Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “ALKANE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 901 records · Page 50
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Analysis of steranes and triterpanes in geolipid extracts by automatic classification of mass spectra

A computer method is described for the automatic classification of triterpanes and steranes into gross structural type from their mass spectral characteristics. The method has been applied to the spectra obtained by gas-chromatographic/mass-spectroscopic analysis of two mixtures of standards and of hydrocarbon fractions isolated from Green River and Messel oil shales. Almost all of the steranes and triterpanes identified previously in both shales were classified, in addition to a number of new components. The results indicate that classification of such alkanes is possible with a laboratory computer system. The method has application to diagenesis and maturation studies as well as to oil/oil and oil/source rock correlations in which rapid screening of large numbers of samples is required.

Wardroper, A. M. K.↗
NASA NTRS1977

Thermal alteration experiments on organic matter from recent marine sediments in relation to petroleum genesis

Three fractions of organic matter: lipid (benzene:methanol-extractable), humic acid (alkali-extractable) and kerogen (residue) were extracted from a young marine sediment (Tanner Basin, offshore southern California) and heated for different times (5-116 hr) and temperatures (150-410 C). The volatile (gases) and liquid products, as well as residual material, were then analyzed. On a weight basis, the lipid fraction produced 58% of the total identified n-alkanes, the kerogen fraction 41%, and the humic acid less than 1%. The volatiles produced by heating the lipid and humic acid fractions were largely CO2 and water, whereas those produced from heated kerogen also included methane, hydrogen gas and small amounts of C2-C4 hydrocarbons. A mechanism for hydrocarbon production due to the thermal alteration of organic constituents of marine sediment is discussed.

Ishiwatari, R.↗
NASA NTRS1977

Origin of organic matter in the early solar system. VII - The organic polymer in carbonaceous chondrites

Degradation techniques, including pyrolysis, depolymerization, and oxidation, were used to study the insoluble polymer from the Murchison C2 chondrite. Oxidation with Cr2O7(2-) or O2/UV led to the identification of 15 aromatic ring systems. Of 11 aliphatic acids identified, three dicarboxylic acids presumably came from hydroaromatic portions of the polymer, whereas eight monocarboxylic acids probably derive from bridging groups or ring substituents. Depolymerization with CF3COO4 yielded some of the same ring systems, as well as alkanes (C1 through C8) and alkenes (C2 through C8), alkyl (C1 through C5) benzenes and naphthalenes, and methyl- or dimethyl -indene, -indane, -phenol, -pyrrole, and -pyridine. All these compounds were detected below 200 C, and are therefore probably indigenous constituents. The properties of the meteoritic polymer were compared with the properties of a synthetic polymer produced by the Fischer-Tropsch reaction. It is suggested that the meteoritic polymer was also produced by surface catalysis.

Hayatsu, R.↗
NASA NTRS1978

Mass spectrometer calibration standard

Inert perfluorinated alkane and alkyl ethers mixture is used to calibrate mass spectrometer. Noncontaminating, commercially-available liquid provides series of reproducible reference peaks over broad mass spectrum that ranges over mass numbers from 1 to 200.

Ross, D. S.↗
NASA NTRS1977

Photocatalytic oxidation mechanism of isobutane in contact with titanium dioxide (TiO2)

The photocatalytic oxidation of isobutane to acetone in the presence of irradiated ultraviolet irradiated titanium dioxide was found to occur in several steps. Insertion of an oxygen atom onto the tertiary carbon transforming the isobutane into tertiary butanol occurred first. This step implied the photonic formation of the 02- species and its reaction with positive holes. The tertiary butanol was then dehydrated to isobutene which is oxidized acetone and carbon dioxide. Insertion of an oxygen atom onto the primary carbon led to isobutanal after oxidation to the alcohol. An analogous reaction scheme was proposed for all alkanes.

Formenti, M.↗
NASA NTRS1977

Thermal alteration experiments on organic matter in recent marine sediments as a model for petroleum genesis

The fate of naturally occurring lipids and pigments in a marine sediment exposed to elevated temperatures was studied. Samples of a young marine sediment from Tanner Basin, California, were heated to a series of temperatures (65-200 C) for varying periods of time (7-64 days). The sediment was analyzed prior to and after heating for pigments, isoprenoid compounds, alcohols, fatty acids, and hydrocarbons. Structural changes caused by heating unextractable organic material (kerogen) were also studied, and the significance of the results for understanding petroleum genesis is considered. Among other results, fatty acids and hydrocarbons increased in abundance although there appeared to be no obvious precursor-to-product relationship via simple decarboxylation reactions. Chlorins were partially converted into porphyrins. The phytyl side chain of pheophytin was initially preserved intact by reduction of the phytyl double bond, but later converted to a variety of isoprenoid compounds including alkanes. Thermal grafting of components onto kerogen occurred as well as structural changes caused by heat.

Baedecker, M. J.↗
NASA NTRS1977

Color of kerogen as index of organic maturity

Kerogen from the Tanner basin off southern California was heated under nitrogen at different temperatures and times and subsequently was studied under the transmitted light microscope. Samples darken in color from yellow through shades of brown to black with increasing thermal maturation. The transition from dark brown to very dark brown marks the range of maximum n-alkane generation where the residue attains an atomic H/C of about 0.80 plus or minus 0.05. The apparent activation energy for this transition was about 45 plus or minus 5 kcal per mole.

Peters, K. E.↗
NASA NTRS1978

Ultraviolet-photoproduced organic solids synthesized under simulated Jovian conditions - Molecular analysis

In an earlier paper, Khare and Sagan reported the production of a brownish polymeric material from the near-ultraviolet irradiation of simulated jovian atmospheres with a low hydrogen abundance. Examination of this product indicates that hydrogen sulfide is the initial photon acceptor; the powder resulting after extraction with benzene is 84 percent sulfur, largely S8. In results reported here, the remaining 16 percent was pyrolyzed and then examined by gas chromatography-mass spectrometry. Pyrolysis at 450 C yielded a series of alkanes, alkenes, C3-alkylbenzenes, aromatics, thiophenes, alkylthiophenes, alkylmercaptans, alkyldisulfides, together with the nitrogenous compounds hydrogen cyanide, methyl cyanide, alkylisothiocyanates, acrylonitrile, and allylisothiocyanates. Some of these compounds might be sought on Jupiter and Saturn and their satellites by remote infrared and ultraviolet spectroscopy and directly by entry probes.

Khare, B. N.↗
NASA NTRS1978

Organic solids produced by electrical discharges in reducing atmospheres: Molecular analysis

The complex brown polymer produced on passage of an electrical discharge through a mixture of methane, ammonia, and water, is analyzed by pyrolytic GC/MS. Pyrolyzates include a wide range of alkanes, alkenes, aromatic hydrocarbons, aliphatic and aromatic nitriles, pyrroles, and pyridine. Similar pyrolyzates are obtained from polypeptides and polynucleotides with hydrocarbon moieties. This polymer is remarkably stable up to 950 C; its degradation products are candidate constituents of planetary aerosols in the outer solar system and the grains and gas in the interstellar medium.

Khare, B. N.↗
NASA NTRS1979

Evaluation of the application of some gas chromatographic methods for the determination of properties of synthetic fuels

The purpose of the investigation was to evaluate the applicability, to some synthetic fuels, of some gas chromatographic methods now under development for use with petroleum based fuels. Thirty-two jet and diesel fuel samples which were prepared from oil shale and coal syncrudes were examined. The boiling range distribution of each was determined by gas chromatography, and from that data distillation properties were calculated. The calculated results gave sufficient agreement with the measured values that the equations could be useable in their present form. Bulk fuel properties were calculated for the sixteen JP-5 and Diesel No. 2 type fuels. The results show that the equations would not give useable results. Capillary column gas chromatography was used to determine the n-alkane content of the eight JP-5 type samples and the results related to the observed freezing points. The results show that the concentrations of the long straight chain molecules in the fuels exert influence on the freezing point but are not the complete controlling factor.

Antoine, A. C.↗
NASA NTRS1978

Pyrolysis and oxidation of aromatic compounds

A study of the questions associated with the use of alternate fuels demands knowledge of the chemical mechanism of pyrolysis and oxidation of aromatic compounds. Both pyrolysis and oxidation are important, because fuel-rich conditions may mean that pyrolysis is competitive with oxidation. Soot formation is certainly a pyrolysis problem. The complexity of system characteristics makes a detailed study of thermodynamical and kinetic conditions difficult. The matter can be simplified somewhat by generalizing the chemistry by classes of molecules. The criteria for such a generalization of the chemistry are discussed along with an evaluation of the rate constants and their temperature and pressure dependences. Attention is given to the pyrolysis of hydrocarbons, the oxidation of hydrocarbons, the oxidation reactions of alkanes, aspects of codification and extrapolation, group additivity, structural consideration, kinetics, and the pyrolysis of aromatic compounds.

Golden, D. M.↗
NASA NTRS1978

Evaluation of the application of some gas chromatographic methods for the determination of properties of synthetic fuels

The purpose of the investigation was to evaluate the applicability, to some synthetic fuels, of some gas chromatographic methods now under development for use with petroleum based fuels. Thirty-two jet and diesel fuel samples which were prepared from oil shale and coal syncrudes were examined. The boiling range distribution of each was determined by gas chromatography, and from that data distillation properties were calculated. The calculated results gave sufficient agreement with the measured values that the equations could be useable in their present form. Bulk fuel properties were calculated for the 16 JP-5 and Diesel No. 2 type fuels. The results show that the equations would not give useable results. Capillary column gas chromatography was used to determine the n-alkane content of the eight JP-5 type samples and the results related to the observed freezing points. The results show that the concentrations of the long straight chain molecules in the fuels exert influence on the freezing point but are not the complete controlling factor.

Antoine, A. C.↗
NASA NTRS1980

Extended hopane derivatives in sediments - Identification by H-1 NMR

Sedimentary C32 hopanoic acid, one of the most abundant in nature and of probable bacterial origin, has been isolated for the first time as a single component and characterized by H-1 NMR. The 17 alpha H, 21 beta H configuration of the C31 alkane has been similarly confirmed.

Taylor, J.↗
NASA NTRS1981

Modelling of polymer photodegradation for solar cell modules

A computer program developed to model and calculate by numerical integration the varying concentrations of chemical species formed during photooxidation of a polymeric material over time, using as input data a choice set of elementary reactions, corresponding rate constants and a convenient set of starting conditions is evaluated. Attempts were made to validate the proposed mechanism by experimentally monitoring the photooxidation products of small liquid alkane which are useful starting models for ethylene segments of polymers like EVA. The model system proved in appropriate for the intended purposes. Another validation model is recommended.

Somersall, A. C.↗
NASA NTRS1982

Effect of hydrocarbon fuel type on fuel

A modified jet fuel thermal oxidation tester (JFTOT) procedure was used to evaluate deposit and sediment formation for four pure hydrocarbon fuels over the temperature range 150 to 450 C in 316-stainless-steel heater tubes. Fuel types were a normal alkane, an alkene, a naphthene, and an aromatic. Each fuel exhibited certain distinctive deposit and sediment formation characteristics. The effect of aluminum and 316-stainless-steel heater tube surfaces on deposit formation for the fuel n-decane over the same temperature range was investigated. Results showed that an aluminum surface had lower deposit formation rates at all temperatures investigated. By using a modified JFTOT procedure the thermal stability of four pure hydrocarbon fuels and two practical fuels (Jet A and home heating oil no. 2) was rated on the basis of their breakpoint temperatures. Results indicate that this method could be used to rate thermal stability for a series of fuels.

Wong, E. L.↗
NASA NTRS1981

Comparison of Michigan Basin crude oils

Michigan Basin oils from the Ordovician Trenton, Silurian Niagaran, and Devonian Dundee formations have been geochemically compared by GC, GC-MS, and carbon isotope mass spectrometry. One oil from each formation was selected for detailed analysis which included measurement of individual n-alkane delta 13 C values. The Ordovician and Devonian oils are strikingly similar to one another, yet clearly different from the Silurian oil. This pattern is unexpected because Ordovician and Devonian reservoirs are physically separated by the Silurian strata. From time-temperature considerations, the Devonian oil probably was formed in older strata and has migrated to its present location. Our analyses suggest a common source for the Devonian and Ordovician oils.

Vogler, E. A.↗
NASA NTRS1981

Organic solids produced by electrical discharge in reducing atmospheres - Tholin molecular analysis

The complex dark brown solid of a class called tholins, produced on passage of an electrical discharge through a roughly equimolar mixture of methane and ammonia with 2.6% water vapor, is analyzed by vacuum pyrolysis followed by gas chromatography and mass spectrometry. Pyrolyzates include a wide range of aliphatic and aromatic nitriles, alkanes, alkenes, aromatic hydrocarbons, pyrrole, and pyridine. This tholin is remarkably stable to 950 C. It and its degradation products are candidate constituents of planetary aerosols in the outer solar system and of the grains in the interstellar medium.

Khare, B. N.↗
NASA NTRS1981

Modeling of photodegradation in solar cell modules of substrate and superstrate design made with ethylene-vinyl acetate as pottant material

The rates of hydrogen abstraction by peroxy radicals were proven to be too slow for significant oxidation of the alkane substrate to be important. The numerical procedure, independent of our particular data base was verified by reproducing concentration time profiles for a model reaction set describing the cesium flare system in the upper atmosphere. Simulation was identical to that given in the literature. Experimental verification of the data base is to be attempted by weatherometry studies in the coming year. Work on the new diagnostic techniques was completed. The adapted automated viscometer was demonstrated to be an efficient and reliable tool for routine measurements of viscosity (molecular weight) changes in solid samples after batch solutions have been made up. The laser photolysis GC method for monitoring extremely low levels of oxidation in polymers proved to be impractical because the yields of carbon monoxide were too low for quantification. Much progress was made with the computer model. The reaction matrix was completely revised, resulting in a new scheme of 31 reactions and time, lifetimes in excess of ten years. The results to date lead us to some tentative observations.

Somersall, A. C.↗