Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Secondary”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 919 records · Page 51

A variable-geometry combustor used to study primary and secondary zone stoichiometry

A combustion program is underway to evaluate fuel quality effects on gas turbine combustors. A rich-lean variable geometry combustor design was chosen to evaluate fuel quality effects over a wide range of primary and secondary zone equivalence ratios at simulated engine operating conditions. The first task of this effort, was to evaluate the performance of the variable geometry combustor. The combustor incorporates three stations of variable geometry to control primary and secondary zone equivalence ratio and overall pressure loss. Geometry changes could be made while a test was in progress through the use of remote control actuators. The primary zone liner was water cooled to eliminate the concern of liner durability. Emissions and performance data were obtained at simulated engine conditions of 80 percent and full power. Inlet air temperature varied from 611 to 665K, inlet total pressure varied from 1.02 to 1.24 MPa, reference velocity was a constant 1400 K.

Briehl, D.↗

Axial compressor middle stage secondary flow study

This report describes an experimental investigation of the secondary flow within and aft of an axial compressor model with thick endwall boundary layers. The objective of the study was to obtain detailed aerodynamic and trace gas concentration traverse data aft of a well documented isolated rotor for the ultimate purpose of improving the design phases of compressor development based on an improved physical understanding of secondary flow. It was determined from the flow visualization, aerodynamic, and trace gas concentration results that the relative unloading of the midspan region of the airfoil inhibitied a fullspan separation at high loading preventing the massive radial displacement of the hub corner stall to the tip. Radial distribution of high and low total pressure fluid influenced the magnitude of the spanwise distribution of loss, such that, there was a general decreases in loss near the hub to the extent that for the least loaded case a negative loss (increase in total pressure) was observed. The ability to determine the spanwise distribution of blockage was demonstrated. Large blockage was present in the endwall regions due to the corner stall and tip leakage with little blockage in the core flow region. Hub blockage was found to increase rapidly with loading.

Wagner, J. H.↗

Secondary electric power generation with minimum engine bleed

Secondary electric power generation with minimum engine bleed is discussed. Present and future jet engine systems are compared. The role of auxiliary power units is evaluated. Details of secondary electric power generation systems with and without auxiliary power units are given. Advanced bleed systems are compared with minimum bleed systems. A cost model of ownership is given. The difference in the cost of ownership between a minimum bleed system and an advanced bleed system is given.

Tagge, G. E.↗

Comparison of secondary flows predicted by a viscous code and an inviscid code with experimental data for a turning duct

A comparison of the secondary flows computed by the viscous Kreskovsky-Briley-McDonald code and the inviscid Denton code with benchmark experimental data for turning duct is presented. The viscous code is a fully parabolized space-marching Navier-Stokes solver while the inviscid code is a time-marching Euler solver. The experimental data were collected by Taylor, Whitelaw, and Yianneskis with a laser Doppler velocimeter system in a 90 deg turning duct of square cross-section. The agreement between the viscous and inviscid computations was generally very good for the streamwise primary velocity and the radial secondary velocity, except at the walls, where slip conditions were specified for the inviscid code. The agreement between both the computations and the experimental data was not as close, especially at the 60.0 deg and 77.5 deg angular positions within the duct. This disagreement was attributed to incomplete modelling of the vortex development near the suction surface.

Schwab, J. R.↗

A conceptual design study for the secondary mirror drive of the shuttle infrared telescope facility (SIRTF)

Various conceptual designs for the secondary mirror actuator system to be used in the Shuttle Infrared Telescope Facility (SIRTF) were evaluated. In addition, a set of design concepts was developed to assist in the solution of problems crucial for optimum performance of the secondary mirror actuator system. A specific conceptual approach was presented along with a plan for developing that approach and identifying issues of critical importance in the developmental effort.

Sager, R. E.↗

Comparison of visualized turbine endwall secondary flows and measured heat transfer patterns

Various flow visualization techniques were used to define the seondary flows near the endwall in a large heat transfer data. A comparison of the visualized flow patterns and the measured Stanton number distribution was made for cases where the inlet Reynolds number and exit Mach number were matched. Flows were visualized by using neutrally buoyant helium-filled soap bubbles, by using smoke from oil soaked cigars, and by a few techniques using permanent marker pen ink dots and synthetic wintergreen oil. Details of the horseshoe vortex and secondary flows can be directly compared with heat transfer distribution. Near the cascade entrance there is an obvious correlation between the two sets of data, but well into the passage the effect of secondary flow is not as obvious. Previously announced in STAR as N83-14435

Gaugler, R. E.↗

The lower main sequence and the nature of secondary stars in ultracompact binaries

The possible nature of the secondary stars in ultracompact binary stellar systems (with orbital periods of less than about 1 hr) are systematically investigated. Using a simplified stellar evolution code, which assumes isentropic stellar models, nearly 3000 separate models for hydrogen-burning main-sequence stars with masses less than 0.3 solar mass are generated. The effects of the (homogeneous) chemical composition on the properties of such stars and in, particular, on the minimum main-sequence mass are explored in detail. It is found that this minimum mass is a sensitive function of the hydrogen content and can be as small as 0.035 solar mass. The properties of fully degenerate low-mass stars, as well as low-mass stars that are not in thermal equilibrium are also studied. In particular, it is shown that the thermal time scale of such nonequilibrium stars may exceed 10 billion yr. The results also confirm the existence of a second branch of the main sequence and shed new light on the thermal instability of this branch. The available observational information on the three known ultracompact binary systems (4U 1626-67, G61-29, 4U 1916-05) is summarized, and the results of the stellar model calculations are combined with the empirical results to place constraints on the properties of the secondary stars.

Rappaport, S.↗

Advanced secondary power system for transport aircraft

A concept for an advanced aircraft power system was identified that uses 20-kHz, 440-V, sin-wave power distribution. This system was integrated with an electrically powered flight control system and with other aircraft systems requiring secondary power. The resulting all-electric secondary power configuration reduced the empty weight of a modern 200-passenger, twin-engine transport by 10 percent and the mission fuel by 9 percent.

Hoffman, A. C.↗

Maser and secondary clock in telecommunications networks

Telecommunication networks of time division switches, interconnected by digital transmission are being put into place. At each switch, each incoming bit stream is brought into its own buffer. Then the clock in the switch reads each buffer to re-establish phase. Care must be taken to keep frequency differences between various clocks from becoming too large. Based on empirically defined data transmission requirements, one major network has determined that fractional frequency inequality between switches should be no worse than 1.7 X 10 to the minus 9 power. A network needs near frequency equality between its own switches, and also between its switches and other networks with which it interfaces. As a practical matter, the best way to achieve needed frequency equality is for each network to have master clock with an accuracy which is at least as good as 1 X 10 to the minus 10 power. The relationship between the master and the secondary clock is discussed. The questions of master clock accuracy and precision and the free-running capability of the secondary clocks are examined.

Risley, A.↗

Accelerator experiments on the contribution of secondary particles to the production of cosmogenic nuclides in meteorites

Through the interaction of galactic cosmic particle radiation (GCR) a wide variety of cosmogenic nuclides is produced in meteorites. They provide historical information about the cosmic radiation and the bombarded meteorites. An important way to understand the production mechanisms of cosmogenic nuclides in meteorites is to gather information about the depth and size dependence of the build-up of Galactic Rays Cosmic-secondary particles within meteorites of different sizes and chemical compositions. Simulation experiments with meteorite models offer an alternative to direct observation providing a data basis to describe the development and action of the secondary cascade induced by the GCR in meteorites.

Dragovitsch, P.↗

Comparison of secondary flows predicted by a viscous code and an inviscid code with experimental data for a turning duct

A comparison of the secondary flows computed by the viscous Kreskovsky-Briley-McDonald code and the inviscid Denton code with benchmark experimental data for turning duct is presented. The viscous code is a fully parabolized space-marching Navier-Stokes solver while the inviscid code is a time-marching Euler solver. The experimental data were collected by Taylor, Whitelaw, and Yianneskis with a laser Doppler velocimeter system in a 90 deg turning duct of square cross-section. The agreement between the viscous and inviscid computations was generally very good for the streamwise primary velocity and the radial secondary velocity, except at the walls, where slip conditions were specified for the inviscid code. The agreement between both the computations and the experimental data was not as close, especially at the 60.0 deg and 77.5 deg angular positions within the duct. This disagreement was attributed to incomplete modeling of the vortex development near the suction surface.

Schwab, J. R.↗

Abundances of 'secondary' elements among the ultraheavy cosmic rays - Results from HEAO-3

The HEAO-3 Heavy Nuclei Experiment has measured elemental abundances of ultraheavy cosmic rays near earth. The elements with atomic number (Z) in the intervals Z = 44-48 and Z = 62-74 arriving at earth are expected to have significant secondary components. However, their source abundances are unlikely to be low enough to warrant treating them as pure secondaries. The present results are consistent with solar system abundances modified for first ionization potential with possibly some enhancement of the r to s ratio.

Klarmann, J.↗

Secondary pattern computation of an offset reflector antenna

Reflector antennas are widely used in communications satellite systems because they provide high gain at low cost. In analyzing reflector antennas the computation of the secondary pattern is the main concern. A computer program for calculating the secondary pattern of an offset reflector has been developed and implemented at the NASA Lewis Research Center. The theoretical foundation for this program is based on the use of geometrical optics to describe the fields from the feed to the reflector surface and to the aperture plane. The resulting aperture field distribution is then transformed to the far-field zone by the fast Fourier transform algorithm. Comparing this technique with other well-known techniques (the geometrical theory of diffraction, physical optics (Jacobi-Bessel), etc.) shows good agreement for large (diameter of 100 lambda or greater) reflector antennas.

Acosta, R. J.↗

Variable friction secondary seal for face seals

Vibration and stability of a primary seal ring is controlled by a secondary seal system. An inflatable bladder which forms a portion of the secondary seal varies the damping applied to this seal ring. The amplitude of vibration of the primary seal ring is sensed with a proximity probe that is connected to a microprocessor in a control system. The bladder pressure is changed by the control system to mitigate any sensed instability or vibration.

Dirusso, E.↗

Epsilon Aurigae during eclipse - IRAS observations of the cool secondary component

Measurements of Epsilon Aur made from 5 to 60 microns over a period of less than 1 month during full eclipse, including special Infrared Astronomy Satellite (IRAS) observations at 12, 25, and 60 microns are presented. The observed flux at 60 microns agrees well with a prediction based on ground-based infrared monitoring of the eclipse ingress in 1982. Fits to the flux in excess of simple models for the primary star's infrared photospheric continuum yield T = 475 + or - 50 K, Omega = 8.6 + or - 1.0 x 10 to the -16th sr for the secondary. The total observed luminosity from the secondary is no larger than 50 solar luminosities.

Backman, D. E.↗

The interplanetary micrometeoroid flux and lunar primary and secondary microcraters

It is proposed that considerable care is required to properly interpret either spacecraft in situ data or lunar crater data as well as near-earth data; in the case of the former, complications may arise which may be attributed to secondary lunar ejecta impacts, in the latter, they may result from impacting earth-orbiting debris. Experimental evidence suggests that most impact pits on lunar rocks with pit diameters smaller than 7 micrometers have been generated by lunar secondary ejecta impacts and not by primary meteoroid impacts. It is also found that lunar crater production rates are more accurate when deduced from meteoroid space experiments and not from solar flare track ages. It is concluded that in so far as all of the above qualifications are taken into account, a self-consistent meteoroid flux versus mass distribution is obtained.

Zook, H. A.↗

Multiple incidence angle SIR-B experiment over Argentina Generation of secondary image products

Original radar images may be geometrically and radio metrically distorted. This may be a particular problem when multiple angle imagery is analyzed and there is topographic relief in the area of interest. This paper describes a set of techniques designed to combine a multiple angle radar data set with a digital terrain elevation model, to generate a set of new images called secondary image products. These new images are geometrically rectified radar ortho-images radiometrically rectified images, and stereo ortho-images. These secondary images can then reliably be used for thematic interpretation.

Domik, G.↗