audio oscillator operation until output has sufficient amplitude. Circuit utilizes 741 operational amplifier on 11.2 volt battery or lower voltage amplifiers.

Reasoner, R. B.↗
NASA NTRS1979

A cesium TELEC experiment at Lewis Research Center

The thermoelectronic laser energy converter (TELEC), was studied as a method of converting a 10.6 mm CO2 laser beam into electric power. The calculated characteristics of a TELEC seem to be well matched to the requirements of a spacecraft laser energy conversion system. The TELEC is a high power density plasma device which absorbs an intense laser beam by inverse bremsstrahlung with the plasma electrons. In the TELEC process, electromagnetic radiation is absorbed directly in the plasma electrons producing a high electron temperature. The energetic electrons diffuse out of the plasma striking two electrodes which are in contact with the plasma at the boundaries. These two electrodes have different areas: the larger one is designated as the collector, the smaller one is designated as the emitter. The smaller electrode functions as an electron emitter to provide continuity of the current. Waste heat is rejected from the collector electrode. An experiment was carried out with a high power laser using a cesium vapor TELEC cell with 30 cm active length. Laser supported plasma was produced in the TELEC device during a number of laser runs over a period of several days. Electric power from the TELEC was observed with currents in the range of several amperes and output potentials of less than 1 volt. The magnitudes of these electric outputs were smaller than anticipated but consistent with the power levels of the laser during this experiment.

Britt, E. J.↗
NASA NTRS1980

Planar multijunction high voltage solar cells

Technical considerations, preliminary results, and fabrication details are discussed for a family of high-voltage planar multi-junction (PMJ) solar cells which combine the attractive features of planar cells with conventional or interdigitated back contacts and the vertical multijunction (VMJ) solar cell. The PMJ solar cell is internally divided into many voltage-generating regions, called unit cells, which are internally connected in series. The key to obtaining reasonable performance from this device was the separation of top surface field regions over each active unit cell. Using existing solar cell fabricating methods, output voltages in excess of 20 volts per linear centimeter are possible. Analysis of the new device is complex, and numerous geometries are being studied which should provide substantial benefits in both normal sunlight usage as well as with concentrators.

Evans, J. C., Jr.↗
NASA NTRS1979

Physical phenomena in mercury ion thrusters

Experimental tests results demonstrating that reductions in screen grid thickness enhance the performance of ion thruster grids are presented. Shaping of the screen hole cross section is shown on the other hand not to affect performance substantially. The effect of the magnetic field in the vicinity of the hollow cathode on cathode performance is studied and test results are presented that show reductions in keeper voltages of a few volts can be realized by judicious applications of fields on the order of 100 gauss. The plasma downstream of a SERT 2 thruster operating without high voltage is studied. A model describing electron escape from the thruster under these conditions is discussed. A model defining the performance of the baffle aperture of an ion thruster is refined and experimental verification of the model is undertaken.

Wilbur, P. J.↗
NASA NTRS1980

F-5F Shark Nose radome lightning test

A unique F-5F radome wtih a geometry similar to a Shark Nose profile was tested with a high voltage Marx generator, 1,200,000 volts in order to demonstrate the effectiveness of the lightning protection system with currents from 5,000 amperes or greater. An edge discontinuity configuration is a characteristic feature in the forward region of the radome and occasionally serves as an attachment point. The results of nineteen attachment tests at various aspect angles with an air gap of one meter indicated that no damage occurred to the dielectric material of the radom. The test proved the effectiveness of the lightning protection system.

Scott, G. W.↗
NASA NTRS1980

Non-heat pipe/P-40 Stirling engine

The non-heat-pipe receiver/P-40 Stirling engine system design is described. A 25 kW direct-driven induction-type alternator will be mounted directly to the P-40 engine to produce to a 60 Hz, 115/230 volt output.

Haglund, R. A.↗
NASA NTRS1980

Interaction of high voltage surfaces with the space plasma

High voltage solar arrays provide spacecraft power while optimizing mass and power efficiency. Operating such arrays in the space plasma environment can result in anomalously large currents being collected through insulation defects. Two thicknesses of the insulating material were tested, with no effect found due to insulator thickness. In these tests the polyimide thickness was always much less than the pinhole diameter. The pinhole area was varied over an area range of more than 30:1. It was found that the current collected was independent of the pinhole area for hole diameters from 0.35 to 2.0 mm. Two types of adhesives were tried in two different configurations. The adhesives were chosen for their extreme difference in vacuum qualifications. Neither adhesive types nor configuration made a significant difference in current collection. The temperature of the insulating material was also varied. It was found that current collection decreased with increasing temperature. Tests were conducted to see if pinhole current collection decreased with time, as was indicated by the effects of several short tests. Current was collected for over four hours while the conductor potential was held constant at 1000 volts. A smooth decrease with time was not observed, but rather a roughly constant current collection with brief surges to high values. Tests were also conducted with the simulated solar cell biased negative. The current was found to be proportional to pinhole area.

Kaufman, H. R.↗
NASA NTRS1979

HG ion thruster component testing

Cathodes, isolators, and vaporizers are critical components in determining the performance and lifetime of mercury ion thrusters. The results of life tests of several of these components are reported. A 30-cm thruster CIV test in a bell jar has successfully accumulated over 26,000 hours. The cathode has undergone 65 restarts during the life test without requiring any appreciable increases in starting power. Recently, all restarts have been achieved with only the 44 volt keeper supply with no change required in the starting power. Another ongoing 30-cm Hg thruster cathode test has successfully passed the 10,000 hour mark. A solid-insert, 8-cm thruster cathode has accumulated over 4,000 hours of thruster operation. All starts have been achieved without the use of a high voltage ignitor. The results of this test indicate that the solid impregnated insert is a viable neutralizer cathode for the 8-cm thruster.

Mantenieks, M. A.↗