Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Inverter”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 919 records · Page 51

Impact experiments in viscous fluid media

Available phase and group velocity data are inverted by a procedure which includes the effects of transverse anisotropy, anelastic dispersion, sphericity, and gravity. The resulting models, for average Earth, average ocean, and oceanic regions divided according to the age of the ocean floor, are quite different from previous results which ignore the above effects. The models show a low-veocity zone with age dependent anisotropy and velocities higher than derived in previous surface wave studied. The correspondence between the anisotropy variation with age and a physical model based on flow aligned olivine is suggestive. For most of the Earth SHSV in the vicinity of the low-velocity zone. Near the East Pacific Rise, however, SVSH at depth, consistent with ascending flow. Anisotropy is as important as temperature in causing radial and lateral variations in velocity. The models have a high velocity nearly isotropic layer at the top of the mantle that thickens with age. This layer defines the LID, or seismic lithosphere. In the Pacific, the LID thickens with age to a maximum thickness of about 50 km. This thickness is comparable to the thickness of the elastic lithosphere. The LID thickness is thinner than derived using isotropic or pseudo-isotropic procedures A new model for Average Earth is obtained which includes a thin LID. This model extends the fit of a P.R.E.M. type model to shorter period surface waves.

Greeley, R.↗

Gravitropism in leafy dicot stems

In an attempt to separate plant responses to mechanical stresses from responses to gravity compensation, six treatments were automated: (1) upright stationary controls; (2) horizontal clinostat; (3) intermittent clinostat (plants upright 3.3 minutes out of every 4 minutes, horizontal and rotated once in the remaining time); (4) inversion every ten minutes (plants upside down half the time); (5) inversion and immediate return to the vertical; and (6) vertical rotation. Epinasty appeared only on clinostated and on inverted plants, both subjected to gravity compensation. The mechanics of gravitropic stem bending and the effects of a unilateral application of ethephon of gravitropic bending were also investigated.

Salisbury, F. B.↗

Road load simulator tests of the Gould phase 1 functional model silicon controlled rectifier ac motor controller for electric vehicles

The test results for a functional model ac motor controller for electric vehicles and a three-phase induction motor which were dynamically tested on the Lewis Research Center road load simulator are presented. Results show that the controller has the capability to meet the SAE-J227a D cycle test schedule and to accelerate a 1576-kg (3456-lb) simulated vehicle to a cruise speed of 88.5 km/hr (55 mph). Combined motor controller efficiency is 72 percent and the power inverter efficiency alone is 89 percent for the cruise region of the D cycle. Steady state test results for motoring, regeneration, and thermal data obtained by operating the simulator as a conventional dynamometer are in agreement with the contractor's previously reported data. The regeneration test results indicate that a reduction in energy requirements for urban driving cycles is attainable with regenerative braking. Test results and data in this report serve as a data base for further development of ac motor controllers and propulsion systems for electric vehicles. The controller uses state-of-the-art silicon controlled rectifier (SCR) power semiconductors and microprocessor-based logic and control circuitry. The controller was developed by Gould Laboratories under a Lewis contract for the Department of Energy's Electric and Hybrid Vehicle program.

Gourash, F.↗

SMM-UVSP ozone profile inversion programs

The documentation and user manual for the software used to invert the UVSP aeronomy data taken by the SMM are provided. The programs are described together with their interfaces and what inputs are required from the user.

Smith, H. J. P.↗

Reflectance Modeling

The main thrust of the work conducted is in the modeling of spectral responses of discontinuous conifer forest canopies, considered as collections of conical forms that are illuminated at an angle and cast shadows on contracting background. The three first-year objectives are: (1) modification of the variance-driven model to incorporate overlapping of shadows and crowns; (2) collection and analysis of photographic data to calibrate tree-spacing functions; and (3) collection of field data to determine height, spacing, and shape of conifers in open and closed stands in the Goosenest (California) test area. Modification of the invertible model uses a linear approximation to correct for the reduction in shadow and canopy area that occurs when shadows fall on crowns or tree crowns intersect. Comparison of the results of the approximation with a series of Monte Carlo simulations shows that the mean area covered by crowns or shadows is approximated quite accurately, but the variance calculated departs significantly from simulated values. The analysis of tree spacing patterns using air photos showed that spacing tended to be somewhat regular at a scale approximately equal to the average distance between trees, but at larger distance scales counts of trees in cells could be approximated acceptably by a Poisson (random) function.

Strahler, A. H.↗

A Crustal Structure Study of South America

Variations in the average crustal thickness of the South American platform were determined by measuring fundamental mode Rayleigh wave dispersion between nine pairs of South American WWSSN seismograph stations and inverting the measurements to obtain average shear wave velocity-depth models across the platform. Additional models were derived from the Rayleigh wave dispersion data previously measured over eastern South America. Both sets of models were interpreted in terms of average crustal thickness and average crustal shear wave velocity. The results obtained were depicted in a contour map of crustal thickness. Average values for seismic velocities in the crust and upper mantle were calculated and compared with maps of regional gravity models, MAGSAT magnetic anomalies, and major tectonic features. The correlations and relationships discovered are discussed.

Renbarger, K. S.↗

Anisotropic models of the upper mantle

Long period Rayleigh wave and Love wave dispersion data, particularly for oceanic areas, were not simultaneously satisfied by an isotropic structure. Available phase and group velocity data are inverted by a procedure which includes the effects of transverse anisotropy, an elastic dispersion, sphericity, and gravity. The resulting models, for the average Earth, average ocean and oceanic regions divided according to the age of the ocean floor, are quite different from previous results which ignore the above effects. The models show a low velocity zone with age dependent anisotropy and velocities higher than derived in previous surface wave studies. The correspondence between the anisotropy variation with age and a physical model based on flow aligned olivine is suggested.

Regan, J.↗

Effects of voltage control in utility interactive dispersed storage and generation systems

When a small generator is connected to the distribution system, the voltage at the point of interconnection is determined largely by the system and not the generator. The effect on the generator, on the load voltage and on the distribution system of a number of different voltage control strategies in the generator is examined. Synchronous generators with three kinds of exciter control are considered, as well as induction generators and dc/ac inverters, with and without capacitor compensation. The effect of varying input power during operation (which may be experienced by generators based on renewable resources) is explored, as well as the effect of connecting and disconnecting the generator at ten percent of its rated power. Operation with a constant slightly lagging factor is shown to have some advantages.

Kirkham, H.↗

Maximization of Growth Rates During Czochralski Pulling

It was suggested from theory(1-4) that silicon can be grown from the melt at rates far exceeding the current state of the art. Previous theoretical and experimental investigations which predict maximum rates of pulling during Czochralski growth are reviewed. Several experimental methods are proposed to modify the temperature distribution in a growing crystal to achieve higher rates of pulling. A physical model of a Czochralski crystal of germanium in contact with its melt was used to quantitatively determine, by direct measurement of the axial temperature distribution in the solid, the increase in axial temperature gradients effected by an inverted conical heat reflector located above the melt and coaxially about the physical model. Preliminary results indicate that this is an effective method of increasing the thermal resistance between the hot melt and crucible wall and a growing crystal. Under these conditions the enhancement of the interfacial temperature gradients permit a commensurate increase in the rate of crystal pulling.

Wargo, M. J.↗

Asteroid Lightcurve Inversion

The application of convex profile inversion (CPI) to the interpretation of asteroid lightcurves is discussed. This technique investigates the problem of extracting information about an asteroid's shape from its lightcurve. Whenever four ideal conditions are met, P is an estimator for the asteroids mean cross section C, a convex set defined as the average of all cross sections C(Z) cut by planes a distance z above the asteroids equatorial plane. C is therefore a 2-D average of the asteroids 3-D shape. The method is tested by inverting lightcurves generated analytically for geometrically scattered ellipsoids (GSE's) with semiaxes a or = B or = C. Using a defined 'distance measure' to quantify the difference between any two profiles, the deviation of P from C for GSE's as a function of lightcurve noise level, rotation phase sampling interval delta theta, and departure from ideal conditions is calibrated. The distance between P and a circle provides a gauge of the asteroid's nonsphericity and incorporates all the information contained in the lightcurve.

Ostrow, S. J.↗

Possible observation of a disconnected magnetic structure in a coronal transient

Solar Maximum Mission coronagraph/polarimeter observations of the coronal transient of March 15-16, 1980, which show a bright front convex toward the sun propagating out through the corona at 175 km/sec, are reported. A fan-shaped bright region connecting this front to the inner corona collapses into a narrow, bright ray over the next few hours. These observations are interpreted as resulting from the disconnection of magnetic loops from the underlying prominencelike loop structures seen rising earlier in the event. Other similar inverted arches exist in the C/P data, but are usually seen with poorer temporal resolution.

Illing, R. M. E.↗

An implict LU scheme for the Euler equations applied to arbitrary cascades

An implicit scheme for solving the Euler equations is derived and demonstrated. The alternating-direction implicit (ADI) technique is modified, using two implicit-operator factors corresponding to lower-block-diagonal (L) or upper-block-diagonal (U) algebraic systems which can be easily inverted. The resulting LU scheme is implemented in finite-volume mode and applied to 2D subsonic and transonic cascade flows with differing degrees of geometric complexity. The results are presented graphically and found to be in good agreement with those of other numerical and analytical approaches. The LU method is also 2.0-3.4 times faster than ADI, suggesting its value in calculating 3D problems.

Buratynski, E. K.↗

Comparison of Yamato and Victoria Land polymict eucrites - A view from mineralogical and isotopic studies

New interior samples of four Yamato polymict eucrites (Y74159, Y74450, Y75011, and Y75015) have been studied by electron microprobe, transmission electron microscope, and X-ray diffraction techniques, and compared with several samples of the Victoria Land polymict eucrites. These same samples have been analysed using Rb-Sr and Nd-Sm isotopic systematics. Several grains of inverted pigeonite, with blebby augite similar to those in Binda and Moama, have been identified in all four Yamato eucrites. Coarse-grained meso-stasis-rich subophitic basalts, which contain Mg-rich pigeonite (with Fe-rich olivine veinlets) zoned outward to a subcalcic ferroaugite rims, have also been found. These unique clasts were not found in ALH76005, 77302, 78040, 7858, and 78165 and EET eucrites. The tight grouping of Rb/Sr and Sm/Nd ratos, and similar modal compositions of the Yamato group indicate that they are most likely to be pieces from a single fall, and distinct from the ALH and EET groups. However, the Yamato, Allan Hills, and Elephant Moraine groups may sample a few distinct magmas or similar but different source regions on the same parent body.

Takeda, H.↗

Inference of the aerosol Angstrom coefficient from SAGE short-wavelength data

SAGE four-channel transmission profiles are inverted to retrieve the extinction profiles from which the aerosol Angstrom coefficient alpha is obtained. The procedure allows one to check the influence of the NO2 absorption profile, which is small below 25 km. The results compare well with those obtained by a completely different procedure at NASA Langley Research Center, and the main features of the alpha profiles seem to be significant, even considering the rather large error bars. The relation between the retrieved Angstrom coefficient, the particle effective radius and the asymmetry factor is considered.

Lenoble, J.↗

Discharge characteristics of a simulated solar cell array

Measurements of the transient characteristics associated with the discharge of a simulated solar array are presented. A capacitively coupled probe is used to measure the discharge current, and antennas are used to measure the electromagnetic radiation. Discharges were observed at low surface voltages and several modes of discharge were observed. The maximum discharge current is found to be 0.2 A. This value is several orders of magnitude higher than that reported by previous measurements. Experimental evidence suggests that the inverted voltage gradient is a very likely triggering mechanism for solar array discharges.

Leung, P.↗

Inversion of vegetation canopy reflectance models for estimating agronomic variables. II - Use of angle transforms and error analysis as illustrated by Suits' model

The technique for inverting a vegetation canopy reflectance model described earlier (Goel and Strebel, 1983) is investigated further. The novel concept of an 'angle transform' is introduced. This concept allows the formation of functions of reflectances at different view zenith and azimuth angles, which are either sensitive or insensitive to a certain agronomic parameter. A proper combination of these functions can allow determination of all the important agronomic and spectral parameters from measured canopy reflectance data. The technique is demonstrated using Suits' (1972) model for homogeneous canopies. It is shown that leaf area index, leaf reflectance and transmittance, and average leaf angle all can be determined from the canopy reflectance at a set of selected view zenith and azimuth angles. A sensitivity analysis of the calculated values to the errors in the data is also carried out. Guidelines are formulated for the number and types of observations required to obtain the values of a particular canopy variable to within a given degree of accuracy for a given level of error in the measurement of canopy reflectance.

Goel, N. S.↗

Residential photovoltaic power conditioning technology for grid connected applications

Major advances in photovoltaic (PV) Power Conditioning (PC) with respect to performance and low-cost potential have been made. Solutions have been obtained to interface and control problems related to adapting available inverter designs to the grid-connected, residential photovoltaic experiments. A description is presented to contributing research and development activities. Attention is given to aspects of residential systems experience, conceptual design studies, questions of optimum topology development, and promising advanced designs for residential PV provided by development efforts of the private sector.

Key, T. S.↗

Pioneering in gravitational physiology

Gravity affects biology at almost all levels above that of the cell organelle. Attention is presently given to progress made in the understanding of gravitational effects through studies employing centrifuges, clinostats, inverted preparations, linear devices, water immersion, free fall, and short- and long-term spaceflight. The cardiovascular changes which cause malaise and illness during the first few days of extended space missions are the direct result of fluid translocation from the lower extremities. Upon reentry, there is hypovolumnia and a cardiovascular deconditioning that can include tachycardia, changes in arterial blood pressure, narrow pulse pressure, and syncope. Attention is also given to NASA's gravitational physiology reseach program.

Soffen, G. A.↗