Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Commanding”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 919 records · Page 51
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

VTOL controls for shipboard landing

The problem of landing a VTOL aircraft on a small ship in rough seas using an automatic controller is examined. The controller design uses the linear quadratic Gaussian results of modern control theory. Linear time invariant dynamic models are developed for the aircraft, ship, and wave motions. A hover controller commands the aircraft to track position and orientation of the ship deck using only low levels of control power. Commands for this task are generated by the solution of the steady state linear quadratic gaussian regulator problem. Analytical performance and control requirement tradeoffs are obtained. A landing controller commands the aircraft from stationary hover along a smooth, low control effort trajectory, to a touchdown on a predicted crest of ship motion. The design problem is formulated and solved as an approximate finite-time linear quadratic stochastic regulator. Performance and control results are found by Monte Carlo simulations.

Mcmuldroch, C. G.↗
NASA NTRS1979

Digital adaptive controllers for VTOL vehicles. Volume 1: Concept evaluation

A digital self-adaptive flight control system was developed for flight test in the VTOL approach and landing technology (VALT) research aircraft (a modified CH-47 helicopter). The control laws accept commands from an automatic on-board guidance system. The primary objective of the control laws is to provide good command-following with a minimum cross-axis response. Three attitudes and vertical velocity are separately commanded. Adaptation of the control laws is based on information from rate and attitude gyros and a vertical velocity measurement. The final design resulted from a comparison of two different adaptive concepts--one based on explicit parameter estimates from a real-time maximum-likelihood estimation algorithm, the other based on an implicit model reference adaptive system. The two designs were compared on the basis of performance and complexity.

Hartmann, G. L.↗
NASA NTRS1980

Equilibrium response of flight control systems

The steady-state behavior of an aircraft in response to control and disturbance inputs has a major impact on its performance and flying qualities, and it is, to a large extent, not readily predicted by the aircraft's stability and transient behavior. Singular as well as nonsingular response can result as a consequence of the command vector's definition, i.e., equilibrium in the command vector can imply disequilibrium in the state. The flight control structure can be modified to account for this characteristic, and it is shown that systems with identical eigenvalues and eigenvectors but dissimilar command vectors have markedly different responses.

Stengel, R. F.↗
NASA NTRS1981

Experimental results with a six-degree-of-freedom force-reflecting hand controller

Control experiments performed using an isotonic joystick connected to a six degree-of-freedom manipulator equipped with a six dimensional force-torque sensor at the base of the manipulator end effector are described. The preliminary control experiments were aimed at the investigation of the human operators' ability to command and control forces in different directions by varying the information conditions and the values of the feedforward and feedback command gains in the bilateral control loop. The main conclusions are: (1) a quantified graphic display of force-torque information can considerably enhance the operator's ability to perform a quantitatively sharp force-torque control, and (2) there seems to be a task dependent optimal combination of the feedforward and feedback command gain values which provide a dynamically smooth and stable bilateral control performance.

Bejczy, A. K.↗
NASA NTRS1981

A program to evaluate a control system based on feedback of aerodynamic pressure differentials

The use of aerodynamic pressure differentials to position a control surface is evaluated. The system is a differential pressure command loop, analogous to a position command loop, where the surface is commanded to move until a desired differential pressure across the surface is achieved. This type of control is more direct and accurate because it is the differential pressure which causes the control forces and moments. A frequency response test was performed in a low speed wind tunnel to measure the performance of the system. Both pressure and position feedback were tested. The pressure feedback performed as well as position feedback implying that the actuator, with a break frequency on the order of 10 Rad/sec, was the limiting component. Theoretical considerations indicate that aerodynamic lags will not appear below frequencies of 50 Rad/sec, or higher.

Levy, D. W.↗
NASA NTRS1982

Analysis of space telescope data collection system

An analysis of the expected performance for the Multiple Access (MA) system is provided. The analysis covers the expected bit error rate performance, the effects of synchronization loss, the problem of self-interference, and the problem of phase ambiguity. The problem of false acceptance of a command word due to data inversion is discussed. A mathematical determination of the probability of accepting an erroneous command word due to a data inversion is presented. The problem is examined for three cases: (1) a data inversion only, (2) a data inversion and a random error within the same command word, and a block (up to 256 48-bit words) containing both a data inversion and a random error.

Ingels, F. M.↗
NASA NTRS1981

Semantic definitions of space flight control center languages using the hierarchical graph technique

In this paper a method is described by which the semantic definitions of the Goddard Space Flight Control Center Command Languages can be specified. The semantic modeling facility used is an extension of the hierarchical graph technique, which has a major benefit of supporting a variety of data structures and a variety of control structures. It is particularly suited for the semantic descriptions of such types of languages where the detailed separation between the underlying operating system and the command language system is system dependent. These definitions were used in the definition of the Systems Test and Operation Language (STOL) of the Goddard Space Flight Center which is a command language that provides means for the user to communicate with payloads, application programs, and other ground system elements.

Zaghloul, M. E.↗
NASA NTRS1981

Space tracking and data systems; Proceedings of the Symposium, Arlington, VA, June 16-18, 1981

The AIAA/NASA Symposium on Space Tracking and Data Systems, held in Pentagon City, Virginia, on June 16-18, 1981, had the purpose of reviewing international activities in space tracking and data systems for civil use in the 1980-2000 time frame. Participants included 225 representatives from industrial and government organizations in eight nations. The nations represented include the United States, France, Germany, India, Japan, Norway, Spain, and Sweden. The major functions of the systems described at the Symposium are related to the initial downlink of telemetry and spacecraft status data, attendant tracking activities, and uplink of spacecraft commands; communication between the associated acquisition sites and central processing and control stations; formulation and implementation of commands that control the spacecraft and its payload; and processing of spacecraft data needed to make command decisions. Attention is given to an overview of current activities and plans, and supporting developments, taking into account the time from 1980 to 1990. New developments are also considered.

Grey, J.↗
NASA NTRS1982

Design and flight testing of a digital optimal control general aviation autopilot

This paper presents the designs of Proportional-Integral-Filter (PIF) autopilots for a General Aviation (NAVION) aircraft. The PIF autopilots use modern control theory to determine heading select and altitude select and hold autopilot modes. The PIF control law uses typical General Aviation sensors for state feedback; command error integration for command tracking; digital complimentary filtering and analog prefiltering for sensor noise suppression; a control filter for computation delay accommodation; and the incremental form to eliminate trim values in implementation. Theoretical developments for the control law are described which combine the sampled-data regulator with command generator tracking for use as a digital flight control system. The digital PIF autopilots are evaluated using closed-loop eigenvalues and simulations. Successful flight test results for the PIF autopilots are presented for different turbulence conditions and quadratic weights.

Broussard, J. R.↗
NASA NTRS1983

Simulator study of a flight director display

A six degree of freedom, fixed base simulation study of the use of a flight director by general aviation pilots in an instrument landing system approach was conducted. An autopilot command law was used to drive the flight director needles. Time histories of the pilot aircraft display system responses and standard deviations and means of the glide slope and localizer errors were obtained. The pilot aircraft display system responses with the flight director were very similar to the autopilot aircraft responses. Without the flight director, the pilot aircraft display system exhibited less damping than with the flight director. The sensitivity of the flight director command laws was judged to be about as high as it could be by the test subjects. Thus, further improvement in the pilot aircraft display system performance by increasing the gains in the command laws was precluded.

Adams, J. J.↗
NASA NTRS1983

An update on the use of the VLA for telemetry reception

An analysis is modified to incorporate the actual structure of the command signal system of the very large array (VLA). In particular, in addition to the 1-ms command signal there is a data invalid signal that is generated. The command signals are transmitted to the antennas during the period in which the data invalid signal is on. This means that the gaps in the received data are really 1.6 ms long rather than 1 ms long. Simulation results with this taken into account show that the VLA will not support (7, 1/2) convolutionally encoded telemetry at acceptable error rates at any of the Voyager telemetry data rates. VLA will support Voyager encounters provided that either concatenated coding is implemented, VLA is arrayed with another receiving site (such as Goldstone), or VLA is reconfigured so that the gaps are rotated.

Deutsch, L. J.↗
NASA NTRS1983

NASA/RAE collaboration on nonlinear control using the F-8C digital fly-by-wire aircraft

A cooperative advanced digital research experiment (CADRE) was established by the National Aeronautics and Space Administration (NASA) and the Royal Aircraft Establishment (RAE), in which nonlinear control algorithms developed by the RAE were tested on the F-8C digital fly-by-wire (DFBW) aircraft based at the Dryden Flight Research Facility. In the initial phase of the collaboration, some variable-gain algorithms, referred to collectively as variable integral control to optimize response (VICTOR) algorithms, were fight tested. With VICTOR, various measures available within the control system are used to vary gains and time-constants within the closed loop and thereby enhance the control capability of the system, while reducing the adverse effects of sensor noise on the control surfaces. A review of design procedures for VICTOR and results of preliminary flight tests are presented. the F-8C aircraft is operated in the remotely augmented vehicle (RAV) mode, with the control laws implemented as FORTRAN programs on a ground-based computer. Pilot commands and sensor information are telemetered to the ground, where the data are processed to form surface commands which are then telemetered to the ground, where the data are processed to form surface commands which are then telemetered back to the aircraft. The RAV mode represents a single-string (simplex) system and is therefore vulnerable to a hardover since comparison monitoring is not possible. Hence, extensive error checking is conducted on both the ground and airborne computers to prevent the development of potentially hazardous situations. Experience with the RAV monitoring and validation procedures is described.

Butler, G. F.↗
NASA NTRS1983

Control definition study for advanced vehicles

The low speed, high angle of attack flight mechanics of an advanced, canard-configured, supersonic tactical aircraft designed with moderate longitudinal relaxed static stability (Static Margin, SM = 16% C sub W at M = 0.4) was investigated. Control laws were developed for the longitudinal axis (""G'' or maneuver and angle of attack command systems) and for the lateral/directional axes. The performance of these control laws was examined in engineering simulation. A canard deflection/rate requirement study was performed as part of the ""G'' command law evaluation at low angles of attack. Simulated coupled maneuvers revealed the need for command limiters in all three aircraft axes to prevent departure from controlled flight. When modified with command/maneuver limiters, the control laws were shown to be adequate to prevent aircraft departure during aggressive air combat maneuvering.

Lapins, M.↗
NASA NTRS1984

Functional integration of vertical flight path and speed control using energy principles

A generalized automatic flight control system was developed which integrates all longitudinal flight path and speed control functions previously provided by a pitch autopilot and autothrottle. In this design, a net thrust command is computed based on total energy demand arising from both flight path and speed targets. The elevator command is computed based on the energy distribution error between flight path and speed. The engine control is configured to produce the commanded net thrust. The design incorporates control strategies and hierarchy to deal systematically and effectively with all aircraft operational requirements, control nonlinearities, and performance limits. Consistent decoupled maneuver control is achieved for all modes and flight conditions without outer loop gain schedules, control law submodes, or control function duplication.

Lambregts, A. A.↗
NASA NTRS1982

NASA Deep Space Network operating control

The primary function of the Deep Space Network (DSN) is to provide effective and reliable tracking and data acquisition for planetary and interplanetary space flight missions. This involves providing data to flight project mission operations, accepting commands from mission operations and transmitting the commands to stations and spacecraft, and providing a record of telemetry and command data to mission operations. Also included are network performance monitoring, the generation of predictions for antenna pointing and signal acquisition, network scheduling, and network validation tests. Descriptions are given of the three facilities and six systems of the DSN. Also described are interfaces, automation and standardized procedures, and discrepancy reporting. It is pointed out that the greatest challenge facing the DSN is the implementation of NASA's Network Consolidation Program, which is scheduled to be completed in 1986. The objectives of this program are enumerated.

Weisman, W. D.↗
NASA NTRS1985

Error and erasure probabilities for Galileo uplink code

The Galileo uplink Frame Erasure probability and Undetected Frame Error probability are derived. The performance meets desired specification under normal operations. The Galileo command system will work well even in an emergency condition, where the bit error rate into the command decoder is 1.00 X 0.001 (although Galileo's command threshold error rate is 1.00 X 0.00001).

Berner, J. B.↗
NASA NTRS1985

Experiences with a preliminary NICE/SPAR structural analysis system

Development of a new structural analysis system based on the original SPAR finite element code and the NICE system is described. The system is denoted NICE/SPAR. NICE was designed at Lockheed Palo Alto Research Laboratory and contains data management utilities, a command language interpreter, and a command language definition for integrating engineering computational modules. SPAR is a system of programs used for finite element structural analysis developed for NASA by Engineering Information Systems, Inc. It includes many complementary structural analysis and utility functions which communicate through a common database. The work on NICE/SPAR was motivated by requirements for a highly modular and flexible structural analysis system to use as a tool in carrying out research in computational methods and exploring new computer hardware. Analysis examples are presented which demonstrate the benefits gained from a combination of the NICE command language with the SPAR computational modules.

Lotts, C. G.↗
NASA NTRS1986

The interpretation of flying qualities requirements for flight control design

The flying requirements of MIL-F-8785(C) are interpreted in terms of command/response configurations, and pilot preference for flight control systems configurations of angle of attack, or pitch rate command, specified independently for the short period and phugoid dynamics, is determined using the Total-In-Flight-Simulator aircraft. The results show that for either command configuration, the short term response applies to the angle of attack response of the vehicle, and that this response must satisfy the omega(n) vs n/alpha requirement. The preference in the long term for angle of attack command indicates that the pilot wants the aircraft to fly in the direction it is pointing, and an attitude hold system is not found to be preferred unless attitude hold results in flight path angle hold.

Rynaski, E. G.↗