Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “pressure”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 901 records · Page 50

Atmospheric-pressure glow plasma synthesis of plasmonic and photoluminescent zinc oxide nanocrystals

In this paper, we present a large-volume (non-micro) atmospheric pressure glow plasma capable of rapid, large-scale zinc oxide nanocrystal synthesis and deposition (up to 400 μg/min), whereas in the majority of the literature, nanoparticles are synthesized using micro-scale or filamentary plasmas. The reactor is an RF dielectric barrier discharge with a non-uniform gap spacing. This design encourages pre-ionization during the plasma breakdown, making the discharge uniform over a large volume. The produced zinc oxide nanocrystals typically have diameters ranging from 4 to 15 nm and exhibit photoluminescence at ≈550 nm and localized surface plasmon resonance at ≈1900 cm{sup −1} due to oxygen vacancies. The particle size can be tuned to a degree by varying the gas temperature and the precursor mixing ratio.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Design and characterization of a solar-enhanced microwave plasma reactor for atmospheric pressure carbon dioxide decomposition

The decomposition of carbon dioxide (CO 2 ) is a main step in carbon re-utilization approaches aimed to fulfill fuels and chemicals demands and mitigate environmental emissions. Plasmachemical CO 2 decomposition processes can be highly efficient; however, their reliance on electrical energy can limit their economic viability and sustainability advantage. In contrast, solar thermochemical CO 2 decomposition approaches can have limited efficiency, but their direct use of the most abundant form of renewable energy affords them the greatest sustainability potential. Solar-Enhanced Microwave Plasma (SEMP) chemical synthesis, based on the direct interaction between microwave plasma and concentrated solar radiation, is investigated as a novel approach to combine the advantages of plasmachemical and solar thermochemical processes. SEMP is motivated by the potential for synergistic effects between solar photons and plasma species, implied by the markedly greater spectral absorption of nonequilibrium CO 2 plasma compared to that of equilibrium CO 2 , to lead to enhanced chemical decomposition. The design, development, and characterization of a SEMP reactor for atmospheric pressure CO 2 decomposition is presented. The reactor is powered by a 1.25 kW magnetron and by up to 525 W of incident radiative power from a high-flux solar simulator. Experimental results reveal that the microwave plasma absorbs up to 20% of concentrated solar radiation at a solar-to-electrical power ratio of 0.5, and that relative absorption decreases with increasing solar input power. Yet, conversion efficiency and plasma energy efficiency increase with increasing solar power, up to 9% and 25% respectively, for a solar-to-electrical power ratio of 0.75. The enhanced process performance appears to be a consequence of the greater power density in the plasma caused by the direct absorption of solar radiation.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Ion fluxes and memory effects in an Ar–O 2 modulated radiofrequency-driven atmospheric pressure plasma jet

In this work we used molecular beam mass spectrometry to characterize ion fluxes produced by a modulated radiofrequency (RF)-driven atmospheric pressure plasma jet operating in a homogeneous gas environment (Ar + 1% O 2 ). The influence of the RF modulation frequency (100 Hz to 20 kHz) on the ion fluxes was investigated by time-resolved measurements, and the lifetimes of the dominant ions, O 2 + , NO + , O − , O 2 − and O 3 − , were found to be 28 ± 2, 117 ± 8, 7.3 ± 0.4, 17 ± 1 and 23 ± 2 μs, respectively. The absolute ion densities in the near afterglow region were found to be of the order of 1011 cm−3. Significant differences in the dynamics of the positive and negative ions were found; these are explained by the presence of electrons at similar densities in the afterglow produced by electron detachment reactions from negative ions due to the large concentrations of atomic oxygen and singlet delta oxygen. Transitions in ion flux dynamics for different modulation frequencies and at the startup of the plasma were analyzed together with intensified charge coupled device images recording the plasma propagation in order to assess the dynamics of plasma plume propagation and how it is impacted by ‘memory effects’. Quantitative measurements of the ion densities enabling these memory effects are reported. The results in this paper highlight the tremendous impact of memory effects on plasma propagation and the corresponding pre-ionization.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Origin of Pressure-Induced Polyamorphism in Ce[subscript 75]Al[subscript 25] Metallic Glass

Using high-pressure synchrotron x-ray absorption spectroscopy, we observed the Ce 4f electron in Ce{sub 75}Al{sub 25} metallic glass transform from its ambient localized state to an itinerant state above 5 GPa. A parallel x-ray diffraction study revealed a volume collapse of about 8.6%, coinciding with 4f delocalization. The transition started from a low-density state below 1.5 GPa, went through continuous densification ending with a high-density state above 5 GPa. This new type of electronic polyamorphism in densely packed metallic glass is dictated by the Ce constituent, and is fundamentally distinct from the well-established structural polyamorphism in which densification is caused by coordination change and atomic rearrangement.

36 MATERIALS SCIENCE↗

Methodology for Stress-Controlled Fatigue Test Under In-Air and Pressurized Water Reactor Coolant Water Condition and to Evaluate the Effect of Pressurized Water Reactor Water and Loading Rate on Ratcheting [Methodology for Stress-Controlled Fatigue Test Under In-Air and PWR Coolant Water Condition and to Evaluate the Effect of PWR Water and Loading Rate on Ratcheting]

Here, this work investigates the behavior of 316 stainless steel (SS) under stress-controlled low cycle fatigue loading. Several fatigue experiments are conducted under different environment such as in air at 300°C and primary loop water conditions for a pressurized water reactor (PWR). Two different loading conditions are also employed to examine the effect of stress rate on material hardening and ratcheting. During PWR water test, actuator position measurements are used to determine the strain of the specimen. Under PWR environment, 316 SS is found to ratchet to a significantly greater degree compared with in air. At slow stress rate, higher amount of cyclic hardening is observed in 316 SS, and slow stress rate increases the rate of ratcheting. Results also indicate that 316 SS exhibits asymptotic strain response at higher stress loading which can cause material to behave very differently under same stress cyclic loading.

22 GENERAL STUDIES OF NUCLEAR REACTORS↗

Magnetically applied pressure-shear : a new technique for direct strength measurement at high pressure (final report for LDRD project 117856).

A new experimental technique to measure material shear strength at high pressures has been developed for use on magneto-hydrodynamic (MHD) drive pulsed power platforms. By applying an external static magnetic field to the sample region, the MHD drive directly induces a shear stress wave in addition to the usual longitudinal stress wave. Strength is probed by passing this shear wave through a sample material where the transmissible shear stress is limited to the sample strength. The magnitude of the transmitted shear wave is measured via a transverse VISAR system from which the sample strength is determined.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Evaluation on the Feasibility of Using Ultrasonic Testing of Reactor Pressure Vessel Welds for Assessing Flaw Density/Distribution per 10 CFR 50.61a, Alternate Fracture Toughness Requirements for Protection Against Pressurized Thermal Shock

This technical letter report provides the status of an assessment undertaken by PNNL at the request of the NRC to verify the capability of periodic ASME-required volumetric examinations of reactor vessels to characterize the density and distribution of flaws of interest for applying §50.61a on a plant-by-plant basis. The PTS rule, described in the Code of Federal Regulations, Title 10, Section 50.61 (§50.61), "Fracture Toughness Requirements for Protection against Pressurized Thermal Shock Events," establishes screening criteria to ensure that the potential for a reactor vessel to fail due to a PTS event is deemed to be acceptably low. Recently, the NRC completed a research program that concluded that the risk of through-wall cracking due to a PTS event is much lower than previously estimated. The NRC subsequently developed and promulgated an alternate PTS rule, §50.61a, that can be implemented by PWR licensees. The §50.61a rule differs from §50.61 in that it requires licensees who choose to follow this alternate method to analyze the results from periodic volumetric examinations required by the ASME Code, Section XI, Rules for Inservice Inspection (ISI) of Nuclear Power Plants.

alternate PTS rule↗

Atmospheric pressure chemical ionization of fluorinated phenols in atmospheric pressure chemical ionization mass spectrometry, tandem mass spectrometry, and ion mobility spectrometry

Atmospheric pressure chemical ionization (APCI)-mass spectrometry (MS) for fluorinated phenols (C6H5-xFxOH Where x = 0-5) in nitrogen with Cl- as the reagent ion yielded product ions of M Cl- through ion associations or (M-H)- through proton abstractions. Proton abstraction was controllable by potentials on the orifice and first lens, suggesting that some proton abstraction occurs through collision induced dissociation (CID) in the interface region. This was proven using CID of adduct ions (M Cl-) with Q2 studies where adduct ions were dissociated to Cl- or proton abstracted to (M-H)-. The extent of proton abstraction depended upon ion energy and structure in order of calculated acidities: pentafluorophenol > tetrafluorophenol > trifluorophenol > difluorophenol. Little or no proton abstraction occurred for fluorophenol, phenol, or benzyl alcohol analogs. Ion mobility spectrometry was used to determine if proton abstraction reactions passed through an adduct intermediate with thermalized ions and mobility spectra for all chemicals were obtained from 25 to 200 degrees C. Proton abstraction from M Cl- was not observed at any temperature for phenol, monofluorophenol, or difluorophenol. Mobility spectra for trifluorophenol revealed the kinetic transformations to (M-H)- either from M Cl- or from M2 Cl- directly. Proton abstraction was the predominant reaction for tetra- and penta-fluorophenols. Consequently, the evidence suggests that proton abstraction occurs from an adduct ion where the reaction barrier is reduced with increasing acidity of the O-H bond in C6H5-xFxOH.

NASA Discipline Environmental Health↗

Analysis of the Ion Conversion Mechanisms in the Effluent of Atmospheric Pressure Plasma Jets in Ar with Admixtures of O 2 , H 2 O and Air

Ionic species in atmospheric pressure plasma jets (APPJs) play an important role in plasmasurface and plasma-liquid interactions, nonetheless, they have not received the same attention as their neutral reactive species counterparts. In this work, a molecular beam mass spectrometer (MBMS) was used to characterize the ion compositions in the effluent of an APPJ operating in ambient air for different feed gases including Ar + O 2 , Ar + air and Ar + H 2 O mixtures inspired by gas compositions used for biomedical applications. Changes in compositions of positive and negative ions as a function of nozzle-to-substrate distance along the plasma plume were analyzed and compared with a pseudo-1D plug flow model. Positive and negative ions were detected up to distances of 12 mm from the visible plasma plume tip. The measurements enable to follow the ion conversion pathways in the effluent of the APPJs as a function of distance from the nozzle. The trends in ion yield obtained from a pseudo-1D plug flow model showed generally a good agreement with the experimentally observed trends after addition of ionic reactions to the previously reported reaction set but also some distinctive differences were observed. The dominant positive ions in the far effluent are water ion clusters, the most stable ion for all gas mixtures investigated, while a large variety of negative ions was found for different gas mixtures.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗