Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “BASS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 919 records · Page 51
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Interconnecting conductively coated coverslides

The International Sun Earth Explorer-1 has the requirement that the entire outer surface of the spacecraft be conductive. A transparent coating of indium oxide was deposited for that reason on the satellite's solar cell coverglasses in order to give them a conductive surface, and the surfaces were interconnected to ground. This paper examines the interconnector attachment problem. On the ISEE-1, wires were bonded to the coverglasses by using a conductive epoxy; the resistance of these bonds increased dramatically with time. A program was initiated to find the functional cause of the resistance increase and to flight-qualify an alternative method of bonding. It was found the tests initiated were insufficient to find the cause of resistance increase and that an alternative solution of using indium solder is acceptable for bonding wires directly to indium oxide.

Gaddy, E. M.↗
NASA NTRS1978

Ultraviolet effects on conductive coated coverglasses

Experiments on the International Sun-Earth Explorer required that the outer surface of the spacecraft be conductive. For the solar panels this was accomplished by using solar cell coverglasses coated with indium-oxide and interconnected to ground. This paper presents results of ultraviolet tests performed as part of the overall qualification program for cell assemblies using these coverglasses. The samples were exposed under vacuum at a controlled temperature to 5000 equivalent sun hours. Coverglass transmission curves and cell assembly current-voltage curves were measured before and after the test. Observed degradations were of the order of 1 percent more for conductively coated coverglasses than for coverglasses without conductive coatings.

Bass, J. A.↗
NASA NTRS1980

Coal conversion and synthetic-fuel production

Report evaluates potential coal gasification and synthetic-fuel production technologies for 1985 to 1990. Book includes overview of present and future technical and economic potential, ways of evaluating gasification facility designs, discussion of promising processes, characterization of potential markets, and list of available gasification systems.

Bradford, R.↗
NASA NTRS1979

Optical analysis of Cassegrainian concentrator systems

Cone optics procedures have been developed to treat optical systems employing multiple reflectors. The objective of the procedures is to develop efficient techniques to treat multiple reflections of cones when the secondary reflecting surface is curved - in fact, curved differently in different directions. The particular optical system under consideration is the Cassegrainian Concentrator System - a system consisting of a paraboloidal primary reflector and a confocal hyperboloidal secondary reflector. Multiple reflection cone optics methodology as well as preliminary results for the flux distributions and intercept factors based on it are presented in this paper. It is shown that neglecting local curvature effects of the secondary reflector, i.e. even in the differential solid angle within the sun's cone, may overestimate the peak of the flux distribution at the receiver aperture by a factor of two or more.

Bass, A. H., Jr.↗
NASA NTRS1984

Solar-array-materials passive LDEF experiment (A0171)

The objective of this experiment is to evaluate the synergistic effects of the space environment on various solar-array materials, including solar cells, cover slips with various antireflectance coatings, adhesive, encapsulants, reflector materials, substrate strength materials, mast and harness materials, structural composites, and thermal control treatments. The experiment is passive and consists of an arrangement of material specimens mounted in a 3-in.-deep peripheral tray. The effects of the space environment on the specimens will be determined by comparison of preflight and postflight measurements of mechanical, electrical, and optical properties.

Whitaker, A. F.↗
NASA NTRS1982

Applications of aerospace technology in biology and medicine

Utilization of National Aeronautics and Space Administration (NASA) technology in medicine is discussed. The objective is best obtained by stimulation of the introduction of new or improved commercially available medical products incorporating aerospace technology. A bipolar donor/recipient model of medical technology transfer is presented to provide a basis for the team's methodology. That methodology is designed to: (1) identify medical problems and NASA technology that, in combination, constitute opportunities for successful medical products; (2) obtain the early participation of industry in the transfer process; and (3) obtain acceptance by the medical community of new medical products based on NASA technology. Two commercial transfers were completed: the Stowaway, a lightweight wheelchair that provides mobility for the disabled and elderly in the cabin of commercial aircraft, and Micromed, a portable medication infusion pump for the reliable, continuous infusion of medications such as heparin or insulin. The marketing and manufacturing factors critical to the commercialization of the lightweight walker incorporating composite materials were studied. Progress was made in the development and commercialization of each of the 18 currently active projects.

Bass, B.↗
NASA NTRS1986

Transition region of the earth's upper mantle

The chemistry of the earth's mantle is discussed using data from cosmochemistry, geochemistry, petrology, seismology, and mineral physics. The chondritic earth, the upper mantle and the 400-km discontinuity, the transition region, lower mantle mineralogy, and surface wave tomography are examined. Three main issues are addressed: (1) whether the mantle is homogeneous in composition or chemically stratified, (2) whether the major element chemistry of the mantle is more similar to upper mantle peridotites or to chondrites, and (3) the nature of the composition of the source region of basalts erupted at midocean ridges.

Anderson, D. L.↗
NASA NTRS1985

Results from the Balloon Ozone Intercomparison Campaign (BOIC)

In the Balloon Ozone Intercomparison Campaign (BOIC), several in situ UV absorption photometers, two solar UV absorption photometers, electrochemical sondes, and a mass spectrometer were intercompared in three flight missions. Concurrent data from Umkehr and satellite observations are also intercompared. The National Bureau of Standards provided a 'standard' ozone source for intercomparing the in situ instruments and ground pressure. Preliminary findings indicate that the standard deviation of the sensitivities among 17 instruments against the NBS reference was about 11 percent. These differences appear in flight at the lower levels and change at higher altitudes, indicating height-dependent errors. The difference among five in-situ UV photometers flown together ranged by plus or minus 8 percent during ascent to about 41 km. During float at 42 km, the difference nearly doubled. During descent, the difference decreased to about 4 percent, which is much closer to the expected accuracy of these instruments. Results from UV solar radiometers have been systematically higher than those from UV photometers by 15 to 20 percent - a very important disagreement that needs to be resolved.

Hilsenrath, E.↗
NASA NTRS1985

The ultraviolet cross-sections of ozone. I. The measurements. II - Results and temperature dependence

Absorption cross-sections of ozone have been measured over the range 230 nm to 350 nm, and for temperatures 200 K to 300 K, with improved photometric accuracy and spectral resolution. These measurements are referred to the cross-section at the 253.65 nm mercury line by the Hearn value (1961), 1147 x 10 to the -20th/sq cm, and show an internal consistency of + or - 1 percent. Tables of ozone absorption cross-section in the ultraviolet have been prepared for intervals of 0.05 nm over the range 245 to 340 nm. at each wavelength entry in the table a set of coefficients has been derived that permits the cross-section to be computed as a function of temperature, between 200 K and 300 K, with an accuracy of 1 percent.

Bass, A. M.↗
NASA NTRS1987

Polyenamines for Films, Coatings, and Adhesives

Easy process makes polymers with good mechanical properties. Synthesis involves Michael-type addition polymerization of two diacetylenic diketones, with various aromatic diamines in m-cresol at 60 to 130 degrees C. Technique provides synthetic route to high-molecular-weight polyenamines with moderate thermal stability and good mechanical properties. Polyenamines produced exhibit potential for use as films, coatings, adhesives, molding compounds, and composite matrices.

Hergenrother, Paul M.↗
NASA NTRS1987

Polyenamines from aromatic diacetylenic diketones and diamines

The synthesis and characterization of several polyenamine ketones are discussed wherein conjugated diacetylenic diketones and aromatic diamines are used as a route to the formation of high molecular weight polyenamine ketones which exhibit good mechanical properties and can be cast into creasible films. Typical polymerization conditions involved the reaction of stoichiometric amounts of 1,4- or 1,3-PPPO and a diamine at 60 to 130 C in m-cresol at (w/w) solids content of 8 to 26% for a specified period of time under a nitrogen atmosphere. Novel polyenamine ketones were prepared with inherent viscosities as high as 1.99 dl/g and tough, clear amber films with tensile strengths of 12,400 psi and tensile moduli of 397,000 psi were cast from solutions of the polymers in chloroform. In most cases, the elemental analyses for the polyenamine ketones agree within + or - 0.3% of the theoretical values.

Hergenrother, Paul M.↗
NASA NTRS1986

Synthesis of thermally stable polypyrazoles, polypyrimidines and other heteroaromatic polymers

As part of a continuing effort to prepare high performance-high temperature polymers for functional and structural applications, the reactions of aromatic dipropynones with aromatic dihydrazine, aromatic dithiols, and aromatic diamidines to provide polypyrazoles, polyenonesulfides, and polypyrimidines respectively were investigated. During the past year, it was demonstrated that polypyrazoles and polyenonesulfides may be prepared by the proposed procedures. However, the preparation of polypyrimidines was not achieved. The preparation and characterization of some polypyrazolones by reaction or aromatic dihydrazines with an activated diacetylenic diester was achieved.

Bass, R. G.↗
NASA NTRS1986

Results from the Balloon Ozone Intercomparison Campaign (BOIC)

Data from the BOIC which consisted of three balloon missions conducted in Palestine, Texas from June 1983 to March 1984 are presented. The BOIC was to assess the ability to perform ozone measurements from balloon platforms. The accuracy and precision of the various ozone measurement systems, which were composed of a photometer, a mass spectrometer, and solar UV absorption sensors, are evaluated. The ozone observations obtained with the instruments on the three flight missions are analyzed and intercompared. The flight in situ data are also compared to the National Bureau of Standards reference photometer, satellite measurements, and under simulated stratospheric pressure and ozone concentrations.

Hilsenrath, E.↗
NASA NTRS1987

The melting curve of iron to 250 gigapascals - A constraint on the temperature at earth's center

The melting curve of iron, the primary constituent of earth's core, has been measured to pressures of 250 gigapascals with a combination of static and dynamic techniques. The melting temperature of iron at the pressure of the core-mantle boundary (136 GPa) is 4800 + or - 200 K, whereas at the inner core-outer core boundary (330 GPa), it is 7600 + or - 500 K. A melting temperature for iron-rich alloy of 6600 K at the inner core-outer core boundary and a maximum temperature of 6900 K at earth's center are inferred. This latter value is the first experimental upper bound on the temperature at earth's center, and these results imply that the temperature of the lower mantle is significantly less than that of the outer core.

Williams, Quentin↗
NASA NTRS1987

Heuristic control of the Utah/MIT dextrous robot hand

Basic hand grips and sensor interactions that a dextrous robot hand will need as part of the operation of an EVA Retriever are analyzed. What is to be done with a dextrous robot hand is examined along with how such a complex machine might be controlled. It was assumed throughout that an anthropomorphic robot hand should perform tasks just as a human would; i.e., the most efficient approach to developing control strategies for the hand would be to model actual hand actions and do the same tasks in the same ways. Therefore, basic hand grips that human hands perform, as well as hand grip action were analyzed. It was also important to examine what is termed sensor fusion. This is the integration of various disparate sensor feedback paths. These feedback paths can be spatially and temporally separated, as well as, of different sensor types. Neural networks are seen as a means of integrating these varied sensor inputs and types. Basic heuristics of hand actions and grips were developed. These heuristics offer promise of control dextrous robot hands in a more natural and efficient way.

Bass, Andrew H., Jr.↗
NASA NTRS1988

Applications of elastic-viscoplastic constitutive models in dynamic analyses of crack run-arrest events

Applications of nonlinear techniques to the first series of six HSST wide-plate crack-arrest tests that were performed are described. The experiments include crack initiations at low temperatures and relatively long (20 cm) cleavage propagation phases which are terminated by arrest in high temperature regions. Crack arrest are then followed by ductile tearing events. Consequently, the crack front regions are exposed to wide ranges of strain rates and temperatures.

Bass, B. R.↗