Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Aviation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 919 records · Page 51

Wind-Tunnel Investigation of a Full-Scale Canard-Configured General Aviation Airplane

An investigation was conducted in the Langley 30- by 60-Foot Tunnel to determine the aerodynamic characteristics of a powered, full-scale model of a general aviation airplane employing a canard. Although primary emphasis of the investigation was placed on evaluating the aerodynamic performance and the stability and control characteristics of the basic configuration, tests were also conducted to study the following effects of varying the basic configuration: effect of Reynolds number; effect of canard; effect of outboard wing leading-edge droop; effect of center-of-gravity location; effect of elevator trim; effect of landing gear; effect of lateral-directional control; effect of power; effect of fixed transition; effect of water spray; effects of canard incidence, canard airfoil section, and canard position; and effects of winglets and upper winglet size. Additional aspects of the study were to determine the boundary-layer transition characteristics of airfoil surfaces and the effect of fixing the boundary layer to be turbulent by means of a transition strip near the leading edge. The tests were conducted at Reynolds numbers from 0.60 x 10 to the 6th power to 2.25x10 to the 6th power, based on the wing mean aerodynamic chord, at angles of attack from -4.5 deg to 41.5 deg, and at angles of sideslip from -15 deg to 15 deg.

Yip, L. P.↗

Disturbance to the population due to flight operations at landing fields. Questionnaire on community reaction to non-commercial and sporting aviation

A field study was undertaken to determine the Sociopsychological effects of air traffic noise experienced by residents of areas near small sporting aviation fields. A questionaire was prepared which includes questions on flight restriction measures, on attitudes which moderate annoyance and on comparisons with other noise sources, etc.

Rohrmann, B.↗

Simulator study of the stall departure characteristics of a light general aviation airplane with and without a wing-leading-edge modification

A six-degree-of-freedom nonlinear simulation was developed for a two-place, single-engine, low-wing general aviation airplane for the stall and initial departure regions of flight. Two configurations, one with and one without an outboard wing-leading-edge modification, were modeled. The math models developed are presented simulation predictions and flight-test data for validation purposes and simulation results for the two configurations for various maneuvers and power settings are compared to show the beneficial influence of adding the wing-leading-edge modification.

Riley, D. R.↗

Designing systems to satisfy their users - The coming changes in aviation weather and the development of a central weather processor

Attention is given to the development history of the Central Weather Processor (CWP) program of the Federal Aviation Administration. The CWP will interface with high speed digital communications links, accept data and information products from new sources, generate data processing products, and provide meteorologists with the capability to automate data retrieval and dissemination. The CWP's users are operational (air traffic controllers, meteorologists and pilots), institutional (logistics, maintenance, testing and evaluation personnel), and administrative.

Bush, M. W.↗

Aircraft noise annoyance at three joint air carrier and general aviation airports

The results of social surveys conducted near three airports that support both general aviation and scheduled air carrier operations are presented and discussed. Inferences supported by these data include: (1) the nature of noise exposure and community reaction at smaller airports may differ from that at larger airports; (2) survey techniques are capable of identifying changes in annoyance associated with numerically small changes in noise exposure; (3) changes in the prevalence of annoyance are causally produced by changes in noise exposure; and (4) changes in annoyance associated with changes in exposure vary with time.

Fidell, S.↗

General aviation's meteorological requirements

Communication of weather theory and information about weather service products to pilots in an accurate and comprehensible manner is essential to flying safety in general. Probably no one needs weather knowledge more than the people who fly through it. The specific subject of this overview is General Aviation's Meteorological Requirements.

Newton, D.↗

Adverse weather impact on aviation safety, investigation and oversight

A brief review of the weather factors that effect aviation safety with respect to U.S. Coast Guard operations is presented. Precise meteorological information is an absolute necessity to the Coast Guard which must conduct life saving and rescue operations under the worst of weather conditions. Many times the weather conditions in which they operate are the cause of or a contributing factor to the predicament from which they must execute a rescue operation.

Smith, M. J.↗

Chinese space and aviation industries score major breakthroughs

An overview of the current status of China's aviation and aerospace industries is presented, as well as planned future development and areas of importance for China's future space programs. The development of China's CZ-1, CZ-2 and CZ-3 rocket program is discussed, as well as China's satellite launch capabilities. China's first geostationary communications satellite STW-1 is also mentioned, and further development of the second and third communications satellites to be launched in 1987 are shown. Other developments include a seventh low Earth orbiting photographic reconnaissance satellite, plans for an image transmitting remote sensing satellite to be launched in 1988 to 1990, and other satellite developments. The Chinese-designed Y-10 transport aircraft is discussed, as well as the TU-16 bomber aircraft and the co-production agreement with McDonnell Douglas for the MD-82 passenger aircraft.

Hu, R.↗

Weight estimation techniques for composite airplanes in general aviation industry

Currently available weight estimation methods for general aviation airplanes were investigated. New equations with explicit material properties were developed for the weight estimation of aircraft components such as wing, fuselage and empennage. Regression analysis was applied to the basic equations for a data base of twelve airplanes to determine the coefficients. The resulting equations can be used to predict the component weights of either metallic or composite airplanes.

Paramasivam, T.↗

Long term deposit formation in aviation turbine fuel at elevated temperature

An experimental characterization is conducted for the relationships between deposit mass, operating time, and temperature, in coking associated with aviation fuels under conditions simulating those typical of turbine engine fuel systems. Jet A and Suntech A fuels were tested in stainless steel tubing heated to 420-750 K, over test durations of between 3 and 730 hr and at fuel velocities of 0.07-1.3 m/sec. Deposit rates are noted to be a strong function of tube temperature; for a given set of test conditions, deposition rates for Suntech A exceed those of Jet A by a factor of 10. Deposition rates increased markedly with test duration for both fuels. The heated tube data obtained are used to develop a global chemical kinetic model for fuel oxidation and carbon deposition.

Giovanetti, A. J.↗

Development of spin resistance criteria for light general aviation airplanes

A brief history of stall/spin technology for light general aviation airplanes is presented. Criteria needed to describe desirable characteristics of a spin-resistant airplane and means to evaluate airplanes for compliance with the criteria have been developed. Initial results from limited flight tests of an experimental high-wing airplane indicated that the basic configuration would not meet the spin resistance criteria. Further tests with the airplane modified to enhance its spin resistance are planned.

Dicarlo, D. J.↗

Upper air forecasting for aviation in the United States

It is shown that the present forecast models used in the aviation digital forecast (ADF) product for automated flight planning in the U.S. did not improve in accuracy and precision over the past two decades. A new approach to the upper air forecasting is presented in the NASA/NOAA MERIT project. In MERIT, a concept of a tailored analysis is used, based on a high density automated aircraft report database (including radiosonde and satellite data), producing an accurate and precise description of the initial state of the atmosphere, and a relatively simple forecast model to move the forecast forward in time. The steadily updated 2-12 h forecasts provided every 3 h will be more efficient and accurate than the present 18 and 24 h forecasts provided every 12 hours.

Steinberg, R.↗

Wind-tunnel investigation of the flight characteristics of a canard general-aviation airplane configuration

A 0.36-scale model of a canard general-aviation airplane with a single pusher propeller and winglets was tested in the Langley 30- by 60-Foot Wind Tunnel to determine the static and dynamic stability and control and free-flight behavior of the configuration. Model variables made testing of the model possible with the canard in high and low positions, with increased winglet area, with outboard wing leading-edge droop, with fuselage-mounted vertical fin and rudder, with enlarged rudders, with dual deflecting rudders, and with ailerons mounted closer to the wing tips. The basic model exhibited generally good longitudinal and lateral stability and control characteristics. The removal of an outboard leading-edge droop degraded roll damping and produced lightly damped roll (wing rock) oscillations. In general, the model exhibited very stable dihedral effect but weak directional stability. Rudder and aileron control power were sufficiently adequate for control of most flight conditions, but appeared to be relatively weak for maneuvering compared with those of more conventionally configured models.

Satran, D. R.↗

Atmospheric Turbulence Relative to Aviation, Missile, and Space Programs

The purpose of the workshop was to bring together various disciplines of the aviation, missile, and space programs involved in predicting, measuring, modeling, and understanding the processes of atmospheric turbulence. Working committees re-examined the current state of knowledge, identified present and future needs, and documented and prioritized integrated and cooperative research programs.

Camp, Dennis W.↗

Comments on the problem of turbulence in aviation

The problem of turbulence since the beginning of aviation is traced. The problem was not cured by high altitude flight and was acerbated by the downbursts associated with thunderstorms. The accidents that occurred during the period 1982 to 1984 are listed. From this is extracted the weather related accidents. Turbulence accounts for 24% of the accidents involving large commercial carriers and 54% of the weather related accidents. In spite of all the efforts to improve the forecasting and detection of turbulence, the problem is still a large one.

Mclean, James C., Jr.↗

Measurement of the effect of manufacturing deviations on natural laminar flow for a single engine general aviation airplane

Renewed interest in natural laminar flow (NLF) had rekindled designer concern that manufacuring deviations may destroy the effectiveness of NLF for an operational aircraft. Experiments are summarized that attemtped to measure total drag changes associated with three different wing surface conditions on an aircraft typical of current general aviation high performance singles. The speed power technique was first used in an attempt to quantify the changes in total drag. Predicted and measured boundary layer transition locations for three different wing surface conditions were also compared, using two different forms of flow visualization. The three flight test phases included: assessment of an unpainted airframe, flight tests of the same aircraft after painstakingly filling and sanding the wings to design contours, and similar measurement after this aricraft was painted. In each flight phase, transition locations were monitored using with sublimating chemicals or pigmented oil. Two-dimensional drag coefficients were estimated using the Eppler-Somers code and measured with a wake rake in a method very similar to Jones' pitot traverse method. The net change in two-dimensional drag coefficient was approximately 20 counts between the unpainted aircraft and the hand-smoothed aircraft for typical cruise flight conditions.

Source record↗

Exploratory wind-tunnel investigation of the stability and control characteristics of advanced general aviation configurations

Results of low-speed wind-tunnel investigations are presented for two general aviation configurations: the AVTEK canard configuration and the DeVore conventional configuration. Cooperative research programs were undertaken by industry and NASA to jointly conduct tests in the NASA Langley 12-Foot Low-Speed Wind Tunnel to explore stability and control characteristics of each configuration. A 1/5-scale AVTEK model and a 1/6-scale DeVore model were tested over an angle-of-attack range of up to 45 deg and an angle-of-sideslip range of up to 20 deg. Results from the AVTEK test are presented with an emphasis on the effects of configuration on the stall and poststall characteristics. Results from the DeVore test are presented with emphasis on the effects of wing leading-edge droop design on spin resistance characteristics.

Yip, L. P.↗