Additive Manufacturing of Research Reactor Control Elements and Subsequent Neutron Irradiation
Additive manufacturing techniques have made major strides in recent years and are now capable of creating complex components in near-final form. The nuclear industry has many applications with complicated and even unique components that are time consuming, expensive, and more difficult to make using traditional fabrication routes. Modern fabrication techniques possess the potential to reduce fabrication lead-time and costs while increasing quality and efficiency. However, these methods have not been adopted due to the need for strict validation for nuclear applications. Unlike structural components that largely consist of a uniform material, for nuclear reactor core components incorporation of fissile or neutron poison materials inside a cladding becomes necessary. This in turn requires a more complex and flexible manufacturing method to produce these hybrid components. In this study, demonstration of ultrasonic additive manufacturing (UAM) process to produce components resembling research reactor control elements was carried out]. Specifically, the control elements for ORNL's High Flux Isotope Reactor (HFIR) were targeted. These control elements (consisting of an inner cylinder and four outer plates) are placed on the periphery of the circular HFIR core. The control elements consist of Al6061-T6 alloy with a 13-cm-long grey and a 56-cm-long black region, corresponding to 40 wt% of Ta and 30 wt% Eu{sub 2}O{sub 3} (europia) are incorporated along their length. In this study various fabrication parameters for production of aluminum blocks with and without embedded Eu{sub 2}O{sub 3} and Ta bearing compacts were explored. Select optimized specimens we then irradiated inside HFIR for one reactor cycle. The UAM process exploits ultrasonic energy to facilitate solid-state welding of metal foils in contact under pressure. This additive process is carried out in successive layers to build up the material and when coupled with CNC milling, it yields complex 3D components. The milling and subsequent additive steps may be used to embed foreign material into the material undergoing buildup. In this manner fissile or neutron poison elements may be incorporated into the complex structure, though in an inhomogeneous fashion. Multiple Al-6061 blocks were produced by UAM using 25 mm wide by 0.15 mm thick Al-6061-H18 tapes. The mechanical properties of these blocks in the as-fabricated condition was characterized in detail and it was shown that a great degree of anisotropy in the mechanical behavior exists between the direction in the tape plane and the direction perpendicular to the tapes (buildup direction) The latter exhibited reduced modulus and significantly smaller strength. Post production heat treatment appeared to greatly enhance the strength in the buildup direction. Multiple tensile specimens machined per SS-J3 geometry were prepared for irradiation testing. The tensile specimen matrix was set up to enable post irradiation examination of mechanical properties in various directions as well as after heat treatment. A small block with embedded Ta- and Eu{sub 2}O{sub 3}-bearing compacts, three of each kind, was also produced, as demonstrated previously. These compacts were 5.7 mm in diameter and 1.6 mm in height and contained 60 vol Ta or Eu{sub 2}O{sub 3}. The poison-bearing Al-6061 block alongside the tensile bars was loaded into a perforated rabbit (irradiation capsule) for irradiation in HFTK. The perforated rabbit allows penetration of HFIR water coolant into the Interior of the capsule in direct contact with the test specimens. The rabbit was loaded into the flux trap region at the uppermost position in the core. Irradiation temperature was 68 deg. C and fast neutron (E>0.1 MeV) fluence was 10{sup 25} neutrons/m{sup 2}. Currently PIE activities are ongoing that are focused on mechanical testing of irradiated tensile bars and metallographic examination of neutron poison bearing block.